Ford - Explorer :: 2000 - Trembling On Acceleration
Jan 11, 2015
My 2000 explorer is trembling when I begin to accelerate. This does not happen when in idle. Why this is so.
View 5 Replies
Jan 11, 2015
Advertisement
Ford - Explorer :: Rattling Or Trembling Sound As About To Shut Down
It's a 2002 Ford Explorer with 93000 miles. When sitting in traffic, for instance, my vehicle makes that little rattling or trembling sound as if it's about to shut off. However, it never does turn off on its own. But I'm curious what's causing that sound.
View 11 RepliesFord - Explorer :: 2000 - Cylinder 3 Misfire Persistently / Engine Stumbles And Has Poor Acceleration
I have a 2000 Explorer 4.0 SOHC that I'm having a persistent problem of cylinder 3 misfire. I've changed plugs with Motorcraft plugs set to the proper gap, put on new wires and have checked the resistance across the ignition module, both primary and secondary without change. I doubt that the problem could be the ignition control module as only cylinder 3 is affected. I have Auto Enginuity that I use to read the codes, attempt a repair and then clear the codes only to have P0303 appear again. Obviously the engine stumbles and has poor acceleration.
View 14 RepliesPassat (B6) :: Trembling When Accelerate While Driving On Highway
Just got my H&R's put on this week and it felt GREAT! But today as I was driving on the highway (stop and go) then road began to clear up, I felt a tremble (Shimmy) coming from the front of the car. I pulled over and checked to see if wheel lugs were safely secured and they were also check to see if there was any play on the top of the front shocks and they were ok I don't feel it in the steering wheel, I only feel it coming from the front. This has only happened once in the past but only when the car was parked with the ebrake on, but it was a very subtle tremble, I was wondering if it may be a motor mount that is either worn out or loose and or it will need a alignment given that it wasn't done after the suspension got put on.......
View 9 RepliesFord - Explorer :: 1992 - Self Acceleration Between 15 And 25 Mph
Why is my 1992 ford explorer self accelerating between 15- and 25 mph?
View 1 RepliesFord - Explorer :: 2000 - Engine Vibration Beginning At About 2000 Rpm In Park
I have been picking at an engine vibration for more than a year.
I have a '00 Explorer 302 V8 installed in an '82 Volvo. This engine/transmission has not been abused and only has 15k miles since it left the Ford factory. It was found intact on a pallet in dry storage. Everything was there as from Ford from the fan to the transmission output bushing. There is an engine vibration beginning about 2000 rpm in PARK so the problem is not in the transmission or drive shaft.
Perfectly smooth at idle and until you approach the start of the vibration.
Replaced the viscous clutch mechanical fan with duel electric so it isn't an out of balance fan.
Pulled the serpentine belt this afternoon and still have the vibration. Might have been a little less and I did find a idler pulley that had a little rattle but the big vibration is still there with only the harmonic balancer through torque converter rotating.
Replaced the pulley. Nothing else changed from when Ford built it.
No OBD codes.
Tiguan :: Shaking / Trembling At Warmup Idle On Cold Mornings
Having issues on cold morning starts where the car is shaking/trembling at warmup idle? Obviously this problem isnt as prominent at this time of year...
View 5 RepliesMercury - Tracer :: 1994 - Engine Started Trembling On 5th Gear?
I have this excellent little car which has not given me any headache on its 210K miles so far. In the last four mounths, however, I started to notice that the engine starts kind of trembling on 5th gear and loses its power as if sothing chokes it, if I keep pressing the gas pedal it will make it worst, but once I let it go or shift down to 4th gear it reasumes normally for a while and then comes back again. I was told this could be a ignition coil or an axle problem.
View 2 RepliesFord - Explorer :: 1996 - Sputters At Acceleration
My 96 Explorer has been sputtering on me. I took a right turn one day and now its sputters at acceleration. It has a new fuel pump, filter, injectors, coil pack, plugs, wires, idle sensor, EGR valve. Also, all vacuum lines are good and not cracked or broken. My mass air flow sensor is also clean and clear. I have done all my own repairs on my cars and trucks all my life and thought I was good at it (not so sure about that now).
View 1 RepliesFord - Explorer :: 2002 - No Acceleration On The Low End Gears
I have an 02 5r55w 2wd that I'm on the fence about right now and not sure if I should try and fix myself or pay $990 for a used one with unknown miles and 90 day warranty..
I bought it with 160-164k with no 2nd gear, OD flashing. Took it apart, replaced some bands, planetary, servo piston(end broke off-think OD.
After that, everything ran fine. NOw at 195k it's doing the I believe 2-3 high flare, rpm's go up to I think about 4k before shifting, sometimes more.
It has no acceleration on the low end gears, sounds like a dang 18 wheeler in it's low gears taking off, then I believe when int band kicks in, it picks up some torq and speed and shifts fine after 2-3 (not always does it-mostly when having to dump on the gas a bit).
Had issues with it jumping forward while on the brake. I've been in an 03 explorer with a good trans and could tell right away mine is pretty weak...
I was looking at the servo bore sleeve piston fix for $200. Maybe that and a shift kit, would that fix the issues I'm having right now? I haven't had any OD flashing or any check engine light codes. Haven't hooked it up to check codes, not sure if it logs if it doesn't flash check engine first.
I'm starting a business and will be pulling a 4x8 and need to get this one replaced or figured out.
Ford - Explorer :: 1995 - Idle And Acceleration Rough
I have some major problems with my explorer. The idle is rough and accelerating is rough also. If I nearly put it to the floor it almost seems like it studders the power. it will feel great for a second that feels like it's less power for a second then more and less and more and less. When I'm sitting at idle, it will idle fine then after a minute or so it will bog way down and shake the whole vehicle. when that happens I give it some gas and it comes back to normal idle then it does it again after sitting for another minute. I've replaced spark plugs, wires, alternator, oil change and some tires. I've been told by many mechanics it could be the IAC Valve or the fuel pump or the fuel filter or a vacuum leak.
View 8 RepliesFord - Explorer :: 2006 V6 - Sputters / Loss Of Acceleration
I have a 2006 Ford Explorer 4.0 V6 that when speed up around high 4 gear entering 5 from what I can hear (it is an automatic) it sputters slightly and you can feel the acceleration kinda die or cut out for a millisecond. I connected the OBD reader and no codes. I noticed the check engine light came on and then off so I replaced the spark plugs replaced and transmission fluids, checked all fluids and leveled them then replaced the fuel filter while I was at it. Drove around for a day like normal did about 50 miles no lights came on but then today while driving in the morning when I accelerated to around 55-60 entering 5 gear the car did the sputtering and loss of acceleration again and no lights or codes.
View 2 RepliesFord - Explorer - Noises :: Airplane Propeller Noise That Comes And Goes With Acceleration
Over New Years I had to engage the full-time 4x4 button on my 2003 Explorer 4WD. Shortly thereafter I started noticing an airplane propeller noise that comes and goes with acceleration. It's pretty loud. It has not affected mileage or dashboard engine indicators. Tires still have 40% left, not them. Have I ruined an axle or something? There is a rear end whine that Ford says is endemic to this model and year, but I think they are not related.
View 1 RepliesFord - Explorer :: 2007 - Started Shaking At Idle And Acceleration?
I have a 07 Explorer with the 4.6 that just developed a problem. It has 75,000 on it and has all of sudden started shaking at idle and acceleration. The acceleration issue doesn't seem to occur until after 45mph. I have cleaned air filter and MAF sensor. Still need to put a code reader on it. Where to start troubleshooting.
View 3 RepliesFord - Explorer :: 2007 - Grinding Sound Felt In Gas Pedal Upon Acceleration
2007 explorer makes a grinding sound I feel in the gas pedal upon acceleration. Also hesitates when acceleration on highway.....
View 3 RepliesFord - Explorer :: AC Working Intermittently Under Acceleration / Worse In Stop And Go Traffic
My AC is working intermittently, best under acceleration, horrible in stop & go traffic. The dealership told me I need a new compressor clutch but the written estimate was to replace the whole compressor assembly. Replacing just the clutch isn't too bad, is it? I'm pretty handy and do a lot of my own work but I typically avoid the AC system. Replacing just the clutch doesn't involve draining the coolant or anything, right?
View 1 RepliesFord - Explorer :: 2004 - Acceleration Responding Slow / Tick Or Tap Coming From Behind The Dash
We have an 04' Ford Explorer NBX 4x4 (auto). We are not the original owners. It has a several issues.
1. Acceleration seems to be responding a little slow when I depress the accelerator pedal. Like a lag of some kind. Engine appears to idle and run fine. Just that subtle lag from gas pedal to engine response. No trouble codes
2. There is a tick or tap coming from behind the dash. This morning as soon as a put the key in the ignition the ticking started but went away after a few minutes on the road. But comes back when I come around turns (like a rounding off ramp from the HWY). Cannot figure out what it is. No trouble codes.
3. My transmission (4x4 Auto) when cold is fine, but when it warms up it seems to go into 4x4 mode and wont come out. All I have to do start going up a subtle hill (or incline) and it engages the 4x4 (at least that's what it feels like). I can hear the sound of gearing. When the transmission shifts it thumps really hard. At low speeds when I let off the gas it thumps really hard. We took it to the tranny shop and they said it was the rear end.
So we had that rebuilt. It was ok for a couple of months (rarely drive it). But it is doing it again, but seems to be getting worse. When in this mode it seems to feel like its dragging. We recently serviced the transmission filter. Replaced fluid. We reset the computer to relearn daily driving. But didn't work.
I was thinking of replacing the 4x4 module and or solenoids in tranny, or 4x4 motor on transfer case, but I don't want to spend money if it doesn't fix the problem. No trouble codes. Are all these issues related to one another? Is one issue causing the other problem to exist?
Ford - Explorer :: 2002 - Hesitation / Jerkiness And Rough Acceleration After 1st Stop - Air Sound?
The problem starts after about 5-10 mins of start up and normal driving. First signs usually come leaving a stop light or stop sign. Hesitation, jerkiness, rough acceleration. It's usually slight, just enough to feel it. Soon it really shows up while keeping the truck at a steady speed, say 40 for example.
I finally heard what I would describe as a puffing air sound and figured vacuum leak.. finally! Nope.. it's coming from the rear underneath of the vehicle. I can't hear it in the engine, or the tail pipe.
2002 Ford Explorer xls 4.0 125k miles, I've replaced the air filter, egr valve, pcv valve, cleaned the maf and covered about every hose I can reach with carb cleaner checking for a vacuum leak. I've yet to try some of the other things due to hearing that puffing sound.
Accent LC (2000-05) :: 2000 - Misfiring Upon Acceleration And Engine Revving
I have a 2000 accent. Automatic tranny with 167000 miles. My current problem is the car is misfiring upon acceleration and engine revving. I have to accelerate very slowly to minimize this but i once the engine revs up enough I can give it more gas and it will rev normally with plenty of power. I have had to unplug the maf to keep it driveable. Ive never had a car stay running after disconnecting the maf so this is strange to me. My accent barely stays running with the maf connected. I just got the car from my dad and he had it fixed and it ran good for awhile with the maf connected so I don't think it is the maf. But the same problem came about and we had to disconnect the maf again. And he cant remember or is not sure what was exactly fixed on the car. I've read up about the purge control valve and havent had a chance to check it out but some of the symptoms fit.
View 21 RepliesFord - Explorer :: 2000 - Idle Goes Down To 900 And Then To 600?
I have a 2000 Explorer, 4.0 V6 SOHC w/ 135K miles. All of a sudden it has an idle issue that's driving me nuts and the dealership can't fix. It has been in the shop 4 times for this problem so far.
It accelerates and cruises great, but when I come to a stoplight, the idle goes down to 900, then suddenly drops to 600 and idles rough. The "Check Engine" light is NOT lit. There is no hesitation, backfire or any other running problem. I have had plugs and wires, PCV valve, IAC valve and MAF sensor replaced. Technicians have checked for vacuum leaks and intake air gasket leaks and have found nothing.
I can "power brake" it and smooth it out some and even turning on the a/c or defroster boosts the idle and works a little. Shifting to neutral or park does not raise the idle like previous cars I owned. I only drive this car back and forth to work, about 1000 miles a month, and I'd like to make this Explorer last at least 200K miles. We just got a Ford Escape and I do not want another car payment right now!
Ford - Explorer :: 2000 - Won't Start - It Sputters
I'm fixing my mother's Ford Explorer 2000 it turns over but won't start it sputters and everyone smile you hear what sounds like a small backfire.
it seems to be getting good spark I can get it to start for a little while and run on either. So I'm assuming the plugs and wires are working well they look good. When I tested the spark it looks very good.
ECM fuses look good able to use a scanner Jump fuel relay and can hear pump run I made sure there is gas in the gas tank