02 limited explorer with 114k. The door ajar light keeps staying on and the dome light wont go off. This has happened 5 times now in 2 days. I open and close each door and hatch a couple times and it eventually goes away or I turn off vehicle and restart trying to clear message. How do I test and locate where the issue is coming from?
View 6 RepliesDoor ajar light stays on. Lights were staying on until they timed off but after two days they have returned to normal operation. Where the switch is located on the door frame, I can't seem to find it. 2002 ex psd.
View 12 Repliesi've got a 2002 explorer xlt and the door ajar light stays on. all the doors properly close. What would cause this ?
View 3 RepliesMy door ajar light & bell goes on and off at random. It's also setting off the alarm when the doors are locked. What might be causing this.
View 14 RepliesSo my 2000 ex has the door ajar light on. I have narrowed it down to the drivers side rear door. I have sprayed wd40 and pb blaster into the latch and its still on.
I have taken the panel off and sprayed everything inside. I pulled apart the wires running inside the door and tried doing some experimenting with twisting wires together, Hoping to close off the circuit.
My 08 Prius developed a hiccup yesterday. While driving down the interstate there was an occasional red flash from the dash. It would come and go so fast that by the time I could actually process it and focus it was gone. I had to stop by the dentist office as I was ready to walk out the door I heard a car in the parking lot with the horn/alarm sounding. I mentioned to the folks in the waiting room that someone alarm was going off. A lady replied that green Prius with the bike rack!
Sure enough it was mine! I was unable to find any causal factor. I left there and at my next stop, the horn/alarm started sounding just as I walked through the entrance door to Home Depot back to the parking lot. This time the Door Ajar/Open light on the dash was lit. I opened and closed all the doors and hatch. The Door Ajar light was still on I then manually manipulated all the door switches and opened/closed/slammed the hatch several times. No Joy I drove home.
About the only thing I was able to find was that it was probably the hatch, the switch is sealed within the locking/latch mechanism and that I could simply just unplug it. So I began troubleshooting.
After removing the rear hatch/floor, plastic bin, etc. I removed the plastic cover from around the latch (above the bumper not on the hatch lid), then removed the longer plastic cover that runs along the same area and provides the cover for the area between the rubber gasket and the inside of the hatch/floor area. Now I was able to see the latch mechanism and associated wiring (looking down toward the spare tire well). I also had the hatch light turned on (left side) which was easier to see than the Door/Ajar light on the dash.
I manually tripped the latch and the light flickered. I pressed down on the latch (hoping to put more pressure on the internal switch)…the light continued to flicker. Using a 10mm socket, I removed the latch, wiring retainers and disconnected the plug. The electrical plug, located about 8†to the left of the latch has 4 wires. The two on the bottom power the electrically operated latch and the two on top go to the Door Ajar switch (the one that is inside the latch assembly).
I noticed a little bit of corrosion and discoloration on one of the male pins (the plug that is connected to the latch end of the wiring). The female plug (connected to the car end of the wiring) also had some discoloration.
I plugged them back together and found that as I moved the wires/plug the light would flicker and change sometimes turning off. I unplugged it and connected my ohm meter (using small jumper wires with clips) to the two top (male) pins on the switch end of the plug. The switch tested fine. I even tested it with my homemade battery powered continuity light (wanting to test the switch under a load). I also wiggled the wires going into the plug itself, Perfect, no problems here! So, I determined the problem was truly with the plug itself. I also jumped the two female connectors with a short piece of wire (simulating the switch) and the light would come on (as it should have). OK, plug problem confirmed!
I cleaned the pins (both male and female), applied some dielectric compound and plugged it up. The light remained off for a few seconds then started flickering again! I could even hear a slight hissing sound coming from the plug (never a good sign). I tried tweaking the male pins (bending them slightly trying for a better connection) No Joy.
I clipped the wires (only the top two) from each end of the plug (red & white/black stripe wires coming from the latch).
Truck '02 F250 SuperCab - I was having an issue with the door ajar light staying on and the radio not shutting off upon exiting the truck. After having no luck with the WD-40 fix, I replaced the door switch sensor on the driver's side door and disconnected the negative battery cable for a few minutes (maybe 5-10).
Problem solved or so I thought...a few days later (approximately 5) the door ajar light came back on and the radio did not shut off. I disconnected the negative cable and sure enough that fixed it...again The problem is that every few days I have to go thru this. I'm not sure if it's related or not, but the CD player has started giving me "error reading disc" on even brand new CD's.
A friend has 2001 Explorer, whose dome light isn't working from the driver's door. Did a quick Google and found a number of excellent answers and how-tos on this site, all focusing on the door switch. Problem: the door ajar light works properly, presumably clearing the switch.
My understanding is that the dome light is triggered by the GEM via a relay. When I considering the following:
- The dome light turns on via the headlight switch;
- The dome light turns on by opening the passenger door;
- The dome light does not turn on by opening the driver's door; and
- The driver's side door ajar functionality works -
I am led to conclude that the fault would lie in the GEM module. If the GEM is indeed bad, then the light will probably just stay out. But is there something else that I might be missing?
I had a problem with my door ajar light always being on, I was able to find out that it was in the sensor for the back glass and was able to fix it. But now when I cut the explorer off and remove the keys the dome light comes on instantly even if no doors are opened and the lock/unlock button on the driver door won't work. However if I manually turn off the dome light my lock/unlock button starts working properly. Also if I do not manually turn the light of with the roll switch the light will stay on until the computer kills the power to it about 10 mins later. What could cause this??
View 6 Replies2007 ford explorer xlt door ajar warning and dome light comes on while driving also dome light comes on while parked for no reason...
View 9 RepliesThe dome light and door ajar light on my 97 Ranger stay on. The switches are good, is there a relay or other device in the circuit?
View 9 RepliesVehicle: 2002 f250 xlt 7.3 powerstroke reg. Cab
Issue: door ajar light stays on, power locks on driver and passenger door don't work, radio stays on after truck is off an door is opened.
Events leading up to issue: went to temporarily hook up a wolo dixie horn to see if it worked. Wanted to do it fast so I took + cable, tied one end to the battery terminal and then connected other end to dixie horn relay. I then grounded both negative wires to the truck. One ground on the frame the other I temporarily wrapped around a one of factory ground mounts under the dash. Immediately after doing this the problems stated above started.
How can I fix this. I need to fix this by tomorrow. I have a guy from Craigslist coming to look at the truck. Now the 4x4 issue.
Truck has zf6 manual and the electric 4wd select ****. Just thought I'd list this if it was needed to be known for solutions.
4x4 high light stays on in while 2wd all the time. 4 low will stay on after switching back to 4 high and 2wd but it goes out if I ether stop the truck shut it off then restart it. or back up and slam on the brakes. Also when in 4 high the front driveshaft won't spin. However It will spin when in 4 low.
Another random issue I'd thought I'd just list while I'm writing this.... Cruise control does not work. And when I press the "on" button and the "coast" button at the same time the horn honks.
I own a 2002 excursion and my dash light for door ajar stays on, I pulled all of the contacts off the rear doors and hatch and found that there are no electric hook up to what I thought would be the contacts i needed to be looking at. So what relays the signal to my dash that the doors are in fact closed?
View 14 RepliesBought a '02 V10 gas 4wd Ex a week ago pretty cheap, and looking to fix a multitude of little issues.
I have been reading about the door ajar warning light issue, and mine alike has door ajar light always on. However, my dome/interior lights do not react to the opening of any doors/rear door hatch.
It's not out of the question that the last owner might have disconnected what he needed to to avoid fixing the problem and still use the truck. Where to start given I can't troubleshoot down to one particular door ajar sensor?
I have a 2002 f250 screw. my door ajar light is lit up on the dash. I have tried the wd40 trick, pulled the sensors and bench tested them. What are the codes the instrument cluster test has for each door?
What I am thinking is, if we get a list posted it would be much easier to diagnose the door sensors for others. there should be a open/closed bit for each door. possibly a code for all doors open too. I am curious if there is a code for bad communication on the VSM.
From what I have read, correctly working the doors should read 00 when they are closed. drivers front open=80, pass front open=40 ... My door code does not change no matter what combination of door open/close I use.
Truck is 2002 f250 crew cab ...
My code is C0 ...
I have a 2002 Camry SE. Recently, the 'door ajar' light on the dash has come on & will not go off. I have reclosed all the doors: still on. I have individually opened each door & pressed the door switch on & off: still on. I have checked the fuses under the hood & by the driver side panel & all look fine.
Also, two other things are curious about this: when I press the key fob to lock the doors, there is a high pitched whine that come from the passenger side engine compartment, & only stops when I press the unlock button on the fob.
The second is that when I am driving and I try to lock all the doors from the drivers arm-rest control, they all lock but cycle quickly to unlock again & will not stay locked. The dome light will not go off either.
i have a 2002 camry le .. my door ajar dash light comes on when the car has been sitting for 2-3 plus hours in cold weather 30 degrees or below ... its draining my battery .. tried lubricating door latches on all 4 doors and has not worked, came back 3 hrs later and door warning light on dash came back on ..
View 8 Replies2 strange things my 03-04 explorer is doing.
(1) it keeps telling me I have a door ajar. the weird part is, if I turn the interior/dash lights off, it goes away, even after I turn them off and back on. Also, after doing that to get the message to go away, when I turn on my rear defrost, the message comes back on. I've sprayed the heck out every door with WD-40 to try and loosen a stuck switch.
(2) occasionally, when I turn on the rear heat, you can hear, what sounds like a relay, steadily clicking in the rear drivers side of the cargo area.
What either of the two issues might be?
I just bought a 2003 Eddie Bauer Explorer. I keep getting a door ajar message on my dash with a beeping sound when driving. I've opened and shut all the doors to make sure they are properly closed but it does not fix the problem. The interior light will also turn off and on randomly whether the car is on or not. What makes it more annoying is that when I lock the doors the alarm sounds, thus forcing me to leave the car unlocked at all times. I could not find any door buttons against the door frame so can't figure out why it thinks a door is open. How I can fix this or if a code reader will tell me which door is the problem?
View 3 Replies I bought a 2002 F350 Dually Diesel 7.3L Lariat Crew Cab. I had the famous faulty VSM issue that plagued many a 2002 model. Got a new security module and everything worked just fine... Except for the doors. The door ajar light constantly stayed on. I do NOT want to pay my local stealership $140 to dig for my VSM and reprogram it since pretty much everything else worked plug and play.
Hoping it was the other infamous stuck door ajar sensor issue, I've been making my door lock hinges drunk on WD40 with no positive results. This saddened me. Today, though, I made a interesting observation.
The door ajar light goes OFF when both front doors are OPEN. Back doors have no effect one way or the other. I was thinking if I switch the polarity of the door ajar buttons by just crossing the wires associated, that should fix my problem.
when i bough the car i went on a test drive and everything was fine, once i bough it and went home my fiance opened the passanger side door to get in, and every sense than the door ajar light is on and the inside lights will never turn off and its draining down the battery, we have tried slamming the door shut and we just dont know what to do, theres not even a sensor botton to check out theres no way to tell what it could be for me as when i open the door to check out the botton like most vehicles do, there isnt one, what could it be?
View 9 Replies