Ford - Explorer :: 1996 - Wheel Shake - Noise From Passenger Front
Nov 24, 2012
I have a 96 explorer 4x4 that i just bought and it has wheel shake. It also has a slight noise coming from pass front. So i jack it up and there is zero wheel play. I spin the wheel and it spins kinda freely until about 3/4 away around then it has some resistance to stop the wheel. Im thinking that could maybe a rotor a lil warped but not sure. Same wheel there are wires showing on the inside. Now i try the driver side and i cannot spin that wheel it has resistance all the time. So could this be hub or maybe just bad tire?
View 12 Replies
Advertisement
It seems to be coming from the front passenger side wheel well area. It's only present during braking and coming to a stop. Seems to be also related to wheel speed. The brake performance doesn't seem to be impacted but it's very embarrassing creaking through a parking lot. The noise doesn't seem to be present on a cold start but once the brakes warm up it really comes to life.
I noticed with both wheels up off the ground that the front passenger side wheel (The side making noise) had more resistance than the drivers side when trying to spin. [URL]...............................
View 1 Replies
Just started noticing that whenever i turn right the passenger side front wheel vibrates. 2003 ford explorer xlt 4x4. i asked a friend and he said cv axle.
View 1 Replies
I have a 1996 Ford Explorer (4WD model). Approximately 4 months ago I had a new set of tires put on it, and in the process of replacing the tires the shop noticed that I had a bad ball joint and one of my wheel bearings was going bad. They said the ball joints were known for completely failing, but the wheel bearings usually didn't, so they recommended that the ball joint be replaced first. That is what I had them do. I haven't had the money to get the wheel bearing replaced yet. This past week it got worse to the point where I can hear it now.
At low speeds I can hear a grinding/rattling-type noise from the front drivers side (that's the side that has the bad wheel bearing). At higher speeds the grinding/rattling-type noise fades away due to road noise, but I can still hear a humming-type of noise that is a bit loader than normal - this noise just started a couple of weeks ago so I'm suspecting that this might also be related to the bad bearing.
I won't have the money to get this fixed for another 2 weeks. In order for me to have the money in 2 weeks I will need to continue working at my job 2 days a week. It's approximately 2 hours round-trip from my home to my job. Obviously with the bearing sounding significantly worse I don't want to drive it any more than I have to, but the only way I can get the money to fix it is to keep driving it back and forth to work.
Here's my question. What risks am I running by continuing to drive this? Am I running the risk of the wheel falling off while I'm driving down the freeway at 70 mph? Am I likely to experience other damaged parts in that area of the vehicle?
View 14 Replies
I have a 03 explorer with approx 160k, I am experiencing a thumping noise while driving. It gets worse on right turns and gets better on left turns. initially i thought LF wheel bearing so i ordered a hub assy and replaced LF. noise is still there. I guess, thumping noise caused by wheel bearings, i know its usually a grinding kind of whirring noise.
The noise doesn't seem to change with accel/decel so I don't think it is driveline related (diff, drive shaft etc.) should i bite the bullet and replace the rf as well??? I should also mention that there is also a shake in the steering wheel that seems to coincide with the thumping (i.e., my hand shakes along with the thumping, and the shake gets worse when the noise does)...
View 8 Replies
I'm working on a 02 explorer. The front end is howling so I replaced the left side and no change. The howl goes away when braking. Is it the right side then or something else? I replaced both front brakes pads so it's not that.
View 2 Replies
I have a 94 Explorer. I recently swapped over from auto to manual hubs. I followed a detailed write-up that I found online. During the process I repacked my outer wheel bearings. Ever since then I hear a grinding noise coming from the front wheels. Sounds like the bearings aren't seated properly. The guide that I followed instructed to torque the spindle nut that sits next the the outer wheel bearing really tight in order to seat the bearing, then loosen it back up and hand tighten it. But when I loosened the spindle nut the wheel bearing would pop back out. What is the best way to get a wheel bearing to stay seated properly?
View 2 Replies
Just installed new actuator and wheel hub assembly on my 2009 f150,truck still had grinding noise in front passenger wheel , New solenoid and vacuum hose kit installed when test drove noise still there until you put the truck in 4 wheel drive it disappears . The noise returns as soon as you take it out of 4 wheel drive. Also mechanic said steering was tight,installed new shaft same thing, could this be the rack and pinion.
View 5 Replies
I have a 96 explorer that has recently developed a coolant leak. i was able to find the location of the leak, but i am puzzled by what is causing it. It is leaking on the back, passenger side of the engine, and while the truck is running it just squirts coolant out on and off...i am guessing it leaks when the thermostat opens. anyways, what is could be? i was thinking lower intake gasket, but i have never seen a lower gasket squirt like that!
View 3 Replies
I have some big time slop in my steering wheel, and what started as a type of binding when turning sometimes, is now really sloppy - almost dangerous
Is this the intermediate steering shaft? I just want to be 100% sure that I get the right thing before I buy it, as it's a dealer only part.
View 2 Replies
I owned a 99 f250 a little while ago. Just bought a 2006 crewcab F150 xlt about 2 months ago, and for the past month there has been this unusual grinding or whirring like noise coming from the front passenger side wheel.
I took it to the mechanic and he found a bad wheel bearing on drivers side and replaced it but that wasn't the issue. He could hear the noise but wasn't able to figure out what the actual issue was.
The noise only happens when my foot is on the throttle. (not when coasting) and i also just discovered that it doesn't make any noise at all when put in 4x4.
View 4 Replies
Concerning my recently purchased '99 GMC Sierra 1500 2wd 4.8L...
There is a seemingly undiagnosable, not that noticeable, rubbing noise that seems to come from the front passenger wheel - one rub for every revolution of the wheel. It is fairly subtle and can be felt (subtle) in the steering wheel between 30mph and 45mph. I don't think a lot of people would notice it and anyone that did would probably just turn up the radio at this point. After all, this truck has a very solid drive train and runs amazingly smooth for its age and mileage (172K)
Here are the repairs I have made that you might be about to suggest:- New front bearing/ hub assemblies on both sides within the last year. No play in any of the wheels.- New tires from Firestone within last month.- New tie rod ends and alignment. - New rotors, pads, and flex lines on front. Refurbished caliper on passenger side front.- New pads, calipers, and flex lines on rear. (one of the calipers had seized and I thought I had finally found the problem... not.) (one of the flex lines was the wrong part and was rubbing up against the rim... I thought that was the problem... not.)
Here are the things you are about to suggest I check:- Transmission, rear axle bearings, etc checked out by my trusted transmission shop. - Wheel well shields are firmly attached.
Things I haven't yet fixed : tail pipe bracket, evap emission solenoid assembly, blower fan resistor thingy, crappy door latch.
View 4 Replies
2004 F-250 FX4 SB 5.4 V8 140k
Issue: rattling/clicking noise from passenger front wheel area at speeds lower than 15MPH, made worse under light braking and/or turns to the right.
Clicking sound is speed dependant.
Spindle? Hub? Balljoint? Sway joint? Rotor Issue?
View 14 Replies
I'm buying a 2003 Ford Explorer, XLS Sport Utility 4D. She's got 150k miles on an automatic transmission (pretty sure this model only came in auto anyhow).I'm mostly concerned about the rear axle, as the title prompted. The rear wheel seems awfully close to the front of the wheel well. Is this normal? I google searched some images of this model and seems to be the norm in some cases, and in other cases not.
Attached is a photo of the concerning placement. Is the rear axle bent? Is this suggesting that the rear end is on it's way to crapping itself?
View 2 Replies
I got 66,000 miles and I am getting a rattle/popping noise when driving on roads that are bumpy. I thought it might be a strut going bad but somebody told me it might be a Lower control arm rear bushing....
View 2 Replies
I'm getting a loud clicking noise on my front passenger side around the wheel or axle. Once I press on the accelerator it starts. It goes faster and faster as the speed of the car increases.
View 5 Replies
Every time I drive on a wet road I can hear my front passenger side wheel going though the water and the driver side makes no noise. What, if any, could be the problem?
View 4 Replies
I have a 1996 Explorer with the 4.0 motor. Today coolant started running out between the Freon compressor and the block at the front left corner. I cant see behind the compressor. Compressor hose seems to be short and stiff so removal of the compressor is questionable? I look from the front and does not seem to be thermostat or temp sensors. It appears to be behind that, like the bottom of the intake manifold? I wonder if there is a known problem in this area or how to go about disassembly. Don't want to take off compressor and steering pump if the problem is intake manifold. Have a problem ? Where to start disassembly to look?
View 6 Replies
I have 2002 BMW 325xi (all wheel drive). For about 2-3 months now there is a squeaky noise coming from passenger side front wheel. It sounds like a really bad and rusty coil spring but the weird part is that that noise only appears in warm weather. It has nothing to do with how much distance I drive. If it is 70 odd degrees or warmer outside, the noise starts. In warm weather, the car does not have to be running/moving to hear the noise. I can just push down the passenger side front and hear the noise. I took to a mechanic and he wants me to replace tie rods, control arm and struts. basically the whole suspension system on the front for this noise (in other words, he does not know what exactly is making the noise, so replace everything)
View 5 Replies
I have an 04 WRX, I've upgraded the suspension (1.5" - 1.75" drop front and back respectfully) and have a full set up of strut tower braces. Recently when accelerating from a stop, I get a clicking noise from the passenger front wheel area, I hear it all the way through first, second, and most of third...the sound is probably present after that but my exhaust drowns it out. My first choice of problem is that the CVs have gone, the car has 140k on it...
View 2 Replies
I have a 2012 Camry SE and my front passenger seat seems to shake/shudder alot. It constantly shudders and makes so much noise when no one is sitting in it, that it's driving me crazy! I can't tolerate the noise of it. If I go over a bump it shudders, if i'm driving on a rough highway, it shudders and shakes so badly that I have to put my hand on it to make it stop. It makes squeaky noises as well. It doesn't happen when driving on smooth surface.
Secondly, the center dash is very squeaky, and made out of hard plastic. I feel there is no insulation behind, and thus it squeaks whenever I go over a bump. What steps did you take to resolve it?
View 12 Replies