Ford - Explorer :: 2003 - Grinding Or Humming Sound Coming From Left Driver Side Front
May 7, 2016
Alright so I'm having a problem with my 2003 Ford Explorer. I've recently noticed that when I get to above 40 mph, if my steering wheel is straight, I hear a loud kind of grinding or humming sound coming from my left driver side front. If I am going about 65 mph, it gets even louder and if I crank the steering wheel to the left, that's when it really gets noisy but as soon as I crank it to the right, the problems gone. When I do hear the hummin sound, I can feel it in the steering wheel. I have replaced al of the tires and it didn't work. Also, the car slightly pulls me to the right.
View 10 Replies
Advertisement
I have a 2003 F150 manual 4WD with 4.6L engine and 165000 miles. When i am driving i feel a vibration in the steering wheel and on floor board that intensifies when i press the accelerator. I do hear an irregular humming that sounds like it is coming from the driver side front. I checked the wheel for any play but it was very tight. i check tie rod ends, ball joints no play. i recently changed both u-joints on the rear shaft and the bearing hub on the passenger side front. Also, the steering feels a little 'wobbly' when i make sharp turns. it almost feels like it is giving. What else should i check?
View 1 Replies
I just recently bought a 2000 Explorer, 4.0 OHV, 4x4 with about 150,000 miles.
I've had the vehicle for about a month, and ever since I bought it, it's had a grinding sound (sounded like wheel bearing) coming from the front right side. I replaced both right and left bearing/hub assemblies, and took it out for a drive. The initial sound that I thought was bearing noise is still there, and at about 65mph I started to get a little bit of steering wheel shake. I took my foot off the gas and it stopped. I accelerated up to about 70mph and it seemed ok.
I hit a VERY small bump in the road and the steering wheel started shaking like hell. So bad that I almost lost control. I slammed the brakes and the shake stopped instantly. I took it home and put it up in the air, half expecting to see something loose or broken, and everything looks perfect. I re-torqued everything that I had taken apart for the initial hub/bearing replacement, and took it out again. Same issues.
I never had ANY of these problems before I replaced the hub/bearing assemblies, so I'm completely confused. I was thinking CV joints, but I have no clicking at all when turning, in forward or reverse, everything is smooth. Outer tie rods were done about 6 weeks ago..
View 1 Replies
I noticed while driving my car there was a unusual rumble or grinding sound coming from my drivers side front wheel well. I get out and look I see a bunch of Fluid all over my wheel well. I look around turn my wheel around and see this fluids all on my rotors and suspension. Ive noticed couple weeks back the boots on the struts were ripped in two pieces from deteriorating or dry rotting (this was on both sides) and ive also been hearing some odd squeaking sound for over 15k miles every once in a while going over big bumps or train tracks. Struts go out at only 80k miles on their corolla? Yeah struts do usually lose their life around 60-80k miles but I've never seen them leak around that many miles. Is this a common issue?
View 5 Replies
I have a 2002 Ford Explorer Sport and after a brake job I noticed that while under braking at slow speed there would be a grinding sound on the front left. I replaced the brakes and wheel bearings the first time. After a while I ended up replacing the caliper itself but it still grinds. I don't notice any wheel shaking, pulling and it hasn't locked up although once I did notice a some smoke under hard braking but only once. I also don't hear any grinding while not braking.
View 5 Replies
I have an 03 Exp 4x4 Limited with 4.6L V8 with 167K on the clock. I'm getting a kind of humming rotating sound out of the front end when moving. The frequency definitely goes with the wheel rotation speed and the noise is the same with the trans engaged and when coasting in neutral. The noise is present at all speeds but becomes more of a humming sound as the speed increases at highway speed.
I've had both front wheel bearing hubs replaced (they were completely shot), brake pads and rotors replaced, and just had new tires. The rotating sound is still there though. What else is there that could be the cause? Is there another set of bearings somewhere in the front end?
View 11 Replies
2008 2wd 4.6L 98K miles F150 for the past few weeks has been humming with a rhythmic vibration which feels like it is coming from driver's side front wheel. It doesn't do it constantly, nor at all speeds. Once I hit about 25mph, you can start to hear a humming. At 35, slight vibration. Between 50-60, heavier vibration. Sometimes at 65+, it subsides quite a bit. Both front rotor assemblies are newer, and I put in a brand new left because I thought it was a bad bearing.
View 5 Replies
Tonight on my way home I noticed a slight creaking sound, coming from front driver side, opening the window it was more noticeable. So when I got home I have tried to locate the source, it is the same with or without the engine running & you can hear it by rocking the steering just a little left to right. It sounds like a dry bush, I had my good lady rocking the wheel while I climbed underneath but couldn't pinpoint it, so I climbed up on the fender with my weight on the radiator support & the battery cover, when she turned the wheel the sound was almost gone but as soon as I jumped off it was back! I then tried rocking the truck from the driver side fender & the sound is there but not quite so pronounced, Any other way before I spray everything with WD40 (don't know if you have that over there but it usually quietens things like this!) There is no play on anything anywhere & the truck has only around 32k miles.
View 4 Replies
I've got a 2006 f150 4x4 v8 ... I get a grinding noise (I think it is coming from the front left of the truck) that lasts only a little while and only comes out after a cold night (so I only get the noise in the morning after the truck has sat overnight)...
The issue details:
1. The grinding noise is constant and the truck has to be moving for it to make the noise
2. The truck will only make the noise while driving forward, it disappears when I drive in reverse
3. The truck has to sit overnight and it has to be cold (below freezing)
4. I only get the noise if I go in reverse BEFORE I drive forward after the truck sat all night
5. Will not make the noise while in 4x46. It has been doing this for about 2 months
What I tried:
1. Replaced both front wheel hubs
2. Replaced 4x4 vacuum and checked the lines for pressure
3. Front brake pads and checked calipers
4. While the truck was making the noise unplugged the 4x4 vacuum - still made the noise
View 4 Replies
I have a 1996 Ford Explorer (4WD model). Approximately 4 months ago I had a new set of tires put on it, and in the process of replacing the tires the shop noticed that I had a bad ball joint and one of my wheel bearings was going bad. They said the ball joints were known for completely failing, but the wheel bearings usually didn't, so they recommended that the ball joint be replaced first. That is what I had them do. I haven't had the money to get the wheel bearing replaced yet. This past week it got worse to the point where I can hear it now.
At low speeds I can hear a grinding/rattling-type noise from the front drivers side (that's the side that has the bad wheel bearing). At higher speeds the grinding/rattling-type noise fades away due to road noise, but I can still hear a humming-type of noise that is a bit loader than normal - this noise just started a couple of weeks ago so I'm suspecting that this might also be related to the bad bearing.
I won't have the money to get this fixed for another 2 weeks. In order for me to have the money in 2 weeks I will need to continue working at my job 2 days a week. It's approximately 2 hours round-trip from my home to my job. Obviously with the bearing sounding significantly worse I don't want to drive it any more than I have to, but the only way I can get the money to fix it is to keep driving it back and forth to work.
Here's my question. What risks am I running by continuing to drive this? Am I running the risk of the wheel falling off while I'm driving down the freeway at 70 mph? Am I likely to experience other damaged parts in that area of the vehicle?
View 14 Replies
About 3 months ago I started having a grinding sound from the front driver side hub area. I replaced it and it fixed the problem. I read where you should do both because he other one is soon behind it but I waited. Now I started hearing it from the passenger side too. So I replaced it today and all was good until I tested it from 4 wheel back to 2 wheel. Once I went back to 2 wheel the clicking that sounds like bearings going out to me, was back. What is it?
View 1 Replies
The sound is coming from the front passenger side. The noise gets louder the faster I go, put in neutal and noise still there press brake noise there turn wheel no change in pitch. Jacked it up and there's no play in wheel. Just changed both front wheel bearings 6 months ago.
Just changes all brakes today and got all new tires today. I'm thinking maybe the differential bearing but not sure and if so how to change it. I travel from Mississippi to Baton Rouge, LA everyday for work, about 240 miles round trip. What would happen if a bearing went out while driving 70 mph on interstate.
View 3 Replies
2011 F150 Limited 4wd 6.2 liter. I just bought the truck a few weeks ago with 26,000 miles. Late last week I began hearing a mild grind/rustling noise that appears to come from the driver's front. It's not terribly loud (loud enough to hear), but it's annoying. It happens when I slow down (on and off the brake and below 25-30 mph) as well as let off and begin to speed up. It doesn't last but a second after I let off the brake and speed up though. The kicker is it does not happen all of the time. I drove it home from work last night and it did not do it one time, but driving to work this morning it happened every time I did what I described above. I have taken it to our local tire/suspension shop and they claim they could not reproduce the sound which does not surprise me. They did a full inspection and found nothing.
View 14 Replies
I have a 1999 VW and i have this grinding, wobbling noise coming from the left front wheel side. I brought it to the dealer and two other mechanics and they can not find why there is that noise.
View 1 Replies
I applied brakes while car was moving slowly, less than 10 mph, and heard loud grinding sound coming from left front as car stopped. Shifted to reverse and car barely moved, less than 1 foot, which was accompanied by the loud grinding sound, then stopped. I could find nothing interfering with the wheels but did find pieces of brake pad on the ground along the path the left front wheel had followed. The left front wheel appeared as if the calipers were holding whatever remained of the brake pad and/or backing tight against the rotor. brake pad fell apart on 2002 at 43,561 miles...
View 19 Replies
I have a 2004 F150, 5.4L V8. A few years back I was in an accident when someone slammed into the front of my truck. The right front wheel & tire took the brunt of the accident. I thought the repair shop had everything back to normal until recently I occasionally have a grinding sound coming from the right front side, seems to be related to the axle. It doesn't do it all the time just at random while I'm driving. The only solution I can find is to pull over or slow my speed to a crawl. Once I slow down enough or turn my wheel one way or the other its like something SLAMS back into place. I had it looked at by a local mechanic and they couldn't find anything wrong. Could it be something in my right front axle?
View 7 Replies
Driving home yesterday I noticed a grinding sound from the driver side rear of the truck. Had a look at the drum brake today and found that the cable to the adjusting lever had snapped and pieces had jammed making the grinding noise. I need to replace the cable and probably have that drum surfaced, but the pads look good.
On the passenger side the hardware is all intact but the shoes look as if they have "spider" cracks everywhere, still lots of shoe left though. What might be causing the cracks on the shoes, and do these need to be replaced? How to do rear drum brakes? (1997 4x4)
View 1 Replies
I have a 2003 Impala. Over the past couple of months I have had an occurance every so often, very random with my front driver side brake. In both rain and dry conditions, braking hard and just slowing to break I will hear what sounds like grinding when I brake, like you do when the pads are gone. Well, I have had the car in and the pads and rotor are fine, the place I took it to even test drove it and tried but couldn't get the sound. I posted here a while back on this issue and the view was that it might be the ABS, but when this occurs the ABS light doesn't come on and the sound is just coming from the driver side front. What my next move should be?
View 7 Replies
A year ago I heard occasional metal grinding noise coming from the front, sounding like front driver side. Sounded like CV joints that I heard before. The mechanic said it's transfer case/transmission problem, so I replaced the transmission but the noise came back a few days later. The mechanic said to drive it for a while and the noise may go away, if getting worse he can fix it since it has 2-year warranty.
Now a year later the noise becomes predicable and easily reproducible, I went back and asked them to check. They said it may be passenger side axle. I am feeling being manipulated.
View 1 Replies
We've noticed an audible knocking that sounds to be coming from the front drivers side. It only happens at speed (over 30) and doesn't seem to be engine related. I can feel it under my resting foot while driving. I know this is vague but I think it may be enough to get started on figuring this out.
View 14 Replies
I've been hearing a rhythmic, metallic ringy grinding noise coming from the driver side front end of the car that seems to be in time with wheel rotation. It happens between 5 and 40mph, worsens while the steering wheel is turned even the slightest to the right, goes away completely during left turns, reduces and becomes intermittent above 45mph, and between 0 and 5mph, as I turn the wheel to the right from any position, I hear squeaking. I recently had the front control arm, ball joints and struts replaced. It has 140k miles. What could it be?
View 4 Replies
