Ford - Explorer :: 2007 XLT - Clunk Noise While Making Left Hand Turns At Slow Speed
Nov 6, 2016
My wife informed me about a noise coming from the chassis of her truck.
2007 Explorer XLT 4x4, 4.0 OHV, AT, 89,000 miles on the odometer.
We took the truck to dinner last night so I could investigate the problem. This occurs while only making left hand turns at slow speed.
There is a definite clunk sound AND feel. It actually sounds and feels like we are driving over a loose manhole cover, and IT DOES feel like metal to metal contact on the driverʻs sids of the truck.
View 2 Replies
Advertisement
I have been getting this weird bumpy feeling when making left hand turns and even sometimes when going strait on the road. It does not seem to effect the breaking for acceleration of the car. This does not happen all the time and will start and stop without any change in driving.
View 22 Replies
I have a 2002 Subaru legacy wagon, 185k miles, 5 speed manual, thumping noise when making sharp turns at slow speed, happens only after I drive over about 10 miles, does not happen after the car sits for any length of time.
View 5 Replies
I got a heat shield that just will not stop causing me grief. When I installed the headers and pipes I had a heat shield that was too close to the passenger side pipes. I bent it down some to clear the pipe and got rid of a nasty metallic sound I had on the throttle and making left hand turns. Well that little sound returned last week and I crawled under and looked and sure enough the heat shield was touching again.
Who knows why maybe a bit a spring sag. So yesterday I bent it down a little more. Today I start getting a nasty clunk on dips and especially when on a bump why turning. I crawl under there too look and find the same heat shield now has a huge gouge on the under side of it where the leaf spring near the rear bushing is smacking it. I'm sure Ford put it there for a good reason so hate to remove it.
First pic of the hacked up bend job I put on it.
Second pic of the gouge in the bottom of it where it's hitting.
View 8 Replies
I'm getting a clunk sound from my Passat's front left suspension when making turns. I've found info on how to diagnose control arms and I plan to jack the car up tomorrow and check it out. But how would I diagnose a tie rod end problem?
My Passat has 53,000 miles on it.
View 6 Replies
I have a 2007 Sonata Ltd (63000 miles) and had a clunk in the front suspension. I had the front upper control arms replaced (which were visually badly worn) and that fixed the problem. But now, a several months later another similar clunking noise has developed when I go over those small speed bumps in parking lots.
View 18 Replies
The other day I hit a good size bump at speed, slightly bent a wheel which I didn't even notice at first. The car drove straight and had no other symptoms, thought everything was okay. A couple days later I heard a weird grinding noise while making a left hand turn, it was so faint I honestly thought it was the fender liner. After the noises continued and further examination I noticed that the carrier is rubbing the rotor on the lower drivers side corner.
View 1 Replies
My truck has grinding noises when i am making turns from a stop or at slow speeds. Also my 4x4 dash light keeps flashing several times both when I am sitting still and when driving. Neither my 4x4 auto or 4x4 high work but the low will work. Trying to pinpoint where I should look to fix them. I did replace the 4x4 control mod as an attempt to fix this.
View 1 Replies
The car is a 2.8L w/ a manual tranny. The car was making a rhythmic clunking and clicking noise around right hand turns on the left wheel. So when the weight of the vehicle is applied to the left, that's when the noise occurs. The car has been in the shop for 6 days and the technicians have replaced both axle shafts (it was time to do so anyway) but the noise is still there!!! What could possibly be making that noise other than bad CV's? The rhythm of the noise coincides with the rotation of the wheel/shaft which is where they have focused. Could it possibly be bad strut mounts? This is driving me crazy!!! They tell me its perfectly safe to drive (how do they know this when thy don't know whats wrong?) but I can't imagine this can carry on much longer without something breaking.
View 2 Replies
What the heck could it be? It gets a little louder on left-hand curves of the road, but pretty much constant. Its not the tires, they are new as of a few months ago.
View 12 Replies
Lariat stepside, 5.4L with 150k miles. Loud popping noise, almost a clunk, when making a slow sharp turn. Put it on jackstands and did the normal tire grab and shake and found no issues there. Tie rods, ball joints and sway bar links all seem tight. Looked for signs of unusual rubber to metal and metal to metal wear and found nothing. The only thing I did see was the rubber boots on the upper control arm ball joints were split. What I have checked or if I am missing something?
View 9 Replies
I have a 2000 Excursion lifted 6 inches with 35" tires on 20" Fuel wheels and i notice when I make a left or right hand turn between 10-20 mph i get a single pop or clunk from the front end.
Also one more really annoying thing while i am turning there is creaking, sounds like body flex? maybe body mounts? Any issues with ball joints?
View 14 Replies
I have noticed on our 2009 F-150 there is an audible "click" (and you can feel it in the steering wheel) in left hand turns at about 1/4 revolution. You can also hear/feel the same thing coming out of right hand turns. It doesn't happen EVERY time, but pretty often. My wife had the service guy drive it when it was in for an oil change, and of course he didn't experience the same thing. What it might be or where to start?
View 8 Replies
Problem is noise that you can describe as clunk, not any harsh or sharp sound. It appears on road bumps or unevenness during slow speed up to about 40kph/25mph. The noise has not been heard over that speed even in bad bumpy roads.
List of thing I've done so far:
- Driven with empty rear compartments
- Driven with open rear door
- Checked the tightness of spare tyre
- Replaced rear stabilizer bar linkages
- Replaced rear stabilizer bar bushings
- Replaced rear axle carrier knuckle bushings
Could it be possible not coming from rear? Should I sit in the cargo space while somebody else driving, any success with this? What to do next?
View 10 Replies
06 sonata v6 standard 16in tires. I do all my maintenance, but i am stumped. A sound that is best described as a rattle crossed with a metal object (bolt/nut) rolling down a rail. Strange i know. Checked for rubbing, nothing. Made sure all bolts and nuts were correctly tight. Does it whether braking or not during any speed. May be dropped object, but neither I or a mechanic could repeat during Right hand turn. I have changed my front pads and dbl checked that is not the cause ( was doing it before change anyway) my fear is I'm missing something and am fearful of a mechanical failure.
View 9 Replies
I have a 2005 Saturn Ion stalls when I make left hand turns! The engine light comes on and the car goes into limp mode! I stop the car and wait a minute or two and it starts right back up and after driving it for a while the engine light goes out! I took it to a shop and they replaced the throttle body and ignition coil on two different occasions and my car still does the same thing!
View 2 Replies
Just like the tittle says. My 2011 ISF with 56k miles on it is making a Clunking noise when pulling out of a parking spot or just anytime I fully steer to the left side and begin to move. If I try it in reverse it doesn't matter if I turn the steering wheel fully to left or right it makes the same noise as I begin to move at slow speed. It almost feels like something is pushing the front wheels out. During normal driving I don't feel anything at all, just as steady as solid the car can be.
Is there any common issues with ISF with premature wear of ball joints, cv joint, sway bar bushings or hub bearing?
View 7 Replies
I own a 2002 Ford Explorer and I need diagnosing a problem. Whenever I start to pick up speed it starts to buckle and I always have the 4x4 on auto and it still buckles.
View 1 Replies
So I got my Haldex fluid and DSG fluid changed two weeks ago. When I picked the car up I noticed a vibration when I was making tight turns. Last week I called the dealer and told them. They said to drive it a bit more to see if it works it self out. But now after getting back from H2Oi, it still is doing it but not as bad.
Its a vibration you can feel and a rumble you can hear when making a tight turn at slow speed. Like turning into a parking space or turning at a stop sign. What would this be? I searched but couldn't find an exact answer.
View 1 Replies
My passenger side has been making thud noises on a number of occasions on my 01 Jetta 1.8t:
1. When I go over bumps, the front passenger side will make a loud thud noise.
2. When I take my foot off the brake, there will be a loud thud from the front passenger side as well.
3. When making left hand turns and I begin to turn the wheel back to return it to its original position, there is a thud coming from the front passenger side as well.
It does not continuously click like a bad CV joint would. All these symptoms came at the same time period.
View 3 Replies
My Neon has this strange problem and I can't figure it out neither can my mechanic. Mainly when I'm making a left hand turn there is a knock sound underneath the car, like I can almost feel something jerking up underneath my pedals. And then after making the left hand turn and then accelerating... my car would almost feel like it was stuck to the left and jerk itself straight again.
NOTE: I have replaced/checked the Lateral and Radius Bushings, Control Arm Bushings, Sway Bar and I also recently got new rims and tires which at that point I got an alignment. But nothing has worked so far and I'm at a loss.
View 4 Replies
