Ford - Explorer :: 2002 V6 - Transmission Is Slow To Go Into Gear
Jan 1, 2012
Our 2002 Explorer E.B., V6 4wd 153,000 miles, when cold only in winter months the transmission is slow to go into gear, forward or reverse, takes 10 or 15 seconds to catch into gear. If you warm the car up for 5 minutes or so it is ok no problem. In warm weather it does not do this. Transmission shifts normally and runs great other than this. I changed tranny fluid and filter with Mercon V about 12 months ago. Could it be the solenoid pack or something else.
View 3 Replies
Advertisement
My 82 f150 4x4 302 c6 trans is acting up. My c6 is slow to shift into any gear when I shift the column shifter, after a moment it jerks into gear, also it doesn't seem D is doing anything but all the other gears seems to function manually or auto.
Fluid level looks ok, maybe a little high on the dipstick. I'm going to check the modulator and do a fluid/filter change but looking for a link to the band adjustment screw ?
View 3 Replies
I have a 2004 Explorer 4.0 4x4 with 130,000 miles. The vehicle will not move while in 2 WD or in 4H. No engagement at all. However it will engage in 4L (reverse and drive). It also makes no sound from transfer case when I try to shift from auto 4x4 to 4H. 4L engages and is a bitch to get out of 4L once it's engaged. Changed tranny fluid and filter with no change. Really need this truck fixed, and by me if at all possible.
View 3 Replies
'98 XLT 4.0 SOHC.
First of all overdrive started to play up, the engine would flare as it went into OD and often would have several goes at it until it engaged OD. Finally it wouldn't go into OD.
Still driving it around for awhile then it went into limp home mode - stuck in 3rd gear. What it might be?
View 12 Replies
I'm wanting to change my trans fluid and filter on my 2002 explorer xlt. it's starting to hesitate when initally going into gear. it doesn't have the dip stick and the new fluid has to be pumped in through some plugged opening in the side of the trans. what tool do i need to pump the fluid in and what is the procedure for getting the correct fluid level installed.
View 1 Replies
My truck has grinding noises when i am making turns from a stop or at slow speeds. Also my 4x4 dash light keeps flashing several times both when I am sitting still and when driving. Neither my 4x4 auto or 4x4 high work but the low will work. Trying to pinpoint where I should look to fix them. I did replace the 4x4 control mod as an attempt to fix this.
View 1 Replies
How I could take my ford explorer 2002 in to the shop to replace the radiator and come out with transmission fluid leaking. The mechanic said it is some kind of hose but it wasn't leaking before and after I drive I can see it dripping out. I'm just not sure if they messed up something. Unfortunately my husband is overseas and cannot check it.
View 3 Replies
I have a 2007 Passat wagon 4 motion V6 and what the problem is I am getting a rough shift between 3-4 gear sometimes, usually on a slow acceleration. I have had the valve body replaced which worked for a couple of months until the problem returned. I then had the transmission replaced which worked a little but the rough shifting is still present at times. The car still has warranty and not even the dealership knows what to do?
View 12 Replies
Replaced the 2002 ford explorer 4x4 traction control module because of a shudder in first gear. With the new module the shudder disappeared but now the truck shifts into 4wd by itself and stays there. I am now on my 2nd new module because I returned the first one thinking it was defective.
If I cycle the 4x4 high switch and the 4x4 auto switch, the truck switches back int 2wd but on for a moment then goes back into 4wd. I don't get a 4x4high indicator light but I can hear and feel it is in 4wd. Almost like it thinks the truck needs work with the traction. I have now disconnected the module completely and the trucks runs/shifts beautifully in 2wd. I know my transmission is good. BTW, I have no trouble codes.
Do I have a bad speed sensor somewhere? and How do I trouble shoot for it?
View 8 Replies
Like the title says. 04 Explorer.
No transmission issues ever. Immediately after doing an oil change myself for first time, get some transmission dropouts, slipping out of gear at stop lights, waiting way too long to go into 2nd, etc.
Then, started getting OD off light, and service engine. Error codes show something about wrong setting for 2nd, 5th, solenoid error... a bunch of 'em.
Anyway, guy at parts store says I must have knocked a wire loose causing misreads between cpu and transmission. It's a real pain getting under there since I'm using jack stands, so exactly what I should be looking for or at least the exact name of a connector or something so I can look it up.
View 1 Replies
I just had my tork converter and flex plate replaced on my 2002 Explorer XLT, it has the v8 with 5 speed auto trans. My question is this : on the bottom of the bell housing under the tork converter is a round hole aprox 1 1/2 or 2 inches in diameter. Should there be a plug or cover of some sore to keed dirt and debri from getting in ?
View 4 Replies
Sometimes when you slow down for an exit and then step on the gas pedal, it lurches like it skipped a gear. Or sometimes is sounds like you're pressing the gas pedal while in neutral and then it kicks into gear with a lunging forward. What do I need to do?
View 2 Replies
My '05 Highlander transmission seems to be geared wrong. When I slow down the car seems to slip into a higher gear and speed up. It is worse when the air conditioning is on.
View 30 Replies
It's a 2002 explorer, 4.0, 5R55W trans, all was fine then O/D light starts flashing, so I limp it home. Trans isn't slipping, every gear works, it does kinda bang into 4th but is otherwise normal. Took it to auto zone to have the code read, but no codes found. Disconnected battery to see if it just needed a reset maybe, let it sit for a few hours, reconnect, OD light still flashes. Borrow a different OBD2 tester, still shows no codes, still drives the same just bangs into 4th. I've read up on the solenoid pack replacement, just kind hesitant as I feel like I'm guessing at the problem and might be throwing money away.
View 2 Replies
My 4.65L V8 Explorer has an issue in low gear - RPMS rev high but car doesn't shift up.. eventually "catches" with a jerk but the OD Light started flashing and the Systems Screen reads Check Transmission. Light goes out and message goes away after turning car off and restarting. Had one Tech look at it - he said second gear is toast and need full transmission rebuild. Another Ford Tech looked and could just be solenoid needing replacement and advised to have a transmission service (not a flush) done....
View 2 Replies
04' Ford Explorer - 4.6l Automatic 4x4 - 138,000 miles... While driving today my transmission hesitated a long time between 2-3 gear and RPM went higher than normal. After coming to a stop a taking off again, long hesitation, slams into 3rd gear, check transmission warning came on and OD light on dash was blinking. I drive it home and pull the code: P0745. I drop the pan and find a piece of metal 1/4 wide x 1/2 long. Does this mean a complete trans rebuild?
View 5 Replies
My '02 Explorer transmission is giving me a little trouble. The vehicle has 240,000 miles, but the transmission has been rebuilt several miles ago. I recently had the fluid changed, and I had them add a bottle of Lucas Transmission Fix, which I have had good luck with in the past. Most of the time, the transmission behaves normally.
Occasionally however, when I come to a stop after driving for a while, the transmission stops pulling, like it has shifted into neutral. Sometimes it will re-engage after a couple seconds, and sometimes I try to hurry it along by shifting to Park, then back to Drive and it will go. If I am on an incline, and the vehicle does this, it will actually roll down the hill.
Hopefully there is a simple fix because this thing is too close to the end of its life to require a hefty repair investment! Maybe a switch or a sensor. I'd love to tell you that I checked the fluid level, but Ford forgot to put a transmission dipstick on it.....
View 7 Replies
I've just bought a used 2002 Explorer Sport Trac (Automatic) 120k+ odo and what I've noticed whenever I shift from Park to Reverse or to Drive it takes about 3 seconds before I feel a slight jerk moving forward before I can step on the accelerator for the vehicle to move backwards or forwards but if I step on the accelerator right after shifting to any gear except Neutral it won't run immediately as if the clutch is disengaged and after about 3 seconds it will suddenly engage. Is this normal or is there something wrong with the transmission?
View 3 Replies
I have an 02 Honda Accord V6 LX with a bit over 142k miles and an automatic transmission. She runs fine (as far as I know). No major transmission problems, just a little slow going from 1st to 2nd and sticks just a tad when dropping down from 2nd to 1st.
Here's the question: To Flush or not to flush?
Mechanic #1 told me to never flush a transmission after 130k miles; instead, he said, I should take it to a specialist.
Mechanic #2 said a flush would be fine.
View 18 Replies
Wife's truck- 2002 v8 limited explorer with 116k... Yesterday she calls and says the od light is flashing and the message center says check transmission. She drove it home then when I got home the light was off and all seemed ok. I am taking it to have the codes read and hoping that my mechanics scanner picks up a code.
View 2 Replies
I had an 02 Explorer for years now and absolutely love it. It has almost 170,000 miles on it and is definitely showing its age. There's alot of rust underneath and ive been replacing things as they break. For about a year now I've been dealing with the transmission leaking fluid. This vehicle doesn't have a transmission dipstick and has to be filled from underneath. When I have the transmission full of fluid it works perfectly until recently. Now, when I go up a hill the transmission goes into an almost neutral state.
The R.P.M's will go up past 4000 and I'll have to stop. It doesn't misfire or bog down, just acts as if the tranny is in neutral. Sometimes I just sit there for a minute and its fine, other times I haven't been as lucky. In one instance I had to sit there for about 20 minutes, in another I disconnected the battery to reset everything, and on another instance it would stall out the moment I put it in gear. I know it's a little low on fluid and will be getting it filled again soon. I plan on possibly getting a new transmission this winter, but gotta keep it going till then.
View 3 Replies
