Ford - Explorer :: 1997 - Choking Sound In Throttle Body Area
Jun 15, 2016
My 1997 ford explorer has this problem that when you start the engine it runs fine then it's makes a choking sound in the throttle body area I have a video of it on YouTube here's the link :
1997 Ford Explorer Engine Trouble !!! - YouTube....
And the truck doesn't give any ob11 codes.....
View 5 Replies
Advertisement
97 Sierra K1500, 5.7 liter. High pitched whistling sound underhood in the vicinity of the throttle body. Starts after truck warms up and quiets down when accelerating. I've wiggled hoses, disconnected what I could without stalling engine, checked air lines into throttle body, checked air filter, etc. Sound does not change when I apply brakes so I don't think it's related to master cylinder. The only time it changes is when I accelerate, then only gets quiet until I come back to steady speed.
Truck has 85,000, runs great. No codes.
View 6 Replies
Just purchased one of the members 2006 Prius. It wasn't in good condition and I knew that upfront. The price I paid justified the imperfections on the car. The car has 117k miles and it does burn oil. To the tune of 1 qt every 3000 miles according to the seller. However I believe it burns more than that amount now. I changed the oil and the dipstick reading was slightly below the minimum mark. The engine doesn't sound all that great but seems to run very well.
I was cleaning the throttle body today and noticed there is oil in that area. I looked down the throttle plate (not sure what that's called), and there was a layer of oil on the bottom. I know oil is not suppose to be in that area. What could this be?
The car had a leaking ice water pump and the coolant was a bit low, not sure if it could have overheated before.
View 19 Replies
I need to clean my throttle body on my '97 F-150 and it has a label saying not to clean directly. Is it still safe to use TB cleaner and to go ahead and clean it? It needs done but how would I go about it.
View 6 Replies
The Throttle Body on my 2001, 4.6 L is making a strange whirring noise, when you puy your hand on the intake pipe, you can feel a slight vibration. The Truck idles and runs okay, with no codes. Giving it a little gas and the noise goes away. The last thing I did was clean the IAC with Gum Out Carb cleaner, the second or third time I've done this over many years, with no problems. I'm a little perplexed at the cause.
View 6 Replies
I'm usually over in the EX forum but today was working on my brothers 1998 F150 - V8 4.6L. Had the EGR code P0401 and due to FTE I found the problem took the throttle body off and found it was definitely plugged. One of the bolts was really loose and came off way to easily. Didn't realize until cleaning why... Now I drilled 8 studs out of my aluminum EX heads but this one has me pondering how I'm going to clamp this thing down and center a bit..
1st pic - ports WOW - guessing this was the problem ...
2nd pic - bigger issue ...
3rd pic - the ports cleaned up ...
View 8 Replies
I have a throttle body noise that sounds like a warble,It is sporadic and I think it should not be their. But I have heard some other f-150s make the same noise. Is it normal or is something not right.
View 3 Replies
I busted the cable end by not removing it properly. My question is what is the proper method of remove the cable from the throttle body? Are the cable ends replaceable? If so who has them as a google search didn't find any? I've tried to find written information but haven't any luck. bl2009
View 1 Replies
I accidentally broke the control lever where the cruize control attaches. I've looked all over but I can't find the lever. Where I could buy just the lever? New throttle body is more than I want to spend.
View 1 Replies
High mileage 1999 4.6 4wd 5 spd: Needed to replace the rear ABS sensor and decided to clean the throttle body too while the battery was unplugged. Cleaned it around the butterfly and not much else. Truck idled at 750 BEFORE cleaning the TB. Now it fluctuates between 820 and 950 rpms. Also tends to stay at a higher rpm after pushing in the clutch and taking it out of gear.
Did a thorough check for vacuum leaks, nothing. After research, I cleaned the IAC and re installed (battery was disconnected then too). No improvement. Unplugged the IAC while running- ZERO change in idle. Installed new IAC, no change whatsoever. Unplugged NEW IAC, no change whatsoever. Is there an issue with the PCM needing time to fully re learn? Am I missing something.
View 14 Replies
So, instead of pushing the throttle cable back and then off, I tried to pop it off and broke the little tab. I've been trying to look for a replacement, but all I'm coming up with is an entire throttle body. Not too bad, but would still like to fix it for much cheaper. It's a 2002 F150 with a 5.4L.
View 2 Replies
Obviously its not a good thing, but this seems a little severe for a truck that hasnt had any issues prior. The truck is a 1998 F150 4.6 and was running just fine until POP!! A puff of grey smoke coming from the throttle body and followed by (obviously) a rough idle. So basically, I know that any metal fragments were directly sucked into the intake and based on the size of the chipped area (roughly 1.5cm). I am wondering what type of internal damage this would (or already has) caused.
View 3 Replies
My 97 Suburban died and will not start. Things I have done:
1 Changed fuel filter
2 Changed fuel pump twice
3 Checked fuel pressure 60psi
4 Changed plugs and wires
5 Changed rotor and cap
6 jumped switch to make sure pump runs
The Suburban will start only if I pour gas in the throttle body and will idle as long as I continue to pour gas in but will die when I quit.
View 7 Replies
So i have been hearing a whistle under acceleration for some time. Normally comes at 1/2 to full throttle. I also have had check engine light for a bad o2 sensor for about the same amount of time(2months). Fast forward to last week. finally replaced sensor. Check engine is gone. Open her up a little on and on ramp, Whistle is still there and the CEL comes back. Have it scanned, and it come back load calculation cross check 17551. I need an sticker so i rest the ecu (no light) and drove it like a grandma 50miles to get the sticker. No CEL. Get sticker. Just to make sure i wasn't crazy i gave her some gas on the way out of the inspection lot, and there is the CEL.
In conclusion, Between the whistle, CEL, and the fact that i drove it 50 miles with out the CEL coming back under very light throttle, and i just replaced the MAF with a new Bosch 2 months ago, i am pretty sure it is some kind of vac leak.
I have a new TB gasket in the mail, but my question is, Is there other places where such a vac leak is common in these cars? Other info on car.
UM tune
evoms intake
HPA downpipes (whistle started after these where installed)
Flapper
no res
74k on the clock
View 11 Replies
Having issue with body squeaking ? . I am getting a squeaking sound coming from around the passenger rear door /body area of my 2010 Passat. Car has 10K miles and has been doing this since around 6K miles. Not noticeable unless going over uneven pavement or railroad tracks but it is annoying. Never had any body squeaks from a new car lite this. Have not been to the dealer with this issue yet.
View 6 Replies
2002 camry. The car will not accelerate. The throttle body makes a clicking sound when pedal is depressed.
So.. I took it apart and cleaned the contacts in it. In the mean time located a spare throttle body from a 2003 from a local yard. The old throttle body has a part number 22030-28030 and the replacement has a part number 22030 0H010. The replacement throttle body wouldn't even move when the pedal was depressed.
I put the old one back on.. and now it doesn't click anymore but the car in Park only revs to 2000 rpm's. Its not sticking or having any mechanical issue.
I checked the parts site for Toyota and the replacement is the new number. Superseded. Does the throttle body after replacement need to be reprogrammed? Or whats the deal. I wish I was more Toyota literate when it comes to this.
View 1 Replies
2006 Honda CRV, throttle by wire. How can you get the throttle plate open to clean the throttle body etc.
View 4 Replies
Got a 97 ford explorer sport that wont start. It will go like its going to start but I've only got it to run with ether then dies got new battery n tps thinking its the alternator because i hear a ticking in that area and the battery is now dead after i charged it all the way up granted. I did try consistently to get and keep running?
View 3 Replies
I have a 1999 Ford F-150 with 149,000 miles on it and when the engine gets warm it seems to flood its self out. I was told to change fuel filter, no change, I was told maybe the catalytic converters maybe plugged but then was told that wasn't the case either. Another mechanic mentioned some sort of ignition relay or computer issue? I do not have any lights on of any sort. I do want to mention before it started acting up the auto door locks would jump up and down erratically and my key phoebe will not work now.
View 8 Replies
I need to pull my throttle body so I can give it a proper clean, but Haynes says that I shouldn't use a wire brush because that will damage the "special coating" on the bore and butterfly plate. It says just to use a rag and solvent.
The crud on mine looks like it will need more than a rag, so I was thinking about a toothbrush rather than a wire brush - do you reckon that'll be OK?
View 5 Replies
I have a 2004 Ford F150 4x4 with 170,000 miles. its running a little rough so I thought I would clean the throttle body. do you clean it on the truck or remove it?
View 6 Replies