I have been puzzled to why my truck isn't running right. We were driving down the highway one day and*then all of the sudden it starts running really rough. I changed MAF sensor, plugs and plug wires, oil change, fuel filter and air filter. Still doing the same thing. What this could be? 2003 ford sport trac..
View 11 RepliesI have a 2001 F150 4.6L auto. This truck suddenly started running rough. Cleared all codes and re-scanned after starting truck. The codes are as follows; P0135, P0155, P0443, P0740, P0743, P0758, P1451, P1460, P1747, and P1760.
My question is; is it normal to have this many DTCs come up at once? Could my PCM be faulty causing this problem? Can you swap a pcm from the same year truck with the same options without reprogramming?
2003 ford explorer 4.6L. This truck will start and run rough high temp low oil light come on and temp gauge is pegged hot. Oil gauge is fine though, checked oil its fine.
I checked coolant reservoir its ok.
If I shut truck off and restart it will run ok and rev like normal and then all of a sudden go into limp mode and will misfire etc...
What sensor seems to be the main culprit?cht sensor???
I have a 93 Ford Explorer, manual transmission. About a month ago it intermittently started running very rough. I does this wether the weather is rainy or not. The engine has done this when it just started up, cold, and when it's been fully warmed up. I have been able to drive it, but it has been quite a challenge. When running, there is a very noticeable noxious exhaust smell. The check engine light has come on some of the time. When the eec codes were checked it only revealed 522, the car wasn't in park or neutral when running the test.
I have tried clearing and rerunning this test several times, yet 522 still shows up. No other fault codes. Don't know how this would cause engine to perform so bad. The fuel tank has been near full when it happened so I believe the gas to be good/ no water. The engine has a lot of mileage on it, over 200K, so I'm not sure if something inside could be malfunctioning, but don't know how to check. The car will run for days very smoothly before this happens again. I have changed plugs, wires and the pcv valve and it still occurs. It's like the engine is hitting on one cylinder when it happens.
Our Accent has just about 86k on it now, back in November it suddenly started running real jerky/rough, misfiring kinda thing. So I was able to drive it to my local repair shop and they found a bad coil pack on #3, so they replaced that and put in new plugs while they were doing it.
Just Saturday we were shopping about 20 miles from home and cranked it up to go home and started doing it again, pretty much identical symptoms, runs out normal at certain RPMs so I knew it was probably same thing...I was able to get it home and then took it in this morning and sure enough now #1 is shot. So they are replacing that. They want about 30$ more per coil then I can order them for myself online so I didn't want to scarf up the money for the other 2 that are still original.
I have 2007 explorer with the 4.6 V8....
Recently it started running horrible. Rough idle, drives badly, hesitation, etc. Check engine light is on, code P0171. I cannot find a vacuum leak, and i am pretty much at a loss. Before it started running poorly i replaced the thermostat, and flushed the coolant. I am assuming this is a coincidence.
126000kms on 03 explorer 4.6 truck started. Running rough at idle and under load.... Code came up for cyl 8 injector. Replaced injector... problem still there. Switched cop and plug with another cyl and plug.... same code and cycl 8 is definitely not working. Would a generic problem always affect i cylinder. I even checked wire clip on for injector... it appears ok. There is power to injector wire clip.
View 5 RepliesOk on the way the my 1997 f150 4.6 L 180,000 check engine light started flashing and running rough and then the light went off, Also we took the Aftermarket Dynomax muffler off of it earlier today if that makes any difference, it still has the Cat Converter, New Plugs and Napa Wires.....
View 12 RepliesI have a 7.3 that's running rough. Started it the other day it ran alright but started blowing white smoke. Bought a oil and fuel additive i was going to run through it. Came a few days later, it stated up and was real loud and sounding like it was loping. It blew a good amount of white smoke, but it just smelt like real heavy diesel. Now i can only turn it over and it won't start.
View 2 RepliesI have a 2001 F350, 7.3. My service engine light came on and immediately the truck started to run rough and lose some power. I've checked the under the cover connections and they were both connected, I replaced the cam position sensor and I still have the same problem. The worse part of the hold thing is that there are no codes stored so I'm flying bind. Where to go next.
View 8 RepliesMy 2002 Ford Explorer 4L V6 is running rough I found out why I just don't know what the piece is called because I need a replacement. Mine fell off and fell down the engine and melted quite a bit. Also the part number on my piece doesn't work anywhere, that I have typed it in. Mine has a Ford part number of 1L2U-9F764-AC. Also need to know the proper Ford number. I have a picture I found online with an arrow pointing to the piece I need.
View 1 RepliesJust replaced my rear gas tank. Drove for a week with no big issues. Started running a little rough just thought it was debri in the fuel line. While it was sitting for a few days fuel was coming out of the carburator. It drained 15 gallons of fuel from the tank. There was pressure building in the tank when I took off the gas cap. Dropped fuel tank and everything seems to be hooked up ok. Put it back now added gas now the truck wont start even using starting fluid.
View 4 RepliesI have a 2001 mk4 golf 1.8T, tonight I was driving and all of the sudden the gear changes started clunking really rough ( it's an automatic) and then it would pulse for power only give it to me at random not when I gave it gas, coming to the next stop sign I pushed the accelerator to go and for the first 3 seconds nothing happened until it jumped in revs spinning tires and shooting me forward, so I shut off all the electronics in my car which seemed to work with the not getting power issue but when I finally got to where I was going it now won't turn over, you turn the key you hear the starter try but that's it it just won't turn over, there's no check engine light and I already have a call into my mechanic.
View 7 RepliesMy explorer has been running a little rough, particularly at idle. When I take off from a rough idle, it'll run rough until I hit 25-30mph. I ran by O'Reilly's hoping to pick up a pack of spark plugs and be done with it, ended up leaving with a new MAF sensor. It ran better for about 10 miles (I'm a delivery driver, so I did a lot of stop and go immediately), before it ran even worse than it did before, but at least my CEL finally came on. Took it back to O'Reilly's and they read a MAF sensor code and a catalytic system code (didn't ask for the codes, and now realize that was a mistake).
So today I took it to a muffler shop to have the catalytic system diagnosed. They looked at it for 10 minutes and told me they didn't think it was the converter. They said it seemed more like the EGR valve or solenoid, or the IAC. He scanned the codes again and got multiple "running lean" codes (0171, 0174, etc). The guy said I didn't have a vacuum leak, so I think I can rule that out. Unfortunately, the truck idled fine the whole time so he didn't feel comfortable giving me a definitive answer. He told to to leave the EGR valve hose unplugged for a few days and see if anything changes. I'm thinking about running a bottle of fuel cleaner through it or taking off the IAC and/or EGR and cleaning them myself.
On my V8 02 XLT Explorer the engine is running rough like it's missing.
I think a coil may have gone bad,,found a LOT of anti-freeze down in the spark plug hole.
Have replaced the intake but now need to fix the roughness.
Is there any easy way to check each coil? Or should I be checing something else?
I have a Ford F150 XLT. I have 67000 miles on it and the other night it just started running rough out of no where near idle. Once you got over 20mph the rough running would go away. I took it to get an engine change and engine flushed but it came back. It doesnt always run rough near idle or below 20mph. The Ford dealer says my engine has only 22 psi oil pressure near hot idle and cant engage the VCT phazers and they want to replace the whole engine.
View 1 RepliesI have a 2000 Dakota 5.9 truck that has all of a sudden started to idle rough, loses power over 3000rpm or any kind of reasonable acceleration , with a big sucking sound from the throttle body ( no leaks), seems like it is not getting fuel. Someone mentioned it maybe the "MAP" sensor.
View 2 RepliesI have a 2000 ford explorer. 4x4 v6. One day i started it up and it was running rough. It had real sluggish power. Then the check engine light came on. I hooked it up to the code machine. The only readout was number 3 misfired. I replaced the plug and all was fine. A few months it happend again. I replaced it again and it was fine. Well it just happened again. I replaced it again. It ran good to work but on the way back no good. Light came on again. Hooked up the machine it read number 4 misfired and number 2 bank lean. So I replaced number 4. It still runs like shit rough idle and no power. Give it gas it dogs out but then it'll kick in if i get on it. Thinking it maybe a vaccum leak or intake leak or o-rings.
View 4 RepliesI have a 98 ford explorer just changed the alternator and now its running rough also it sounds louder than normal from the muffler. I am clueless, what the problem can be?
View 7 RepliesI have a 98 sport 4.0 i bought awhile back and its been running rough.. When driving it seems to cut out.. I had it scanned and it has code PO453 which is pressure sensor.. I was told they replaced the fuel pump when i got it.. After driving and i get out i can smell gas on the drivers side.. I replaced the gas cap but no change.. I was just wondering about this code and what i should start with first..
View 3 RepliesMy wife's car suddenly started running rough. 2005 Taurus, 6 cyl, 3L, OHV, 83K miles. CEL came on and code came back as "P305 - cylinder 5 misfire detected". As a side comment, her tachometer has been fluctuating big of late as well.
View 2 Replies