1998 explore will not start when hot will turn over sputter and die, after 15 minutes it will start right up that was last monday when it was 80 outside it now colder outside has not done it again, the only thing i have seen that temp gauge is not going past cold never getting to center it will try and drop back down...
View 11 RepliesI was told by the dealership that the battery was bad and needed to be replaced ( which I did) I went out to my car this morning and had the same problem. When I turn the key nothing happens. When I turn the key you hear a click but that is it.
View 3 RepliesHas happened twice now but last night I had to disconnect the battery. A few years ago the driver's door switch was replaced for the same reason. I would do it again but I can't find anything that looks like a switch. Where that thing is? It is a '98 Explorer XLT.
View 4 RepliesI have a 1998 Explorer XLT V6 (4.0 SOHC) with an AC problem. The AC compressor will not turn on via normal means - turn to AC or AC Max, rotate temp to left. It hasn't been a problem as I never use the AC, but I'm fixing a few of the minor inconveniences (dash lamps, re-solder radio) and figured, why not look at the AC too.
A while back my mechanic said he used the Explorer to test his AC equipment and made sure the Freon was good. He said everything was working. I am assuming he was able to control the AC system from his tools under the hood. This tells me the system is good and the problem is related to the temperature control or a switch somewhere.
I drive a 2005 Jeep Liberty with about 96,000 miles on it. A couple weeks ago, the Jeep had some trouble starting. It would crank and turn over and then sputter out. I tried it again and it did the same thing. After letting it sit for a couple minutes, it started and ran fine. No warning lights or anything on the dashboard and nothing that seemed unusual. A couple days later, my wife noticed a small pool of pink fluid on the floor of the garage where my Jeep parks.
So I took the Jeep in to get it looked at. They said there was a leak in the coolant line as well as the pinion system, both of which they repaired. Since then, the Jeep has done this 3 more times, usually from a warm start. If it's been sitting for a few hours, it starts without a problem. But if I'm running errands, then the third time I try to start it, it will fail until I let it sit for a couple minutes. Then it will finally start up. What it could be before I take it back to the mechanic?
We bought it and the dude that owned it cut the radio wires and messed with the wiring everywhere because he thought he had a short. I've hooked up the radio and everything and it does the same thing. How do I bypass to make it stay running.
View 10 RepliesThe right turn signal on my 1998 Ford Explorer recently stopped working. The flasher was making a horrible buzzing sound when I tried to signal right, but worked fine signaling left.
I just replaced the flasher, which has cleared up the buzzing noise when trying to signal right. The flasher clicks like it's supposed to, but the lights still do not flash.
Here's a summary of the current symptoms:
-Hazard lights work fineFlasher clicks; interior indicators flash; exterior lights flash
-Left right signal indicator works fineFlasher clicks; interior indicators flash; exterior lights flash
-Right turn signal does not work
-Flasher clicks
-Interior indicator stash off; exterior lights stay off
What to check next???
I have a 1998 Ford Explorer. It was running fine until last Mon. On my 3rd start of the day , it wouldn't stay started long enough to get into gear; sometimes it sputtered violently. I tried starting over the next 2 days with the same outcome so I towed it to mechanic. They replaced spark plugs, wires & started (because it was throw lower voltage than normal). It ran fine the short distance home. The next day, it started fine but sputtered in corners/lower speeds. About 12 miles into the drive, which was at ~60 mph, my auto died and wouldn't start again. What's going on? Could it be the fuel pump?
View 1 RepliesMy '98 was running fine. It had 272 miles on the tank of gas (from full) when I parked it nose down in the driveway last night. Went to start it at 5:40 in the morning and it would crank fine but wouldn't start. I'm thinking all kinds of things could be wrong. Finally checked for fuel at the fuel rail and nothing. Woke up the wife to assist. Had her turn the key to "ON" and the fuel pump sounded dry.
Put in a couple gallons of gas I had for the lawn mower and it fired up. Gas gauge was about 1/4 on level ground before adding gas. I talked to everyone at work who has an Explorer and they all have had the same thing happen. I'm hoping the fuel pump didn't get damaged from running dry.
I've never had this happen with my Ranger. It happened once on my Aerostar, but it was extremely low on gas and I let it sit idling in the driveway for a long time to bleed the cooling system. Normally, I get gas at 1/4 tank.
I have a 1998 Explorer XLT with the 4.0 sohc engine.
Recently the truck started being difficult to start and takes a few times of cranking to get it going. Once running, it idles and drives fine on city streets and freeways. When trying to start it turns over fine but doesn't start. After a few times of that, it will finally start. Sometimes it will sputter out an die but then it will start right away and be fine.
It never starts right away when cold and when hot or after short trips its intermittent...Sometimes it will start right up...others it takes a time or two of cranking. I just replaced the fuel filter and it did not work. I am thinking the fuel pump but since its in the tank, I am hoping its not that.
I have a 5.0 Explorer 1998 and it has a problem for which I cannot find a definite solution, everyone says a different thing. The problem is that when the weather is hot, sometimes the engine does a strange thing. You ride the car for some time, especially if you do it on a high speed so the engine is really hot (but no overheating symptoms) - and then you kill the engine and leave it for a few minutes - to walk into a store, let's say.
After that you attempt to start the engine... sometimes it starts, but there were several times when it refused to catch, it cranks, at first tries to start, but stalls... then it just cranks without even attempting to start. And I had one occasion when it stopped working right in the middle of the road while crawling in traffic, but it was really HOT outside. Luckily, all other cases were in our town, so I could at least walk home. So, the problem seems to overheating of something, as in normal or cold weather it never happens. And every time, after the car is left to stay in place for some time, an hour or more, cannot say exactly - it starts perfectly!
I am really tried of this and want to eliminate the reason. But I am hearing so many different opinions about this problem. I thought that it could be the overheating of the fuel pump. But then it would stop working while moving, not after you shut the engine off and the pump cannot be still working and overheating. The only place where the heat can build up when you stop and turn the engine off is under the hood, as the fan stops, the coolant pump stops and the air isn't blowing as the car isn't moving. But the pump is in the tank! And I never ride on empty fuel tank, I always keep some level, lately I tried to keep it even higher, but yesterday it refused to start when the tank was almost half-full. Also, if it was just dying - a dying fuel pump gives certain symptoms like slow acceleration, engine shaking and trying to stall when you press the pedal, sudden stalling, uneven idling etc. In this case, nothing like this. The car's behavior is absolutely normal, acceleration good, normal idle. It happens ONLY under certain conditions, involving heat.
Other people say that it can be due to low pressure in the fuel ramp and the gasoline is starting to boil at some moment, when the temperature under the hood rises to a certain point. As a reason they name the pump (but as I said, I doubt it) or the fuel pressure control valve - don't know its exact name, it's a valve which maintains a certain pressure in the fuel ramp and releases excessive pressure by returning some fuel to the tank. However, when this valve gets stuck and doesn't maintain pressure, it mostly influences the cold start, as the fuel pressure drops and you have to crank for a long time while the pump is building the pressure again. But my car has never had any problems with the cold start, it's always instantaneous. Also, when this problem occurs and you start the engine after it cools down, it catches instantly which means THERE IS pressure in the ramp. So I don't believe in low pressure, gasoline boiling and resulting vapor jams.
And finally, I read that it may be caused by defective/dying engine temperature or crankshaft position sensors. As for the temp sensor, I will replace it tomorrow anyway. I am also thinking of having a look at the crankshaft sensor, where it's located on 5.0 V8?
I have a 2003 Explorer 4.6, about 2 weeks ago the CEL kicked on but I didn't notice any problem. Last week I stopped at a red light and felt it shacking a little, I took off everything seem ok. At the next light I felt it again and that time it started sputtering, I drove it for a few more days and it would sputter now and then as I was driving and every time when I would stop when it was in drive. I had the codes pulled and it came back with P2196 & P0405 (o2 & EGR).
I was going to buy a new 02 sensor & EGR but I was told that a bad EGR could be causing the o2 code also. I put the new EGR on yesterday and had the codes cleared. I test drove it for about 10 miles with no problems. Today while driving I felt it start doing it again and about 5 mins. later the CEL was back on. I got the codes and again its P2196 & P0405, Should I have changed the 02 sensor instead or what I should do next?
I have a 1998 Ford Contour se 2.0. The alternator went out in the beginning of January. Had it replaced, got it back it ran for a couple of days and it just died on me and wouldn't start. So back to the shop it went, fuel filter was clogged so they changed it, and I got it back last Friday. It ran until Saturday morning and as I was driving down the road it just died!! Just like that...died. Got it to run for a few seconds...it would die.
Finally got it back home and now it won't start. It will turn over, but won't start. If it does start it won't stay running longer than 2 or 3 seconds. I've had the fuel pump, fuel injectors, and spark plugs checked. Everything is fine. Oh and yes, it has 3/4 of a tank of gas in it. What is wrong with this thing?? It also has around 151,000 miles on it.
i have a 1998 passat 1.8t and in the past week my car started a slight sputter when i get on the gas and it gradually got worse the car starts up fine and idles perfect i did a compression check all 4 cylinders are exactly 150 psi now the problem just got worse when i go to leave a light or when im cruising down the highway and grt on it it sputters or and like pops or backfires outta the exhaust i just replaced the fuel filter and i still have the problem im stumped
View 14 RepliesDrove it yesterday no problems. got in this morning tried to start and would not turn over. thought it was a dead battery. Ran jumper cables to my wifes car waited for a while tried again. nothing. bought a new battery put it in. Nothing. I did notice when turning the key the dash lights come on then half a second they go out. interior lights, and 12v outlet work but no headlights. Any issue other than the obvious corroded terminals or loose terminal wires?
View 2 Replies1998 Ranger, 3.0 liter manual transmission. The vehicle recently has had the engine replaced. Still a 3.0 Liter, but possibly is from a 1995 or 1996 Ranger. Replacement motor from a wrecking yard, appears to have been sitting for quite some time prior to purchasing. I had a friend change the motor out after getting the vehicle a few weeks ago.
Ranger drove fine for a week, but this morning it wouldn't start. One click is all it would give when you turned the key. Thinking the culprit was the all in one starter/solenoid, I replaced it with a new one this morning. Now the solenoid will click continuously when the key is turned, starter still will not rotate then engine.
Battery tests good - 12.4 volts; connections appeared fairly corroded.
Here is what I have done:
- Clipped off the first half inch of corroded terminal leads, replaced both sides with new battery connectors and wire brushed connections off at battery and starter.
- Replaced Starter
- With "S" connector disconnected, attempted to bypass starter connections and short terminals to see if a faulty clutch position sensor was to blame; shorting did not produce anything other than turning the key did.
- Paralleled an additional cable from battery to starter terminal to see if corroded wire connections were to blame; still just clicked repeatedly when attempting to start.
Crankshaft does rotate manually, does not appear to be seized up. Unsure of what else to check for. Not confident in friend's engine installation abilities, he may have screwed up something I'm not thinking of. On the other hand, I don't believe I would have been capable of swapping out the motor myself.
I have a 1998 F150, had this truck for just shy of 200,000 miles, never a major problem and now she's killing me. Turn the key, no crank,no start, the same time this started the radio also quit working. I can start her with a screw driver at the soleniod (new by the way) runs perfect after that. By the way it's a 2 wheel drive with the 4.6 v-8
View 1 RepliesHave problem with Golf IV 1998 1.6 74KW.
Ignition is troublesome, takes few seconds to start. RPM stays still at 800 idle but when pressing down gas pedal it takes few seconds to accelerate to 2000+. While driving engine starts to sputter under 1500-2000, happens after every gear shift. 2000+ does not sputter much but car still feels very weak.
Everything works fine at the morning or several hours after last ride. Problem starts when car hasn't run in 15min - ~1hour, problem seems to go away only in several hours.
I drive a 2007 Ford Focus and when the fuel level gets to half a tank the car tries to die, and quite often does, when making a left turn. About 1% of the time it will do it when making a right hand turn. It will also sputter and die when running it on idle for a few min. It first started doign this at 1/4 tank but has gotten to where it will do it at 1/2 now.
View 8 RepliesMy 98 Yukon won't turnover. There is power to everything, but when I turn the key nothing happens. What's wrong?
View 3 RepliesI have a 2003 F350 V10, was pulling out of the driveway earlier with no issue, then as soon as I went up the road my truck started to sputter and it died. Went to start and it just clicked and wouldn't turn over? I tried jump starting it which worked, but once the cables were off within a minute the truck would die. Got it back home and now the windows won't roll up but the radio works and the door locks work.
View 5 Replies