Ford - Explorer :: 1995 Will Not Start / Zero Pressure
Sep 10, 2012
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 4 Replies
Advertisement
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 8 Replies
I have a 95 Ranger 2.3 with a manual tranny. In the past I have had problems with this truck not starting do to a bad inertia switch and numerous fuel pumps. A couple of weeks ago I pulled the truck off of the driveway into the street and let it set there for a few hours. When I went to put it back on the driveway it would not start. I got it pushed on the side of the garage. I did my normal routine of doing a pressure check. I had no fuel pressure so I assumed that it was the fuel pump (as usual) so I dropped the tank and changed the pump.
I got it back together and it still wouldn't start. I checked the fuel pressure and the manifold still had 0. So I started my diagnostic. I have power from the fuse to the fuel pump relay. I then checked the wiring at the inertia switch and found that there is no voltage with the key on at the supply side of the inertia wiring. I verified continuity between power distribution block and the inertia switch. I put in a new fuel pump relay and it still has no fuel rail pressure and there still is no electric signal at the inertia switch. Where to go from here?
View 6 Replies
2000 explorer XLT, 4.0L, OHV (VIN "X")---sitting for 15 months, engine turns over but no start unless 10 cc's of gasoline into intake manifold, then runs for 4-5 seconds. Fuel pressure of 5-6 PSI at fuel rail AFTER replaced fuel pump assembly and fuel filter. I can hear fuel pump come on for about a second with key on. Doubel checked fuses and relays for fuel pump and PCM, then again checked that engine would run briefly with gas squirted into intake manifold. Questions:
1) Could fuel lines be clogged after sitting for over a year?
2) Area driver's side next to spare tire, underneath jack storage, where return fuel lines are clustered (nuts are rusted and need to be sawed off)---some type of fuel regulator here? I thought fuel pressure regulator was on fuel pump assembly.
View 11 Replies
I have a 2002 ford explorer with 70000 miles on it. The problem is that the oil pressure occasionally go from normal to no pressure immediately. Then within a minute it pops right back to normal. It has happened when I first crank up and sometimes just going down the interstate at a normal speed. My fear is that the oil pressure is really gone and there is a pump problem but with it either working or not I fear it could be a sensor problem.
View 5 Replies
I just got a 1995 explorer from my father in law... I have noticed a vibration from 55 to 60 cannot figure it out.. What might be causing it? It is my daily driver to work...
View 1 Replies
I have some major problems with my explorer. The idle is rough and accelerating is rough also. If I nearly put it to the floor it almost seems like it studders the power. it will feel great for a second that feels like it's less power for a second then more and less and more and less. When I'm sitting at idle, it will idle fine then after a minute or so it will bog way down and shake the whole vehicle. when that happens I give it some gas and it comes back to normal idle then it does it again after sitting for another minute. I've replaced spark plugs, wires, alternator, oil change and some tires. I've been told by many mechanics it could be the IAC Valve or the fuel pump or the fuel filter or a vacuum leak.
View 8 Replies
The OD OFF light starts flashing by itself and I can't get it to go out. Everytime it does this, the car is sluggish, won't pull very good at stop signs and kicks hard when down shifts. Thought it was weather related but it doesn't matter what the temp. is. Eventually it will go out by itself and everything is fine.
View 4 Replies
My 95 explorer heater only blows out cold air. I have topped off the antifreeze and just replaced the thermostat. The engine operating temperature is very cold, it won't even come up to the first mark. It is very cold here in Utah but I still can't imagine why the engine won't heat up.
View 9 Replies
I'm working on a 95 Explorer, and I need to know where the end of the negative battery cable should be bolted to. Right now, it's hooked to a bolt on the back of the starter. That just doesn't sound right......
View 3 Replies
I'm working on one of our fleet vehicles here, a 1995 Explorer. about 2 months back, it stalled out. Got it back to the shop and turned the key on .... I couldn't hear the fuel pump. I replaced the fuel pump and the fuel pump relay. Vehicle started right up and seemed to run O.K. About 2 weeks ago, it stalled out again, same symptoms, acts like it runs out of gas and can't hear fuel pump.So, I have been playing with it and find that it starts up great in the cool mornings. In the afternoon when the temps are hotter, it won't start (can't hear fuel pump). The following morning when temps are cool, it will start right up and can hear the fuel pump. I almost wrote this one off as a defective fuel pump, but I'm not sure on this one.
View 7 Replies
I have a 1995 F150 with the 4.9L and it has 73000 miles on it. One morning recently (it was about 35 degrees outside) I went to start my truck to let it warm up. When I let off of the clutch it stayed on the floor. I shut it off and drove my car to work instead. I asked around at work and one guy mentioned that it was probably my clutch master cylinder...so that day we replaced it, and bled it until it felt like knew. Since then, we have had to bleed it three more times, because the pedal keeps losing its pressure making it harder to shift. I have inspected around the clutch line and the bellhousing for signs of needing to replace my slave cylinder, but everything looks fine.
View 8 Replies
My truck is vibrating and shaking when you go over 30. but occasionally stops. I replaced the whole rear end, rear shocks, rear brakes, rear drive shaft U- joints, rebalanced the rear tires( they needed that). at least that fixed the noise (grinding) from the rear end is gone but it is still vibrating.. Over $700 in it this week. at least i did the repairs myself and saved a bunch of money. But i am now stumped... I dont know it if is front end issues, transfer case issues, transmission issues....
View 4 Replies
I had a clutch, slave cylinder, and master cylinder replaced about 20,000 miles ago. Everything seemed to be working fine until I drove across the Rockies. The transmission was extremely difficult to shift, and the vehicle would actually roll forward when cranking the engine at fuel stops (temps were minus twenties). Once I got out of the mountains on both ends of the trip (where it was warmer), the clutch worked normally. The local Ford dealer found lots of air in the hydraulic clutch system, bled it, and it worked fine for several months.
The clutch is doing the same thing currently, but not all the time. Some days it's fine, other days it's difficult to shift although double clutching seems to work. It gets particularly hard to shift after a long drive (e.g., interstate driving for a couple of hours). I took it back in this morning to see if the dealer could figure out what is going on, they're saying it's likely a bad slave cylinder. I've heard the 1995 Explorer clutches are a bear to properly bleed, and can't work but think there may still be some air in the system.
View 5 Replies
The cruise control and the overdrive off dash lights go out when I turn on the headlights. The cruse control and overdrive still work but the dash lights are not lit. It is a 95 4door explorer.
View 1 Replies
I have a `95 explorer with the 4.0 motor. The electronic overdrive off indicator light (O/D Off) on dash started flashing today. The transmission seems to be shifting into overdrive. Owner's manual says to have it checked as damage can be caused. What I should be checking?
View 11 Replies
My car is taking a long time shifting from reverse to drive in the morning. Do you know what may be causing it and how to fix it. It's a 1995 automatic ford explorer.
View 3 Replies
My truck is a 1995 Explorer 4.0 150,000 miles, 5 speed.
Problem - Rough idle : when cold it's worse and will stall and choke a little. When warmed up it just has a rough idle but will not stall and stays at a pretty constant RPM. It's very tolerable when warmed up but still not right. It drives fine once off idle. No black smoke that I can see. Power may be just a little off but I would not bet on it. MPG seems about normal but haven't been on a long enough trip since problem started to tell for sure. Also longer than normal cranking on occasion.
Diagnostics so far : Fuel pressure is at 32 PSI, vacuum off regulator it's at 40 PSI. Not sure about key on only as I don't trust the autozone loaner gauges. You have to fiddle with it each time before it will read. Leak down after 30 minutes was about 4 PSI
No Check engine light ever. KOEO test shows no hard or on demand codes, I get the 111 pass. From CM I get 336 and 45.
336 is EGR related and my looks pretty rusty. I put a vacuum pump on it while running and the EGR held vacuum but had no effect at all on idle, I was expecting it to get worse as I opened the EGR so it may be stuck.
Searched high and low for vacuum leaks by ear, visual and with starting fluid all turned up nothing.
Actions so far : Replaced plugs, wires, IAC, and fuel filter. Cleaned MAF sensor and throttle body plus ran lucas fuel injector cleaner through it.
Next steps : I've got the EGR but it's so rusty I am sure I'll break the tube it bolts to plus I don't know it that alone will cause the rough idle. Will the DPFE sensor and/or EVR create a rough idle yet not turn on the CEL?
Thought about changing the fuel pump and/or regulator but the numbers are not terrible. Agree?
Thought about changing the intake gaskets but don't see any leaks.
View 8 Replies
I have a 1995 Explorer 4x4, and starting last month i have been having an intermittent problem with bang shifting, the only time the bang shifting occurs is when the overdrive off light flashes, the only time the O/D Off light flashes is after driving the interstate or driving around town on hot days, after a few days or a few weeks the light turns off and its shift normal and no bang shifting, but i have a new problem now, the O/D Light off started flashing last night after driving the interstate and I noticed on my way home that it wont shift, it hit 4000rpm and i had to tap the break and accelerate again to make it shift, I went to AAMCO and they wont give me the codes the only thing they said is they want to do a soft parts rebuild, and something about hte gear ratio being off, i dont have the money to spend for a new trans or have one rebuilt, i would like to fix this myself.
View 14 Replies
I have a 95 4-door Explorer XLT. When either front door is opened, the front courtesy door lights and the front dome lights on the overhead console don't come on. (I have tested and/or replaced the bulbs.) However, the rear and cargo dome lights do come on. The LED display on the overhead console does correctly display temperature and direction. The lamp buttons on the overhead console, also, don't turn on the map lights. The interior dimmer switch will turn on just the rear and cargo dome lights. The fuse is good and the vanity lights in each sun visor work fine.
View 6 Replies
I have a 03 explorer sport trac that has no fuel pressure the pump will not run. It is a bew pump just replaced it amd drove 4 miles cut it off filled up with gas now it wont run I replaced the pump again thinking I might have got a bad pump but it still wont run. I've checked the relay and inertia switch I have the 5 pin connector on the fuel pump module. 1 wire has good power to it but the pump won't run...
View 6 Replies
