Ford - Explorer :: 2000 XLS - Cruise Control Not Working
Sep 21, 2011
Cruise control is not working on my 00 Explorer. The horns were not working as well so I assumed the clockspring at first. Upon checking out the underside I found that the horns were not grounding properly. Cleaned up some rust and installed new ones. Good as gold. The cruise is still a problem though. The lights are also out on the steering wheel. I checked all the fuses associated with it and they are all good. What else could be the cause of this. Clockspring still possibly?
View 1 Replies
Advertisement
On my in laws 2000 explorer the cruise control does not work. When driving and activating the cruise control (on, then set), the cruise-control dash light comes on for a fraction of a second and goes off again. Tried it at freeway speeds.
Any clue ? I heard there is a separate brake switch for the cruise control and one for the brake lights. The brake lights operate normal. Could it be the other switch ? If so where is this switch ? Under the dash or under the hood ?
View 7 Replies
I have a 1994 Ford Explorer and the cruise control stopped working about a year ago. The horn still works. I changed the fuse but it's still not working. My mechanic checked the cruise control, and was able to determine it was either the clock spring or the control module located above the glove box. He told me it was most likely a bad clock spring, especially considering the number of miles on the truck (385,000). However, in speaking with a Ford dealership parts department, the '94 Ford Explorer does not have a clock spring. So, I'm back to square one.
View 3 Replies
I have a question on my '00 7.3. Cruise control just quit working. From reading the threads/forums I have gotten some ideas, but how about no dash light when turning the key to on? Nothing with the self test also. How can I troubleshoot the switch in the steering wheel? I could also have a bulb out in the cluster, but either way- no cruise function.
View 4 Replies
My 2000 4.0 XLT Ranger has been without working cruise control for several months now. I've checked what appear to be likely related fuses and they're all good. I *DID* have a recent problem with my brake lights but that's been fixed. (The shop that replaced my rear leaf spring hanger brackets pinched a hot wire between the brackets and the frame which eventually shorted. Wire and fuse were replaced.)
A few years back, Ford had a recall related to the Cruise Controls causing fires. I had the recall service performed on this truck. In a nutshell: The switch to disengage cruise when braking is attached to the master brake cylinder, and a leak in the switches diaphragm allows brake fluid into the switch causing an electrical short, causing the wires to heat up, and in some cases causing a fire. Ford, instead of switching to a different switch design (like maybe a mechanical switch on the pedal?) put a fuseable link in the hot wire from the potentially leaky switch.
Well, the truck now has over 150K miles on the factory brake cylinder/cruise control switch. I'm suspecting that my switch finally leaked, shorted and blew the fuseable link. Would Ford fix it? (They should, considering the lame fix for a lame design flaw.)
View 6 Replies
I did the diagnosis,on my non working cruise control on my 2000 f250. The cruise light came on when, I, depressed the off switch and turned key on. I depressed on switch,cruise light came on.
I then depressed the resume, coast, and set switch, as described in the diagnostic procedure,suggested,and no light came on. Do the switches for the cruise control are bad.
I have checked the fuses at the power distribution box under the hood and checked the fuses under dash,all are fine. I just replaced the switch at master cylinder, as it was leaking and it had the recall switch replacement, too.
View 8 Replies
Our cruise isn't working, I've read through the posts here and tried a few things
2000 F-250 V-10
-First symptom was the cruise light would light with the ON button and go off with the OFF button but I could not set the speed with the SET button. Now the cruise light hardly comes on at all any more.
- I've run the cruise self-test diagnostics and all the switch presses passed with no additional light blinks. After the static test the speed control servo makes a sound but does not move the throttle at all.
-The horn works
-Fuses are good
-Truck was taken to the dealer several years back for the cruise update. The pigtail with the green label is installed at the master cylinder. I've disconnected both connections and sprayed with contact cleaner.
That's about it. What it could be or what to test next?
View 10 Replies
Was hoping to get confirmation on a fix I intend to repair.
2000 F350 SuperDuty 7.3l Diesel 4x4
Cruise isn't working...... lights won't even come on and nothing happens at the switches.
This morning I put in a new airbag clockspring ...... just requires patience but not too hard to do.
That didn't resolve. Was going to put in new cruise switch at the brake master cylinder.
My question is would that part prevent the cruise control from even turning on at the steering wheel controls? I don't get any light or anything when I hit "on".
I checked literally every fuse in the under dash and under hood boxes. All are good. Is it likely it's the cruise switch?
View 8 Replies
2000 F250 Super Duty cruise control not working. I looked through a lot of threads on this subject and cannot pin point my problem. Cruise control was working, had to slow down wile approaching a town, back on the highway and now it won't turn on.
Looked at the brake pressure switch, it was till good but was the old type but had the recall harness on it. Bought a new one and replaced it anyways. Still nothing. All my brake lights work, I also did the Cruise control diagnostic and it passes everything. No lights on my dash are on, speedometer works, horn works.
The only thing I did not check is the Vehicle speed sensor. Even though my speedometer works and my ABS light is not on, can this still be the problem? If so how do you test it? Do I just remove it and test continuity?
View 10 Replies
The cruise control on my 2000 Blazer LS 4X4 is not working. I just changed the multi-function switch and still nothing. I looked at the throttle cables and they seem to be fine. All the fuses are good as well.
View 4 Replies
I have a 2004 Explorer with the V6 engine. Twice I have had the engine die while I was setting the cruise control at speeds around 35 MPH. I shift into neutral and it starts right up but it sure startles you when it seems that you can't turn the steering wheel. What causes this?
View 1 Replies
I drive a 2005 Ford Explorer (automatic) with 84k miles on it. Recently when I was driving on cruise control at 35 mp/h down a hill and applied the breaks to make a turn, the engine completely shut off. The lights came on, the power steering went off, the engine had shut off. I pulled over, turned the key off, turned it back on and it started no problem. I drove it for 3 days without problems (and without using cruise control of course), then I took the car to a shop. They ran diagnostics on it, test drove it, but couldn't find anything wrong with the cruise control or the transmission. I don't think they tested this driving downhill as the shop is not in a hilly area. Tonight, I went down the same road again, 35 mp/h in cruise control, slowed down for the same turn, and the engine shut off again exactly the same way it did before. What this could be?
View 7 Replies
My college son's 2014 Charger V6 has developed three issues since he purchased it used in late May. The cruise control has stopped working and the anti lock brake and traction control lights are constantly on. Any possible cause?
View 15 Replies
So I've been away a long time. My sister recently bought a 1997 Ford Explorer with the V8. When she tries to turn on the cruise she says it throws the transmission in to neutral and then locks the gas pedal...
View 5 Replies
Have this problem?
View 2 Replies
I had had intermittent issues with the cruise control not working in my excursion. most of the time it was fine though. after a recent 150 mile trip it stopped working half way through. i didnt worry about it too much..got back into town and checked under the hood. i found brake fluid running down the inner fender well! all over everything under the master cylinder. finally tracked it down to the cruise control switch on the master cylinder leaking. I pulled the plug apart and it was full of brake fluid.
Meanwhile the master cylinder was about half full, so i replaced it with the same switch out of a '96 parts explorer which is the same part luckily. also yes i have had the cruise control recall done. So if you have lost CC and you have a leak replace the switch! seems it can leak..and at a pretty good rate..alittle scary! glad i figured it out before my 800+ mile trip later this week/weekend.
View 5 Replies
My 04 f150 fx4 has some cruise control issues. The cruise doesn't work at all and the self test doesn't do anything on my truck either. I tested the disengage switch which tested good but replaced it anyway. I've checked all brake lights and replaced the 3rd light which was burned out. I've unplugged the brake switch and reconnected in case of loose connection with no luck. I removed the brake switch and tested as follows.
Top to bottom pins 1-6 for sake of this discussion. Pins 1 and 2 no continuity until brake button is pressed. Pins 3 and 4 are blank so no test performed. Pins 5 and 6 tested the same as 1 and 2 so am I correct in saying the switch is good? My truck will shift through all gears and back without ever applying the brakes. Bad shift interlock inside the shift console? I haven't torn into that yet but it's the only thing left I can think of. Is there any tests to be run on it with a multimeter?
View 1 Replies
My 1997 Aerostar's cruise control is not working. Horn is functional however. I've checked fuses and they seem to be ok. What could my problem be?
View 10 Replies
Looking for any pointers on fixing my cruise control Have looked around under hood but what it looks like. I've got the air working again,put Warn hubs on and have ordered the Hellwig rear sway bar,adjusted steering box i/2 turn....
View 14 Replies
The cruise control in my recently purchased '01 Excursion isn't working. I've done a lot of searches and discovered there was a recall for a wiring harness: 2001 FORD EXCURSION Recalls
I called my local dealer and they stated there aren't any open recalls for this vehicle, so the previous owner must have taken care of it.
Is there any way I can verify that the warranty work was done? Can I visually inspect the harness? What else I can check to fix the cruise control? The lights on the steering wheel are illuminated.
View 14 Replies
I have a issue with my cruise control not working. The Ford dealer in my home town has had my truck for 3 days now and cannot figure out what the problem is. I finally went by the dealer and wanted to know what the deal is and how can this take so long to figure out when they have to of seen issue like this in the past. The tech that is working on my truck said he has traced wires,etc and think it has something to do with the after market JVC touch screen DVD/backup camera. My question is would this affect the cruise? I cannot find anything on the net that may point in that direction. The steering wheel controls work for the fan and temp controls but not the radio as its aftermarket. Radio adapter for the controls?
View 14 Replies
