Ford - Explorer :: 4x4 - In 4 Wheel Drive High Loud Clunking Noise Constantly?
Apr 6, 2012
Alright so a friend of mine has a Ford Explore with the little switch on the dash for auto 4 wheel, high 4 wheel, and low 4 wheel. When it is in Auto it has no issues drives fine and good. As soon as you turn it to 4 wheels high and start to go all you get is a loud clunking noise constantly. Another friend had a similair issue with an AWD explorer that we just pulled the front drive shaft and it seemed to solve the issue. How would I test the driveshaft to see if that's the issue.
View 2 Replies
Advertisement
I've got a 97 explorer xlt 5speed.... When you start the truck and start driving... its making a Loud clunking noise from under the car... at first we thought it was the gear box but then after replacing with a reconditioned gearbox and transfer case it was still there... it is doing this in auto mode and in 4x4 mode... during city driving it does it all the time .... but when you drive it to 100km/h the clunking completely stops.... and then you can bring the car to a complete halt (without turning the engine off) and start driving again and the clunking is still gone... BUT as soon as you turn the engine off and on again (even if only for a minute) the clunking returns again until you drive to 100km/h and then it stops again.
View 2 Replies
My boyfriend bought a 1999 ford explorer, he put about 2,000 miles on it in four months... I believe it now has roughly 110,000... Now the other day, he was pulling out and shifted from reverse to drive, we heard like a loud clunk/thump noise... It shifts into drive, and revs but won't move, it feels like neutral... If you shift to second, first, or reverse it's fine... Tranny fluid is good... O/D is always engaged...
View 3 Replies
There is a clunking sound and feel from the front end of my 2007 Ranger FX4 when in 4 wheel drive. This happens sometimes but not always on engaging or disengaging 4 wheel drive, as well as sporadically while driving along. I took it back to Ford on warranty with this problem last year, and after a few attempts I had them admit that something was wrong and they finally diagnosed that it was the front drive shaft that was binding where it leaves the transfer case, this was replaced. I have now put maybe 50km (max) on in 4 wheel drive and the problem is back, I don't think the problem was ever fixed.
View 14 Replies
Have some clunking I can feel through the steering wheel. Starting with checking ball joints.
1999 explorer Eddie Bauer.
Would I jack it up on the control arm to release any tensions? Any tips or tricks after doing a visual to find my clunking?
View 3 Replies
Is there a way to disable the auto 4 wheel drive on a 98 Explorer for testing purposes? I believe there is a module but can't remember where it's located and I don't know if it can be temporarily disabled.
View 10 Replies
My problem is that my explorer, 130,000 miles will not engage in any gear while in 2 wheel drive or 4H. Truck will only engage in 4L. And when it does engage in 4L it hesitates and jumps into gear, especially drive. Also takes some doing to get it out of 4L. While truck is in 2 wheel and in drive, my speedometer reads about 20 mph with truck not moving. It does not do it in reverse. Also gears will grind when I attempt to put vehicle back in park because of it registering that I'm doing 20. Dropped pan and changed tranny fluid and filter. No change. Also not hearing transfer case engaging while I shift between auto, 4H and 4L. Really need this truck fixed ASAP, and need to do repairs myself.
View 2 Replies
My 2004 V8 egg is currently at 111,000 miles and I'm starting to have problems that are really cause for concern. Since the blue book value on the Touareg is worthless and I've got it paid off, I might as well keep it until the wheels fall off of it. Anyhow, on to the problem at hand ...
When driving on the interstate at high speed somewhere around 80 - 90 mph and you push the accelerator to get that extra bit of speed out of the downshift so you can pass or just for the heck of it, the transmission starts clunking, LOUDLY, which of course causes you to let your foot off the gas. The clunking continues for about 5 - 10 seconds until the car has slowed down a bit.
I can still get the car up to speeds of around 110 mph (my wife tried it just about 15 minutes ago on our way back from Florida), but it has to be done gradually as to keep the transmission from downshifting.
Around town the car responds fine. Occasionally it will have a hard shift, but I can't find a reason or pattern to that. Fifth gear also works fine in city traffic, I've used tiptronic to keep it in 5th and I've also watched the main display change from D4 to D5 to D6 and back again without incident.
I'm too afraid to take the car up to 90 and then engage tiptronic and downshift to 5th. This transmission has had its fair share of problems. I'm on my third stepper motor, the forward transmission seal had to be replaced and then later the hydraulic pump had to be replaced. There are no noticeable fluid stains on the belly pans and there are no stains on my garage floor, so I doubt its leaking fluid. Can you even check the transmission fluid level in this thing?
Other than the transmission problem, the Touareg is behaving fairly well. (Knock on wood) It still rides nice and I've learned to put up with the little electrical anomalies that happen like the blue strobe backlight compass (it's just dancing along with the music) and the lights switching ON in full daylight (with the euro switch installed).
View 4 Replies
Yesterday I noticed when I pushed the 4x4 high and the 4x4 low button nothing happened, there was no light indicator coming on at the dash, and also there was no differece in gears when 4x4 low was selected, is there an easy fix to this like possible a fuse blown?
View 14 Replies
So my Push Button 4 wheel drive wont engage. The light on the dash wont light up and it doesn't shift into 4x4. Where to start? I would like to check the simple stuff first. O and my heat only gets hot when im giving the vehicle gas. This is all on a 2003 Ford Explorer.
View 2 Replies
I have the ESOF in a 2000 Excursion. I went to use 4X4 high and it would not give me 4 wheel drive. light on dash said 4X4 but no 4 wheel drive. I was in snow and only rear wheels spun. When switch is placed in 4X4 low I get 4 wheel drive.
View 1 Replies
I think it's possessed! My sisters vehicle, a 2002 Explorer with a 4.0 V-6, automatic, 2 wheel drive will just shut off. At first it acted like it would vapor lock. But it would start right away. then the a while later, (several months), it got where it would drop rpms and the engine shudders, sometimes not dying.
When this first started, the throttle body was cleaned, a new air filter installed, fuel pressure checked. Everything checked out and for a few days it ran fine. Then it started all over again. There has never been a code thrown. All of this goes on only when the ambient temp is above 70 deg.'s. below 70 deg.'s it runs perfect.
Last week it went to the mechanic again and a new crank speed sensor, fuel pump, and diagnostic done. He could not find anything wrong any where. Took it for a test drive and it dyed on the mechanic. Still no codes. What the problem might be? Every Mechanic that has looked at it has gave up, one even saying, " it's possessed."
View 14 Replies
I made a big mistake, I was cleaning out my truck and accidentally switched my 4 wheel drive to the 4 low position. Not knowing this I started the truck and just drove it all day. Then I noticed my mistake and now the truck will not shift into either 4 high or 4 low!
The truck drives just fine, I feel no pull when I turn to the left or right so it seems that it never did any shifting into 4 high or 4 low, so I'm looking for recommendations on maybe how to fix?
View 3 Replies
For the last few weeks, when I make a turn (particularly a sharp turn in either direction) I get a "clunking" noise that sounds like it is coming from the front end somewhere. I can also feel it - almost like a gear slipping and engaging again. I am not in 4WD mode when this is happening. It NEVER happens unless I am turning a corner. If I drive straight, it's fine. 1999 Explorer XLT (4 door, 4wd model)....
View 2 Replies
So I have a 06 350 and I'm getting clunking from drive to reverse and now with drive too, I know my rear diff is on it's last days but I am wondering if that could cause the clunking and now my truck around 90km shakes likes crazy and same thing wana know if that's the diff. And if I was to fix diff myself would it not just be easier for me to just swap axles if I wanted to be cheap??
View 12 Replies
Every time I turn on my 2010 impreza and slowly drive away i hear a clunking sound coming from somewhere in the front. it happens almost every time i start it up, even if it is warmed up.
Went to the dealer (car is 4 weeks old) did a test drive and it only did it once for them of course even though we tried almost 10 times. What it could be and will take it in for a full day to let it get cold.
Also, a slight rumbling when the car is cold and the blue cold engine light is on? I know the car being cold explain that but you'd think that a brand new car would be free from things like that.
View 11 Replies
I thought there was a v10 specific superduty section like how the psd does, but my thread went in the "performance, engine, troubleshooting" section.
I wanted more exposure than that particular small viewed area.
I don't have a video of the noise, but my 99 f450 v10 5spd has some iffy noise coming from the front. I've read so many threads on this and they either end with "my motor had 1-2-3 bad pistons" or "my flexplate was cracked" and all that dealt with chain tensioners were never finished.
I know what piston slap sounds like (worked on many cobras and lightnings with forged pistons that had it) and have experience with bad wrist pins and broken piston skirts, and this noise doesn't sound like any of it.
Noise is a loud clicking/clunking/Detroit diesel idle noise. When you rev the engine up it doesn't lighten or get better, only worse as rpm goes up. Oil is terrible looking, I'll be getting that changed this week.
Story on truck. I've had this thing for 4 years with blown motor. I got a buddy that acquired a parts truck and he said it ran good. I dropped my truck off and he swapped the engine. I got my truck back running, but with this engine noise. He said it needs to get run some more and change oil.
I think it's timing tensioners, my buddy says it will come out of it, a mechanic friend says it's going to blow up "because they all do" and I don't really want to replace the engine again.
If it's tensioners, how big of a job is it. I have the cam clamps and crank stop and the ford tools to make sure crank and cams don't rotate while apart.
I'm just 650 miles from my truck and may need someone else to do the work. Which sucks.
View 4 Replies
2004 Santa Fe, clunking noise in drive or reverse. checked brakes and cv joints, replaced drivers front and still making the noise. Transfer case was a little low on fluid but not much. Put up on stands and turn wheels with no noise. Put in drive or reverse while in the air and rear wheels sit still. It is a 4wd so I would think that all 4 tires would be turning. While in the air the front both turn and no noise is made.
View 18 Replies
When driving, getting up to about 30 mph, a loud clunking noise and feeling seem to come from under the center armrest. I have looked underneath to see if something came loose or was missing, but nothing looks out of place. Increase in speed makes it get worse.
2004 Touareg V6 67k Miles
View 19 Replies
We're having problem with our Prius where car suddenly started to make weird clunking noise from the engine (28k miles, 2011 Prius). Car sounds unsafe to drive around, so I left it parked in the drive way. I did check engine oil level and it was at F level.
View 4 Replies
I have a 2006 Hyundai Sonata that is making a loud clunking noise when I first put the car in gear. I start the car, put my foot on the brake, put the car in R and I hear a creeeeaakkk, clunk! noise coming from the front, passenger side of the car. I back up out of the driveway/parking spot, put the car in D and get a slight clunk! noise out of the same area again.
At first, I thought this was maybe a ball joint or a tie rod failure, but a friend of mine and I took the front wheels off of the car this past weekend and I gotta say, everything was found to be in solid shape. Nothing loose, bushings are in good shape, boots are in fantastic shape, no loose wheels that can be moved in ways they shouldn't move. After getting the noises and clunks to happen again, my buddy's opinion is that it's my transmission having a tough go of it and that I should take it to a transmission shop. Is it a transmission thing?
2006 Sonata, 6 Cylinders, 141,000 miles (227,000 km)
Never did anything with the transmission fluid since I've owned the car. I bought it in 2010 when it had 80,000 miles (129,000 km) on it.
View 1 Replies
