My 2004 ford explorer 4.0 has this issue where the check gauges will come on for 2-3 sec, then the temp gauge will go from normal and peg to hot and as soon as it pegs it drops right back down to normal. I have had the thermostat replaced and have flushed the radiator. I am at a loss here....
View 3 RepliesWhile driving at any speed my temp gauge and oil pressure gauge spike well above "H" and stay there. The red battery light sometimes flickers too. The Battery gauge is low. I replaced the terminal to then negative battery cable because It was loose. I have also replaces the alternator. I had the battery checked and it was good, it just at 45% charge. That's why I replaced the alternator. After I did that, It seemed to have fixed the issue. But after 3 days, it has come back again. Now this morning on the way to work, driving down the freeway, my speedometer jumped to 85 MPH and there was a squealing like noise coming from the engine. I am not sure if the two are related issues.
View 10 RepliesDriving my 2003 today seen the "check gages" light on and the trans temp gage pegged on hot. CRAP, tranny time! look at the edge evo and it reads trans temp as -60F ???. Plugged in the torque pro and it reads 8,240F. At that point I figure its PROBABLY not that hot. Let it sit for a while and back to normal. Watch trans temp on torque pro as I drive it and everything is fine till it gets to about 150, then it jumps to 60F, then 30F, the 8240F. The cooler lines and trans pan are both feel normal. Picked up a new temp sender on my way home.
View 5 RepliesSo, last December, I was sitting at a stop light, when my engine suddenly started rattling. "Check Gauges" light on, ZERO oil Pressure..
Took car to mechanic, he removed the valve covers, and scoped out the timing chains with a camera, and found everything intack, and no chips out of the timing guides (125K miles on the engine). no sludge, nothing.
Engine runs fine (for 5 seconds at a time) no issues. Removed Intake to check the Oil Pump Drive Gear, all is well.
Removed Oil Pan Inspection Plate, All is well. ZERO plastic chips in the oil pan from timing guides, ZERO sludge, all is clean.
Back up to top of engine, pull the Oil Pump Drive Shaft using needle nose pliers from the top of the engine. BUT!!!
Only the top 8 inches of the Oil Pump Drive Shaft comes out! The bottom gear is not present! Is it still in the oil pump?
OK, so I need a new oil pump drive shaft. no Problem.. BUT: how do I get the broken oil shaft out of the engine before I put a new one in? Use a magnet? Rubber hose?
Dad's 2000 F150 5.4 ltr will start intermittently, when it does fire it runs fine, but right after start up all the dash gauges "spike" to the max levels for a sec and then go back down to normal....
Put the Cen-Tec 98614 code reader on and it continues to say "Link error" and I can't communicate to the interface. P.S., I confirmed the Code reader is good by pulling a 420 O2 sensor code from my Toyota in just a few seconds....
I can hear the fuel pump kick in so I doubt that is the culprit. Because of the gauge spike at start up (every time) this problem screams grounding problem, but I don't know where to start. Could it be a faulty relay?
I've been searching for a while now but have not found an exact match to my problem.
So, Yesterday I was pulling a large load home (15K lbs) over flat land/small rolling hills and I experienced a coolant temp spike. And I am trying to figure out what caused it. I was traveling 65 mph about 2k rpm and 20lbs of boost, I was motioning the ECT, EOT, TFT, and Fan Speed via my scanguage and 99% of the time the ECT was in the 209-220 range, once it got up to 220 the fan would come on and the ECT would drop to 209 ish pretty quickly.
However, twice the ECT shot up from 215 ish to 240 within seconds then the dash indicator said check coolant temp then the fan came on and cooled it down to 200 within seconds, I did lose about 1/2 gal of coolant. So today I'm going to get a new degas cap (still OEM original) and continue to monitor the situation.
My EOT ECT delta has been a constant 10-13 degrees for the 3 years i've been monitoring it so i believe my oil cooler is still functions within spec and all my cold soak temps are within a degree or two for various ambient temps (20 -80) so all my sensors should be good.
Also, tonight I'm going to pull the EGR valve and check if there is any coolant in the intake, but if there is not, where should I start looking and what should I start worrying about e.g. head gaskets?
I just installed my Edge Evolution from my 2006 F-150 5.4 into my 2008 F-150 5.4. It is not displaying oil temperature. It just shows 0 degrees. why?
View 1 RepliesA warm startup on my 2007 Explorer causes an RPM spike and subsequent stall (half of the time) on the way back down. I've tried a fuel additive, Ford ran codes with no problems...
View 6 RepliesThis morning, the tow/haul light came on, tranny temp gauge wouldn't read (stayed below zero), "check gauges" warning came up on the panel, and "check engine" light came on. Truck ran fine/shifted fine, always has.
2007 F-250, V-10, 5-r 110 tranny.
i have a 1988 2.4L 185,000+ miles chevy s10 pu. the check gauges light has been coming on for some time. the gauge bounces up and down a lot. but settles to 20psi at driving speeds. there is no tapping or noises from the engine and has good power and oil. what should i have check
View 4 RepliesI have a 2000 Cherokee Sport and the Check Gauges Light has come on, it usually happens after during my commute and I have been on the freeway for about 10 minutes, I exit and at the first stoplight it comes on. Doesn't come on in normal around town driving, just in that situation each day. I took it in to my mechanic and twice and it still comes on, they said they replaced the oil pump. Anyway, could it be that the gauge light has to be reset? I don't see any leak after two days on the street now. I am at my wits end, before I take it to different mechanic, I'd like to see what the boards say.
View 3 RepliesSo my band mates and I own a 2002 Dodge Ram Wagon (15 passenger) with ~130k miles on it. Bought it 2 years ago with 106k. We've had a slew of problems with it ranging fro brakes to radiator to electrical problems. We are often on the road for 4-6 hours straight (sometimes more) and we typically drive it above the speed limit on the freeway because we need to be somewhere. So lately while driving the check gauges light will come on suddenly and the alternator/battery gauge is maxed out, which lasts a few minutes and then returns to normal. Im wondering if this is something indicative of a potential alternator issue or merely just the van working hard and having some sort of power fluctuation momentarily. There's typically no issue in starting the engine or anything like that, and we actually had the alternator belt blow out about 6 months ago and we replaced the battery probably a year or so ago, so the whole system should be pretty new and in good shape.
View 3 Replies2000 Dakota, 4.7 V8 ... The 'CHECK GAUGES' light comes on intermittently. As soon as it comes on, the voltmeter gauge drops to zero (it is a brand new battery); the temperature gauge does flip flops; the truck dies right now. Walk home and come back later, and it starts up again. When you get home, you sure don't feel secure in taking it on the road again. The shop checked it and of course there was nothing wrong when they had it Where do I start the troubleshoot? Is it computer or?
View 1 RepliesThe check gauges light on my 1988 Cheyenne 4x4 is coming on and the oil pressure gauge is erratic back and forth from low to high pressure.
The vehicle is a 4.3L manual. Any likely cause or where to start with troubleshooting?
2003 ford explorer 4.6L. This truck will start and run rough high temp low oil light come on and temp gauge is pegged hot. Oil gauge is fine though, checked oil its fine.
I checked coolant reservoir its ok.
If I shut truck off and restart it will run ok and rev like normal and then all of a sudden go into limp mode and will misfire etc...
What sensor seems to be the main culprit?cht sensor???
Just purchased this truck and noticed the gas and temp guages neither work. Where do I start/ How about fuse box?
View 5 RepliesI've been having some issues shifting and been paying more attention to the gauges. On the first start of the morning since its gotten colder, the trans temp gauge gets warm quite quick just idling and the water temp goes no where for quite a while driving or idling.
The truck essentially doesn't shift normally until the water temp is up, over revs, and shifts are much more abrupt and at higher rpm's (like shift pressure is higher if there is such a thing).
My uneducated thinking I think the sensors are reversed, I would expect the water temp to go up while idling and not the trans temp.
I had a loose bulb in my overhead interior light I tightened the bulb and now the gauges quit working the sunroof, rear window, air compressor, windows, radio and airbag warning flashes?? I checked the appropriate fuses in the panel fuses and the 30 amp breaker all good??
View 1 RepliesI have a 2003 Excursion 6.0. I didn't post this in the 6.0 section because it may not be just a 6.0 issue. (See what I get) On cold starts, anything under 150 degree water temp reading on the SGII. I get a CHECK GAGE light on accompanied by the check engine light. No codes read on the SGII pending or stored. Just some of the time I get a water in fuel light too. This tends to go out fairly soon after driving. (Even after I just drain the fuel pump it still happens.) other issues that accompany the lights are as follows.
The trans temp does not give a reading to the dash. The oil temp does not give a reading the dash. Both show proper temp on the SGII. When in reverse the back up alarm beeps as if something is behind me. And the auto door locks will not activate after 10 mph. The tach also will not show a reading in the dash. SGII shows the numbers. Now the kicker, this ALL gets resolved the instant the water temp hits 150 degrees. The only lingering issue is the that the tach will surge or drop every now and then. The tow/haul light does not come on when this is going on. I've checked the battery terminals all are clean. Both batteries are brand new.
Just over 6000 miles....Yesterday morning the light came on. Dealer wouldn't look at it for a week. Went to my mechanic this morning to check the code it was p0181 fuel temp sensor. I read something online about the block heater making it too warm. The other night it was cold so I plugged it in, then yesterday morning it got warm overnight like into the lower 40s. I noticed the grill felt warm too. My mechanic cleared it if it comes back on do I have an issue? Is it ok to drive?
View 14 Repliesi have a continuous Check Engine light in my 2008 ford explorer. Dealer recommend replacing a sensor but I do not know which sensor to change.
View 4 Replies