Ford - Explorer :: Intermittent Check Engine Light - P0193 Code
Jul 19, 2017
My 2007 Explorer (XLT, V6 4.0L, 4WD, 175k miles) has been experiencing a check engine light, intermittently, for the past few months. I took it to AutoZone to read the code and they gave me a printout for P0193. For awhile, the light would go off after I filled the tank with gas (usually the next day) and would come again as the level in the tank decreased (typically around 1/4 of a tank). Then about two months ago, the behavior seemed erratic and I could no longer predict when it would appear. During the past couple of weeks I only recall seeing the CEL once (briefly); it's mostly been off. Saturday night I was out driving and it came on again.
About two hours later, my vehicle "conked out" on me. It started hesitating (it's been a very long time since I've run out of gas, but that's what it reminded me of). Fortunately, there was no traffic and I was able to get it off the road but didn't have enough momentum to get it into a defined parking space before it quit. I sat there for awhile pondering my options (not too many since it was the middle of the night and I don't have road service). After about 10 mins or so, I decided to see if I could get it started. It did start and I was able to drive it home (< 10 miles). It's been sitting in the driveway since because I'm afraid of getting stranded if I drive it again. BTW, I was low on gas when it died -- about 50 miles to E (was headed to the gas station when it happened, but took it home instead).
After everything I've read the past few days, I'm expecting that I need to replace at least the fuel filter, the fuel rail pressure sensor and the intake gaskets for the manifold. I am not a mechanic, don't have diagnostic tools, my funds are really limited right now and I'm pretty much on my own to figure this out.
Q1: For those who may have some knowledge about this particular issue, does the intermittent nature of the CEL give any clues to which part(s) might be malfunctioning?
Q2: I found a replacement FRPS made by Bosch on Amazon, significantly cheaper -- is this brand ok or should i stick to Motorcraft?
Q3: Any advice on the manifold gasket replacements (is one brand better than another)?
Q4: Do I really need the special tool to replace the fuel filter?
The questions above are no longer relevant. I'm in the process of "locating" the sensor. I have the air hose and throttle body off. Now I'm looking at the EGR valve. It looks like I will have to disconnect the it from the large pipe beneath it. Will I also need to remove the two smaller bolts that mount it to the manifold cover, or can I remove the cover & valve together? It looks like those little buggers are going to be challenging since they are facing the back of the engine compartment. This is rather slow-going for me, but there's no turning back now.
View 4 Replies
Advertisement
This is for our 2005 Mercury Monterey. The check engine light is on and the code says P0193, Fuel rail pressure sensor circuit high input. Last week we were waiiting in he car with it running on idle and heat running, about 5-10 min, later the the light came on and has remained on, so checked for the code and above code displayed. Possible causes/fixes could be broad as per the sheet printed at ORailey's for this vehicle, but based on above info can it be narrowed down? How urgent the repair is, needed to show right away? What could be done at home before taking it in? car has around 108k on it.
View 5 Replies
For the last few months my truck has been throwing an intermittent check engine light due to the same code every time - P0171. The dealer has allegedly checked everything and has given me the "We have done all we can do" speech. Lead tech even suggested that since today's fuels have alcohol in them, that a check engine light would be normal. The truck has been in the shop 3 times with no success or even remote possibility of what the problem could be.
The check engine light has since gone from intermittent to constant and comes back on after 5 drive cycles after clearing with an OBD2 scanner. Also, I'm now getting a P0174 code.
Personally, I think they're trying to blow me off because I'm a few months and about 2k miles away from being out of CPO warranty.
Truck is a 2013 F150 Super crew 2wd 5.0 with about 45k miles.
View 9 Replies
I have an 01 Explorer Sportrac with a 4.0, 105,000 milles. Got the check engine light with the EGR low flow code. I get this code about once a year and a new DPFE usually takes care of it. I get the sensor from Advanced Auto which explains the short life I am guessing. Last time i replaced the sensor the light came back on a couple weeks later.
After highway driving smoke starts pouring freon under the hood, passenger side, but by the time I get the hood opened its done. Cant tell where it is coming from. Could a faulty DPFE cause the smoke or do you think the EGR valve may be sticking? I was going to try a Ford DPFE this time but I hate to just throw parts at it. Where do the smoke is coming out of, air filter box????? cant see anything else over there related to the EGR system......
View 4 Replies
I have a 99 Ford Explorer - w/217k miles. (2nd owner) .. I got an oil change 3 weeks ago, tune up 2 mos ago, and new brakes/tires within the last 6 mos, oh, and Brother-In-Law just recharged my a/c last week.
Runs well, and I hope to keep it for another few years, but having problem lately.
Check Engine light keeps coming on - I've taken it in, and they read the code, and it comes up with a misfire. Mechanic resets it, and it will stay off for a few days/weeks, and then comes back on.
View 3 Replies
2004 Sports Trac Got a check engine light: a code P0913. The truck , once in a while, hesitates like it not getting fuel. Is this a fuel pump problem or something else?
View 1 Replies
I have a 2006 Sonata with an intermittent check engine light. The light will be on for a few days then goes out for a day or two. This pattern has been going on for about 3 months now. A scan tool was used and showed the code P0011. I know this code has to do with the camshaft timing. My question is should the light be going out on its own if there was a problem with the camshaft timing? Does the engine correct itself and then experience the problem again. Is it normal for check engine lights to go on and off with out being manually reset? Could this be a faulty sensor or loose wire causing the light to go on and off? The car has about 75,000 miles, mostly Hwy, and is driven just about everyday.
View 36 Replies
1996 Ford Explorer on a small island with no mechanics. Vehicle does less than 100 miles per year, never over 20 mph. The check engine light came on and the code reader says it's a problem with the Camshaft Position Sensor. The vehicle runs fine, just as it did before the check engine light came on. I'm tempted to put some electrical tape over the check engine light and keep driving.
View 2 Replies
My 2005 Dodge Dokota 4.7L V8 152,000 miles has an intermittent check engine light (CEL) code P0420 ('catalylst efficiency') that turns itself off.
1) 151,000 CEL on, code P0420, checked, cleared at dealer.
2) 151,948 CEL on, code P0420, checked, cleared at dealer (Cat Conv).
3) 152,200 CEL on, code P0420, checked, cleared at local auto parts store.
4) 152,597 CEL on. No checks.
5) 152,815 CEL turned off on its own
6) 152,849 CEL on. No checks.
7) 153,137 CEL turned off on its own.
Twice in this time CEL has came on soon after a fill up from near empty.
Engine runs fine, 18-19 mpg highway.
Have seen numerous on-line reports of other possible causes:
a) base engine problems (coolant or oil) -- coolant temp sensor
b) Air inleakage -- air systems or manifold
c) Lazy front O2 sensor
d) fuel pumps
e) timing or misfire
f) what else? - (gas cap, other...)
What to check first or categories to eliminate?
View 4 Replies
I have a 2003 Elantra GLS. I am intermittently Check Engine light and error code is P0113 - Air Intake sensor issue. I can't locate where the sensor is. I don't see any wire coming of the tubing that connects the air filter to the engine.
View 18 Replies
I have a 2007 f250 and got a check engine code icp circuit intermittent and to what I know icp sensor should be on the valve cover on the passenger side but it's not I bought the truck few months ago could it be that they swapped the engine for an early 6.0 or is there any other place for the icp sensor???
View 7 Replies
Book says "catalyst system efficiency below threshold (Bank 1)".. Is it just based on mileage or an actual bad O2 sensor or other bad system component?
View 14 Replies
Im getting an intermittent stumble with a check engine light. I have a 1990 Ranger XLT with a 2.3L 5spd. I pulled the codes 32 41 88. I looked them up but Im not sure what to check next. I have done much searching on several sites but havent found much. OBD-1 eludes me.
32(R)EVP - EGR not responding properly during test - EVP
41System Indicates Lean
88 Loss Of Dual Plug Input Control c ..
What does it all mean??? What would you check next?
View 7 Replies
My 2004 Outback now has 120K, has always been maintained and repaired at the dealership (except tires and battery), and has always run great! I've had the plastick-y parts replaced over the last few years including head gaskets when one cracked and made smoke. In July I got a jump from a AAA tow truck, who said my battery tested as needing replacement.
In September my check engine light went on, and the dealer found the code PO420-catalyst system efficiency. They didn't seem to look any further into causes. The cat converter replacement was to cost $2521. They reportedly tested the battery as OK as part of their routine checkup. I declined the new cat converter till learning more. Meanwhile, my check engine light seemed to cycle on, then off, then on, then off . . . every several days.
In December I had the battery checked at Sears, who replaced it under warranty. So I guess it wasn't okay after all. After that my check engine light stayed off for somewhat longer than usual, then back on for most of January. I was just about to give in and get the repair done when it cycled off briefly a few days ago.
I've lost trust in the dealership because of their battery check which differed from others before and after theirs; and for their lack of specific diagnostics. The light is back on and I don't know what to do next.
View 7 Replies
i have a continuous Check Engine light in my 2008 ford explorer. Dealer recommend replacing a sensor but I do not know which sensor to change.
View 4 Replies
My 2014 F-250 is having a repeat problem with an intermittent cell engine light. About 10000 miles ago it happened, and they changed out the egr cooler. Saying it was gummed up with soot. Problem just started up again. Light will stay on for about 3 or 4 restarts then sir off on its own. It's this a known issue with the 6.7? Is there a way to prevent it?
View 7 Replies
My 1998 Explorer with 120,000 mile on it. The check light just came on. I have had several auto part stores plug in the scan tool and there were no error codes. I'm looking for the reset button location. I am also wondering should there be something missed by the scan tools, will the light activate should there be a real problem.
View 9 Replies
2001 explorer sport, need to reset and clear check engine light I know the problem a small pinhole in exhaust that opens up and i fill it in How do i reset check engine light...
View 1 Replies
Check Charging System message, battery-shaped idiot light, and audible beep has happened a few times over the past month or so. Yesterday it happened while my wife was driving so I had to bring it to the dealer, not to mention I drove it last night and there was constant beeping for about a minute which was pretty annoying.
But first I had the battery checked, which turned out to be OK. Also we got a new alternator 5 months ago, installed by the dealer.
Today they said they "updated the computer" whatever that means, and otherwise couldn't find anything wrong. $99.85 plus tax.
Needless to say I'm not confident that "updating the computer" has fixed it. What are the odds we get the warning again in a couple of weeks? Short of disconnecting the sensor, is there anything that can be done?
View 2 Replies
For the past few months, I've had a weird intermittent check engine/VSC light problem. I've noticed that it comes after getting gas...and sometimes goes away after getting gas. I've jiggered the gas cap to be sure it's tight. Is it possible that this is something as simple as the seal in the cap gone bad?
View 4 Replies
Our 2008 with 110,000 mi is intermittently displaying CEL. First appeared about 3 wks ago. I took gas cap off and then put it back on and let car sit overnight. Next day and for 10 days no CEL. Then one mornng, at first start, CEL reappeared. Repeated gas cap process that night. CEL disappeared for 6 days. Then CEL came on in middle of day after car had been started and stopped 3 times. Repeated gas cap process that evening with no success. Did the gas cap thing one more time, last night, and today the CEL is off. First time CEL came on was right after a fill-up. Subsequent CEL's have had no relationship to refueling. Car has been nearly flawless for 68 months. Engine coolant pump changed @ 75k. Aux batt changed 24 mo ago.
View 8 Replies
