Ford F-150 - 1997-2003 :: 1998 - Heater Blows Cold?
Apr 16, 2014
1998 F150 step side, 4.6 V-8 automatic, 176,000 miles -
Heater begins to blow heat as the engine warms up - heat gauge moves up to normal level - running at speed, suddenly the heater blows all cold, the heat gauge pegs to total hot - the oil light comes on, the engine begins to miss - stop the truck, shut off the motor, wait 10 seconds, start back up and all is normal and away I go. Heater working just fine. Gauges are just fine. Have checked the hoses when it pegged to hot, and they are just warm just as if everything is normal.
Problem is intermittent.
Have changed radiator reservoir cap, thermostat, made sure fluid level and mixture is correct - what else to check? Computer issue?
View 7 Replies
Advertisement
I have a 2003 Ford f150 5.4. Heater blows hot, then cold, then hot then cold. When it start blowing cold it pukes out the degas bottle. I have burped it, did the combustion test to make sure not a blown head gasket, the oil clean, there is moisture coming out tail pipe but it has no coolant in it. flushed heater core, pulled water pump off and checked it, its good. Changed thermostat 2 times, put front on ramps to get any air out. I am at a total loss now.
View 8 Replies
A friend has a 2003 F150 that after starting up will run hot but blow cold air when the heater is on. The truck will run hot for ~ 5seconds then all of a sudden the temp drops to normal range and the heater begins to blow hot. Simultaneously, the oil pressure light comes on when the truck runs hot, then falls to the normal range when the temp drops. I thought perhaps the thermostat is in backward.
View 2 Replies
I took the dive into a new heater core, as the heater was not getting hot. These are the things I did while on my adventure.
1. Before reinstalling the hoses, I blew thru them to make sure of no clogs...water flew out the other hose..no problem..no clog.
2. inspected mix door not cracked or broken...no problem
3.actuator opens and closes ok, I assume, I can hear the motor run and the door thump closed...no problem
4. water and anti freeze level good....no problem
Start vehicle,let warm up, turn on heat.....No Heat...
5. check hoses at core, one is hot ,the other is not....Problem...
1997 f150 4x4 ...
View 14 Replies
I just bought a 1997 Toyota Tercel 5-speed stick, with 175,000 miles, and the temperature gauge moves from its lowest possible position to its highest possible position when the key is turned on, although the engine does not overheat, and no coolant is leaking or being burned. I replaced the coolant temperature sensor, but the actions of the gauge were not affected. I don't know if it is somehow related, but the heater blows cold, regardless the setting of the temperature dial on the dash. What I might try next?
View 3 Replies
When I turn on the heater on at any temp and fan setting the A/C automatically turns on (compressor and condensor fan turns on) . Engine temp comes up and stays at 190. I can turn up the heat to HI and still cold air blows. All buttons and LEDs work on the climatronic, is it the climatronic that is bad?
View 1 Replies
My 2003 Buick Century heater works fine while accelerating but as soon as I release the gas the air begins to cool, swiftly. I have had the radiator flushed and the coolant topped off but the problem persists.
View 17 Replies
My 1999 F250 ld light duty has an AC problem. It only blows cold sometimes. And it doesn't always work when selected to AC or Max AC. It will work on Panel also. When it works it works great. It blows really cold. But it will work fine then I'll come to a stoplight and it will stop sometimes.
View 9 Replies
98 F150 2wd 5.4 -even though VIN says its "W" 4.6; it has a 5.4 with 4.6 timing setup-found. But that's a whole other story...
So, Replaced heater core. did the blend door too.
A week later it overheated and blew a heater hose off the core at the firewall (several times). Temp was up and down, forced me into cylinder head protect mode, so i called my mechanic.
Mechanic used a sniffer (blue liquid turns yellow) in my overflow tank and there was exhaust gas in it... so we replaced head gaskets, intake, timing, water pump, radiator and the rotted out rad support.
Got it done and back on the road, but a few weeks later and the heater hose quick disconnect blew off again, spewing coolant all over (again). This was what we thought was part of the original problem- head gasket allowing cylinder compression into the coolant passages. the little rubber hose that comes from the back of the intake and goes up into the heater core builds enough pressure to pop the disconnect right off and I dont know why. Like I said- I thought it was the head gasket blowing pressure into it but that's all been replaced. Why the pressure would be so high at that point, and how do I correct this?
This is my daily driver, so for now I've bypassed the heater core, but I'm afraid that pressure is gonna burst a hose and/or fitting again.
View 4 Replies
How to replace the heater core?
View 13 Replies
My heater core has a leak in it, but I can not get it replaced so I want to bypass it. How do I do that? Is there a video somewhere? Or tutorial with pictures? F-150 1998 ....
View 8 Replies
I have 1998 F-150 and the heater core was replaced 18 months ago. All was going well until about 2 weeks ago I noticed under heavy acceleration I would smell antifreeze. The smell would clear up and would not re appear for a day or so. Finally the other day when it was 8 outside I got in the truck and got about 5 miles from the house started up a hill and it was like a fog machine was mounted behind my dash the windows fogged up almost immediately so I figured great the core went bad again. Now the temperature has warmed up the last couple of days and there is nothing no fog in the cab the heater works fine just an occasional slight smell of antifreeze. Before I go through the trouble of tearing out the dash is there anything I should check I already checked the connections on the firewall and they were fine.
View 5 Replies
I have a friend that wants me to replace his heater core on his 1998 f250 with a triton 5.4. I told him I would and I've done the one in my 1995 f150 5.8. is it the same process or where to find the step by step instructions.
View 1 Replies
My brother-in-law has a 97 F-150 with 4.6L that has no heat in the cab (blows cold air no matter what setting at HVAC controller). Heater core was replaced one year ago and T-stat was replaced last night. Coolant level is full and the heater hoses are BOTH hot so I believe warm coolant is flowing through the heater core. I am thinking that the HVAC controller may be at fault or maybe the mixing door in the HVAC plenum is malfunctioning. I have 97 rangers that had a broken hinge pin for the mixing door inside the plenum (a common problem with these trucks), maybe this is the same issue (I don't know). I am taking the whole dash out to see what the trouble is.
View 9 Replies
My 95 explorer heater only blows out cold air. I have topped off the antifreeze and just replaced the thermostat. The engine operating temperature is very cold, it won't even come up to the first mark. It is very cold here in Utah but I still can't imagine why the engine won't heat up.
View 9 Replies
The heat up front blows nice and hot but no matter how I adjust the rear ceiling mounted controls it blows cold in the back. Is this a blend door issue or something with the rear controls? Also, on a side note, one of my rear power vent windows just stopped working too. I guess it's either the overhead switch or the motor back there.
View 8 Replies
I have a '99 F150 4.2 5 speed, my problem is, my heating isn't working. My A/C works fine, my blower motor does too, i changed my heater core about a year ago. I turn my truck on wait for it to warm up and once my gauge reads normal temp, i turn my control to the warm position but the air blows cold with just a very small hint of heat. I looked it up in my Chilton book and they said to check my hoses that go to the firewall/heater core. They say that both hoses should be hot and if one isn't to check it. i did that and the one on the left side(facing the truck) is barely warm. what could be my problem? heater core? my friend from Autozone said something about a vacuum control somewhere in the engine compartment but i don't know where it is, could that be a problem? Or would the flapper door be stuck?
View 7 Replies
Ok I have a 97 f150 4.6L. My radiator has been bad for a while. With brown rust color. I replaced my radiator, thermostat, new upper and lower hoses. Everything runs great but I have no heat. I flushed everything including the heater core. Core is not leaking into cab, and both heater hoses are cold. FYI heat worked great until 5 days ago.
View 7 Replies
So the heater on my 2001 f150 will only blow through cold air. I thought that I may have a heater core clog so I back flushed it with water until it was coming through clean and unrestricted but that didn't solve the problem.
Now, some things to note are a potential coolant leak. I can't seem to find one but I filled up the antifreeze about two months ago and when I checked it the other day it was more or less empty. I've filled it up again and I will monitor it for the next couple of days.
Another thing to mention is that no matter what setting I have the heater on (ie 'panel' or 'defrost') I get cold air blowing at the passenger side's feet. Is this indicative of a hose leak or something?
Also worth noting is that the intake hose to the heater core gets hot after driving but the outtake stays cool. This is why I originally thought I had a core clog.
Should I be checking my blend door? If so how to I access it?
View 9 Replies
I have a 1997 ford f 150 lariat with the 4.6 v8 and my engine had a piston slap so I replaced the engine with a used one and I put a new water pump on the engine. My problem is the heater does not get hot and it only gets warm when I get on the freeway and the rpms stay steady for a bit. but when i idle it just blows cool air. the heat door works cause I can turn it to cold air when I'm on the freeway and i just replaced the thermostat so I don't believe its that. It weird because the heater worked fine before I changed out the engine so i cant figure it out. the only thing i can think of is the water pump is bad out of the box. Could it be the belt or does spacing on the water pump have something to do with it. nothing is leaking.
View 7 Replies
i am having some big difficulties with my car i own a 2002 Lincoln LS v-8, has about 118,000 miles on it. when i bought the car USED the heater or ac didn't blow at all we fixed that all it was a fuse. But know that it is winter time the thing is my cars heater blowsn out cold air. ive noticed some times heat blows a little from the passenger side but not the driver and then if it does get warm (my car) its takes for ever. Know i dont really have a problem with the defrost becaseu in the mornings my windows are defrosted after like 20min. ive been reading alot about DCCV and i want to think thats the problem but i really dont know.
View 2 Replies
