The 4x4 lights do not come on. I have check all fuses. I have replaced my module still nothing. I guess I could try another module but dam I am really at a dead end before I have to take it to Ford dealer and get hosed.
View 2 Replies2002 Ford Explorer Sport .. Just started last evening when I returned home .. Closing lights low beam ( yellow & rear tail light ) did not shut .. Bell sounding .. Not dealing with it last night disconnected ground cable off battery ..
This morning took a look .. Connected ground cable too battery. Expecting low beam lights too go on. Did not .
Turning lights on & off. Head lights work fine. yellow and rear stay lit ..
Disconnected battery, OFF .. Reconnected battery cable yellow light stays off until I turn on head lights, and will not shut off from switch .. Thinking light switch ?
Could a burned out fuse in another fuse cavity cause this effect? How can I test ??
I replaced the factory head unit with a aftermarket radio. While making adjustments my battery died, I jumped my battery and now I don't have any dash lights. I found 3 blown fuses that I have replaced, however the only lights that don't work is the dash lights. I replaced the headlight switch and the dash lights are still not working?
View 6 RepliesWe have a 02 Sport Trac that has intermittent brake light problem. All other functions for the bulb filament for the brake lights work! Turn signal and flashers work great. The brake light that is above the rear window works, BUT the brake lights on the rear of the Sport Trac work when they what to.
Right now I can not find a cause that causes them to not work or to work. This morning they worked in the garage but did not work as my wife pulled out of the driveway. Last night they did not work on part of the way home but worked coming into the drive way.
Which fuse controls the parking and license tag lights in 2002 Ford Explorer??? I can't find it in the wording of the owner's manual diagram.
View 9 Replies2002 ford explorer v8 4x4, ok I had some noise coming front the right maybe middle axle area so I pulled the driver's side tire and inspected all the bushings ball joints and hubs. The hub had a little play and so did the upper ball joint. So I replaced the hub thinking this could be the problem and the steering stabilizer bar (all the bushing on the bar where toast). Ever thing was tight but the upper ball joint still had a little play but not enough for me to spend the $ to replace the whole control are (as I am told you cannot replace just the ball joints you have to replace the whole control arm). Any way got it all back together and still same nose. What it could be? Also the four wheel low will not engage could this be part of the problem or one more thing un related ( the four high engages just not the low)...
View 14 RepliesI was told by the dealer it would be over 150 to scan and do a fuel trim on my 02 Explorer, XLT, 4.0, Auto. I can't afford the scan or a garage. I paid 4200 for it and a short time later it starts surging at stop lights then it starts sputtering when idling and taking a while to start. Next it stops accelerating past 2.5k, then works well a bit then stops accelerating past 50 miles an hour. Then it works with an 02 disconnected then starts acting up again. It now either runs normal, wont accelorate past certain ranges, or starts then quits 3 seconds later, unless I unplug the MAF then it runs 15 seconds then stalls. Through all this symptoms come and go. Always banks 1 and 2 lean.
Symptoms
Knock
Rough Idle
Slow Starts
Hesitation
Lag
Stall
Replaced
02 Sensors
Fuel Filter
Injectors
Plugs
Plug Wires
Tested
Maf
TP
Temp Sensor
Cam Sensor
Crank Sensor
All EGR Components
Idle Valve
Coil Pack
For any air leaks.
Fuel pressure 37 or higher
Clean Fuel Pump Strainer
Flow tested pump
Checked air filter
While pulling the bed and dropping the fuel tank to replace the sending unit, I noticed a green wire that had been cut extending out of the harness of wires that connect the rear lights. a bunch of cars were tagged in the neighbor hood and they probably cut that wire. it connects to a black and red wire in the Y at the harness. Where does it go to? Simple ground wire? No tow package on the truck either. Where it leads too?
View 4 RepliesAsking for my Dad. Driving lights suddenly quit coming on. dealer checked fuses - no problem. Dealer (oil change guy) not sure how to access lights for bulb checking or replacement. Says you need to remove front bumper cover...
View 1 RepliesLast week my ABS warning light came on. I took it to a mechanic (who I trust but is not a Prius-specific mechanic) who said warnings are coming up for the anti-lock accumulator and hydro boost motor. However, in July 2011 I had these both replaced. The work was done by a Toyota dealership. I ended up taking my car back 4 times after this work was completed as it kept having braking issues. They replaced the shim kit and bled the brakes. And eventually they replaced the master cylinder (this they did under warranty bc there was no way I was paying them any more money). At no point did they seem to understand what they were doing. (Along the way they broke my windshield and killed my battery.)
Finally by November 2011 my car was driving normal again. And then the warning light and high-pitched alarm went off again last week. I talked to Toyota Corporate who suggested I call the dealer to do the work since technically the accumulator and motor just ran out of their one year warranty. But this is the same dealer that didn't seem to know what they were doing last year.
We have a 2002 Malibu with 216,000 miles. Car in excellent condition and always garage kept. We have used the same mechanic for many years until this year when he closed his shop. We do plan to replace the car next year, but it's just not necessary to do so just yet.
A couple of month ago someone rear ended me and the body shop replaced the trunk weather stripping, rear bumper, light assemblies, repainted the trunk/bumper/rear side panels.
Several weeks ago, while hubby was pulling the car out of the garage I noticed every time the brake is pressed the backup lights come on too. I then checked turn signals, all other lights, etc. Everything else appears normal except this oddity.
I took it back to the body shop and told them what was happening and said it had to be something done during the repair work. He checked and said everything was hooked up correctly and I needed to take it to a mechanic because it wasn't anything they did.
I have researched and researched and found several other people with this problem. One answer was that the new light assembly was after market and the "pins" were not compatible with the original wiring harness. Another was that the wiring harness coming from the trunk was somehow damaged.
I was wondering if there was a DIY mod so I can have my foglights on with my parking lights and my high beams..
View 7 RepliesAfter using the 4wd it's not going back into 2wd,the 4wd lo light is on and I dont hear the "click" when turning the switch. I've had the truck several years so I know how the 4wd works,is there a fuse or something else to try?
View 4 RepliesI just bought an 02 explorer it has a 4.6 V8 it has a bad motor. I was wondering what other vehicles and years I could take the motor out of.
View 2 RepliesI recently acquired an 02 explorer sport. Noticing a loud hum(similar to what knobby tires sound like) at 25-40 mph. Doesn't make noise at any other speeds. I replaced both front hubs, new shocks, new rotors and pads, sway bar links, even tried rotating tires, absolutely no change. Tires are a standard highway pattern , not luggy so I don't think it's those. Kinda lost on what to do next.
View 9 RepliesI have a 2002 for explorer 4wd 4.0 it won't accelerate. it's fine to 25, but it pings, and won't go over 40. I've changed to the plugs, wires, coil pack and fuel filter. I've also checked the fuel pressure, and it's 65psi. no codes are being set. I've been told plugged cat, but they're welded on, and no way to test them...
View 1 Replies2002 explorer 4.0l. No crank just click new starter in and cables hooked to battery...
View 1 RepliesKids called and said the battery was dead, truck would not crank over. 2002 EXP 4 L. Drove 90 miles and checked battery to be o.k. Changed out with my truck to double test... no crank. Decided the starter must be bad. Banged on it with a long pipe from above - no start.
Winched onto a trailer and brought it 90 miles home. Winched it off and pulled to the garage. Looking from above i looks like this is a straight forward solenoid / starter / hot wire to the battery. No switches/ etc in between. Though i would try it one more time ... clicked key on and off 3 times and truck started on the 4th turn.
Tried it 6 times over 2 minutes and it started every time.. I am thinking the starter and solenoid don't owe me much after 11 years and 165k miles. Plan to check the cable and ends also.... Just wondering an specific known problem with the starter / cables before i jump in.
My explorer is stuck in 4wd and no 4wd light is on. How can I get it out. Coz its hard to drive?
View 14 RepliesMy truck has been sitting for a couple of months while I work out an issue with the guy I bought it from. It worked perfectly fine but now it will crank but not turn over. Could it be that the key has deactivated? I looked under the #1 sparkplug cover and found it to be chewed up and the wire shield looks as if it has melted. I understand it could be other things like fuel filter, fuel pump but it acts as if possibly a filter clogged? I realize I am female but I would rather ask here than have a mechanic come out and tell me it's something that it is not. 2002 Explorer Sport ....
View 2 RepliesI just replaced the trans in my 02 sport trac and have no speedometer and ABS light is on now. I made sure all connections on trans were tight and I didn't mess with speedometer sensor seeing how it is on the rear diff on this truck. spent two weekends replacing this thing and am not at all happy with the results. By the way i did it all on my back. No vehicle lift or trans lift.
View 8 Replies