I have a 02 ford explorer sport trac the overdrive is not working and I have fixed the wire in the steering column and the neutral safety switch and it still does not work. What it could be???
View 3 RepliesMy 1991 Explorer 4.0 4x4 overdrive not working, so far have checked ohms on sensor at trans and it appears to be ok. Also looking for the pinout of PCM under passenger kick panel to see if voltage is being output to the sensor at trans.
View 1 RepliesMy 2002 Ford Explorer has a 4.0 liter engine. The overdrive light on the dash is blinking.......what repair and how much would it cost to expedite that repair? Also the ABS light is on....
View 19 RepliesMy son has a 02 - 2 wheel driver xls. His over driver light is blinking on and off. what the problem might be? He has about an 80 mile round trip drive today before he can get it to the dealer. Would he be damaging the vehicle if he drives it that far?
View 1 RepliesI have a 2002 7.3 ltd X with the 4r100 transmission. The trans shifts fine until it get over 160 deg (glow shift gauge in test port) Then the OD stops working and get no engine braking until I turn off the OD. when od is turned off, appears to shift OK. When the trans temp gets below 150, I get the OD back. The OD light did flash on 2 occasions but no code while engine on and light flashing but OD was working at the time. after shutting off engine and restarting light stopped. New fluid and filter, torque convert was flushed also and X has larger 6.0 trans cooler. Tran did get hot once while towing 4 ton trailer 240 f, thus bigger cooler. what would cause the OD to go out when above 160 f but come back when cool?
View 7 Replies2002 Escape. The over drive deselect button stopped working on my wife's escape. Is their a fuse other than the box under the hood? Transmission was rebuilt not too long aga and has been running fine till the other day.
View 2 RepliesFuse 29 was blown when I got my truck, automatic headlights and overdrive lock didn't work. I replaced the fuse, the lights came on and overdrive locked out but when I shifted into park the doors locked and the fuse blew. How the door locks are related and why they would lock when shifting to park?
View 2 RepliesNO RESPONCE TO REr wiprt control ?
View 6 RepliesIi have a 2002 Ford Explorer XLT. Some days ago I tried to open truck doors with the remote controller and I couldn't. I put new batteries on it and it didn't work either. So i change for another controller I had (not new but in good conditions) i programmed that control and was perfect for 4 days. Now the new control does the same, it has new batteries and doesn't want to work.
View 3 RepliesI just bought an 02 Eddie Bauer 4.6 4x4 for my mother in law. The power gas and brake pedals are not working. Worse than that the gas pedal is stuck all the way forward (firewall) and the brake pedal is stuck all the way up high(towards the seat) They do try to move, so the switch is working. How do I get them even again?
View 4 RepliesJust purchased this vehicle. The cruise control and radio controls On the steering wheel will not work. It has aftermarket stereo , not sure if wiring from that would affect cruise control as well as radio controls. Cruise light does not even light on dash. Clockspring? Radio wiring harness?
View 2 RepliesMy entry pad on the outside of the drivers door stopped working on my 2002 Explorer. Not only does it not open the doors but they don't light up when push the buttons. I looked in the owners manuel for a fuse related to this but did not see one. Which fuse the number pad is controlled by?
View 5 RepliesMy 2000 Explorer overdrive light will blink once in awhile no hard shifting, no slipping, i also pushed the overdrive button while it was doing this and it went out of overdrive , trans has been service, I know this is a common issue with explorers . I understand that it could be caused by a number of issues. I haven't had the codes pulled yet.
View 4 RepliesRecently my check engine light came on. I understand this isnt such a big deal, but then my engine started "skipping", and my overdrive light is now flashing. my car will stall if i come to a complete stop without putting it into park or nuetral. I dont know what to do.
View 7 RepliesGot a call from my little sister about two weeks ago that her Ford Explorer would not drive forward. Checked it out and put it into second to get it home.Last weekend me and my dad changed the filter and fluid and then drove it for a bit. It sounded a little better but still would go into drive or reverse. We shifted into second which we knew worked and then back into reverse immediately and now reverse worked, although sluggish. The same was true for drive. A few days later dad changed a solenoid and now it will go into drive and go up to 15mph, but will not shift from first to overdrive first. And still no reverse right away. She is able to get to school with second gear and pop into drive when she gets up to 40-45mph. If she has to backup from start, first she has to put it into second and then back to reverse. Something in overdrive doesn't seem to be doing its job right.
View 3 RepliesI own a 2009 ford explorer 4wd 5 speed auto with only 44,000 miles when I drive using overdrive just before it shifts into overdrive it bucks and when I slow down below 50 mph before it will down shift to 4th gear it bucks. I have had the suv to a ford dealer repair service 2 times and they ran a diagnostic computer check on it both times and found nothing. What I need to do next?
View 1 RepliesWas told that I need to replace the torque convertor as it is slipping, has 144,000 on it. 2001 Sporttrac ...
View 8 RepliesI have a 99 explorer and the OD off light just began flashing. Is this something serious, that will need attention?
View 1 Replies2002 ford sport trac.I have been having an ongoing issue that started with the engine cranking but would not turn over until an hour passed. After replacing multiple parts (cam shaft sensor, crankshaft sensor, ignition pack) I am now down to poor fuel economy as the last of the issues (roughly 12 in the city and 15 highway). I was told the issue may be the engine coolant temperature sensor going bad so I decided to replace it. I found this was very difficult due to it being a plug and locking pin design and in a very tight spot in the engine.
I tried to purchase a replacement and the parts store kept trying to insist on selling me a part with threading. I finally found someone that figured out the issue and found the part for the 2001 sport trac had the same plug style with clip that did fit but was shaped a little different on the sensor end which I assume was due to being aftermarket. I noticed that there were two plugs side by side and the one easiest to access was on the left and I was told the one on the right was the sensor that gave the temperature reading to the gauge.
After installing the engine coolant temperature sensor I found the temperature gauge on the dash now will not respond and is sitting below the cold end of the gauge completely off. Is it possible this is because the part was for a 2001? Is the sensor on the left (passenger side) the engine coolant sensor?I would hate to put the old sensor back in just to test if that's the issue due how difficult it was to put that locking pin back on. What to check that could resolve the gauge issue before pulling this sensor back out?
My 2002 Explorer LTD with 155K miles on it is in terrific shape except for a worsening rough shift into overdrive (automatic transmission) and a clunk which occurs with increasing frequency when I shift into reverse. I would love to keep the car but don't want to spend the money for a new or rebuilt transmission. There is no access for owner approach to transmission fluid - I have already looked in the manual. I would need to take the truck to a garage as I cannot do repairs myself.
View 2 RepliesI have a 1996 Explorer XL 2 dr. It has the 4.0L OHV V6 and the 4R55E Transmission. I bought it used with 152,000 miles on the odometer. About a month after I bought it I noticed it sounded different. I looked down at the tach and the RPMs are up around 2500 with the overdrive engaged. I turned the overdrive off and nothing changed. I turned it back on and nothing changed.
That weekend I pulled the tranny pan and filter and replaced the filter and fluid. There was the normal amount of debris in the bottom of the pan but nothing major. Now when I drive it it tries to shift into overdrive but when it does the engine bogs down and the O/D off light starts flashing. I know how to do the overhaul but I wanted to get a few opinions before I start tearing into it. What could be wrong .