Ford - Explorer :: 2002 XLT - Rear Vents Do Not Blow Out Enough Air In The Back Or Third Row Seat
May 20, 2014
My defrost & front vents work fine. My back vents that are in the back of the console switch from hot to cold like it suppose to, but they do not blow out enough to feel it in the back seat or third row seat.
Also when I use the heat the front flat part of the console by the drink holders especially gets red hot to the point it can melt plastic ink pen or anything else you lay there. which concerns me since I have a 9 yr old.
View 3 Replies
Advertisement
My a/c stopped blowing from the front seats but the back seats still blow. My gut is saying that the blower motor has went out, because all my fuses that I've checked aren't blown. It's too hot for the blower to go out.
View 4 Replies
To kick off the coldest week (so far) of the winter season, I noticed a problem with the heater controls in my 06 Explorer with manual temp. controls. No matter which fan settings I select (defrost, panel+floor, etc), air does not blow through some of the vents. I can hear the fan working and air flows through the defrost vents and through the floor vents, but the there is no airflow through the vents below radio and round vents on the far left and far right sides of the dashboard.
Perhaps related to this problem, a couple months ago I replaced the blower motor resistor because fan speeds 1 and 2 did not work, only 3 and 4 worked, so whenever I would turn on the heat or A/C, it was on full blast all the time. After replacing the resistor, the issue was resolved and all of the speeds worked well. I guess I just never realized the issue with the vents, or maybe the problem happened because I replaced the resistor?
Since I'm not too knowledgeable with the climate control circuit, I'm not too sure where to begin, perhaps the switch or blower motor?
View 3 Replies
Cannot figure out how to get the heated air to flow through the back via the rear vents. All I get is outside air. I cannot find anything about it in the manual. The dealer has no clue but is trying to find something on it. New 2009 Santa Fe Limited.
View 11 Replies
So a recent problem on my 2012 sf.. the front vents blow hot and the rear blows cold.?
View 13 Replies
My daughter has a 94 explorer xlt 4 dr. The window motor regulators are going out. I replaced one of the front ones and decided I'd just make the parts needed next time. All that was really wrong with the front was the little plastic slugs were crushed. They are easy enough to make.
Tonight I tried to remove one of the rear motors, so I could open it up and get the measurements I needed. I found 2 screws that secure the motor, but that's not all that holds it. It seems to be mounted with a spot welded stud as well. There is a small dimple in the door panel in the approximate area.
Before I start drilling things that might not need drilled, I thought maybe I better check here first. How is this supposed to be removed ? The Haynes manual for it tells nothing as to the removal and replacement of any of the window motors. Is the reg inside the gear head anything like the front door motors ?
View 4 Replies
I am upgrading an F150 w/ pass-through console to an F250 w/ jump seats. Have not gone to see the truck in person and am wondering where the rear air vents are located?
Reason being I have two very large dogs that own the back seat. It's basically a large dog bed. The console vents are fantastic, keeps them cool back there. I can't figure out where the vents are in a jump-seat configuration.
View 2 Replies
I have a friend with a problem. He has a 2007 Explorer Limited that when he hits a bump the drivers side power seat moves all the way back.
View 1 Replies
When using the power lumbar adjustment in the seat back of my wifes 08 eddie bauer explorer, it stopped moving and I now hear a snapping / popping noise from the seat back. Is there any way to remove leather seat cover to check out what might have come loose or broke?
View 5 Replies
I sat in the back of my recently purchased 2011 Prius Three, not III, for the first time yesterday. I learned from this forum that the vent in the rear seat is to keep the hybrid battery cooled. However, while sitting the back during a ride, I noticed it was blowing air out instead of sucking air. I would think the vent should be sucking air from the cabin to keep it cool, but that does not seem to be the case here. After a 30 minute drive, I even felt the air coming out of it was warm and the A/C began to feel that it was not enough for my area in the back of the car.
View 16 Replies
Well I was recharging my a/c yesterday because the system was low so I used one of them 24oz cans and now I am getting cold air out of my passenger side and luke warm air out of my driver side vents. Also if I switch to the different vents I don't get anything out of the floor only. I get air out when I select it, but it's coming out of the defrost. Other than that everything else works just fine, just no floor. I've read issues with the blend doors but my vehicle doesn't have the dual climate controls so I'm at a loss...
View 4 Replies
There are no A/C vents for the rear seat passengers. I would be downsizing from a 2005 Sienna and my kids have become accustomed to the rear seat comfort, especially the air conditioning vents directly over their heads.
I would like to know, especially from those of you that live in hot and dry climates, how well the front vents are able to cool the rear seat without freezing the occupants of the front seats.
View 19 Replies
So rolling down I29 and its cold and the wind is howling. Rear tire goes out sidewall blow. Thinking load rating of C is not enough for the EX?
Anyways not a big deal cause I'm smart! I checked my spare and all the stuff I need to change it cause i'm prepared. Go to put the tire iron on that I removed from under the hood perfect fit too. Guess what, it is way to small for the lugs. Luckily I had earned some karma points the day before working for a guy with a 02 F250 7.3 who's alternator died. A guy in a suburban stopped and his wrench was close enough to crack the nuts.
So after searching and not finding much my two questions are. Any replacement for the factory tire iron that bolts under the hood? Is there another vehicle other then an Ex I can take it from? I like the idea of it being there bolted down under the hood.
What load rating is everyone running and or recommends. I noticed my spare was an F lol which is far from C. My EX is 7.3 and She was loaded heavy with black friday goods.
View 6 Replies
I was driving home today and randomly thought to open the vents in the b pillars and noticed that neither rear vents were flowing any air. I opened and close them and I tried every mode on the AC, and even tried turning the rear vents from the arm rest to the back seat off. Any clue as to what the deal is?? I just cant imagine what the issue is. I have never used the vents in three years of ownership but would like to think that I have the option.
View 3 Replies
is there a fan in there...I was driving home no music and in the quietness of my Pri...I hear this sound....
View 12 Replies
My uncle has an 05 F150 extended cab. When he bought it he put his license plate in the rear window until he could get some bolts for it. When it was there it fell between the back of the rear seat and the back of the cab. Currently he has one plate on the rear, but is worried he will get stopped for not having a front plate installed. So he knew I am an FTE member and I could find out how to remove the seat back. I have not tried to remove it nor seen if I could reach it.
View 4 Replies
Trying to install some nice seat covers in my '11 supercab and can't seem to figure out how to remove the rear seat back. What is the combination?
View 2 Replies
I've got a 2014 f250 xl super cab and can't for the life of me figure out how to remove the back seat back.
View 2 Replies
How difficult it is to remove the rear seat on a 5th gen 2002 Camry XLE? There's a set of leather seats at a local yard and I'm thinking of buying it.
My follow up question is what the h ell do I do with my old seats? Is there even demand on Craigslist for that stuff? They're power and in good condition.
View 3 Replies
2010 Explorer XLT. The left rear power window lowers, but does not raise back up with the driver's master control switch (the 4 switch control on the driver's door). It does, however, lower and raise fine with the single switch on it's own rear door. Thinking it was a bad master switch module on the driver's door, I replaced it and the same thing still happens - works fine with it's own single switch but will only lower and not raise with the driver's door switch. All the other windows work fine. This has me totally stumped.
View 11 Replies
I have a 2002 Chevy Impala with power driver's seat. The seat has three motors which move the seat forward/back, front of the seat up/down, rear of the seat up/down.
The seat will no longer go up/down in the rear of the seat. More importantly, it will no longer go forward or back. The left side jack screw spins and wants to move the seat forward or back but eventually stops when it can no longer go any further because the right side jack screw will not turn at all.
All of the motors are working properly and turning the flexible drive shafts. The drive shafts do not appear to be stripped at the ends. After removing the drive shaft covers and reinstalling the drive shaft, I can see that they are turning when the motors are activated.
I then removed the drive shafts and inserted a square bit into the end where the drive shaft gets inserted into the gearing attached to the jack screw. The bit just spins and spins and doesn’t turn the jack screw.
I cannot removed the seat because it is in a position where the rear bolts are covered by the seat. I have tried to remove the four bolts under the seat that attach the seat to the frame. I am unable to break these bolts free (they appear to be welded or loc-tited down).
View 5 Replies