Happened two times already if i press gas when turning 90 degrees. My engine stops and i have to start car again, why could this be happening?
I got misfire cylinder 4 and 6 perhaps its related however i am trying to understand dynamics of things why engine only stops under this conditions?
How to reset the Anti Theft on my explorer? The light is flashing fast and the engine won't start. Without the anti theft being reset the truck won't start. Been checking around to find an answer but can't find one...
View 7 RepliesMy '03 passat w8 just started making a lot of noise which sounds like the engine fan is running very fast and blowing like mad even though my car is not warm. It started 3 nights ago and sounds like a street sweeper, which is what I thought it was until I looked around and saw there was no street sweeper to be found. When I turn the car off the noise winds down and disappears with the fan still running just making the normal amount of fan noise so I don't think the problem is the actual fan.
View 1 RepliesMy 2001 Outback has a jumpy thumping problem when making a 45 degree turn and when going in reverse. My mechanic has been unable to figure out what the problem is. It only happens once the car has been driven for a while
View 1 RepliesIts getting worse. Noticed it a month or so ago, very slight ticking noise when the engine was cold. It would go away after a minute or two when the engine warmed up. Kinda sounded like a lifter ticking type noise when low on oil but I was not low on oil.
Now its getting more noticeable and it doesn't go away. Very noticeable when I take off or accelerate. less noticeable when I take my foot off the gas but its still there.
What it might be? I am pretty newbie about engines and I don't want some repair outfit telling me I need a rebuilt engine if all I need is to tighten my manifold or something. Because that would be my luck.
2000, XLT, 5 Liter V8, 178K miles.
My 2004 started shuddering at 45mph or while going up a 4-6 degree hill. It was well past the suggested 100,000 mile spark plug change. I thought about changing the plugs myself until I heard that they could possibly break and would be difficult to remove. I took the truck to a shop and had the plugs changed.
For about 2 days it ran okay, but the shudder returned and we got PO303 (mis-fire cylinder #3), PO316 (mis-fire on start-up), and PO171 (system to lean, bank one) Codes. The shop replaced the fuel injector on cylinder #3 and again the truck ran okay for about 2 days. My son and I cleaned the other three injectors on bank one, cleaned most of the sensors and the MAF.
That work cleared the PO171 Code, but we still had a mis-fire on cylinder #3. We swapped the spark plugs between #1 and #3 and got a mis-fire on cylinder #1. We replaced the plug on cylinder #1 and that cleared the code. The truck is running great.
2005 explorer just started having a fast blink on the right turn signal. Left turn and hazards work fine.
View 3 RepliesAt highway speeds above 60 mph on a smooth road, the vehicle runs fine. But if the road has any bumps at all, even small ones, it starts to vibrate very fast as long as there are bumps. The steering wheel almost becomes a blur. It's like it's going into oscillation.
The wheels have been balanced and rotated. The movement the steering wheel is not side to side, like I have experienced with imbalanced wheels.
The shocks look fine and I am told that they are OK by the tire dealer . I have never had this kind of a problem with bad shocks. The vibration is just too rapid.
Before I take the truck in for the mechanic to inspect it, I would like to know what the problem might be.
'99 Explorer 5.0 doesn't want to start in the cold weather, below 30. After it finally starts it runs great and will start all day. It cranks fast but it doesn't get driven every day.
View 2 RepliesMy 2000 Explorer overheated and I had water pump and intake manifold replaced.. then it had a freeze plug rust out and its replaced, I'm holding water.. but now it just wont start.. we've tried everything from changing fuel injectors, fuel delivery unit on intake, now the fuel pump is changed.. still wont start and the theft light is flashing fast.. my dad changed computers while I was out of town,, is it the theft device or does the computer need coded for this explorer?? we have taken negative off battery but nothing.. And if I change the motor will that work or still not run because of theft light or computer??
View 3 RepliesMy truck is vibrating and shaking when you go over 30. but occasionally stops. I replaced the whole rear end, rear shocks, rear brakes, rear drive shaft U- joints, rebalanced the rear tires( they needed that). at least that fixed the noise (grinding) from the rear end is gone but it is still vibrating.. Over $700 in it this week. at least i did the repairs myself and saved a bunch of money. But i am now stumped... I dont know it if is front end issues, transfer case issues, transmission issues....
View 4 RepliesI forgot something my battery went dead and it got jumped (left lights on) and now i am getting the 4x4h light blinking it blinks 10 times and then stops and after about a min or so it blinks 10 times again and i am also getting a low oil message on the message center all this started after the battery went dead?
View 4 RepliesAbout 3 weeks ago my truck decided not to start after having driven many miles. It has happened again after a day of driving with multiple stops. It cranks but doesn't turn over. Mechanic could find no code errors, there is no service engine light. Problem?
View 9 RepliesRecently bought a 91 f250 4x4 460 turned the air on and after a few min running the ac unit clicks. The front of the unit stops turning and makes a clicking sound. Then starts to spin again. Air blows kinda cold....
View 10 RepliesMy '02 Explorer transmission is giving me a little trouble. The vehicle has 240,000 miles, but the transmission has been rebuilt several miles ago. I recently had the fluid changed, and I had them add a bottle of Lucas Transmission Fix, which I have had good luck with in the past. Most of the time, the transmission behaves normally.
Occasionally however, when I come to a stop after driving for a while, the transmission stops pulling, like it has shifted into neutral. Sometimes it will re-engage after a couple seconds, and sometimes I try to hurry it along by shifting to Park, then back to Drive and it will go. If I am on an incline, and the vehicle does this, it will actually roll down the hill.
Hopefully there is a simple fix because this thing is too close to the end of its life to require a hefty repair investment! Maybe a switch or a sensor. I'd love to tell you that I checked the fluid level, but Ford forgot to put a transmission dipstick on it.....
I have a 99 explorer that stops blowing air when I get on the gas or climbing a hill. The motor is still blowing but it stops air coming out the vents. What could be causing this? It works fine other than that.
View 3 Replies4.0 v6 A/c works great at first. Then after a while stops blowing out the center dash vents. What to check? Still blows cold out the vents by each front door...
View 2 RepliesA friend of mine have a 94' Explorer with the 4.0 v6. Fuel pump starts for 2-3 sec when i turn the key, stops when cranking and starts again when i stop cranking. i checked the fuel shutoff switch and it was ok, and it have spark.
View 3 RepliesRhe problem is that both sides blink fast the left one used to blink normally sometimes and fast again. All the light bulbs work and are not led. I found the problem on the right side : in the front the side light blinks but the drl doesn't blink with it. Now both sides blink fast. What part of the car i should check ?
View 3 RepliesThe problem is that both sides blink fast the left one used to blink normally sometimes and fast again all the lightbulbs work and are not led i found the problem on the right side : in the front the side light blinks but the drl doesnt blink with it now both sides blink fast. What my problems might be? What part of the car i should check ?
View 3 RepliesIn the summer I have a habit of switching off the air conditioner every time I pull away from a stop, then turn it back on after I get up to speed again. Because the engine needs the most power when pulling away from stops, I have the impression that this saves fuel. Is this necessary?
View 19 Replies