Ford - Explorer :: 2002 XLT - 4x4 High Light Flashing
Jul 8, 2014
I replaced my wheel bearings and wheels roughly 6 months ago, right after I noticed my wheels gittered when turning at low speeds. I assumed this was a power steering issue or the new tires. I have now learned from this forum that it is most likely stuck in 4x4 HIGH but has no indications on the dash. Just yesterday though the actual 4x4 High light started flashing in different variations. I get 6 flashes one time, then 8 flashes 2 minutes later on the dash and so on back and forth. When I stop I can put the truck in 4x4 high and the light stays on, same with 4x4 low. Then when I go back to 4x4 auto they go off but I still feel gittering while turning at low speeds. What would cause this? I see a lot of people replacing the Xfer case control module but no one seems to have the same problem.
2002 4.0L XLT 135k
View 3 Replies
Advertisement
So I just bout an 03 explorer with 85k miles on it last month. the 4wd high light keeps flashing 10 times. i read the thread below and found this...
Diagnostic Flash Code Information
NOTE: The following flash codes 1 through 16 are
On-Board Diagnostic
(OBD) codes generated by the control module. If a system fault is detected, the control module will "flash out" the corresponding fault code on the electronic four-wheel drive Malfunction Indicator Lamp (MIL) on the instrument panel. Also, notice that all the codes that can be generated pertain only to the speed sensors, the clutch coil and clutch with the exception of the first flash code.
The electronic four-wheel drive system also includes the brake switch input, Park/Neutral Position (PNP) switch input, one power and two ground lines, along with the E-4WD MIL. The following pinpoint tests include testing on every electronic four-wheel drive circuit and not just those covered by the flash codes.
DIAGNOSTIC FLASH CODE CHART
Flash CodeDescriptionAction to Take
Inoperative or Erratic System Errors.Complete Tests AA through DD.
1Microprocessor RAM (Random Access Memory) access error.Replace Control Module.
2Clutch connector or clutch coil has discontinuity.GO to Step FF1.
3Front output speed sensor connector or internal circuitry of sensor has discontinuity.Go to Step EE1.
4Rear output speed sensor connector or internal circuitry of sensor has discontinuity.Go to Step EE1.
5Both front and rear speed sensor connectors and/or internal circuitry of sensors have discontinuity.Go to Step EE1.
6Clutch and front sensor connectors and/or clutch coil and/or internal circuitry of sensor have discontinuity.First see Step FF1, then Step EE1.
7Clutch and rear sensor connectors and/or clutch coil and/or internal circuitry of sensor have discontinuity.First see Step FF1, then Step EE1.
8Clutch and both sensor connectors and/or clutch coil and/or internal circuitry of sensors have discontinuity.First see Step FF1, then Step EE1.
9Mechanical problem that allows clutch plates to slip during clutch engagement (or faulty sensor output signal).First see Step FF1, then Step EE1.
10Both Code 9 and Code 2.See action for Code 9.
11Both Code 9 and Code 3.See action for Code 9.
12Both Code 9 and Code 4.See action for Code 9.
13Both Code 9 and Code 5.See action for Code 9.
14Both Code 9 and Code 6.See action for Code 9.
15Both Code 9 and Code 7.See action for Code 9.
16Both Code 9 and Code 8.See action for Code 9.
Regeneration (Recovery) of Flash Codes
If the ignition is turned OFF and the code is lost, the ignition will have to be turned ON again to regenerate codes 1 through 8, if the condition or conditions still exist. To regenerate codes 9 through 16, the vehicle must be driven again.
How accurate is this information? also where can i find a replacement clutch connector? New to fords so I am not sure where to get parts.
View 6 Replies
04 Explorer XLT, 4dr. 4wd, 4.0 engine - after replacing front rotors and pads the "4X4 High" indicator light flashes then pauses then flashes again. Did I brake something, what is the cause and how do I fix it. ABS light stays on all the time.
View 1 Replies
I have a 02 explorer XLT with the 4.6L and the oil pressure gauge has never worked (the three years I have owned it) I did an oil change yestarday and replaced the sending unit thinking that was the problem but the gauge is still not working. What other problem it may have? 4x4 light flashing (instrument panel looks like a xmas tree)...
View 10 Replies
Wife's truck- 2002 v8 limited explorer with 116k... Yesterday she calls and says the od light is flashing and the message center says check transmission. She drove it home then when I got home the light was off and all seemed ok. I am taking it to have the codes read and hoping that my mechanics scanner picks up a code.
View 2 Replies
It's a 2002 explorer, 4.0, 5R55W trans, all was fine then O/D light starts flashing, so I limp it home. Trans isn't slipping, every gear works, it does kinda bang into 4th but is otherwise normal. Took it to auto zone to have the code read, but no codes found. Disconnected battery to see if it just needed a reset maybe, let it sit for a few hours, reconnect, OD light still flashes. Borrow a different OBD2 tester, still shows no codes, still drives the same just bangs into 4th. I've read up on the solenoid pack replacement, just kind hesitant as I feel like I'm guessing at the problem and might be throwing money away.
View 2 Replies
How to reset the Anti Theft on my explorer? The light is flashing fast and the engine won't start. Without the anti theft being reset the truck won't start. Been checking around to find an answer but can't find one...
View 7 Replies
Just recently purchased a 2004 Eddie Bauer Explorer w/ 110k. Took a Snap On scanner with me to look at it. ABS light was on and I also get a 4x4 high flashing light every 2-3 minutes. Blinks 8 times then goes away. Scanner showed the RF speed sensor isn't sending any mph signal back. Just reads 0. Will my problem be a new sensor or is the sensor getting a dirty signal trying to read dirty teeth on the hub? Also, will fixing this stop out with the blinking 4x4 light?
View 1 Replies
Any reason why the OD light flashes, and how to fix it with out spending an arm and a leg?
Light flashing on a 99 ford Explorer.
View 3 Replies
Recently my check engine light came on. I understand this isnt such a big deal, but then my engine started "skipping", and my overdrive light is now flashing. my car will stall if i come to a complete stop without putting it into park or nuetral. I dont know what to do.
View 7 Replies
1996 Explorer xlt 4.0l ... I ran into this issue a few years ago on a drive up through the mountains. Had the tranny replaced shortly after.
Rebuilt the engine once due to leaking head gasket.
Rebuilt it again 2 months ago due to leaking rear main seal.
Had a new torque converter installed during last engine rebuild, so tranny has been shifting and driving like a dream.
Just drover about 30 miles on highway, all pretty flat. OD light started flashing. I didn't notice ANY change in the way it was driving, sounding, shifting... anything! I know this is some sort of oddball error with this transmission in this vehicle, but i need to know if it requires further investigation.
Also, sometimes upon starting up (i am a pizza deliver, so i often shut it off and start it again 1 minute later) the OD and (i think) the 4x4 light flash at the same time, and my windows wont work for around 15 seconds. I've also noticed that my ABS will sometimes kick in randomly on dry ground during slow stops.
I am not in the mood to just start dropping cash on random sensors or modules or repairs if i can find any solid evidence of an issue (i've been battling an EGR issue for 4 years). I was thinking maybe the vehicle speed sensor?
View 1 Replies
The OD OFF light starts flashing by itself and I can't get it to go out. Everytime it does this, the car is sluggish, won't pull very good at stop signs and kicks hard when down shifts. Thought it was weather related but it doesn't matter what the temp. is. Eventually it will go out by itself and everything is fine.
View 4 Replies
Was driving into town today in my 96 Ford Explorer XLT v6 4wd, when I noticed my O/D off light flashing. I thought to myself, "Another problem I have to bash at with a wrench to get going again." I figured that meant I'd be stuck with gear 1 and would burn some extra gas on the ride home, but after parking and running an errand, woe behold me but my car won't start! The starter turns, but no other noises come out of my now very-large paperweight. I've tried shifting into neutral, moving the car to get the gearbox turning, starting the car in neutral and park, yet the stubborn car remains dead. Am I drawing a connection between the light and the failure to start where one need not exist?
View 4 Replies
Was told that I need to replace the torque convertor as it is slipping, has 144,000 on it. 2001 Sporttrac ...
View 8 Replies
I have a 99 explorer and the OD off light just began flashing. Is this something serious, that will need attention?
View 1 Replies
My 1996 X with the 4.0 has developed a flare from 2-3, and the O/D light flashes. It still drives well, but it's bothersome, to say the least.
I'm hunting a replacement tranny, and am wanting to know which year X's to look at as a donor.
View 6 Replies
I have a `95 explorer with the 4.0 motor. The electronic overdrive off indicator light (O/D Off) on dash started flashing today. The transmission seems to be shifting into overdrive. Owner's manual says to have it checked as damage can be caused. What I should be checking?
View 11 Replies
The air bag lite is flashing 3-3 when you start up the truck. After several 33 codes it stays on constantly. I look up on internet and 33 is "passenger air bag open circuit". Pulled the glove box door and disconnected the wires and wiggled and reattached, still have code.
View 7 Replies
I've got a 2003 Ford Explorer The transmission O/D light is flashing, and the check engine light came on. I'm getting and Code of P0775 Pres. Ctrl Solenoid B Circuit Malfunction. Also it shifts rough between gears, the rpms ramp up to much before it shifts. What the problem is, and how to fix it?
View 13 Replies
My 2000 Explorer overheated and I had water pump and intake manifold replaced.. then it had a freeze plug rust out and its replaced, I'm holding water.. but now it just wont start.. we've tried everything from changing fuel injectors, fuel delivery unit on intake, now the fuel pump is changed.. still wont start and the theft light is flashing fast.. my dad changed computers while I was out of town,, is it the theft device or does the computer need coded for this explorer?? we have taken negative off battery but nothing.. And if I change the motor will that work or still not run because of theft light or computer??
View 3 Replies
05 Ford explorer O/D light flashes along with check transmission. Iv had it at ford and they checked it for codes and said it needed a new torque converter, and valve body torque plate. They changed the torque plate, cleaned the valve body changed the fluid and filter, checked it again for codes and said it was fixed. less than 100 miles and 1400 dollars later with a new torque converter new torque plate and fresh fluid and filter still have the same problem. What else could be wrong with this transmission It drives and shifts as it should and it has from the start of the o/d light flashing and the check transmission message.
View 4 Replies
