Ford - Explorer :: 1996 - Cranks But Will Not Start
Aug 1, 2015
Parked in driveway and 2 hours later it cranks but will not start. Pushed on fuel rail Schrader valve and it squirts out. Turn key and the fuel pump runs for 2-3 seconds then off...... Thought I had fuel... assume electrical. Read posts last night and thought crank positioner pickup was a good place to look. Took spark plug leads off #1 and #4 at coil and set a 1/4 steel dowel in each so they were 1/2 inch apart. Crank motor and I get spark out of coils so I assume the plugs are getting fire... Took off intake hose and shot ether in the tube while cranking... no fire or pop at all.
Where to now ? Seems like I have fire to the plugs, and fuel available but will not start. I have only one code and that's PO1116 coolant temp out of range..I don't have a cam sensor code or a crank sensor code...I thought they might effect the timing ? With spark at the plug wires, you would think I would get a "POP" now and then, especially with the ether ?
View 8 Replies
Advertisement
I just purchased a 2004 Explorer from a police auction. It had driver side damage but nothing major. When I try to start it it cranks but nothing else. I purchased a new battery, fuel filter, coil packs, spark plugs and installed all. But same thing it tries to fire up but stops short. A few times we sprayed starter fluid in it and it would start for about a second and a half and shut off..... I also listened for the fuel pump and I hear it coming on when I turn the key and checked the inertia switch...
View 9 Replies
My explorer starts fine some days and others it just wont. No codes, have replaced fuel pump. Rail and starter.
View 11 Replies
'99 Explorer 5.0 doesn't want to start in the cold weather, below 30. After it finally starts it runs great and will start all day. It cranks fast but it doesn't get driven every day.
View 2 Replies
I have my My brother-in-law's blazer in my garage after a 60 mile tow. This is a TBI model with distributor. The dash lights went out, and it cranks fine but does not fire, even with starting fluid sprayed int the throttle body. Below are the details of what has been done so
far:
- Checked all fuses, none are blown.
- Could not get a spark from the coil wire when next to block while turning it over
- with ignition on we are only getting .11 volts from the connector that goes to the coil, should this be 12 volts?
- Ignition module tested ok (out of the vehicle at an auto zone and they said it was fine)
- can hear the fuel pump run at startup, (was replaced with a delphi pump last winter, but we could not get the fuel filter off at the time and he never replaced it)
- Did not check fuel pressure, but it sprayed out at test port when I pushed the valve.
PCM failure? What else?
View 4 Replies
I am having a problem with my 96 ford explorer.
Usually this only happens on warmer days, but after a few starts, my car will suddenly not turn over. I have found that the only solution to starting it is by pumping the brakes about 6 or more times, fast and hard. Its not the battery because all lights and everything work.
Something it may have to do with, I just found out when going to get my car smogged, my monitors reset everytime I turn on/off my car.
View 1 Replies
Was driving into town today in my 96 Ford Explorer XLT v6 4wd, when I noticed my O/D off light flashing. I thought to myself, "Another problem I have to bash at with a wrench to get going again." I figured that meant I'd be stuck with gear 1 and would burn some extra gas on the ride home, but after parking and running an errand, woe behold me but my car won't start! The starter turns, but no other noises come out of my now very-large paperweight. I've tried shifting into neutral, moving the car to get the gearbox turning, starting the car in neutral and park, yet the stubborn car remains dead. Am I drawing a connection between the light and the failure to start where one need not exist?
View 4 Replies
I have a 96 v6 explorer that has lost spark and fuel press....
View 4 Replies
I have a 1996 4.0L Sport - 2 weeks ago, stranded wifey at food store, had it towed home, and replaced the starter solenoid - it started and ran for about 4 days, and then stalled once but started back up (it was cold out)
Another day, I went out to start it, and the same thing... loud click when you turn the key to start position, seems to be coming from solenoid again...
so, I thought, ok, the parts a week old, but sometimes they do fail...
So, I bought the best one around: standard "blue" which had brass on the back to best couple to ground, etc...
Put it in, and reconnected everything - and the SAME THING... clicks every time I turn the key. (single click for each time I try to start it....
questions is - how can I check these to see if I had 2 bad ones in a row, or would there be something else wrong?
View 14 Replies
I have a 96 explorer XLT 4.0 4 wheel drive. The alarm will start honking the horn after the alarm has been activated. It usually takes a few hours then it goes off. I was in extreme temps and was thinking that was it. I am in another state now and it's not that cold here. Could it be a battery in the fob? I have gone to each door and rear hatch to make sure nothing was left open.
View 3 Replies
4.0 SOHC cranks once no start, then starts on second crank. 104K miles and used to idle very smooth, now mildly rough and sometimes upon stopping the rpms will dip down to almost stalling but not every time. Also just had the fuel pump replaced.
Also... Seafoam? Is this really as good as it sounds, I mean it can be used on anything, except cereal!
View 2 Replies
My new-to-me Explorer appears to switch to 4WD high but refuses to engage 4WD low. And now I have the 6-times-flashing 4WD and 4WD low dash lights when turning the ignition on.
I used the correct procedure: Stop the car, put it in neutral, and switch to 4WD low. Nothing happens.
I looked for a ground wire from the top of the transfer case to the chassis. I can't find any such wire. All the under-hood fuses are intact.
In the process of looking for the ground wire I discovered a capped 3/8 inch or so vacuum hose about 6 inches long with a right angle fitting at the front of the transfer case. I also found a capped 2-foot-long hose of similar size connected to the top of the front differential. What the heck are these hoses? Has somebody intentionally disabled the 4WD?
I am reasonably adept at electrical repairs, troubleshooting, and modifications..
View 4 Replies
96 sebring 2.5l v6 non-convertibleRan terribly for 12 blocks when I bought it, then died and wouldn't start.Bought it because friend said that mechanic had told him it just needed the head gasket changedReplaced the head gasket then it would crank but not start
checked, getting spark and compression on all 6 cylindersreplaced:-ecm-crank position sensor-combination distributor/camshaft position sensor/coil-flushed fuel system and replaced gas. checked everywhere for possibly misconnected wires and possible misconnected vacuum tubes, they are all triple checked ok. Checked the timing about a dozen times. Checked for misaligned timing sprockets, all ok, no sheared keyways, valves open and close at appropriate times / correct order and crankshaft timing mark matches cyl 1 position.
Fuel pressure is great.Turns over but doesn't fire at all.
View 1 Replies
My 1996 Ford Explorer makes this dreadful droning noise - but only when the outside temperature is above 78 degrees and the engine is warm. This is summer 3 and it seems to get louder and louder each year. The doing is loud. I am embarrassed in parking lots. It does not matter if a/c is on, or the fan. The noise goes away with throttle. Which may mean the engine vacuum is involved in the noise.
View 4 Replies
My 96 Explorer has been sputtering on me. I took a right turn one day and now its sputters at acceleration. It has a new fuel pump, filter, injectors, coil pack, plugs, wires, idle sensor, EGR valve. Also, all vacuum lines are good and not cracked or broken. My mass air flow sensor is also clean and clear. I have done all my own repairs on my cars and trucks all my life and thought I was good at it (not so sure about that now).
View 1 Replies
On my 96 explorer the speedo most always reads 50mph. It goes to this as soon as you take off. You can be doing 5mph or 75mph and the speedo goes to 50mph and stays there. Everything else on the instrument cluster works. Is there something I can replace on the speedo only or do i need to find a good used instrument cluster?
View 1 Replies
1996 Explorer xlt 4.0l ... I ran into this issue a few years ago on a drive up through the mountains. Had the tranny replaced shortly after.
Rebuilt the engine once due to leaking head gasket.
Rebuilt it again 2 months ago due to leaking rear main seal.
Had a new torque converter installed during last engine rebuild, so tranny has been shifting and driving like a dream.
Just drover about 30 miles on highway, all pretty flat. OD light started flashing. I didn't notice ANY change in the way it was driving, sounding, shifting... anything! I know this is some sort of oddball error with this transmission in this vehicle, but i need to know if it requires further investigation.
Also, sometimes upon starting up (i am a pizza deliver, so i often shut it off and start it again 1 minute later) the OD and (i think) the 4x4 light flash at the same time, and my windows wont work for around 15 seconds. I've also noticed that my ABS will sometimes kick in randomly on dry ground during slow stops.
I am not in the mood to just start dropping cash on random sensors or modules or repairs if i can find any solid evidence of an issue (i've been battling an EGR issue for 4 years). I was thinking maybe the vehicle speed sensor?
View 1 Replies
I'm replacing the oil pan gasket and the new gasket came with a half moon plastic seal. I noticed that there is a grove in the new engine at the rear of the engine but the old engine does not have this grove. Looking for info about this seal, do I need it or not?
View 2 Replies
I have a 96 explorer, and it will just shut off, but restart ok. V6 push rod motor. It has only done it 2 times in the last 2 weeks. One time I was driving slow, been running for about 20-30 min
The other time I had left it run, while I ran in to pick up a pizza, and my wife said it just shut off, had been running around that day , but started it about 15 min earlier. I fill it up before it hits 1/4 tank....
View 1 Replies
I recently acquired a 1996 Ford Explorer XLT with a 4.0 OHV engine 62K mile. During vehicle evaluation I found a small coolant leak on coming from the timing cover gasket. I had the timing cover gasket and water pump replaced by a trusted mechanic.
Upon receiving the vehicle from the shop I immediately noticed wildly fluctuating engine temps, going above normal to nearly overheat and then suddenly dropping too cold. This would happen as I am driving at speed or at idle. I replaced the t-stat with a fail-safe type and find that it still does the temperature fluctuation. Called mechanic and he recommended burping the cooling system. Freed air in the system by topping off during cold start and adding coolant till full, and the condition seemed to improve but not fixed.
The fluctuation is much more minimal now, but the engine temp is always lower than normal on the gauge display. Before the initial service, temp gauge read dead center at operating temp always. Now it always runs colder, no matter what. The heater works too, and sometimes it seems to affect the temperature when I engage the heater during driving after warmup, the temp will start fluctuating.
I noticed that the upper radiator hose is much hotter than the lower radiator hose. In this case, after a drive the upper hose had surface temp of 200 F and lower hose had surface temp of 130 F. I have heard of backwards water pump manufacturing and I am beginning to think that is culprit. I can see the flow indicators on the upper hose showing coolant flowing from the radiator to t-stat, but hose surface temps testing suggest that it is operating backwards to me. I do not have the original water pump to comparison.
It became apparent that the fan clutch may be sticking some. When I cold start (30 F ambient) the fan runs at high rpm for several minutes before slowing. Even warm start fan will spin up with engine until second or third gear, then spin down. Is that normal operation?
View 7 Replies
When car is started, volume on radio is very low. As the car warms up, the radio volume increases. What do I check or fix?
View 13 Replies
