Ford - Explorer :: 1997 - Popping At Exactly 20 MPH
Feb 19, 2014
Just got this vehicle a week ago. Test drove before I bought but that drive was fine. Then after driving I started have a popping. Started paying attention at this point and noting what happens when.
It seems I don't have any problem at all until she gets warmed up. I can drive about 20 miles with no problem. Then the OD is Off light starts flashing. Then when I decelerate to stop, I have a big popping at exactly 20 mph. I then have 2 smaller pops once I take off from my stop.
I started searching online everywhere to determine the cause. I am a female whose daddy taught them just enough not to be completely stupid, but not near enough to be able to fix my own car problems. I thought from what I've read that this issue might be a torque converter. I do have a hum after a while that sounds like road noise....like I saw one other person post about bad TC's. But I haven't seen any posts that address the popping.
View 1 Replies
Advertisement
My explorer is making this popping/ cranking noise when I back up and I give it a little too much gas. It will also do this in drive and also when i'm driving and I get back on the gas pedal it will jerk. I really don't want to take it to ford...
View 5 Replies
I replaced my right front axle a week ago because I was getting severe popping/clicking noises. The boot was torn on the axle and I had grease all over the inside of my rim etc...
The popping/clicking sound was gone immediately after replacing the axle. Now starting yesterday, exactly one week after I replaced it I noticed the popping/clicking sound coming back. It was faint at first but started getting louder. Now today it's almost as bad as it was before I replaced the axle. I still have to get underneath and see if I can hear where it's coming from? Think the axle is bad again? It is an after market Axle, ToughOne is the brand I believe.
Just for a quick history. All four wheel bearings were replaced about two years ago. All four ball joints about a year and a half ago. I replaced the outer tie rod ends about two weeks ago.
2004 Ford Explorer, 4X4, 4.0 Flex Fuel
View 4 Replies
When using the power lumbar adjustment in the seat back of my wifes 08 eddie bauer explorer, it stopped moving and I now hear a snapping / popping noise from the seat back. Is there any way to remove leather seat cover to check out what might have come loose or broke?
View 5 Replies
I have a 2003 Explorer EB that on deceleration of all speeds, the drivers side rear axle is popping or clicking. Could this be a CV joint? It does not happen on acceleration.
View 3 Replies
Today I changed my intake manifold gaskets n I hooked everything back n now its bogging out n popping as it's idling, I put new spark plugs but it still the same. What the problem might be?
View 2 Replies
1997 Ford F150. 6 cyl, 4.2L, 138K miles. (Still) keep getting back the P401 code. I've checked (and re-checked) and cleaned all the ports and checked connections on the EGR valve, DPFE sensor and EVR solenoid. Everything seems to be working OK. Have replaced the EGR valve, DPFE sensor and EVR solenoid and (still) after clearing the code and driving ~30 miles, I keep getting the CEL light pop back on and P401 code popping up. Is their anything else to check ??
View 5 Replies
My friend has a 2000 f-150 2x2 and was following him and he said he heard something pop and then no transmission , haven't put a code reader on it yet. It's not the flex plate starer works fine fluid is a little discolored and has no bad burned smell to it.
View 1 Replies
I've recently purchased a 02 F-150 4x4 with 135k showing. About a week after purchase 4 COP's were replaced to eliminate a skip that started the day I drove it home. After a few hundred more miles it started shuttering at take off, much the same as the trans shuttering usually in higher gears/speeds. Only does it briefly in 1st gear and occasionally it goes into 2nd, but stops immediately after shift. After about 10 miles it stops doing it and until the trucks sits awhile it stays gone. About the same time a popping sound started coming from the rear axle at slow speeds. It changes sides as you drive and turn, and sometimes goes away intermittently altogether. Also is it possible or probable the two are related ?
View 4 Replies
I'm going crazy here with this strange noise on my '01 Screw. EVERYTIME it starts to rain - and I mean immediately upon starting to rain - I get a strange clicking and popping sound that is unmistakably near the passenger rear door, up high, almost in the corner of the cab. Today my wife and I were driving and it starting to rain and I saw her start cocking her head and I said, "Do you hear it too?" She confirmed where it is coming from, but I just can't figure it out. My truck has a cap on it, but it doesn't seem like it is related to that. It is ANY kind of rain too. Precipitation=sound. Really odd.
View 9 Replies
Got a 1999 ford f150 2 wheel drive. I have replaced both upper and lower control arms with ball joints on both sides. New shocks, new stablelizer links, new inner and outer tie rod ends. Also, a new steering gear and i still have popping noise coming from both sides around the wheel area when i enter or leave out of drive ways, turning, or running in a hole. Doesn't do in going straight. I don't know what else to do. Driving me insane. I keep spending money on this truck and still where i first started.
View 9 Replies
I have a 98 with the 4.2.The troubles started with popping a little through the exhaust ,bogging down and bucking,rough idle and had the two codes together that deal with having bad intake gaskets don't remember the codes offhand.
I also noticed every plug in the truck was wet and black however it didn't appear oil wet.I have changed the fuel filter,spark plugs,lower intake gaskets,plenum gasket ,injector o rings,checked injector ohms all were 16.5,new EGR gaskets,all bolts are torqued to specs
Now I have a no run condition, it will crank but not run. I heard a pop in the engine one time. I cranked till the battery went dead.I also noticed as I was calling it a day last night the radiator reservoir was empty. I don't know if somehow I got a hydro lock even though I put new intake gaskets in it or i have some other issue like timing or something. I don't know where to look next....
View 6 Replies
Lariat stepside, 5.4L with 150k miles. Loud popping noise, almost a clunk, when making a slow sharp turn. Put it on jackstands and did the normal tire grab and shake and found no issues there. Tie rods, ball joints and sway bar links all seem tight. Looked for signs of unusual rubber to metal and metal to metal wear and found nothing. The only thing I did see was the rubber boots on the upper control arm ball joints were split. What I have checked or if I am missing something?
View 9 Replies
Recently, when turning while the car is in reverse, I started noticing a popping sound coming from the area near my right front tire. Now, when I accelerate quickly from a dead stop or drive away after being stopped on a hill, I'm hearing that same popping/clunk noise from the right front tire. When I'm stopped at a light and then take my foot off the brake, wait a second, and then gently accelerate, I don't hear it. I've had a couple of mechanics take a look at the cv boot for the right front tire, but they tell me that it's not cracked or broken. Is it possible that the cv joint has gone bad, but the boot is not broken? Or, is there something else going on?
View 4 Replies
It's Nissan Altima 97. My friend need to take her road test so I let her borrow my car this weekend to do some road practice (I was in the car with her). Besides all the heavy braking, and sudden acceleration. She did alright. Because she is from VT, so she was practicing this VT Turn Around (I have never heard of it before today). She turn the wheel all the way to the right and back up.
I heard a small popping noise, and didn't pay too much attention to it at that moment. However, After she finish that VT Turn Around, we started to driving down the hill, and heard this metal-on-metal noise. It lasted for 10 ft, then went away. The noise is coming from my driver side front wheel. When I got off the car, I found the center of the wheel cover pop off.
(see this link for the pictures) [URL] .......
Now here are my questions. What just happened? and do I need to get it look at immediately, or can I wait until the next oil change?
View 9 Replies
I drive a 1997 dodge Dakota 5.2l 5 speed manual 4wd and recently it started making a really aggressive banging or popping noise while I was driving, it also made the truck bounce up and down a little bit and I could feel the shifter move up and down while this was happening. So I went underneath and discovered my transmission mount was out so I changed that and as well I changed a few u joints. One thing i noticed while I was replacing u joints was that when I had the front drive shaft off the whole problem was reduced to just a minor popping noise but once I slapped back on the front drive shaft it all came back. Another problem that is occurring because all of this is that when I tried to use the 4wd in 4 hi it just kicked it out of 4hi but in 4 lo it would stay in but all the problems were still there. The only time it doesn't do anything is when I am already rolling and I put the 4wd selector in neutral to disengage the drive shafts.
I have asked a few different people their opinions and I get different answers, someone thought it could be something to do with the steering shaft or intermediate steering shaft but I think that is not the correct diagnostic. Another one of my buddies suggested that it might be a stretched chain or gear in the transfer case that is causing it.
View 6 Replies
After replacing a faulty spark plug wire on my '97 explorer, I started the engine (4.0 liter pushrod) and noticed the idle much lower than it was previously- to the point it now borders on stalling. The wire I replaced was on the right side (if facing engine from front) closest to the firewall. I thought I may have worked a vacuum hose loose when feeding the wire under the intake, but I checked and checked and saw nothing amiss. What I may've did (if anything) to cause this problem?
View 7 Replies
My 'new to me' '97 Explorer has this odd 'rumble' every now and then, as if I just ran over some rumble strips. Very brief, maybe a second or less, as if I hit 5 or 6 of those bumps. It is a V8, XLT all wheel drive and I'm not familiar with it. Is this something I need to get looked at soon or is it just one of those things with the AWD. I only driven it a few times so I don't see a pattern and all else is great. Its a tight truck with less than 100K miles and I really enjoy it.
View 7 Replies
Have a 97 Explorer 4x4. lately when I start the truck it has shifted itself into 4x4 low. I had disconnected the battery for a few minutes, re-connected and the truck was back in auto. This no longer works and it is stuck in 4x4 low. Mechanic wants to replace transfer case encoder, but says more diag needed after to replacing encoder motor to determine internal failure and may need more work. Can I simply have the 4x4 low disengaged manually?
View 3 Replies
I just bought a 97 explorer and the abs light is on is there a way to pull the codes without an abs scanner?
View 3 Replies
I have a 1997 Ford Explorer with a 4.0 SOHC engine. It bogs down and won't go over 20 MPH. I'm showing codes P1405 and P1151. Would either of these codes cause that issue? I'm not even sure how to start diagnosing this.
View 1 Replies
