Ford - Explorer :: 1996 V6 Won't Start / Lost Spark
Feb 1, 2016
I have a 96 v6 explorer that has lost spark and fuel press....
View 4 Replies
Feb 1, 2016
Advertisement
Celica :: 1996 GT Won't Start - No Spark On Any Cylinder
This has the 2.2 engine with the ignition coil mounted on the firewall, not inside the distributor.
Original not start condition seemed to be fuel related because it tried to sputter on time after it died in the middle of the intersection.
Changed fuel filter, primed and no start.
Checked for spark at the plug wire using a solid wire and touching a ground - no spark on any cylinder.
Tested for voltage at the center distributor cap - have 12 volts - replaced distributor - no spark
Replace ignition coil and ignitor - no spark
The wires all test with the right ohms so I'm not sure what is left to replace.
Ford - Explorer :: 1996 - Cranks But Will Not Start
Parked in driveway and 2 hours later it cranks but will not start. Pushed on fuel rail Schrader valve and it squirts out. Turn key and the fuel pump runs for 2-3 seconds then off...... Thought I had fuel... assume electrical. Read posts last night and thought crank positioner pickup was a good place to look. Took spark plug leads off #1 and #4 at coil and set a 1/4 steel dowel in each so they were 1/2 inch apart. Crank motor and I get spark out of coils so I assume the plugs are getting fire... Took off intake hose and shot ether in the tube while cranking... no fire or pop at all.
Where to now ? Seems like I have fire to the plugs, and fuel available but will not start. I have only one code and that's PO1116 coolant temp out of range..I don't have a cam sensor code or a crank sensor code...I thought they might effect the timing ? With spark at the plug wires, you would think I would get a "POP" now and then, especially with the ether ?
Explorer :: 1996 Ford Won't Start Unless Pump Brakes
I am having a problem with my 96 ford explorer.
Usually this only happens on warmer days, but after a few starts, my car will suddenly not turn over. I have found that the only solution to starting it is by pumping the brakes about 6 or more times, fast and hard. Its not the battery because all lights and everything work.
Something it may have to do with, I just found out when going to get my car smogged, my monitors reset everytime I turn on/off my car.
Start - Ford - Explorer :: 1996 - O/D Off Light Flashing
Was driving into town today in my 96 Ford Explorer XLT v6 4wd, when I noticed my O/D off light flashing. I thought to myself, "Another problem I have to bash at with a wrench to get going again." I figured that meant I'd be stuck with gear 1 and would burn some extra gas on the ride home, but after parking and running an errand, woe behold me but my car won't start! The starter turns, but no other noises come out of my now very-large paperweight. I've tried shifting into neutral, moving the car to get the gearbox turning, starting the car in neutral and park, yet the stubborn car remains dead. Am I drawing a connection between the light and the failure to start where one need not exist?
View 4 RepliesBuick - Regal :: 1996 3.8 Won't Start / Can't Hear The Pump Running - No Spark
I have a 96 buick regal thats been giving me problems for over a year now. it from time to time acted like it was out of gas even though it might have a half a tank. Turns over fine but won't start after it sits for a couple of days then it starts fine. Last summer my son replaced the fuel pump after doing a pressure test and getting a low reading. No more problems until jan then it started doing it again. Well about 3 months ago it wouldn't start so I had my wife turn the key on and I stuck my ear in the fuel fill tube and I could not hear the fuel pump.
I checked the fuel pump relay by putting my finger on top of it and I can feel it click when the key is turned on. Also the air relay next to it is the same so I switched them no change so I replaced the fuel pump again and also the sending unit so every thing in the tank is new. Car still won't start can't hear the pump running and i checked for spark no spark now. My other son has been saying he thinks its the ecm so I just put a reflashed used ecm in. Did the security relearn procedure still nothing. whats next? Somebody told me check the cam and crank sensors and wiring. I also replaced all the ignition coils last summer.
Ford - Explorer :: 1996 - Won't Start - Loud Click When Key Turned?
I have a 1996 4.0L Sport - 2 weeks ago, stranded wifey at food store, had it towed home, and replaced the starter solenoid - it started and ran for about 4 days, and then stalled once but started back up (it was cold out)
Another day, I went out to start it, and the same thing... loud click when you turn the key to start position, seems to be coming from solenoid again...
so, I thought, ok, the parts a week old, but sometimes they do fail...
So, I bought the best one around: standard "blue" which had brass on the back to best couple to ground, etc...
Put it in, and reconnected everything - and the SAME THING... clicks every time I turn the key. (single click for each time I try to start it....
questions is - how can I check these to see if I had 2 bad ones in a row, or would there be something else wrong?
Ford - Explorer :: 1996 - Alarm Will Start Honking Horn After Activated
I have a 96 explorer XLT 4.0 4 wheel drive. The alarm will start honking the horn after the alarm has been activated. It usually takes a few hours then it goes off. I was in extreme temps and was thinking that was it. I am in another state now and it's not that cold here. Could it be a battery in the fob? I have gone to each door and rear hatch to make sure nothing was left open.
View 3 RepliesEscort :: 1996 Ford - Spark Plug Removal
I want to remove the spark plugs but unable to loosen them. How I can easily loosen them up without breaking them?
View 2 RepliesEscort :: 1996 Ford / Change Spark Plugs And Wires?
I want to change the spark plugs and wires in my 1996 Ford Escort (1.9 Engine).
The problem is trying to remove the No. 1 spark plug boot and spark plug. Both are located behind the alternator and are difficult to get to. I tried a boot puller but could not get easy access to the boot to pull it off the spark plug. The other three boots and spark plugs are readily accessible.
Is it sufficient to place the dielectric compound just inside the opening of the boot before placing it back on the spark plug, or should it be placed on the metal clip that is ~2-3 inches down inside the boot?
Taurus :: Spark Plug Lost Platinum Tip And Banging Around
Can a computer detect issues with a fuel injector and disable it or randomly send signals if the injector is damaged? I have a 2002 Sable with the 3.0 OHV motor. Same as a Taurus for the most part. A while back I lost cylinder 5 while driving. Made a lot of pinging and misfired badly. What I saw was that the spark plug had lost the platinum tip and it was apparently banging around until I could get stopped.
I replaced all plugs and wires and find it has a bad misfire at idle. Not at normal speeds though. I checked and found the injector is "clicking" half of the time. About 30 seconds or so of every minute at idle it simply does not work. Thought perhaps the injector was damaged but I hooked a no id light to the cable and the pulse is random. Seems a bit much of a coincidence that something else would be wrong so am curious if perhaps the computer may be detecting issues and sending a random pulse. Of course that does not explain to me the random flashing of the no id light.
Ford - Explorer :: 1992 4.0 - No Spark And No Fuel
VEHICLE: 1992 Ford Explorer, 4.0, 4wd Automatic, CALIFORNIA EMISSIONS w/ 59,000 Miles...
PROBLEM: Engine rolls over great, BUT No Spark, No Fuel
Here are the tests I've done:
- Each and every relay √
- Each and every fuse √
- Ensure inertia switch hadn't popped √
- Directly connect 12 volts to pump & pump came on √
- By-pass inertia switch √
- Replace PCM √
I'm thinking it's time to start checking grounds and chasing wires....
Ford - Explorer :: 2003 - Blower Lost Speeds 2 And 3?
2003 Explorer. The blower lost speeds 2 and 3. Ford wants megabucks to replace the module. I have no clue on removal of the center of the dash. Access to used parts is no problem.
View 5 RepliesFord - Explorer :: 2002 - Spark Knock Noise When Hot
My 4.6 explorer has a spark knock noise when hot. When the engine is cold or on cold rainy days it does not make the spark knock noise. I have tried higher octane gas and octane boosters but it does not seem to work. Check engine light is not on and there are no codes. Could I have a bad egr valve or knock sensors with no codes...
View 5 RepliesFord - Explorer :: 2003 - Keyless Entry Lost Code
I have a 2003 Explorer with the Factory Keyless Entry on the driver's door. It recently quit working with either my code or the factory code. I have cleared my code, and the only response is that the keypad will light up, and I can lock all doors with the pad. It refuses to take a code to unlock. Other than the dealer route (and a possible new GEM)? The wireless remotes continue to work well.
View 14 RepliesFord - Explorer :: Coil Pack Isn't Putting Out Spark To Cylinder 1
1998 Ford Explorer. Coil pack isn't putting out spark to that cylinder. Would the next step be to replace the pack, or might I check something else 1st?
View 5 RepliesFord - Explorer :: 2001 - Engine Shut Off Without Warning / No Spark?
I have a 2001 Sport Trac with the 4.0L engine and it's not producing a spark. The problem started when my dad was driving down the road and be claims it just shut off without warning, no sputtering, nothing. He had taken it to a shop and they had just come right out and said the engine went. My bf looked at it and he says there are no signs whatsoever of the engine going.
No oil in the coolant or coolant in the oil, we have replaced the ECM, coil pack, crank sensor, spark plugs, and checked the fuel. The theft light flashes every few seconds, not rapidly, so we ruled that out. The truck turns but doesn't start, when the key is turned to the "run" position, you can hear everything turn on, it just doesn't start. When it cranks, it isn't fast or slow, it's the normal speed from what I can remember so I'm not sure if it could be the timing chain or not. Where we can go from there?
Ford - Explorer :: 2002 - Antifreeze Buildup On Top Of Spark Plug 6
My 2002 Explorer is having a problem. It started running rough suddenly and when I had it checked the # 6 coil pack on the spark plug was bad. We replaced it and it still ran rough. Found fluid on top of spark plug. At first thought it was oil due to the color but later figured out it was antifreeze. We do have a cracked thermostat housing that we tried to seal up a few months ago. Doesn't seem to be coming from there. This is my only reliable transportation.
View 4 RepliesFord - Explorer :: 2000 - Number 1 Spark Plug Not Firing
Ford Explorer Sport 2000, Number 1 spark plug has miss firing already replaced spark plugs wires and coil pack what more can i do to get spark from number 1 to spark and took garden hose to listen to injectors clicking when running. any other part for spark.
View 1 RepliesFord - Explorer :: Automatic Transmission Quit / Lost Power Going Up A Hill
We have a 02 explorer with the 5R55W transmission. We lost power starting up a hill. Now it has nothing. No reverse, forward. Does not even think about moving an inch.
We can not find the dip-stick. Looks like a nut on top of the transmission that you stick a finger into or makeshift dipstick to see if it is topped up. It probably has a cooler on it.
Never noticed a loss of fluid. Nothing at the bottom of the hill...
Ford - Explorer :: 2000 V6 Lost Power And Died When Driving Down The Interstate Doing 70 MPH
My daughter was driving down the interstate doing 70 mph when her explorer lost power and died. It will not re-start. Checked the DTCs and there were no codes. This same thing happened about a year ago and she had it towed to the dealership. After 3 weeks, they called and said to come pick it up. They said they had no idea what had been wrong but it was running. They replaced crank sensor, cam sensor, cleaned and checked several others an it still would not start. Then one day they sent one of the flunkies to move it back into the shop and he started it up and drove it in! They checked several more things but claimed they really didn't know what was wrong or why it started running. Now it has done it again. I suspect it may be a faulty ECM.
View 3 Replies