Ford - Explorer :: 2004 - Trans Slips In Between Second And Third Gear
Feb 18, 2014
My wifes 04 explorer 4.0 4x4 slips in between second and third gear and you cannot manually shift the gearshift below 3rd gear. I assumed tranny was going out but was told that it could be the transmission control solenoid or the transmission control switch (i think they are the same thing). I read that the most common symptom of this going bad is a slip between second and third gear. Haven't checked codes but will when i get home to see what it comes up with. This is the messed up model where you have to add fluid underneath through the drain plug. Was going to change fluid and add lucas to it to see if it remedies the problem.
View 1 Replies
Advertisement
Ok, my clutch has been giving me trouble for a little bit and I'm almost positive that I have a bent release fork. It also slips under heavy acceleration in 6th gear. I am planning on doing a clutch, compete with flywheel and release fork and a new rear main seal. My problem is, here within the last couple of days the trans would pop out of 4th gear if I was just coasting. It has been getting noisy over the last few weeks also. I'm no manual tyranny expert, but this is making me think I'm gonna need to have it rebuilt.
View 14 Replies
If I press the gas a little hard in drive, my tires squeal but if I'm in reverse I can feel a slipping in the trans. If I try to back a trailer up an inclined driveway, it won't go, the trans slips. I have no crud in the pan. I've replaced the reverse boost valve. I installed a Trans-Go kit which is suppose to eliminate the reverse slip but it hasn't worked. Everything else works just fine and my fluid is red. I have engine braking in 2nd and 1st. The van backs up fine, it just does this in reverse under load.
View 2 Replies
I got a 2000 ford explorer with 151k on it... Since iv had the truck (5yrs) its always had a slight slip around 3rd going to 4th. The tran is auto!!
I use to be able to jump in and take off but here lately i have to let the truck idl for a few sec or up to a min before i can take off (warm or cold). This just started a month ago...
The trans fluid smells burned and it has be 2yrs since iv changed fluid and filter in the tran...Everything other then that iv kept up to par. What do you think should i start looking for something new or just change filter and fluid????
I know the truck has had a good life so I am starting to think the tran maybe trying to go.... My friend has a 85 dodge ram charger suv not sure the miles but its auto as well....It has a 318. Other then a small dent the thing look good... It has some kinda vacuum leak major but doesn't effect running. He told me the leak is from something he had removed when we left CA that they said he had to have for smog?
View 3 Replies
2003 Ford Exploreer 4x4 5R55W Auto Tranny. From driving the car it does not shift into 2nd or 5th gear. The O/D light flashes, and the check engine light comes on. Gives Code P0775, which indicates a problem with Solenoid 2.
This weekend I changed the Shift Solenoid Pack with a brand new one from Ford, and the exact same problems still exist. It's as if I hadn't done anything to the car. I have read somewhere that 2nd and 5th gears share a band in the tranny, could the the problem.?
View 14 Replies
It's a 2002 explorer, 4.0, 5R55W trans, all was fine then O/D light starts flashing, so I limp it home. Trans isn't slipping, every gear works, it does kinda bang into 4th but is otherwise normal. Took it to auto zone to have the code read, but no codes found. Disconnected battery to see if it just needed a reset maybe, let it sit for a few hours, reconnect, OD light still flashes. Borrow a different OBD2 tester, still shows no codes, still drives the same just bangs into 4th. I've read up on the solenoid pack replacement, just kind hesitant as I feel like I'm guessing at the problem and might be throwing money away.
View 2 Replies
2006 f150 4x4 4R75E trans slipping in forward gears, reverse is ok. I dropped pan and it was clean. I dropped valve body and found OD servo shaft clip broken, the large snapring was I fine and in place. It allowed the inner shaft to float up and down. Would this cause my forward gears to slip or do I have a bigger problem?
View 14 Replies
2001 VR6 owner. I'm looking at a Jetta currently that I suspect has a trans problem. Current Owner was bounced around shops being told it was a timing chain issue causing it to rev around 50-55 mph. Now I know that is definitely not it.
View 3 Replies
Truck has 222000 miles on it. With gentle acceleration not noticeable, with maybe half throttle rpms increase for say one second or two and then shifts smoothly into third, However at full throttle with the shift coming at 55 mph or so, it shifts perfectly with no slip. It also acts the same manually. I had asked my mechanic about changing the fluid and if it could fix the problem, he said, "well it could work or hurt it." After thinking about it, we decided to change the fluid. He did a full flush and cleaned out the pan which had lots of sludge in it but no pieces of metal in it that would seem to indicate a major internal problem. It doesn't seem to have made it much worse if at all, but did not fix it.
View 1 Replies
I just picked up a 2000 v6 passat with an automatic trans. I am new to passats, esp with autos. The cars transmission is having problems shifting with the trans gets hot (25-30 min run time) and slips. What is the trans code for this car and is it FWD or AWD? It has 220k, and the engine runs great. It was sorta an impulse buy, I plan on flipping it so hopefully tis a good investment. Any common things I should be aware of so I can get it tip top shape to sell it?
View 3 Replies
I have a 2002 Elantra GLS with the 4 speed auto and in the mornings or after sitting in lot at work for 9 hours, the trans shifts hard from second to third (almost as if it has a shift kit) and slips a little from third to fourth. The TPS was changed once and that seemed to eliminate problems at the 26K mark. I have 109K on it now and at around 80k took it in to the dealer with the receipt for the same complaint and what was done the first time. Dealer kept overnight and said there were no problems. I do know from having a performance TH350 built that the harder a trans shifts (up to a point) the longer it will last due to less friction on clutches and bands.
View 6 Replies
'96 Explorer 4.0l V6 4X4... 214,000 miles. So, I'm having some transmission slippage and was wondering what can be done about it. You see the mileage and the only thing done to the trans was a drain and filter/fluid replacement at 120,000 miles.
Here's what's going on... When cold, in the morning, I put it in drive, trans engages, I move maybe 20 feet and it disengages. I wait up to 20-30 seconds and it engages and slips right back out. I wait, engages, move 50 feet and it disengages. You get the picture. After doing this 4-5 times it will engage and I can drive a 100 miles with no problem. Seems like it need to build up pressure or warm up before it will drive normally. I've checked the fluid and it is at the correct level. I guess my question is, would I be wasting time and money to replace the filter and fluid again or is it just warn out?
I've read when a trans starts slipping after it's warmed up means it needs a rebuild and mine is the opposite.
View 4 Replies
Here's my transmission problem. 2007 f150 crew lariat 4x4 with a 5.4
When my driving conditions force me to cruise at the 28-30 MPH range my transmission often hunts for an upshift, like a slipping gear hunt then it hits in firm. It must be from 2nd to 3rd gear I'm thinking. It doesn't occur at all if i am accelerating through this gear or past this shift point. under normal acceleration through and past this speed or shift point it is as smooth as can be.
I often drive some flat but winding dirt roads out in a forest area near my deer camp and it seems this is where I settle into a speed of 28-30 mph for several miles at a time. This is where it happens, the transmission seems to begin to shift but seems to slip or hunt for that next gear then it hits in fairly firmly.
Truck has 83k on it....
View 4 Replies
Early 70's Ford Truck w/Dana 20 Xfer case
The problem is that when I put the truck in 4W Low, it will sometimes slip out of gear into 4W Neutral. It happens more often when climbing hills than driving on level ground. It hasn't ever slipped out of 4W High. It is drivable the way it is, but it's annoying. If there were an easy fix I'd do it. If I have to remove the xfer case, that seems like a big job, so probably not. What do you think?
The manual suggests these four as possible reasons
Shifting poppet spring weak.
Bearing broken or worn.
Shifting fork bent.
Improper control rod adjustment.
Which is the most likely problem? What is the "poppet" for and where is it located? Can anything be done to diagnose or fix this problem w/out removing the xfer case from the vehicle? What about the control rod? Can it be adjusted with the xfer case installed? If so, where is that adjusted?
View 7 Replies
I recently purchased a 04 f250 with the 6.0l powerstroke. I drove it for about 3 weeks now, Ive put my trailer behind it with small loads and just today tried to use the tow/haul button. When you go to pull out the tranny never shifts from first gear?? Its pulls and runs fine until you push the buttan and no shifting........
View 6 Replies
It has a floor shifter for the xfer case with 2wd, 4wd-H,and 4wd-L, and Neutral positions. It works fine in the 2wd and the 4wd-H positions. The problem is it sometimes slips out of 4wd-L position into 4wd-Neutral, which I have just lived with, but it is annoying. I think I heard this is a known problem with these 1970's Ford xfer cases, and the fix involves removing the xfer case and replacing a part.
View 10 Replies
I have a 1987 ford ranger 4x4 2.9l v6 but my transmission slips out of gear and its auto im not sure why but ive been told im missing a over drive gear is this a possibility or what???
View 1 Replies
I have a 2008 F-150. When moving gear selector from park to either reverse or drive, trans has a delay engaging. After engagement, it runs fine, shifts ok, downshifts ok....
View 7 Replies
My 1997 F250 Heavy duty shifts very hard and sometimes feel like it slips out of gear (i press the gas pedal to the floor and speedometer rises very slow and truck doesn't move like it should.
View 14 Replies
I have an '04 Camry with auto trans that has developed a whine in 1st gear, not noticeable in the higher gears. Is this normal and nothing to be concerned about or is corrective action needed. I have searched other threads but none with this particular issue. I have 50,000 miles and the trans has not been serviced other than checking for normal fluid level and color/smell.
View 14 Replies
I have a 2004 Explorer 4.0 4x4 with 130,000 miles. The vehicle will not move while in 2 WD or in 4H. No engagement at all. However it will engage in 4L (reverse and drive). It also makes no sound from transfer case when I try to shift from auto 4x4 to 4H. 4L engages and is a bitch to get out of 4L once it's engaged. Changed tranny fluid and filter with no change. Really need this truck fixed, and by me if at all possible.
View 3 Replies
