I am having problems with the blower on my truck. I can feel the air coming from vents no matter what setting on it. I think it maybe the blower itself as it was working and just quit. Is there a fuse for the blower that I can check? And I have the V6 4.2L 2 wheel drive
View 8 Replies1998 F150 XLT 4.6l automatic,,,
Drove the truck on a trip the other day, about 650 miles with a loaded 5x8 trailer in tow. A/C started acting weird. When the truck was on level ground, or going down hill, the A/C was fine. Cold air coming out the correct dash vents. As soon as I started up hill, or put the truck under strain of acceleration, the A/C would stop blowing out the dash vents and would start coming out the floor or defrost vents, or just not come out anywhere.
When I turned the A/C off and just used the vent setting, it would do the same thing with the fresh air. I guessing this has something to do with my vacuum lines, somewhere. What I should be looking for and where?
About mid-October I noticed when it as real cold out and I had the heat running whenever I would come to a stop I noticed there is very little to no heat coming from the vents, despite the engine being warm and running at operating temps. At the time I was working for a shop and I asked one of the mechanics what the problem was. He said that it was the radiator not having enough coolant.
Turns out when we pulled the cap the coolant res, was just about bone dry. So we added in about a gallon or so of coolant with the truck running and sure enough at idle the heat was back.
Fast forward to the last couple of weeks and when I am sitting at idle again same thing happens. So somehow the engine is losing coolant. Its not ending up in the oil (no white on the dipstick) and there is not a coolant leak. As it sits there is 255,300 miles on the truck now. 1999 5.4L F150....
I have a 1998 F150 with a 4.6 engine and is a 4x4 now the other day when I was backing out of the garage I heard a clunk noise and it seems like it is coming from the right front, so I tried it going forward it made the same noise but not as bad. There is no road noise and all the u joints are good and tight, the noise was when I gave it a little gas. My question is the front cv u joint would this make the noise? And what about the hub? What is the proper why to check the CV joint and the hub? The noise was when I was in 2 wheel drive.
View 14 RepliesI had the battery unhooked for an extended period of time while replacing the starter. My father owns a 1997 F250 heavy duty. Well he was parked beside me when I was putting everything back together. He goes to lock his doors and ended up locking mine and his. After that my remote won't work at all, but his does. What happened? Howdo I fix it? I tried to unhook the battery for 3 hrs and plug it back in. Still nothing.
View 2 Repliesmy heat has suddenly quit woking getting hot. It has plenty of water, my heater hoses are not gettting hot.
View 14 RepliesI have a 99 F150, with the 4.6, and my headlights just randomly quit. I checked all the fuses, and switched the MFS, and main headlight switch. All I have is my DRL's. I also checked for wires coming out of the plug-in on the column, but they seem good too. I'm just not sure where to go from here....
View 14 Replies1997 Ford F-150 4.2L V6... I got into my truck yesterday and went to turn it on. The motor cranked half way then quit. Now everyone time I attempt to turn it on all I hear is a click and nothing else. A friend of mine who is pretty good with cars took a look at it with me. He tested my starter with a volt meter and said everything seems fine. We proceeded and checked all fuses, non of which we found are blown.
We then focused on the starter solenoid. We were able to get the truck running by arcing the 2 lower big terminals. I purchased a new solenoid thinking that was the problem, however replacing it solved nothing. Same problem is still present.
I have now arc the terminals to get the truck started 2-3 times in order to get to a shop. They spent all day looking things over and are pointing the problem to a bad starter relay. (i thought the starter relay was actually the same thing as the starter solenoid) Anyways they told us they have looked over all the diagrams they have access to and cannot locate the location of the starter relay. (maybe becasue its the solenoid?..)
Bought this truck earlier this year, and started to notice from time to time a smell in the cab that can only be described as propane. Truck was sound and the windows were down most of the time so I let it go. Probably not smart. With the windows up more often now, what this could be. It comes and goes. My guess is it's somehow coming through the vents, but what the heck is it? Is there anything in a truck that has mercaptan in it?
View 10 RepliesMy uncles 99 f150 is acting a little strange. When he steps on the gas, the air conditioning comes out of the defroster vents. What's going on?
View 9 RepliesThe AC works, but just not well enough on a really hot day. On a day in the 90s I have to put it on Max AC and even then it does not cool down for a while and the air out of the vents is not ice cold.
So, it works, but I cannot tell if there is something wrong or not. I recently put in a can of AC Pro and it did not change anything.
I'm guessing my heater core is bad as I smell coolant thru the vents. I think the blend door is broke too. I'm guessing the heater core and blend door are in the same area?
View 2 RepliesI have a 2002 F-150 SC and the drivers side window quit working yesterday. All the other windows work fine and I can't see where anything else is not working. The only other thing that quit prior to this window problem was the cruise control quit a while back.
View 1 RepliesI have a 1997 ford f150 V-6 4.2. My son was driving the truck on the expressway and it quit running. The toe truck has delivered the truck back to my house. The engine turns over but will not start. I shot gas into the engine with a spray bottle and the engine still would not start. Was going to check the coil for spark next. What to check first. Was thinking the problem could be the modulator or coil.
View 10 RepliesI have a 2000 F-150 and my lights to my gauges and heater controls quit working. I checked all the fuses inside and under the hood. All good. I swapped a few relays around and no luck. I tried replacing the headlight switch and that did not work. I checked power to the gauges from the headlight switch and there is no power, I then ran a hot wire to the wire that powers the gauge lamps and they do light up, so it is not a bulb issue. I assume I am not getting power, but do not know where else to look?
View 14 RepliesI have a 2000 Ford E150 Van with 5.4L and auto trans. I left the lights on and ran the battery dead. Charged it back up and now ever since then, when I am going 50-60mph and let off the gas, the van freewheels for a short distance and then acts like it shifts out of overdrive and pulls the van down like its not in freewheel mode anymore. Only has 73K on it.
View 3 Replies2001 F150 5.4 4wd - AC not working but when I turn the temperature dial to the blue side and turn on the fan, super hot air comes out of the vents or wherever I direct the fan to blow (Floor, defrost, etc) I know it shouldn't blow ice cold especially since my AC doesn't work but.....shouldn't I feel a temp change coming from the vents when I move temp dial from the red area to the blue? It's max heat wherever I have it set.
View 6 RepliesI noticed a couple weeks ago after starting the truck and turning on the a/c that nothing was coming out of the vents. I found it odd when after driving a few miles the a/c kicked in and started blowing cold air. Today I needed to put on the defrost and same thing, nothing came out of the vents. I drove around for a while hoping it would kick in just like the a/c did but nothing. I did check the fuses and relay. When you turn the control either to heat or a/c you can hear a clicking sound under the hood. It's trying to engage but nothing is coming out of the vents.
View 12 RepliesTruck is a 02' F350 xlt crew cab, 7.3l, 4x4, 4R100, manual transfer case, 125,000 miles.
So me and the family were pulling out of the driveway tonight and electrical smoke starts blowing out the vents. My wife had just plugged a cheap USB charger into the auxiliary outlet above the cup holders for only 30 seconds. I immediately pulled back into the driveway, yanked the charger out, and found it had melted a hole in the side of it. No smoke had come from the charger or the outlet. The outlet looked fine and wasn't hot to the touch. I pulled the dash off real fast and started grabbing wires, feeling for anything that was hot or melting. I couldn't find anything.
I pulled the cover off under the steering wheel and couldn't find anything. I never turned the truck off while I was looking. After a few minutes, I noticed that the cover over the fuse panel was warm. Pulled the cover off and felt every fuse end and they were all cool to the touch. The relays in the middle were all pretty warm(almost hot to where I couldn't touch them). I was still faintly smelling the burnt smell and I couldn't tell if it was just stuck in my nose. I disconnected the batteries and we had to switch cars(heading to a bbq).
So I just got home and I'm going to start looking for any obvious signs first. What could be going on at the panel? So far, everything is still working. I haven't found any blown fuses.
I am having a problem with my 1998 F150 4x4. The 4WD is not engaging. It is a manual shift. I have checked the transfer case by turning the drive shaft in 2WD it is free. When I shift into 4WD it is does not spin freely. So I believe that is OK. I have checked the vaccum diaphram. It will move the piston when I attach a hose and pull vacuum on the inboard hose barb. So I believe the diaphram it self is OK. I am not sure if the hoses and selenoids are OK. They look fine. However there is a constant vacuum on the inboard hose line (red/pink color) wether I am in 4WD or not. Is this OK? How can I check the selenoids. If all this is OK, the next thing I believ it could be is the shift fork in the differential. Is that a difficult job? Do you need to pull the whole axle out to replace it?
View 14 RepliesJust bough a '98 F150, 4.6L; drove it home and it ran great, lots of impressive power etc... Parked it my shop and getting it ready for safety check so I can register it. All I did was change the oil, oil filter and air filter.
Couple weeks have gone by, I went to start it and it does start & idles beautiful but it will not rev. I give it gas and it's like it's choking / wants to die. The signal lights are flashing super fast which I don't recall doing before. Battery wasn't holding charge so I installed a new one tonight; no difference. Alternator is good.
I have not checked the plugs yet because I don't think that would be the cause of an overnight change from running excellent to what it is now but I will check them.