A few days ago my wife's 07' explorer 4.0L, 4wd, 72k miles, had the abs light, traction control light, and a wrench light all come on. By the the time I got to look at it, they were off. Now 3 days later, they have all come back on. To me it seems like a electrical issue or maybe a sensor or something but I wanted to get your thoughts on where to start looking.
View 7 Replies2007 Explorer Limited . The traction control light will start flashing and the engine will lose all power, it slows to 30-40 mph, then goes again and the light goes out. This is intermittent and seems to happen the most when the engine is cold. This morning it wouldn't go over 20 mph and finally warmed up and went well enough to get it home. There is no check engine light or codes saved. This is my wife's driver, and it completely stopped one day and threw a check engine light. She turned it off and restarted and the light went away and the car would go again. I've read Ford had bad throttle bodies, (TPS)...
View 3 RepliesNew problem this evening went to start Santa fe and ABS and Traction Control lights are on tried to shut ignition off and restart and both remain on. Drove the vehicle and noticed no brake control problems, tried to push the traction control switch and no on off control of light remains on. I believe in a situation such as this a good computer diagnose at the dealer is in order.
View 9 RepliesI need to troubleshoot a problem with the ABS & Traction control lights on a 2006 Mountaineer Premium with 126,000 miles. During the year that I have owned the vehicle this problem has occurred every time it is driven on a long trip. The previous owner never drove on longer trips so has no experience with this problem.
When you drive the vehicle around town and on shorter trips (less than an hour) there are no indications of problems. The ABS and Traction control lights come on as part of the start-up check cycle and go off. The ABS and Traction control work in low traction conditions and the lights function correctly when either one is activated.
The unusual behavior occurs on trips longer than an hour. Typically after about 1 1/2 hours at highway speed both the ABS and Traction control lights come on as well as the Wrench symbol in the message panel. It you hit "Reset" the Wrench symbol goes away but the ABS and Traction control lights stay on. The brakes work normally. I do not know if the ABS and Traction Control will work. I have never been in a low traction condition when the lights are on.
Both lights stay on until you stop the vehicle and turn off the ignition. When you restart the vehicle the ABS light is on but not the Traction Control light. When you start to drive the vehicle the ABS light goes out immediately.
After about 1/2 hour of driving both lights come on and the Wrench symbol displays in the message panel. Whenever you stop the vehicle and restart during the trip the cycle repeats. The day after you finish the long trip everything is normal for driving around town and on short trips.
My '07 passat has recently been giving the same error sequence, I am driving and start to accelerate when a ding sounds and the traction control light on the right display lights up, as well as the EPC (or ECP) on the right display along with the ! on the MDF display which blocks the use of the cruise control.
Shortly after (30 sec.) I lose the turbo, and then the engine light comes on on the left display. The turbo resets after turning the car off, and the rest to the error lights reset in ~24 hrs.
It happens when I am driving on dry clean roads, so I have not been losing traction. Took it to the dealer and they said the battery was bad, replaced it under warranty and all seemed well, but 5 days later the problem re-occurred, everything reset, and then re-occurred again 2 days later.
Evertime I turn left the brake light, traction control and stability control lights come on and the car starts dinging. Mechanic says it could be front wheel bearings because they are tied to the ABS system??? But I have been seeing alot about wheel speed sensors?
Second, everytime I brake suddenly, a cloud of smoke comes from the front end and there is a burning oil smell. The oil is fine and no leaks. Again mechanic says it could be a cracked CV boot throwing grease?
Lastly everytime I put in reverse or when I lightly put pressure on the brakes when driving I get this noise like a humming (errrrrrr) noise. Its not the grinding/squealing noise you would get when brake pads needs replaced. I only have 60k miles on this.
My college son's 2014 Charger V6 has developed three issues since he purchased it used in late May. The cruise control has stopped working and the anti lock brake and traction control lights are constantly on. Any possible cause?
View 15 RepliesI have a 2005 explorer, eddie bauer (120k), which i really love driving. Recently, i have lights coming on in my dash: ABS, traction control and the 4wd light intermittently flashing. I went to Advance auto parts and they were able to read the codes, a B1155 - speed wheel sensor LF input circuit failure and a B1145 - speed wheel sensor RF input circuit failure. I have replaced both wheel bearing hubs (with the speed sensors) about 6 monthe ago. the connectors leading to the speed sensors are both showing 12v at the plug. Is the problem both my sensors have gone bad? Is there any way to test these sensors. I need to get this fixed quickly since i am due for an emission test very soon and it will not pass if any dash lights are on.
View 6 RepliesSo a little while ago I had my parking brake, ABS, and traction control lights all come on at the same time. There was no change in performance, but they have been on ever since. I looked in to it online and a bunch of people said this was a common problem with damaged tone rings, so I checked them out, but they were fine (as far as I could tell anyway). So I scanned the vehicle using a buddy of mine's Snap On scanner, and it came up with the following code:
B1342 Faulty Control Module
We tried to check the fault code through Mitchell OnDemand but it said that this code was for a faulty Parking Assist Module. I don't have any kind of Parking Assist system on this vehicle however. I looked around a little more and this seems to be a pretty generic code for brake system faults with Fords. Also, if the control module for the ABS is the same one that handles traction control?
Just put new wheels, tires on my car...19's with tires 235/35/19, soon as i put them on and took it out to see any issues, the driver side rear wheel/tire making some horrible squeaking noise that just kept getting worse as i just drove the car around the block..ABS light and traction control both came on and stayed on as well (doesn't sound good, expensive) my H20 is ruined it seems.
View 1 RepliesRecently I started to have my EPC and Traction Control Lights come on once in a while (no CEL). And when that happens, it looks like my Passat is going into limp mode, because it drives, but it hardly has any power.
VagCom confirmed that the problem was coming from Throttle Body (I don't remember the exact code), I replaced the throttle body, did Throttle Body Adaptation, but I still have the same problem.
Here is the most recent VagCom screenshot:
Address 01: Engine Labels: 03H-906-032-BLV.lbl
Control Module Part Number: 03H 906 032 C HW: Hardware No
Component and/or Version: P 3.6-FSI-LEV2 G00 8030
Software Coding: 0000075
Work Shop Code: WSC 00028 028 00001
1 Fault Found:
000290 - Throttle Position Sensor (G69): Signal too Low
[Code] .....
From what I've read it seems this combo of lights usually stops the awd from working. However the lights came on and as a test I did a few hard 1-3 pulls listening for wheel spin... Nothing, all traction and pull.
What may be causing these lights? Hopefully I can get my vag com to work so I can scan it. Planning on checking the fuses and connections on the battery too.
I put in a new air filter today, 2003 GTI vr6 24v, and three lights (Check Engine Light, Electronic Control Power, and ABS) all turned on and haven't turned off yet, I'm not sure if I plugged in the sensor wrong or if there is something else that needs to be done. None of the lights were on before.
View 4 RepliesMy 2012 F250 6.7 once again (third time in 2k miles) got stuck in park with no brake lights or traction control. I found that removing the shroud from the steering wheel allowed me to manually activate the solenoid and get into gear but could only drive in manual shift mode.
Something is causing the brake switch fuse to blow. When I replace the fuse all is well for maybe 1k miles then it happens again! After the second time I replaced the brake switch thinking it was the cause but no deal. It happened a third time. The dealer who fixed it the first time could not find the cause.
This is frustrating and downright dangerous! What in the circuit could be causing the short?
Anti lock brake light and traction control light come on when starting car. 2000 Regal GSE - The anti-lock brake light and traction control light come on when starting car. This happens intermittently. The next time I start the car it doesn't come on. Then it will come on at a later time when starting the car. The car has 97000 miles.
View 7 Replies2010 Prius 98,000 miles - No Accidents
I was driving on the freeway cruising about 65-70mph.. Not using the brake at all. All the sudden the car starts beeping loudly with the Brake light going off, traction control light going off, and the ((!)) light as well. So I wanted to pull over to the side and realized my brakes were not working . It was the same as if you're trying to brake the car when the car is turned off. I slowly pulled off the freeway. Tried to reset the ECU, battery, everything, thinking at the traction control is just going crazy.
Within a few miles my ABS and traction control lights go on...when I shut it down they go back off, but, within 5 miles or so, they're back on again..how do I diagnose on which wheel the offending sensor is causing this?
View 6 RepliesMy car sat for 2 days this week and was completely dead when I got back. I had the alternator and battery tested and they were both fine. I put everything back and ran a vag-com and it still shows running voltage at 9.7 volts. ABS and traction control lights are on intermittently. It seems to be having trouble starting which leads me to believe it's a bad starter but I don't know how that would drain my battery. The car also has a sunroof drain leak which got water on the monsoon amp. I've tried with and without the amp connected. No difference.
View 24 RepliesSo yesterday at night i take the isf for a boot, everything is going great and then i rip it off the lights, as soon as i do the traction starts acting weird and so do the rpms for a few seconds, rights after that the light show started. Check vsc, abs off, traction control off, afs off. all came on at once. i didn't turn anything off.
View 6 RepliesI was installing a neutral saftey tow light under the dash of my 06 sport trac. I touched one of the two wire to ground and wrench light came on. I checked fuse #18 and it was good. WHAT Did I do?...How do I fix it?
View 10 RepliesMy traction control lights is on and stays on during driving. Any reason for this?
View 9 Replies