Ford - Explorer :: 2002 V8 Has A Bad Motor
Mar 2, 2017
I just bought an 02 explorer it has a 4.6 V8 it has a bad motor. I was wondering what other vehicles and years I could take the motor out of.
View 2 RepliesI just bought an 02 explorer it has a 4.6 V8 it has a bad motor. I was wondering what other vehicles and years I could take the motor out of.
View 2 RepliesStarted up the 2002 EXP today and thought the fuel pump was failing. Get a consistent thump every 1 second. Later today i looked and noted the noise is coming from drivers rear fender well (i think). I took off the small plastic cover of the rear blower motor and thought it was in that area. Disconnected the motor and still thumps. Disconnected the blower motor resistor block and still thumps. Looked at the overhead consol and the rear blower was on HI. Turned the blower down and as you reduce speed the noise volume is lower. Turned the switch off and i thought the noise was gone. Pulled the cup holder above the fender well looking for a relay or something in that area. I cant isolate the noise but seems to be real close to that area. Later i heard the noise, very faint, and the blower switch was off. Turned it to 1-2-3 and it gets much louder. Turned it off and very slight noise. What am i looking for? My hearing is not accurate enough to find it.
View 2 RepliesMy daughter has a 94 explorer xlt 4 dr. The window motor regulators are going out. I replaced one of the front ones and decided I'd just make the parts needed next time. All that was really wrong with the front was the little plastic slugs were crushed. They are easy enough to make.
Tonight I tried to remove one of the rear motors, so I could open it up and get the measurements I needed. I found 2 screws that secure the motor, but that's not all that holds it. It seems to be mounted with a spot welded stud as well. There is a small dimple in the door panel in the approximate area.
Before I start drilling things that might not need drilled, I thought maybe I better check here first. How is this supposed to be removed ? The Haynes manual for it tells nothing as to the removal and replacement of any of the window motors. Is the reg inside the gear head anything like the front door motors ?
Ok its a 96 explorer 4x4 and I just picked it up so I am learning all the things wrong as I go here. First off every now and then when the truck was almost to a stop the abs motor would kick in and make the abs noise. I checked the brakes and decided to change all 4 rotors and both sets of pads. I just push the fluid back up when I change pads instead of making a mess with bleeding and I am still getting the abs noise once in awhile. So could this be something wrong with the abs or should I sit there and bleed all 4? There is no lights on in the dash.
View 2 RepliesI'm fixing up my 1991 Ford Explorer Sport. I've replaced door panels, handles, center console, seat upholstery etc... I'm now looking for a replacement headliner. I've already checked LMC without any luck. Also my windows will not roll up/down even though the electric window motors are working. I can push and pull the windows up and down by hand while pushing the corresponding direction on the door control so it seems the mechanism is just slipping against the window. What exactly is this mechanism? what do I need to fix this problem?
View 3 RepliesI have a 1997 Ford Explorer. Starting about 4 months ago I have had intermittent problems with it not wanting to start.When you turn the key the radio and dome lights etc. come on but it is dead silence from the motor.First time it happened we ended up replacing the starter solenoid. Next time we discovered that if you "jump" the 2 posts on the solenoid (using well insulated rubber handled pliers) while turning the ignition it will start every time.Took it to a local, reputable mechanic - he is baffled. They looked at every connection and wire they could think of.It is not the battery or solenoid, as best we can tell. It does not do it all the time. It will ocur, then it will start fine for 2 weeks then happen 3 times in a row, then not happenf for say another week or two.
View 7 RepliesWhen I turn-on AC or defroster, motor idles rough then stalls. My mechanic says it is not related to CHECK ENGINE light or exhaust O2 sensor? I have an 02 Ford Explorer.
View 4 RepliesGot a 06 Limited with power third row option. The rear Pas. side seat is stuck down and when I push the button you can hear the motor running but the seat does not move. I have tried shaking the seat while pushing the button with no luck.
View 14 Replies99 Explorer Blower motor quit working. Disconnected and hot wired to a battery and blower motor worked. So I know it is in the switch and/or wiring. I need this truck everyday so going into the shop is out. Live in Northern Mn and the temp was -15 degrees. So as a temp fix what does everybody think of running a wire from the battery to a switch inside and then to the blower motor and then to a ground. Would have a inline fuse. If this will work what gauge wire and what amp fuse would you use. Its getting cold without heat.
View 4 RepliesI have a 1997 ford explorer, the passenger side rear window only works in one direction, I have tested motor and it does work in both directions reversing the polarity, checked switch by checking voltage on each prong of plug (where motor plugs into harness), and does get 12 volts on each line as switch is being activated,I think there may be a ground problem on the one side that does not work, where to start looking??
View 1 Replies2007 Sports Trac .. Does the motor need to be removed to replace head gaskets? 4.0 sohc
View 1 RepliesI am in the middle of replacing the timing chains on my 1998 4.0L SOHC 4x4 Explorer. I was going to ignore the balance shaft chain but a piece of the broken jackshaft chain tensioner broke the balance shaft chain tensioner too. Now I have to pull the upper pan/ladder frame.
Of course, the manual says I have to pull the motor to remove the upper pan/ladder frame on a 4x4 but I have heard there may be a way around this. How to avoid pulling the motor and still be able to replace the balance shaft chain tensioner?
Can the power window regulator motor on a 96 Explorer be repaired? I can hear the motor make a thump noise but it is bound. I have seen videos on earlier model Fords where the motor can be taken apart and the plastic spheres can be replaced but I didn't know if that can be done on a 96 model.
View 1 RepliesI recently purchased a 2003 Explorer. Two weeks after I bought it I found out the motor on the windshield washer water pump was shot. The dealership fixed it for free. About a week after I got it back when I was driving in the morning to work I noticed the check gauge light go on and saw that my temp gauge was pointed at HOT!! I pulled over and stopped immediately. As soon as I slowed down the temp gauge went back down to normal. It happened 2 or 3 more times and had it back at the dealership. They are stumped. They sent it to a Ford dealership and they couldn't find anything either.
They said they have checked everything and it is not overheating. They even put a thermometer on it while they drove it and it didn't get over 205* I am surprised it didn't do it to them because it happens almost every morning. I only work 4.3 miles from my house so its not like I am driving very far. It usually happens at about 3 miles. As soon as I see it going up (and I watch it a lot!!) I take my foot off the gas and start to slow down or barely press the brake it goes right back to normal. Then it stays at normal the rest of the day. Is it the sensor or the wiring or did the do something to it when the fixed the washer motor?
My wife started our '99 Explorer last week and she said that the engine was rattling. I started it up when I got home and it sounded like something had let loose in the engine. We took it a local mechanic and he basically said that the motor was shot. I pulled the codes and it doesn't look good to me but I'm not a mechanic. Codes are:
P0301
P0302
P0303
P0173
Three days ago, my 2002 Taurus ses, 144k, auto, 3.0 v6 motor, started "ticking" after I drove it to the local grocery. It is coming from the top of the motor, but does not make noise when it is first started, cold, only after it is warmed up. Oil & filter has 2500 miles on them, all other fluids are good.
View 1 RepliesI have a 1999 Explorer. 5.0 V8 auto AWD. Motor bogs down when going up hill. Smoke coming from under vehicle. Recently tuned up & oil change. 157,000 miles. No warning lights. Not over heating. No burnt smell from oil or trans fluid. No leaks from motor or trans. Oil & trans fluid look clean. I have a little mechanical knowledge. Someone said it could possibly be a bad catalytic converter.
View 2 RepliesCurrently My AC / Heat blower motor operates but, speed 1 and 2 are the same, 3 and 4 are fine. I replaced the blower rheostat that is located on the firewall, but still no difference in fan speed.. A few years ago the blower only operated on Hi and the rheostat was the problem then.
View 3 RepliesI have a 2002 F350 Triton V10, Automatic 4x4 Lariat. I have a tapping noise in my motor, and I've had people tell me it could be the timing chain slapping around, a rod or lifter. The tapping noise gets quieter after the motor has warmed up, but gets louder when given gas. I've been told to try thicker oil, pure gasoline (no ethanol), The truck runs fine for the most part except for a vacuum leak on the top part of the motor underneath the throttle body. I have someone that says they can work on the motor and so on. But I don't know where to look to buy the parts for the motor, and what I should have replaced, while he's got the motor out and apart, so far he said he'd change the lifters, timing chain, the vacuum leak.
View 4 RepliesAfter using the 4wd it's not going back into 2wd,the 4wd lo light is on and I dont hear the "click" when turning the switch. I've had the truck several years so I know how the 4wd works,is there a fuse or something else to try?
View 4 RepliesI recently acquired an 02 explorer sport. Noticing a loud hum(similar to what knobby tires sound like) at 25-40 mph. Doesn't make noise at any other speeds. I replaced both front hubs, new shocks, new rotors and pads, sway bar links, even tried rotating tires, absolutely no change. Tires are a standard highway pattern , not luggy so I don't think it's those. Kinda lost on what to do next.
View 9 Replies