Ford - Explorer :: 1998 - Headlights Light Up But Fairly Dim
Mar 28, 2012
Ok when I turn on my explorer the rectangular portion of the headlights light up but are fairly dim. When I I turn the switch from the off position to the first position, the front and rear parking lights come on, but when I turn the switch to the final position, ie the headlights on, nothing happens. My high beams still work in both the flash position and the on position, and the bulbs and fuses are good. I'm at a loss of what to do.
View 3 Replies
Advertisement
I have a very well maintained 1998 Ford Explorer 4.0 SOHC 4X4 with only 67,000 miles. Sometimes at highway speeds ( 65MPH ) there is a fairly pronounced bump / jerk. I will also happen occasionally when accelerating from a stop. IMHO, it's not a slip. Fluid has been flushed and is bright red. The best I can tell the RPMs are not jumping when this happens. I've all but counted out an engine misfire. There are no engine or OD light on. Where I should begin troubleshooting? I don't want to spend tons of money trying to isolate the issue but this Explorer is in exceptional condition so I want to have it fixed.
View 8 Replies
My girlfriend just bought a 98 XLT AWD 4.0. does have a few problems.
First, the brake light is on (on the dash). all the lines are good, but the front pads need to be changed. if i take off hard, the brake light goes out for a bit.
Second, had a CEL. P0743, torque converter clutch circuit blah blah. also, the o/d light flashes constantly.
The trans shifts fine, even under WOT. also goes into o/d with no problems, and the button works.
View 3 Replies
I'm thinking about buying a 98 Explorer that has an ABS light on. I haven't looked at it yet. In the ad, the seller claims it's due to worn brake pads in the rear. If that's true, then it's not a big deal. Can the ABS light be set by worn pads? Most of my cars are too old to detect this, but even if they did, I wouldn't know because I never let my pads get that low.
View 7 Replies
Has happened twice now but last night I had to disconnect the battery. A few years ago the driver's door switch was replaced for the same reason. I would do it again but I can't find anything that looks like a switch. Where that thing is? It is a '98 Explorer XLT.
View 4 Replies
We bought it and the dude that owned it cut the radio wires and messed with the wiring everywhere because he thought he had a short. I've hooked up the radio and everything and it does the same thing. How do I bypass to make it stay running.
View 10 Replies
When running and turned off, after 5 minutes of being on, the headlights blink on and off randomly. The only way to stop it is holding the brights/blinker/wipers wand back to temporarily engage the brights. Pushing the wand forward to fully engage the brights does not stop the blinking. Not fun for night driving!
View 5 Replies
I would like to permanently disable the automatic headlight feature on our 98 Mountaineer. I do not want them to come on automatically or stay on after the vehicle is turned off.
There is a switch located on the mirror. It does not work. This is the mirror that it has. I do want to retain the automatic dimming mirror feature. Is it possible to jumper the switch inside the mirror?
View 10 Replies
The cruise control and the overdrive off dash lights go out when I turn on the headlights. The cruse control and overdrive still work but the dash lights are not lit. It is a 95 4door explorer.
View 1 Replies
Headlights won't come on. They used to work but started flickering and quit working. (1993 Explorer).
View 5 Replies
Got a 98 explorer eddie bauer and the low beams went out. A search through the console revealed this explore doesn't have the lamp/light out module. So i guess a multifunction switch would be the next place to go? Fuses look good too btw.
View 3 Replies
My 98 Limited started blowing hot air yesterday, even in Max AC. It even blows hot air out the defroster when the climate control is shut off. It started doing this 2 days ago, but I could still get sporadic cold air from Max AC, but now nothing. What could be the problem?
View 8 Replies
Okay here is my issue : I have explorer 98 v6 4.0L 4wd .. I changed my transfer case with the shift motor because the old one was making noise and grind .. I put a good used and tested transfer case but once i started the car to test it I noticed its feels loke stuck in 4 low ..
I parked the car and switched it to 4wd Hi. The light of 4wd hi came ON in the dash. Then I put the shifter in Neutral and moved the switched to 4wd low but the light of 4wd hi stayed ON never seen the 4 low light in the dash. I'm so confused and disappointed now. Even with the old bad transfer case it was fine other than the noise the transfer case making.
View 1 Replies
I have a 1998 Ford Explorer 4.0 V6 with 200K miles. I plugged an OBII scanner with live data readings and my o2 sensors never relayed any information (voltage), they all ead -100% and the voltage never changed. Could all four be bad? I left the truck running for 15 minutes with the scanner attached and nothing changed.
BANK 1 SENSOR 1 = -100%
BANK 1 SENSOR 2 = -100%
BANK 2 SENOR 1 = -100%
BANK 2 SENOR 2 = - 100%
View 3 Replies
I was told by the dealership that the battery was bad and needed to be replaced ( which I did) I went out to my car this morning and had the same problem. When I turn the key nothing happens. When I turn the key you hear a click but that is it.
View 3 Replies
Got a call from my little sister about two weeks ago that her Ford Explorer would not drive forward. Checked it out and put it into second to get it home.Last weekend me and my dad changed the filter and fluid and then drove it for a bit. It sounded a little better but still would go into drive or reverse. We shifted into second which we knew worked and then back into reverse immediately and now reverse worked, although sluggish. The same was true for drive. A few days later dad changed a solenoid and now it will go into drive and go up to 15mph, but will not shift from first to overdrive first. And still no reverse right away. She is able to get to school with second gear and pop into drive when she gets up to 40-45mph. If she has to backup from start, first she has to put it into second and then back to reverse. Something in overdrive doesn't seem to be doing its job right.
View 3 Replies
My 98 explorer is hiccuping when i am stopped for more than a few seconds and when I press the gas to get going it stutters. It only does this if I am stopped at a light or stop sign for a few minutes. Once I get going again it runs fine. The check engine light is not on and I have replaced the o2 sensors and spark plugs. I am at a loss on what to do next.
View 6 Replies
My ford just suddenly started backfiring and started smelling like this sulfer kind of smell and knew I needed a new exhaust so I got a new tailpipe and muffler and problem still persisted so then I replaced the driver side catalytic converter because I had noticed after driving it that it was smoking after driving it. So now I've replaced that and i still got the smell and it just rides rougher and the check engine light is blinking after driving a couple minutes....
View 9 Replies
Have 1998 Explorer with 5R55E tranny and the automatic transmission extension housing seal keeps coming off, allowing a fluid leak. I just replaced it and it's doing it again. When I put it in there, it seemed tight, but... How to keep this thing in there?
View 3 Replies
My explorer 98 seat lumbar does not work. When i push the switch i only hear a motor noise and nothing happens. How to fix that?
View 6 Replies
my wifes explorer is getting no fuel. (there is a valve I depressed similaR to a tire valve, I pressed it once some fuel dribbled out, and thats it, turned the key several times and not a drop off fuel. I went as far as checking the fuse, the fuse is not blown. what are my next steps of trouble shooting.
View 8 Replies
