Ford - Explorer :: 2002 V6 - Long Crank Time Before Start
Jan 22, 2017
So my 2002 ford explorer with the 4.0 L V6, has been cranking along time before it starts. I thought i had this figured out already, i put a brand new fuel pump in it from the ford dealer. That seemed to work, but the problem came back.
Especially when it is cold, it cranks a lot longer than normal to start. and when it does start RMPS go way up briefly and come back down. Seems to only act up when its cold out, say 35 degrees and lower.
So the remote start wont work because it only cranks for a few seconds and then stops. it tries this three times and it gives up. i go out there to start it and cranks for 10 seconds it seems like, sometimes i have to feather the fuel pedal.
View 7 Replies
Advertisement
I have a 2002 Ford Windstar that only in the fall and winter it has a longer crank time of at least 10 seconds. In the summer it starts as it should within 3-4 seconds. I did notice that the times it did start normally in the colder air is when I turned the key on and listened to the fuel pump prime the system. All other times it doesn't do that and that's when I get the long crank time. Once it is started it runs as normal. Am I looking at a possible fuel filter or pump? I am due to replace the filter as the van has 83,000 miles on it. If this is the possible culprit, is this something that is easily replaced at home?
View 4 Replies
Removed my oil rail to replace standpipes/dummies (04 Wavy rail) and now I have huge crank times to start. This is after the initial Huge crank to get it started. Do I have air in the system, or did I bugger something. I did the whole deal very careful. I lifted the rail up very carefully, pipes removed. I lined up the rail nipples with the injectors and evenly pressed it back in place, and then inserted my dummies/standpipe. Tightened the rail to 120 inch lbs then the dummies/standpipe to 60 ft lb. I did my son's '06 a month ago with no troubles. (didn't remove rails though). Once running it sounds perfect, turn it off and re-start and it's a long crank (30 seconds or more). I have not monitored ICP/IPR while running, will try that today.
View 8 Replies
Car does not have to get wet, just be in humid air. Problem going on 2 years now, mechanics tried disconnecting a (?) ground/sensor from computer, major tune up, new fuel pump. Until recently, it just took keeping it in crank position for a long time for it to finally start. Recently, in crank position for 30 seconds does nothing and has me worried I'm doing damage. In dry weather, it starts first time every time.
View 12 Replies
My wife's Pathfinder (a 2002) has developed a problem with slow starting. The car cranks well (even at -20F, so it's not a weak battery) but takes a long time to start. It might crank for 5 seconds before sputtering to life. After being driven and shut off, most of the time, it will start up instantly again, just like it used to before the problem started. The problem is intermittent in that it sometimes starts pretty quickly in the morning, although it's not the instant start that it used to be, it might only crank for 1 second or less. I know that sounds like a normal time for a car to crank before starting, but the Pathfinder used to start, almost literally, instantly after the key was turned. So, even 1 second is an uncharacteristically long time.
What I've done:
-- Replaced spark plugs
-- Swapped the starter relays with identical relays under hood
-- Replaced fuel filter
What I haven't done:
--Replaced fuel pump
--Replaced fuel pressure regulator
Both of these are somewhat big jobs (I think I can handle both of them) and more expensive than what I've already done, so I'd like to get some input on where the fault could lie before picking one. Or, am I completely off base thinking it's fuel system?
View 2 Replies
I've been working on this explorer for a week now and I figured it's time to ask around. My explorer won't start/crank, I've replaced the starter, battery terminals, tested voltages/amps/relays and fuses, still nothing. All i get is a heavy clunk, like the starter is engaging but the flexplate won't budge. It's a 2002 4.0 xlt automatic.
I'm fearing the engine is seized as I've tried manually turning the engine with a socket on the crank pulley bolt and even with a breaker bar I can't get it to move. The thing ran fine a week ago and I can't imagine this thing would seize at barely over 100k miles, not hydrolocked or anything I can think of, are these engines prone for spontaneous seizure or am I missing something?
View 14 Replies
So how long does one have to crank until it is considered an extended crank? 2 seconds, 5 seconds, 10 seconds.....?
The reason I ask is after all the motor work I did on my truck sometimes she fires up in less than 1 second of cranking and other times it take maybe 2 seconds of cranking. I do not think 2 seconds is considered and extended crank time but was just curious about what is considered extended cranking.
View 12 Replies
I have a 2006 F350. I have long crank times. No Codes. I have Autoenginuity with Enhanced Codes and everything shows fine. I replaces standpipe and dummy plugs. Glow Plugs and harness. I was hoping it not be the STC but I needed to do oil cooler so wanted to eliminate STC. Got truck apart and the STC Fitting is newer style so I'm kinda bummed out. Not sure if I'm missing something and as far as I have it torn down is there anyway to test what could be causing the problem? Or just put it back together and keep my fingers crossed that whoever put the new STC fitting in screwed it up. I'm beginning to not like my truck.
View 8 Replies
I've got a 2002 Ford Sports Trac that won't start ! It will crank till battery dies but is not getting fuel. I have had it towed 4 times in the past year. of the 4 times,this last time it wont start. Every time that I have had it towed back to my house and dropped in the driveway it has started up with no problems. It will run for a few months or more.This last time it would not.
Could this be an electrical problem.Maybe loose ground somewhere or something else. Would like to rule out some things before investing in a fuel filter or fuel pump. Would hate to buy new FuelPump and that not be the problem. Can't find free wiring diaghrams for this issue.
View 3 Replies
The past couple of cold starts (not real cold mornings though) I have experienced long crank time to start. Once started she starts normally. No time to read but I'm getting a little worried that I'll get stuck somewhere. I'll check back with my phone when I get into an area with cel service.
View 14 Replies
So ive had a starting issue in the R32 for quite some time now. With waterfest approaching and the new S3 going into production that i ordered, it has come time to finally fix it. I have taken in to many dealerships and very talented techs, and no one has any idea. The car seems to crank for a very long time or start right up and then just completely stall and die. The second time i start it, it starts completely fine like nothing ever happened. This only happens when the car sits for a few hours. It has never done it if the car has sit overnight or during the cold months. It has to be warm and sit for a specific amount of time. Its like it catches the car transferring into a cold start but not fully cold yet, if that makes sense. Also i am now noticing a small squeak each time it starts, like a belt. I have replaced the fuel pump/spark plugs/coil packs. Nothing has changed. We thought maybe a stuck injector but were doubtful as its not constant. Im debating a cam position sensor just to see if thats the issue. There is no CEL or any codes.
View 12 Replies
I have a 2006 Sonata GLS with the 3.3L V6 and close to 230,000 miles. A few months ago I noticed that my crank time at starting was longer than typically - it has steadily gotten worse.
Now the crank time is close to 8 - 10 seconds. (Which might not seem like much but trust me, it is).
I suspected that the fuel pump was faulty, however, once started - it runs great.
I put a pressure gauge on the fuel pump outlet and found that it only kicks the pump on when the car is cranking, the fuel pump does not kick on when the key is in the "on" position. Once the vehicle starts, it seems to be drawing fuel.
The pump has all sorts of pressure, I am not worried about that.
I decided to change the Fuel pressure regulator valve thinking that maybe it wasn't holding pressure - That didn't seem to do anything.
Do I need to change the entire Fuel Pump Assembly?
View 5 Replies
Finally finished rebuilding my 5R55W transmission and have it back in the 2002 Explorer. Reverse works good, Drive works great, but I am having problems with it wanting to take a long time shifting from 2nd to 3rd. Have to let up on the accelerator in order for it to go into 3rd.
Goes into 3rd hard! 4th gear and 5th gear are finally back. I rebuilt it because I didn't have overdrive. When I didn't have overdrive, it would also take a long time to shift into 3rd and was hard.
Checked codes and am getting a "pending" P0745. Pressure Control Solenoid "A". What I need to start with?
View 3 Replies
I recently (in the last few months) have noticed my truck (1999 F350 duallie) seeming to be running very rich … I pull a 32' trailer with it and noticed on the art few trips the front and right side of the trailer covered with diesel fuel spots when I got home …. It also smells very rich when idling…. The last couple times I started it in the mornings it seems to crank a very long time before it starts …it still runs but its got issues evidently … it has these 3 codes :
P1280
P0475
P1670
The 1670 will clear , but the other 2 I can't clear, they are right back every time you turn the key on …
View 14 Replies
I own 2013 Mk6 GTI. I am having to over crank the engine for a period of 8 seconds or so before the car starts, especially after it has been sitting for a few hours. My thought was a faulty check valve in the fuel pump. I have heard that our fuel filter has a built in pressure regulator that may get stuck open for whatever reason and that may also cause a long crank time.
View 9 Replies
I have a 1988 Dodge pickup 1500 with a 5,9 gas engine. It used to pop right over all the time. Now, in the morning, I have to crank it forever until it starts, and if it sits for 1 hour or more, same thing (have to crank for a long time). It is my understanding there is a valve called a one day valve that holds pressure on the gas line. Is it possible this valve is not working properly? And if so, do I have to replace fuel pump to fix problem? once started it starts up with no problem until it sits for hour or more then hard to start.
View 15 Replies
04' Ford Explorer - 4.6l Automatic 4x4 - 138,000 miles... While driving today my transmission hesitated a long time between 2-3 gear and RPM went higher than normal. After coming to a stop a taking off again, long hesitation, slams into 3rd gear, check transmission warning came on and OD light on dash was blinking. I drive it home and pull the code: P0745. I drop the pan and find a piece of metal 1/4 wide x 1/2 long. Does this mean a complete trans rebuild?
View 5 Replies
Little background- this is my first winter in a diesel truck. When I purchased it- it had 4 glow plug codes. Everyone around me just told me to plug it in and fix it later, that if I plugged it in, glow plugs don't matter much.
Had hard starts all last week with temps down to -20, turns out my block heater wasn't turning on due to a bad cord. Replaced cord end today. Let the oil temp get up to around 60F according to torque pro.
Still had a long crank despite warmer oil (15ish outside). Batteries dip to around 10V when plugs are on, then cranks at around 11V. Lots of white smoke which I know is normal.
I still had to fight with it a little bit to get it to start, as soon as she was actually going- runs flawlessly, no lope, no smoke. Runs and drives flawlessly. If I turn it off, she fires right back up instantly every time without hesitation, until she cools off again.
From what I'm seeing I'm thinking my batteries are fine, and my starter is probably fine. Are glow plugs making this big of a difference even though the truck is plugged in?
Truck has 0 codes when warm, 0 blow by, drives fantastic, Just under 300k miles. The only thing I'm thinking of is the glow plugs need swapped. I have a set of ZD11s sitting in the truck waiting for a warm day.
View 6 Replies
The problem I'm having with this vehicle is that, it will start up just fine most of the time if I just hop in my after and haven't drove it for a while, however after I drive lets say 20 min+ and then decide to turn the car off and go back to turn it on, it just wont, it will turn over and its getting power but it won't follow through to start the engine, took it to a place by my house for 3 days and they said its probably the fuel filter but they couldn't give me a straight answer, what it most likely is? Its a 2001 Ford Taurus...
View 6 Replies
I have a 2002 v8 lse with 92000. When i go to start it after it has been sitting for 20 minutes or more it cranks for a long tome before starting. When it does start it idles fine but has a strong fuel smell. There are no codes and no problems once it starts. However it starts up right away in cold weather. It seems like a flooding issue. The fuel pressure is within range but it does seem to bleed off quicker than most cars i work on when the engine is no longer running..
Unfortunately I don't have the specs on on fuel pressure runoff. I suspect the fuel pressure sensor/regulator. I don't believe it would be an injector due to the fact it never runs rough or misses once started and if it was the pump it wouldn't give off a fuel smell in the exhaust once started.
View 14 Replies
I have a 2002 celica after sitting for a hour or so car has very long crank....
View 1 Replies
