Ford - Explorer :: 1999 - Loud Clunk / Thump Noise - Shifts Into Drive And Revs But Won't Move?
Jan 1, 2014
My boyfriend bought a 1999 ford explorer, he put about 2,000 miles on it in four months... I believe it now has roughly 110,000... Now the other day, he was pulling out and shifted from reverse to drive, we heard like a loud clunk/thump noise... It shifts into drive, and revs but won't move, it feels like neutral... If you shift to second, first, or reverse it's fine... Tranny fluid is good... O/D is always engaged...
View 3 Replies
Advertisement
2002 ford explorer 4x4 150k miles when i put it in reverse a loud clunk noise but when put in drive no clunk noise. But on highway when its shifts a very loud clunk and like a real hard shift !!!!!o/d light is flashing also .transmission shift solenoid ? rear ?
View 8 Replies
Our excursion usually sits unless we are towing or need to haul a group of people. The past three days my wife has been using it as a commuter. Yesterday she told me that two times at start-up she has heard a loud clunk/thump sound coming from the rear of the vehicle. At first she thought it was happening when she engaged the brake to put it in drive. Today she called me and told me the sound came just after start-up while the vehicle was warming up before the brake was applied. What this could be? I wish I would have observed it so I could give more details.
View 2 Replies
1999 ford 4x4 ranger,auto trans and abs. My pick up would not move in either drive or reverse until i gave it a lot of gas. then after a loud clunk sound from underneath, it took off and drove normally. my mechanic said if the tranny is a quart low it will do that. i checked the fluid and it has too much fluid
View 4 Replies
My wife's car, '06 explorer 4.0, experienced trans. slipping issues last year. The trans was replaced under extended warranty. Now it's doing the same thing. Warranty expired. The dealer claims they can't find a problem. It does it when you slow down at a light and then accelerate without stopping, or going around a corner and accelerating. It shifts but requires more rpm to move. Almost like I am dragging a piano or something.
View 2 Replies
Alright so a friend of mine has a Ford Explore with the little switch on the dash for auto 4 wheel, high 4 wheel, and low 4 wheel. When it is in Auto it has no issues drives fine and good. As soon as you turn it to 4 wheels high and start to go all you get is a loud clunking noise constantly. Another friend had a similair issue with an AWD explorer that we just pulled the front drive shaft and it seemed to solve the issue. How would I test the driveshaft to see if that's the issue.
View 2 Replies
I have a 1997 Nissan Altima that I just barely got and it has started to show signs of trouble.
Sometimes when I put the vehicle into drive and step on the gas the car will not move and instead the engine will rev.I'll put the car back into park and then into drive and it'll work fine.
I checked the ATF, which was incredibly low and refilled it. The engine oil was also very low, which was refilled. The problem still persists. So I decided to add a bottle of Fuel Injector Cleaner to the gas tank.
I took the car for a short drive and nothing happened aside from the fact that the Check Engine light now comes on and off. The car also idles between 1000-1500 rpms.
View 19 Replies
My problem is that my explorer, 130,000 miles will not engage in any gear while in 2 wheel drive or 4H. Truck will only engage in 4L. And when it does engage in 4L it hesitates and jumps into gear, especially drive. Also takes some doing to get it out of 4L. While truck is in 2 wheel and in drive, my speedometer reads about 20 mph with truck not moving. It does not do it in reverse. Also gears will grind when I attempt to put vehicle back in park because of it registering that I'm doing 20. Dropped pan and changed tranny fluid and filter. No change. Also not hearing transfer case engaging while I shift between auto, 4H and 4L. Really need this truck fixed ASAP, and need to do repairs myself.
View 2 Replies
I've just bought a 2005 Prius, 142k miles. It's a great car, and frankly with any 'new' car I buy I always worry about new sounds. This time it's 'clunk' or 'thump' noise when shifting from D to R and vice versa. It doesn't happen all the time, but it's a noticeable noise that can be felt as well.
View 7 Replies
Ok just needing info, am I about to have any major issues as my truck is making a loud rhythmic squeaking noise when I move at any speed that is lower then what the speedometer will register (5mph or less) should I be concerned about the noise? It only occurred when I'm at very slow parking lot speeds....
View 8 Replies
I'm using the 2011 Santa Fe.Got few question to ask.
1.When start to move there is a thump noise and sometimes it feel like going over something from the rear area.Happen only when start to move.
2.Using the keyless remote. Sometimes push the rear trunk button to lock and arm the car there but will be a beep sound continuously. Sometimes the rear trunk button are unable to open or arm the alarm system.
View 3 Replies
I have a friend who called me today, she has a 1999 Explorer Sport with over 200,000 miles on it. She said she was coming home the other day and as she was pulling into her driveway she heard a clunk then the steering kind of locked up, and it felt like a tire was dragging. She moved the truck later and said that it goes forward and backwards fine but grabs and skids while trying to turn.
She called her local mech, and he thought the diff could have given out on her and is basically acting like a locked diff rather than open.. I think the front axle must have somehow engaged, and is stuck.. So my question is this, how does the front axle on a explorer engage.. I know on Jeeps and Chevys there is an actuator that moves an arm that moves a sleeve that engages both sides of the axle. Does ford work the same way?? It would seem to me that if the truck is going front and back fine the diff itself should be ok?? The xfer case was replaced about 3 years ago.
View 3 Replies
I am trying to track down where exactly a clunk is coming from on a 2003 Explorer 4x4(auto, hi, low). My buddy brought it by my house yesterday and i cannot pin point it. If you put the truck in reverse, once you hit the gas, it clunks pretty loud. If you just put it in reverse, let off the brake, it will not do it until you hit the gas.
I got the explorer up in the air and crawled under it. I had my buddy switch from forward to reverse, and back again. Every time he let off the brake in forward or reverse, it would clunk. The reverse clunk was definitely louder.
It does the clunks in all settings, -auto,hi,low. No flashing dash lights. The dash lights do come on accordingly. One thing he pointed out was the Auto,HI,Low Buttons themselves are not backlit anymore. Not sure if that has anything to do with it?
I cannot narrow it down as the whole transfer case, front driveshaft and front diff, shake with the clunk. U joints don't seem to have play (prying with small prybar). I then went ahead and unplugged the big wire connector at the transfer case and the clunk went away.
View 3 Replies
I took my truck to an alignment shop to have him look over my truck to find a steering wheel jerk and a loud clunk noise. He believes it's in the transfer case driveline. Said to remove the driveline then drive it around and see if it goes away, if it does then that's the problem. So to the question, how to properly take this out? Do I need to make marks with a paint pen anywhere to line things back up or does it matter?
View 14 Replies
I have a Ford Explorer that my mechanic says needs a new trany. The vehicle takes a while to engage in reverse and does so with a loud clunk. Otherwise it runs good. I have 198K mi. It's an "02 4wd. Their asking $2,100 for the rebuilt trans. Wondering if it's worth it? May have reached the end of the line on this vehicle?
View 1 Replies
Started up the 2002 EXP today and thought the fuel pump was failing. Get a consistent thump every 1 second. Later today i looked and noted the noise is coming from drivers rear fender well (i think). I took off the small plastic cover of the rear blower motor and thought it was in that area. Disconnected the motor and still thumps. Disconnected the blower motor resistor block and still thumps. Looked at the overhead consol and the rear blower was on HI. Turned the blower down and as you reduce speed the noise volume is lower. Turned the switch off and i thought the noise was gone. Pulled the cup holder above the fender well looking for a relay or something in that area. I cant isolate the noise but seems to be real close to that area. Later i heard the noise, very faint, and the blower switch was off. Turned it to 1-2-3 and it gets much louder. Turned it off and very slight noise. What am i looking for? My hearing is not accurate enough to find it.
View 2 Replies
Can the power window regulator motor on a 96 Explorer be repaired? I can hear the motor make a thump noise but it is bound. I have seen videos on earlier model Fords where the motor can be taken apart and the plastic spheres can be replaced but I didn't know if that can be done on a 96 model.
View 1 Replies
Ive got a 04 f350 that after u shift into 4hi or 4lo when u accelerate it it makes loud clunk noise in fwd or reverse hi or lo. With hubs unlocked it still clunks. Have checked, wheel bearings, axle U-joints, and driveshaft joints all good. So I am thinking I've got issues in t-case. Popped drain plug out and wow that dex merc 4 looks nasty. So thinking I need exploded view of transfer case.
View 4 Replies
New truck 11000kms ago thats done medium amount of work but nothing heavy or sustained for long periods of time. I get the feeling of clutches slipping especially when truck is cold but also when normal temps. Doesnt make any weird noises or anything. I can really notice the difference in torque if in manual mode being much better, but still not perfect if i stomp on the gas pedal and go through the gears in manual mode will still slip. Also is really harsh shift if i come to a halt in 3rd manual mode with the brake pedal depressed push minus button the truck makes very loud clunk noise into gear 2 then 1. Took it to ford they couldnt find anything ? Thinking of trying another dealer.
View 2 Replies
I have a 99 jeep grand cherokee. Started car up and there is a shrieking loud noise. the car worked fine when i drove it yesterday. the steering wheel will not move. i looked under the hood and the steering wheel fluid is completely drained. do i just need fluid? what is the shrieking noise?? It's sunday so i'm unable to contact dealership or get the fluid that i was told i can only buy from dealership.
View 1 Replies
My 1998 Volvo V70R with only 53,000 miles (I'm the original owner) has picked up a problem. It started a year ago and seems to occur only when I do not let the car warm up for a few or several minutes: once I put the car into drive and start to move -- no matter how slowly -- a loud, high speed whirring sound begins. It will last for a minute or two and then stop. The speed of the whirring is constant and is not affected by how fast I drive or even if I come to a stop. It happens in both cold and hot temperatures. The whirring does not occur if I start the car and just let it idle and warm up. The loudness of the sound is such that it can be distracting to pedestrians 40 feet away. Changing the oil hasn't worked. More recently, the noise sometimes reoccurs in the middle of a drive. It always occurs when I start the car after it's been sitting for a few hours or more.
View 2 Replies
