Ford - Explorer :: 1998 - Difficult To Start And Takes A Few Times Of Cranking To Get Going
Oct 15, 2012
I have a 1998 Explorer XLT with the 4.0 sohc engine.
Recently the truck started being difficult to start and takes a few times of cranking to get it going. Once running, it idles and drives fine on city streets and freeways. When trying to start it turns over fine but doesn't start. After a few times of that, it will finally start. Sometimes it will sputter out an die but then it will start right away and be fine.
It never starts right away when cold and when hot or after short trips its intermittent...Sometimes it will start right up...others it takes a time or two of cranking. I just replaced the fuel filter and it did not work. I am thinking the fuel pump but since its in the tank, I am hoping its not that.
View 8 Replies
Advertisement
I have a 98 Mountaineer, 5.0 auto that I just picked up. It takes some extra cranking to start it, and then when it does start it idles like it's missing. Also, the throttle response is not good. I have two codes that come back as soon as they are reset. P0340 (cam shaft sensor) and P0350 Ignition coil malfunction. I have been reading threads here saying that sometimes the P0340 can be the alternator it not always the sensor.
View 7 Replies
2012 Golf GTI, bone stock, 18k miles. The issue is pretty straightforward. It takes longer to crank than I feel it should, perhaps 5-6 seconds, sometimes the car is cold, sometimes warm. Sometimes it cranks right up with no issue. A VCDS scan is clean. This is Atlanta weather too, so the temps are pretty mild.
View 6 Replies
My '08 2.7 has difficulty starting in the morning. It makes the normal cranking noises but won't fire up immediately. I typically let it try to catch for 5-10 seconds, pause, and try again. Then I wait a minute, try again, and everything starts fine. Then it'll start normally the rest of the day.
Pardon my ignorance, but isn't there some sort of compartment that holds fuel into the engine with a check valve that keeps it from releasing back into the tank? Could it be that this valve is leaking?
Or does it sound like I need a whole new fuel pump? I tried to find schematics, but had no luck. I tired hmaservice.com, but I'm not willing to install the Adobe SVG app (obsolete and security risk) to view the documents.
View 2 Replies
I just finished installing a new set of injectors, standpipes and the blue spring kit on our 2005 Excursion 6.0. The truck idles and runs much better but now it takes almost two seconds of cranking to start the engine. Cold and hot are the same and the length of time between shut down and start doesn't seem to matter either.
What to check? I am planning to check the ICP tonight when I get home. Could I have air trapped some where in the system? This is my first powerstroke so I don't know if this is a possibility.
View 8 Replies
I have a 1999 Honda Civic manual transmission. 1.6 litter. I have a starting problem. I have replaced the fuel pump and fuel filter. Sometimes the car starts up immediately and sometimes it takes 2-3 try's (4-5 secs cranking). It is worse with fuel is low.
View 6 Replies
Summary of Events:
Lower radiator hose decided to disconnect itself.
Stopped and had car towed home.
Connected hose and filled coolant system.
Car is hesitant to start and takes a couple seconds of cranking.
Misfires in cylinder 3, and a few in cylinder 5, no other codes.
New OEM plugs, no change.
Swapped coil packs around, no change.
Idle is rough but at speed, everything is smooth.
View 2 Replies
Revo stage 2 --1.8t ... For the past few days I have tried to figure this issue out I am having with my 337. The car takes 2 or 3 times to start from being cold. Once its started it has no issue it drives awesome, pulls hard no codes when vag com'd. Can start it up anytime with ease for the rest of the day. Tried doing to solve:
-I have pretty new coilpacks---FSI- they are ok
-Spark plugs are 3 months old --checked those
-Checked Battery and its all normal and no issue
-Cleaned the throttle body = No change
-Installed new CTS yesturday (green) < no change
-Cleaned the MaF = NO change in start up but car runs way smoother
-Put in new Filter= No major change
-Did the Crank sensor under a month ago (Bosch)
I have a few more things on my list to check :
1. Fuel pump relay
2. Fuel Pressure Reg
3. ECU relay/ check immobilizer
4. Fuel Pump
View 5 Replies
My 2002 Honda CRV has had occasional problems starting over the years i.e. takes 2 times to start engine. But lately it is struggling more to start i.e., engine turns over but you can hear it struggling to start i.e. sounds like dead battery but in fact battery is brand new. Now it can take 3 turns to start and this morning it took 5 tries. The problem is no mechanic can find out what is wrong i.e. starter, fuel line, electrical or what? because it always starts when in the shop. I have even taken it to the Honda dealer and they could not find the problem. This is a random problem but seems to be getting worse and happening more often. I am worried I will be stuck somewhere when the car does not start AT ALL one day.
View 19 Replies
The colder it gets the harder it takes to start my 2000 Ford Explorer. Have read that it's the Intake Air Temperature Sensor.
View 3 Replies
My 2004 explorer honks 3 times on lock and 4 times on unlock when you just press the remote once.
View 5 Replies
Trying methods found elsewhere on this site not working anymore. No matter how much wd-40 and door slamming I do, I am getting the 4 short honks on lock and 2 on unlock. No door ajar light and interior lights go off as normal so it doesn't seem to be door open sensor.
View 9 Replies
I had a clutch, slave cylinder, and master cylinder replaced about 20,000 miles ago. Everything seemed to be working fine until I drove across the Rockies. The transmission was extremely difficult to shift, and the vehicle would actually roll forward when cranking the engine at fuel stops (temps were minus twenties). Once I got out of the mountains on both ends of the trip (where it was warmer), the clutch worked normally. The local Ford dealer found lots of air in the hydraulic clutch system, bled it, and it worked fine for several months.
The clutch is doing the same thing currently, but not all the time. Some days it's fine, other days it's difficult to shift although double clutching seems to work. It gets particularly hard to shift after a long drive (e.g., interstate driving for a couple of hours). I took it back in this morning to see if the dealer could figure out what is going on, they're saying it's likely a bad slave cylinder. I've heard the 1995 Explorer clutches are a bear to properly bleed, and can't work but think there may still be some air in the system.
View 5 Replies
The 2003 Ex. Made it back home last week after a couple years at college. .. registration sticker expired last June! Drivers side mirror "taped" on. Rear bumper cover torn in half w/ a few screws holding it on.
Busted out foglight & small tear in bumper cover above it.
Brake light on - noticed fluid low & cap not seated correctly. One of the tabs that hold the cap in place is broken... new reservoir under $20 at rockauto. Looking for a write up or better to replace entire master cylinder?
View 3 Replies
My 98' 1.8t AEB was having a bad valve tick so i took the valve cover off and noticed the top camshaft had a lobe eaten away pretty bad and it looks like the bearing next to it was spinning I KNOW that its from a lack of lubrication so that means its my oil pump? there was absolutely no sludge or swarf that i could see.
what made me take the valve cover off was a small oil leak and i thought it was the gasket, but my PCV valve slipped out of its sleeve so thats where the oil came from.
also, every time i started my car the oil would come on right away, beep three times, and blink until i shut the car off.
So, i guess i am wondering, do i have deeper problems here or could i replace the cams, bearings and oil pump?
View 2 Replies
I have a 2002 Camry LE V6 with 189K on it and noticed that it takes several seconds (4 to 5 seconds) of cranking before the car starts. When the car was newer, it used to crank quicker.
Here is what I have done so far:
- Changed all spark plugs @ dealer using iridium type
- Always used Premium Fuel (Petro Canada 91 grade)
- Put in a bottle of injector cleaner (Redline Complete Fuel System Cleaner)
- Throttle Body has been cleaned about 20K ago
- Oil changes are Mobil 1 5W30 year round with Denso Filter
- Battery was replaced last year with an Optima Red Top and was tested a few months back to be in excellent working order.
What I have observed is that when the weather is VERY cold outside (i.e. -20), it seems to crank quicker, but if I keep my car parked in my garage overnight and start it, it takes several seconds. I have never had the car not start on me so that's a good thing.
View 12 Replies
I have owned this 01 LS with a V8 for about a year now and have had it to the dealer at least 6 times. After bringing the car in twice, the dealer finally found that there was a problem with the fuel injector. 3 months later the problem came back - basically the car takes 3-6 seconds of cranking before it starts (from a cold start of more than 2 hours). The last 3 times I have had it in the dealer has reprogrammed the computer and thought it was fixed - Wrong! After this last time, the dealer said they could not find a problem and felt they were doing all they could - in fact, they told me to switch to a lower octane gas and see if that works.
View 14 Replies
1998 explore will not start when hot will turn over sputter and die, after 15 minutes it will start right up that was last monday when it was 80 outside it now colder outside has not done it again, the only thing i have seen that temp gauge is not going past cold never getting to center it will try and drop back down...
View 11 Replies
My truck has a short in it. I've noticed this delay for the past few months. Takes a few seconds when I'm cranking it, then it finally starts. Could it be the alternator that I need replaced? It's not the battery, cause I'm getting plenty of juice.
View 1 Replies
I have notice maybe a dozen times in the last few weeks that my 2013 5.0 Screw downshifts at odd times. It usually occurs while coasting around 35-40 mph (in 4th gear and downshifts to 2nd gear) or around 50 mph (in 5th gear and downshifts to 3rd gear). Obviously when this occurs, the rpms jump and when I get into the gas, the truck takes a few seconds to accelerate because it first must shift into the next higher gear. What is causing this?
View 2 Replies
I have a 1998 Ford Explorer. It was running fine until last Mon. On my 3rd start of the day , it wouldn't stay started long enough to get into gear; sometimes it sputtered violently. I tried starting over the next 2 days with the same outcome so I towed it to mechanic. They replaced spark plugs, wires & started (because it was throw lower voltage than normal). It ran fine the short distance home. The next day, it started fine but sputtered in corners/lower speeds. About 12 miles into the drive, which was at ~60 mph, my auto died and wouldn't start again. What's going on? Could it be the fuel pump?
View 1 Replies
