Ford - Explorer :: 2010 - Automatic Door Locks Does Not Lock When Vehicle Starts Moving
Jan 25, 2017
I have a 2010 explorer. I bought it with a lot of the lights, i.e. tire pressure, skid control, abs, service engine, air bag, service rcs and some others on and these systems are not working. a module was missing associated to the AWD system, I have put one in but awd still does not work through the 4 high and 4 low work. The automatic door locks does not lock when the vehicle starts moving. Some of the lights on the dash and doors don't work either.
View 2 Replies
Advertisement
Ever since I installed my L.e.d. lights in my doors the automatic door lock once moving keep locking like 3 times. I don't know why this would happen I didn't touch anything I shouldn't have. Why this would be happening.
View 11 Replies
My front driver side auto door lock isn't working. I thought it was the actuator but I already replaced that and there is no improvement. It unlocks just fine by pulling the handle, but the keypad and door switches don't work.
View 12 Replies
Is there a programming sequence that will keep my 2002 Camry from locking all doors when the vehicle is put in drive/reverse. I realize this is considered a safety feature but I prefer to lock them myself.
View 10 Replies
2001 ford explorer sport trac. Power door locks lock from both sides but will not unlock from either side, have tried new switches and lookd for broken wires in all four door jams.
View 10 Replies
I have a 2001 F150 2 door 2wd 5.4 engine. When I put it in gear the automatic door locks do not activate. The procedure for programming the remote does not work either. It calls for turning the ignition switch on and off 9 times, and the doors should unlock, so that procedure does not work either.
I took it to the dealer to have the BCM reprogrammed, they say there is no BCM in the vehicle. The codes they got says there is a door ajar, and the interior lamp relay DTC. I am not sure what the DTC means, forgot to ask.
The door warning light goes out when the doors are closed, and the interior light goes out. They do not seem to know how the system operates. I bought the wiring diagram.
From what I can see, closed lock switch connects directly to the GEM. The dealer told me there is two switches in the door. There is only one as far as I can determine. Ther are two plugs on the locking mechanism, on is for the remote lock, it works. So the lock closed switch is also working.
Reading this forum, I see several cases where people have changed the GEM, and that did not fix the problem. I can not see any other solution, as the door closed switch connects directly to the GEM, and the door open warning goes out, and the interior light goes out.
View 2 Replies
2006 F-350 diesel 4x4 ... Is there someway to disable the automatic door locks?
Truck is used on a construction site and every time someone moves it and then I need something out of it doors are locked. I hate having to try 3 doors every time until I remember to go to drivers door.
View 6 Replies
I have a 2004 Explorer 4.0L with 190,000 miles. My wife was driving it and the vehicle stopped moving. Sounds like the torque converter whining and will not drive in any gear or 4wd.
View 1 Replies
How to turn off the Automatic Door locks that engage once your Passat goes over 10mph? Its really anoying. Can it be done? 2000 GLS...
View 2 Replies
i have an 09 corolla s auto.i wanted to change it so it would not unlock when you put it into park. i read the manual Page 42. it says to
step 1: turn key to on position (engine off)
step 2: shift the lever to p or n(for stick). and press the the lock button for approximately 5 seconds and then let go to activate or deactivate the auto locking. or if you push and hold the unlock it activates or deactivates the auto unlocking.
well they don't say to wait for the seat belt chime, when you hear the chime push and hold the lock or unlock button depending on what you want and release just prior to the end of the chime. -- they don't say this in the book, but this is the only way to get it to work.
View 14 Replies
I am trying to reset the automatic door locks on my 2000 1500. i have followed the owners manual. it says to pull in the directional and turn the key from off to run twice. then release the directional. Doors should lock and unlock and horn should chirp.
1= my horn does not chirp.
2=the manual says I have the choice of doors locking at 8mph or when i put the car in drive, or no lock. All I can get is the 8mph or no lock. I cant get the lock when placed in drive option.
View 3 Replies
I have a 2011 Avalon. The power door locks will all lock with the door button and the remote key. The problem is that only the drivers door will unlock with either method, what a pain.
View 8 Replies
I just got a 4.6 4WD Explorer in for rough running. It had timing chain noise and some odd codes for primary coil H codes along with cylinder 8 misfire.
I replaced the coil to get rid of the "H" code and it was fine. Still misfires on 8, and I really don't care because it's coincidence that the timing could be affecting it or perhaps.... bent valves!
The vehicle starts and idles a bit rough. Can't go very fast, and of course I know I should run it as little as possible!
Here is the deal, how should I present this to the customer? Should I let him know that some valves could be bent after replacing the chain (and all associated parts) and that it could still be effed? Or will I be fine after replacing? Pretty much, where they had a tensioner failure/guide breakage and valves bent too?
View 14 Replies
2005 Grand Caravan with 160K miles. Automatic door locks started not working two years ago and needed to be reset by either disconnecting the battery or pulling the fuse. First this would happen every six months, then about every three months, then monthly, and now about every two weeks. Is there anyway to avoid having to reset the system every two weeks?
View 3 Replies
2000 Ford Explorer Limited - door locks not working. When they started to go bad, they would lock but not unlock. Then shortly after they were inoperative, including the lock in the back. I checked the fuse and it is OK. This may be something - when I pulled the fuse I tested on side and got battery voltage. The other terminal was showing just over 8 volts. With the fuse pulled, should it have any voltage at all??? Also, what should the voltage be at the switch in the drivers door?
View 2 Replies
I am getting ready to tackle a few projects on the new X. First I would like to fix the door locks. passenger side front, it makes a noise when i hit the lock/unlock button, but doesn't move. Hoping it is the actuator but wanted to make sure first. Is the actuator the first culprit to fix? I guess, How do i know it is the actuator? Wanna order them from rockauto soon. I've researched on here door actuators, looks pretty simple.
View 2 Replies
2000 superduty. When you hit the door lock/unlock button, they try but won't move up or down on any of the 4 doors. The switches no longer are illuminated either. Where or have a wiring schematic for the drivers door with power windows/locks? I have done some testing for power, which seems to me there isn't enough voltage going to the actuators, but I can't seem to find power anywhere. The power mirrors don't work either. All fuses are good.
View 8 Replies
I've noticed that if I press the EV button when stopped at a stop sign or red light, I can get the vehicle moving up to 25 MPH with the battery. This must save fuel. But I wonder if I am doing something that causes problems with the battery, motor, or other systems.
View 19 Replies
Can I disable the automatic door lock mechanism? Maybe pull a fuse? All of a sudden the locks start locking and unlocking over and over and the lights dim. I would like to disable the automatic and use the key to lock and unlock the doors. It is a 2002, F-250-Super Duty 4x4 SuperCab.
View 5 Replies
2000 f350 7.3 Door locks unlock and lock constantly. Wait to start light and 4x4 lights don't come on. Gauges stopped working and clicking behind dash.
View 1 Replies
I am trying to change the automatic door lock setting to unlock the doors when I open the drivers side door not when I shift into park. The manual is vague and I am not having any success at all.
View 2 Replies