Ford - Explorer :: 2007 - Growling Noise From Front End
Aug 21, 2017
Front end has a growling noise. When pulling a load it is worse. When the front end has more weight the noise and vibration is less. When traveling dead straight now growl really but turn the wheel a fraction of an inch either left or and a growl vibration. Turns left or tight fully bring on the same hard growl. Steering pump is pumping fine. Either steering box or front wheel bearing is my guess. 2007 Explorer 4.6 ...
View 4 Replies
Advertisement
2010 v6 4wd. I have some growling in my front end. I got the truck in the air and neither wheel has any wobble (to check the front wheel hub assembly). I got under the truck and disconnected the large plug going into the T/C. Still noisy.
This truck used to be so quiet, but a couple years ago I had uneven tires that caused the 4wd to be on a ton. I just replaced all 4 a few weeks ago and that did not change the noise.
Is it possible that a bearing is still the culprit even without wobble? I can weave right and left and cannot notice it getting better or worse.
Also noticing my gas mileage dipping over the years, I am down to low 18s/high 17s with somewhat highway miles (2 miles of my commute around 35mph and the other 18ish going around 55 with 1 or 2 stops).
View 2 Replies
I have some pretty bad grinding/growling in the front of my 2005 Explorer XLT 4-door. It is ABSOLUTELY NOT a wheel bearing. The noise seems to be coming from the front left wheel, and you can feel it when turning the hub by hand. I've changed that hub twice now (took a chance that the first one was defective), but neither made any difference. Both were torqued to 184 FtLbs per spec.
I took the outboard end of the left front cv shaft out of the hub and turned it by hand, and something at the inboard end felt crunchy. So then I pulled the shaft out and checked it over, and both sets of splines and CV joints are good. Axle shaft bearing in the differential looks good too---rolls well and no visible damage to the rollers. I'm thinking that it's got to be something in the front differential like a carrier bearing. The odd thing is that when I drove it with my Chassis Ear tool hooked up underneath, the noise was picked up at the left front knuckle, with nothing really audible from three different points on the differential case. I'm stumped on this.
Is there any safe way to drive the vehicle with the front CV shafts pulled? I'd like to isolate the front diff to be sure it's the source of the noise.
The noise does quiet way down in right turns, but the FR hub bearing was pretty quiet with the Chassis Ear hooked up. The noise starts at 20mph and dissipates above 45mph. Not like what the bad bearings on my Escape did...those just kept getting louder.
Are these Explorers known for front diff weaknesses? How can I find out what gear ratio I have, in case I decide to replace the whole unit (a used one is half the price or less than the rebuild quote I was given by a local shop).
View 4 Replies
I have a 2005 Explorer XLT with the 4.0L V6 and AdvanceTrac.
I've had a worsening growl in the front end that sounds like it's coming from the front left wheel. I can feel it in the steering wheel, and the sound goes away when I turn the wheel right of center. Center (going straight) or leftward steering, and the noise comes right back.
I changed the wheel bearing today, and there is absolutely no change in symptoms. Turning the CV shaft back and forth by hand, something feels kind of "grindy." It is the same at any point along the shaft, which has me worried that the bad bearing is in the front differential.
View 6 Replies
Have an 06 2WD Explorer with 80,000mi and when driving down highway there is a bit of growling noise when any pressure is applied to the steering wheel. When driving straight not moving steering wheel its quite but when going around corner or curve tends to make noise. What I should be looking for? Brakes were replaced 10K miles ago. Ball joints or wheel bearings?
View 3 Replies
As I'm driving my ford focus I hear a growling noise from the right front. It goes away while turning left.I jacked it up and feel no play in the wheel. I'm thinking it is either the wheel bearing or the drive axle. How could I tell which one?
View 2 Replies
Last week I heard my front end start growling and figured it was a bearing. I bought bearings and when I tore the front end down the left (driver) side felt fine when I had the knuckle out. I changed it anyhow. The right side felt kinda OK and I changed it. I've got a press and made sure not to press on the wrong parts. When I took it for a drive the noise is actually worse now. It's got all the standard bearing symptoms. It get louder the faster I drive and changes when I swerve back and forth. I put the car back on the jack and noticed I could wiggle the wheel a bit. I pulled the wheel and the spindle was able to wiggle. I figured maybe the axle nut was a little loose and I was able to get about 1 more turn on it. That took out the wiggle but the noise is still there. Did I get 2 bad bearings or did I do something wrong?
View 13 Replies
I've recently experienced a rattling(vibration)/growling noise around the engine when the car is running with the AC on. The sound gets louder when I put the car in drive and it goes away when I turn the AC off. The sound seems to be coming from underneath or next to the engine(right of engine when sitting in the car/left of engine when standing over the hood facing the engine)
I took it to Lexus and they told me its likely the water pump. The car drives great and I'm not noticing any leaks(water or otherwise) underneath the car. I had to park the car for 6 weeks while on a military exercise, and don't recall hearing the noise before going away. could 6 weeks of inactivity on the engine have anything to do with this?
View 6 Replies
I have 2007 Camry LE with about 88K miles on it. I get the growling noise from the read right wheel, particularly when turning right. I can very clearly hear it inside. Interestingly, this happens only first couple of times after I pull it off from parking.
I recently had the brakes and rotors replaced but the noise did not start coming until a couple of weeks later. I suspected it must have something to do with tires so I got them rotated. But that didn't stop the noise.
Initially, when I first heard the noise about 2 months back, it was very seldom but now it's almost everyday. When I got the tires rotated, I was told that I needed the rear wheels aligned. (But if it's due to alignment issue, shouldn't be coming from both wheels?)
View 6 Replies
I have a 4 cyl. '99 Chevy Malibu with 137K. Two weeks ago she started making a growling/rubbing noise coming from the front of the car. If I steer even a little to the right the noise goes away. If the steering wheel is straight or turned to the left the noise persists. The noise is always present, except when turning to the right and at when I slow to stop there becomes a slight oscillation in the noise.What is it? Is it hard to repair? I typically change my own brakes, alternator, tie-rods, and simpler car repair tasks.
View 2 Replies
My 2011 Prius plus made a growling noise from the front right engine compartment area the other day. Yesterday as I drove it to work...it stopped growling and the A/C stopped blowing cool air. The volume of air from the vents is the same, just no A/C.
View 2 Replies
I just acquired a 2007 Ford explorer. I'm in the process of changing all the fluids and am wondering if there is room to pull the front differential cover off to clean the gunk out of the bottom of the front differential. It looks tight and I'm wondering if the differential or the steering rack and pinion need to be removed to remove the cover or if there is just enough room?
View 1 Replies
2003 F250SD 5.4 4x4... When I recently heard a growling coming from my front end. I read some great posts on here about the whole front end tear down. Replaced all my ball joints, universals, wheel bearing hub units, locking hubs.....
So yesterday i came home from work, about 30 minutes later i hit the key on the truck and it wouldn't start. Kinda sounded like it wanted to but was starving for fuel. SO i grabbed the fuel pressure gauge and did a quick check......and No fuel pressure at all. Checked the fuse, Couldn't find a Relay in the fuse panel (Is there one for the fuel pump??). Anyway 4 hrs later the trucks starts right up like nothing is wrong.
Go figure, I'm 2 days away from my last payment ...now everything has to be going wrong.... Do these fuel pumps act up like that ??
View 6 Replies
I have a 03 explorer with approx 160k, I am experiencing a thumping noise while driving. It gets worse on right turns and gets better on left turns. initially i thought LF wheel bearing so i ordered a hub assy and replaced LF. noise is still there. I guess, thumping noise caused by wheel bearings, i know its usually a grinding kind of whirring noise.
The noise doesn't seem to change with accel/decel so I don't think it is driveline related (diff, drive shaft etc.) should i bite the bullet and replace the rf as well??? I should also mention that there is also a shake in the steering wheel that seems to coincide with the thumping (i.e., my hand shakes along with the thumping, and the shake gets worse when the noise does)...
View 8 Replies
I have a 2005 Explorer XLT Sport 4x4 w/ 118k miles. I am having front end noise when I go over speed bumps, driveway aprons, etc.
I already replaced the Struts/Coils, and ball joints, the sway bar end links are newer. The noise is almost like a noise an old spring mattress would make.
What could the issue be?
View 2 Replies
I have a 2004 explorer that has a clicking/rattling noise in the front of the engine. What i found is that the bottom pulley has a sleeve or ring inside of that pulley that is just floating loosely back and forth. What this is or what it is supposed to be ??? If it is a bad part, what is the best way to fix it ?
View 12 Replies
On my 96' Explorer 4wd, 4L V6, auto tranny the front end makes a roaring noise when slowing down from 30mph to stop; no shimmy or shake or any other noise, it has 133K miles on it, original wheel bearings; just wondering if it is wheel bearing assembly and are these pressed on or can you remove them and replace with new assembly fairly easily. Are there any threads with the procedure here.......
View 11 Replies
I have a 96 explorer 4x4 that i just bought and it has wheel shake. It also has a slight noise coming from pass front. So i jack it up and there is zero wheel play. I spin the wheel and it spins kinda freely until about 3/4 away around then it has some resistance to stop the wheel. Im thinking that could maybe a rotor a lil warped but not sure. Same wheel there are wires showing on the inside. Now i try the driver side and i cannot spin that wheel it has resistance all the time. So could this be hub or maybe just bad tire?
View 12 Replies
I'm working on a 02 explorer. The front end is howling so I replaced the left side and no change. The howl goes away when braking. Is it the right side then or something else? I replaced both front brakes pads so it's not that.
View 2 Replies
I have 98 ford explorer sport 4x4 does has a clicking noise coming from the front driveshaft that connects the transfer case to the front differential. At first we thought it was the front drivers side cv joint which we replaced. nothing changed. there is still a noise apparently coming from the front driveshaft. we can not tell if it is the front differential or the transfer case itself. The noise is being transfer through the front driveshaft. It sounds a bearing is going bad.
View 1 Replies
I first heard it start about two or three weeks ago. It started when I would brake too hard. So I took a look at the brakes and the caliper pin was rusty so I loosened it up and it was fine for a day or too. Then all of a sudden it started in the front like something was grinding. Someone told me it was the transfer case. so i put in 4 wheel drive and it goes but then you really hear the grinding. How can I tell if its the transfer case or the front end where the drive shafts go into.
View 1 Replies
