Ford - Explorer :: 1997 - Whining Noise In Front End When Brake Too Hard
Oct 14, 2011
I first heard it start about two or three weeks ago. It started when I would brake too hard. So I took a look at the brakes and the caliper pin was rusty so I loosened it up and it was fine for a day or too. Then all of a sudden it started in the front like something was grinding. Someone told me it was the transfer case. so i put in 4 wheel drive and it goes but then you really hear the grinding. How can I tell if its the transfer case or the front end where the drive shafts go into.
View 1 Replies
Advertisement
Had a lift done (Rough Country, after reading through these forums) on my 04 F150 Newer Body Style 4x4. Now, sometimes the pedal gets harder to push on until it won't go down at all and the brakes (only the front) start dragging. It goes away after awhile (my rotors are shot and I'm going to have to replace them after I figure out what is going on) but always comes back. The brake lines have been bled and I'm having a shop bleed them again tomorrow (that's what they said the issue was) just in case.
View 11 Replies
I have a 2003 Explorer 4.0l 4x4 auto. Yesterday day the passenger rear tire got a flat, so I put the full size spare on, and went about my business. About 2 miles up the road is a stop sign, so I start slowing down, and while slowing down I can hear a whining thumping sound from the front of the vehicle. It wasn't doing this before the flat, but right after I put the spare on it starts to do this. It only happens when slowing down, not under acceleration.
View 6 Replies
Purchased a 2004 Lincoln Aviator, AWD, 200k miles at an auction, I'm familiar with standard 4wd systems, but this auto AWD is confusing me.
Truck is auto engaging the AWD after 30 seconds of driving, if I reset it back to auto, it locks AWD 30 seconds later.
If I'm driving above 30-40 MPH this gives a pretty intense whining sound. I assume overheating the system. Last test drive put it in AWD disabled mode- I assume from overheating.
Truck wants to auto lock AWD no matter what, I don't seem to be able to do anything to prevent this other than turn OFF traction control- which then ends up disabling the auto AWD and telling me to see owners manual as well.
Truck does pull a little from needing ball joints, but would this tell the computer to engage the AWD constantly ? Any thoughts?
I'd also mention the ABS light is on- I'm guessing a speed sensor could throw this off as well? My code reader can't seem to connect to this aviator- it could connect to my old explorers, but not the aviator strangely enough.]
View 6 Replies
2005 Sport Trac 4x4... So, my fiance purchased this new off the floor before i met her (or else she wouldn't have bought it). Had a motor issue which required a new motor after 90k miles.. Anyways, while driving on a normal road, i dropped the rear window and hear this whining noise. Checked the transmission fluid and it was a little low, nothing major. Topped it off with Mercon V... No effect. Where do i look next. It does not have a tow package. Do i check the transfer case, or rear differential?.I am thinking differential because the transfer case is more upfront to where the noise is. you cant hear it with front windows down. Only the rear sliding window or rear passenger's windows.
View 9 Replies
I posted awhile back about a loss of power and hard shifting in the transmission. I thought I had it fixed, well I kind of did...... Replaced the IWE that had locked in solid. I replaced both, added some transmission fluid, new front brakes, and a new belt back in July/August. Truck was fine for a few thousand......
Well it's back. Now I have a noticeable whine in the cab. I haven't pin pointed it yet. It is only audible when the truck is running from 35-50 mph. It is not RPM dependent, it doesn't change when I take it in or out of four wheel drive. It isn't there when the truck isn't moving.
The truck has 61,000 on it. I bought it with 35,000 on it because I wanted a vehicle that wouldn't nickel and dime me. Something I could climb in and not worry about making home.
Well here I am less than 30,000 miles later and I have had issues with the fuel controller under the bed, brake calipers sticking, IWE's, new shocks, broken front coil spring, recall for the airbag, tie rods, ball joints, power window regulator, and now what appears to be a transmission.
I come from a long line of "FORD" guys, but I am seriously considering something else. This 04-08 model has to be one of the worst pickups ever built by ford.
Are the newer ones any better? Other than routine maintenance a vehicle shouldn't have to be touched before 61,000.
View 4 Replies
So ever since I bought my f150 about three months ago it makes a whining noise from the transmission while I am reversing it. What could be the cause of this? Should I bring it in for a trans flush and filter change? What would that run me?
View 1 Replies
I have a 2002 f150 with the 5.4 motor and a auto transmission and when I go in reverse the rear end makes a loud whining noise? The fluid level is fine. Should I add the gear oil additive to the rear end or change the rear end oil and add that? I am looking to sell the truck so what could cause this noise?
View 1 Replies
I'm a new Ford owner, when I engage 4wd I get a fairly annoying whinning / wheering sound that sound like the front end. Only makes sound under acceleration not coasting. No vibration at all.
View 11 Replies
'05 F150 5.4 Sounds like a whining noise from the front end when turning to the right or going straight. Goes away on left turns. Thought it was tire whine but put originals back on and got same thing. 13.5x35 verses 275 Truck has a Fabtech 6" lift. Right CV axle seems tight, rotor assembly replace 2k miles ago. Any other option before going into front diff?
View 2 Replies
My teenage son just bought his first car, a 1991 Ford Explorer XLT 2-wheel drive. I had it checked out by our mechanic before I let him shell out the money, and everything seemed OK. It's the prototypical low-mileage car (127k actual, confirmed by Carfax) owned by a little old man who took good care of it (stack of service records a foot high) and didn't drive it very much.
Earlier this week ... he'd driven it for about two weeks with no issues ... the left front brake caliper locked up on it, to the point where it heated up enormously, the pads and rotors got so hot they were discolored and some transmission fluid got blown out by the strain.
He took it to our regular mechanic, great guy who we've used for years and has worked magic with our cars, he got into it and he diagnosed the problem as ... I hope I'm explaining it right ... a little pin or piston or something in the caliper was upside down. He put it back in the right way, and everything seemed to be OK, although he said my son would probably end up needing a brake job sooner than later because of the way the pad got ground down.
FYI, master cylinder is full of fluid, our mechanic couldn't see any leaks anywhere. Although when we took the car to the mechanic, my son tried to back it up to get a better angle at getting into the service bay, and the pedal went to the floor.
Fast forward two days, and danged if the same thing didn't happen with the right front caliper, seized up although he didn't get it as hot as the other time, parked it a lot quicker. And of course it happens on Friday going into the weekend, when our mechanic isn't working, he won't be able to do anything until Monday, which leaves us scrambling trying to get everyone to work, etc., down one car.
Doing a little online homework ... which we probably should've done before my son made this purchase ... I'm seeing a lot of brake issues with '91 Explorers. I asked my mechanic if he thought there was some ABS-related problem here and he said he didn't think so.
I will say that the car apparently sat undriven for a long time, which I know can unleash a lot of issues. What might be going on here? Do we just need to go ahead and replace the calipers, any hoses, etc., as preventive maintenance?
View 1 Replies
I have a 2002 Ford Escape 3.0V6 with high miles. A while back the transmission on this vehicle went out while at work. I got the bright idea that I would tow it home with a dolly until the funds were available to make the repairs. We pushed it up onto the dolly and secured it. I also put it in park. It took me about a 1/4 mile to figure out what was with all the resistance (my first thought was "Dang, that sucker is a lot heavier than i thought"). I pulled over, put it in neutral then proceeded without any more problems. A junkyard tranny was put in it. Rides and drives fine. There is a whining noise that is very distinct and gets worse with increased speeds. It sounds like it is coming from the rear end. No noise while stopped.
I have checked everywhere i can reach to see if anything is hot... (thoughts were maybe a bearing) nothing found.
Fluid is full in rear end.
I just drove it and figured it would get worse or get better.
Now that winter is almost over I am very confident that the 4x4 is not working. It does not matter if you are in Auto or 4x4 only the front tires spin.
View 3 Replies
I have a 2002 Ford Explorer Sport and after a brake job I noticed that while under braking at slow speed there would be a grinding sound on the front left. I replaced the brakes and wheel bearings the first time. After a while I ended up replacing the caliper itself but it still grinds. I don't notice any wheel shaking, pulling and it hasn't locked up although once I did notice a some smoke under hard braking but only once. I also don't hear any grinding while not braking.
View 5 Replies
At my wits end on this. Left front brake is pulling ever so slightly on my '02 RWD Sport Trac. Just enough to annoy the crap out of me. Sometimes I hardly notice it. Over the past year or so I've flushed and bled the lines after replacing rear wheel cylinders, rebuilt the front calipers and replaced the rotors and pads. It's still pulling. Is there some electronic adjustment for the module that the brake lines come out of? Does the ECM control the pressures?
View 5 Replies
Have a continuing problem with the front brake pad antirattle clips? Mine keep bending or rusting and prevent the pats from retracting. I live in a high salt area but still I shouldn't have all the problems I do.
View 1 Replies
My wife's Explorer 4x4 has a noise in the front at around 100km/h. It is not detectable below 90km/h. Its not noticeable from a standstill until around 100, then you hear it a little. I find I can make it more noticeable if I vary my speed from 110 to 105 up and down, then its easier to hear. Once you get below 90 km/h you cant hear it at all.
I have a broken leg right now, and I normally do ALL my own work so I'm a little-limited mobility wise at the moment.
I'm suspecting a wheel bearing. I put the Explorer in the garage and my son jack up both wheels on the drivers side. I started the engine and SLOWLY accelerated up through the gears to 100. I know the hazards with this as I've done it with other vehicles, but this was the first 4x4. Then we jacked up the passenger side (after lowering the drivers side) and did the same thing. I could slightly hear/feel the rumble when the passenger side was jacked up.
I did drive the vehicle on my outdoor ramp/pit so I could use my crutches and get underneath to have a look. I grabbed the cv axles and they feel solid. The propeller shaft was replaced last year, and the cv axles look brand new. (bought the vehicle off a friend two years ago.).
So, are my suspicions correct, is it the pass. side wheel bearing? The Explorer has 294000kms. Never did test it on corners as I didn't want to swerve back and forth on the highway with the amount of traffic.
View 4 Replies
My 2007,4.6 is making a whinning noise from the front of the engine around the idler/tensioner/alternator. What I have read it might be a problem with the alternator getting cold, I forgot to mention it's cold up here. Fixed by changing the alternator and did the noise come back as it seems to be a design problem?
View 12 Replies
This morning while listening to cartalk I am stopped at a stop sign. I press on the gas to start off from stop - hear a loud bang as if I hit something. All of a sudden my engine is revving hard, whining noise but no power to drive. Luckily I had enough gradient to put the car in neutral and float it to a stop by the curb. Car does not move on Drive or Reverse but engine runs fine and revs up but no power to both axle. Where the issue is? The car is 82K miles and has driven great. where is the issue??? Axle break down/ CV joint break down/transfer case break down/ What is it?
View 18 Replies
My 07 SCREW 5.4L 4x4 has 77,000 miles and has a high pitch whining noise on front right side of engine. Sounds worse in the cold,increases with RPMs.
View 5 Replies
2001 supercrew 4x4 all wheel disc brakes. Driver side brake is stopping harder than all the rest to the point that the pads will smoke if you do a hard stop
thought it was the caliper sticking. Replaced caliper and mount. Still same problem. Thought possibly there was air in the lines. Bled all 4 brakes several times. And still the driver front wheel still stopping harder than the rest. I wouldn't think it would be the master cylinder.
View 4 Replies
1997 Limited SOHC auto.
I just replaced the transmission with a known good one from my XLT but the reverse doesn't work now and there is a loud banging coming from the front when I turn left or right.
It feels like the tyres are slipping on the road, like axle wind up. This happens in auto and 4wd high. What the banging is?
View 13 Replies
