Ford - Explorer :: 2002 - AC System Low / Luke Warm Air Out Of Driver Side Vents
Sep 8, 2012
Well I was recharging my a/c yesterday because the system was low so I used one of them 24oz cans and now I am getting cold air out of my passenger side and luke warm air out of my driver side vents. Also if I switch to the different vents I don't get anything out of the floor only. I get air out when I select it, but it's coming out of the defrost. Other than that everything else works just fine, just no floor. I've read issues with the blend doors but my vehicle doesn't have the dual climate controls so I'm at a loss...
View 4 Replies
Advertisement
I have an 09 Limited with the dual automatic climate control. It finally got cool enough to start running the heater. The passenger side vents are throwing cold air instead of warm like the drivers side. This includes the windshield defroster. I'm thinking there is a diverter "somewhere" that is not working properly.
View 2 Replies
The A/C on my 2004 Accord has started blowing warm air out of the 2 driver side vents, but still blows cold air out of the 2 passenger side vents. It also occasionally blows condensation out of the 2 cold passenger vents. When this same thing happened last summer, the condenser and compressor were replaced within 3 weeks of each other. It is less than a year later and the same problem is occurring. Even more odd; every once in a while the 2 driver side vents will blow cold for just a few minutes, then revert to blowing warm air. The car does not have dual climate controls.
View 1 Replies
I have a 05 Avalon XLS and I've just discovered an issue with my climate control. It's that time of year that things are warming up so we started using A/C and found that driver's side vents are blowing warm air while passenger side vents are blowing cold. I've tried varied temps and dual mode on and off as well as auto and manual control. Nothing makes a difference. I suspect some sort of thermostat for the driver's side, but I really have no clue.
View 1 Replies
I have a 2002 Ford Explorer Sport and after a brake job I noticed that while under braking at slow speed there would be a grinding sound on the front left. I replaced the brakes and wheel bearings the first time. After a while I ended up replacing the caliper itself but it still grinds. I don't notice any wheel shaking, pulling and it hasn't locked up although once I did notice a some smoke under hard braking but only once. I also don't hear any grinding while not braking.
View 5 Replies
My uncle has a 2002 Explorer and the driver side rear spring is cracked. I have agreed to fix this as he is on a tight budget and has no mechanical skills or tools for that matter.
Anyhow, I did some reading and have two monroe quickstruts to replace the OEM stuff. I did not want to screw around with a spring compresser and everything else. Were in Michigan, and I can only imagine how rusted the bolts are on this. So I figured getting the whole unit with new hardware would be the best route.
Hopefully these are easy questions. (I do not have the truck to look at right now, and will be doing this Saturday Morning)
I have air tools, Jackstands, 2 floor jacks, a bottle jack, and everything else I need at this point including PB Blaster, rags, pry bars, sockets, etc.
1. I am assuming once I get the truck in the air, I will put the frame on jack stands, and use the floor jacks to manipulate each side of the rear suspension as needed. If I remove the three top bolts, and the bottom bolt holding the shock, can I move the control arm down enough to get the old parts out?
2. What are the torque specs if any for the top three bolts, and the bottom shock bolt? I read the top three bolts are difficult to get out due to limited clearance, so I doubt a torque wrench will fit in there.
3. Would you locktite these top three bolts at all?
4. Weakest question of the day, What are the torque specs for the lug nuts.
5. Anything I have obviously missed? I have done front struts before with a compressor so I am somewhat familiar with the process. Just not on this car before.
6. When Im in this far, anything else I should look at. I will inspect the brake pads etc. Drain and fill the rear diff fluid if needed, etc.
I have searched high and low on the net to find a pictorial write up of the process....
View 11 Replies
The driver's window suddenly, and without warning, collapsed and fell into the door while driving. Fortunately, it didn't shatter.
I pulled the cover and found that the lift cable ball for the fwd track had apparently come out of its receptacle allowing the window to free fall. I hate to just reinstall it as I fear it will happen again and shatter the window.
I heard that possibly Ford has redesigned the cable bracket or some part of the system so that the cable ball can't come loose. Need to know anything about a redesigned bracket or a good way to secure the cable ball? This thing is very difficult to reach and work on, especially for a guy with fat arms!
View 4 Replies
My entry pad on the outside of the drivers door stopped working on my 2002 Explorer. Not only does it not open the doors but they don't light up when push the buttons. I looked in the owners manuel for a fuse related to this but did not see one. Which fuse the number pad is controlled by?
View 5 Replies
Just went on a trip to SC. It was hot as hell - 100F most of the trip. The a/c would blow cool (not exactly cold) for a while and then go luke warm (way better than outside but not particularly refreshing) for a while. So I was reasonably comfortable but definitely not cold.
This would happen about every 15-30min where I felt like the compressor had stopped working for a while. I am thinking the compressor is probably limping along and about to die. Usually I thought these things just up and die though. Clogged accumulator? IDK - nothing has been done to the a/c system since 2009 head gaskets.
View 14 Replies
My manual heat/cold adjustment dial is working fine and transitions from heat to cold readily. However when in max heat, it is blowing luke warm. The higher the RPMs going down the road the warmer it blows (still not near as hot as normal), then idling at stop lights or in park it goes back to warm only.
My engine temperature is running normal at all RPM levels while driving and idling. Partially clogged heater core maybe, where higher RPMs force more water through it? I assume its not the water pump or thermostat since my operating temperature is staying normal...
View 13 Replies
When my hvac controls are turned to hot, I'm getting only luke warm air. When moved over to cold it feels like the a/c is on...granted it is 21 degrees here. What I've done so far:
1. Flushed the coolant system at the local COOP TBA
2. Flushed heater core-Both heater hoses are hot to the touch as well as the heater core itself. The hoses are within 10 degrees of each other tested by an infrared temp gauge.
3. Verified the blend door actuator is moving. I can see it spin while attached to the box as well as I pulled it out and plugged it in it will move from hot to cold.
4. Smacked the #$%! out of the blend door box.
The fan still functions as it should from low to high. The truck also gets up to operating temp as usual.
Is it possible the actuator is still faulty even though it moves and not going all the way to the heat side? I considered picking up a replacement but I hate to start throwing parts at it.
Did the blend door give up? The snow is here and I need the heat for those 4am waterfowl hunting trips.
View 12 Replies
My car doesn't blow hot air. the temperature gauge goes up to half way like it normally operates at but the air never get more than luke warm. I changed the thermostat last year with no better results and I just had the timing belt and water pump replaced in July. It been an average of 8 degrees here for the last week.
Its a 98 camry, 4 cyl, Automatic...
View 2 Replies
I am having a heat problem...first my temp gauge never goes above 160...second...my return heater hose is not hot...my upper radiator hose is tight when I squeeze it.
View 7 Replies
I have a SF 2009 Limited. Since I bought it 2 years ago, I noticed the heater blows luke warm air. Not hot. It takes 20min for the cabin to reach 22degC when it's only 0 outside.
It was like that when brand new.
It has the auto temp control, so it might be playing tricks on me but I don't think so.
I am tempted to find the pipe feeding the heater radiator and insulate the pipes. Maybe the heater only gets warm liquid.
What else can I do?
View 4 Replies
I just changes the heater core, water pump and thermostat and I only get luke warm heat coming out of the vents. Did I need to have bled the heater core?
View 3 Replies
I have a weird issue on my 2008 Elantra. The heater starts blowing luke warm/cold air after running for about 1 hour or so and stays like that.
View 9 Replies
Nissan Frontier 2004 with v6, air, automatic 4x4.... I only have luke warm air coming into my truck. The switch on dash switches from defrost to floor or thru dash . Was thinking maybe a switch under dash not working maybe, but do not know where to start looking.
View 3 Replies
My Ford Explorer blows warm air instead of hot air and it's getting colder and my windows get fogged up. I fixed my clicking sound behind the dash.
View 1 Replies
It blows luke warm air, no hot or no AC just luke warm... what could it be?
View 1 Replies
My defrost & front vents work fine. My back vents that are in the back of the console switch from hot to cold like it suppose to, but they do not blow out enough to feel it in the back seat or third row seat.
Also when I use the heat the front flat part of the console by the drink holders especially gets red hot to the point it can melt plastic ink pen or anything else you lay there. which concerns me since I have a 9 yr old.
View 3 Replies
Just had the truck in the dealership for a bad blend door/ heater core case. Heat would only blow out warm on the passenger side, blows cold on drivers side. Dealership replaced the case, heat works normal on both sides now. It was a little warm out yesterday so i turned on the A/C, frosty cold on passenger side, warm on drivers side, temperature does change when i select different temperatures (dual zone.)
View 1 Replies
