Ford - Explorer :: 1995 - Can't Hear The Fuel Pump?
Apr 3, 2012
I'm working on one of our fleet vehicles here, a 1995 Explorer. about 2 months back, it stalled out. Got it back to the shop and turned the key on .... I couldn't hear the fuel pump. I replaced the fuel pump and the fuel pump relay. Vehicle started right up and seemed to run O.K. About 2 weeks ago, it stalled out again, same symptoms, acts like it runs out of gas and can't hear fuel pump.So, I have been playing with it and find that it starts up great in the cool mornings. In the afternoon when the temps are hotter, it won't start (can't hear fuel pump). The following morning when temps are cool, it will start right up and can hear the fuel pump. I almost wrote this one off as a defective fuel pump, but I'm not sure on this one.
View 7 Replies
Advertisement
Geo won't start. It has a new battery and air filter. Just replaced the fuel pump and fuel filter. I don't hear the fuel pump "whirring" when I put the key in the ignition (to on position). All the dashboard lights come on when the car is in on position.
I suspect the relay or the fuse, but having trouble finding the correct one of each. What does the relay look like? i.e. part number? What is the spec for the fuse? 20amp 30 amp? This has been a great car.
View 5 Replies
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 8 Replies
when I turn key I should hear fuel pump, I don't. I can jump pump & it will run but it still won't start. I reset inertia switch, switched pumps (new one) still won't start. What next????
View 1 Replies
I've followed steps 2-6 from this image
I don't feel any pressure in the hose from the fuel filter. I can hear a buzz (guessing its from the fuel pump) but no pressure.
I've checked both fuses, the efi main relay, and swapped out the circuit opening relay with a known good one and all checked out good. Only thing left is the fuel pump or the writing and electrical connectors.
Car has pretty much took a dump one morning and has almost no power. I can't find anything else wrong with this car besides this. Is the fuel pump the problem even though I can hear the pump?
View 5 Replies
Got done with replacing head gaskets and intake gaskets, Van started fine and I backed it out of the garage. Left it running and put down ramps and drove up on them so I could get under and connect the exhaust. Got that done and then got back in it and all it will do is crank and it will not start now. It also has a new cam shaft sensor( wire broke on old one). I can hear the fuel pump when I turn the key. It is like now there is no fire to start it. What could be wrong? What do I check? What causes it to fire? If something was connected wrong, would it have still started and then wont do anything but crank? Got dark on me and started raining so I say tomorrow is another day. I feel it is something simple.
View 4 Replies
2005 1.8t gti wont start. The other day I was driving on the highway when a thin plastic type wrapping got caught in my serpentine belt. The car immediately died and I hit the gas and nothing and with no power steering i pulled over to the side.
Timing belt was done with water pump and tensioners
Spark plugs and coils are brand new
What fuel line to disconnect to test if the fuel pump works? Like I said in the title I cant hear the fuel pump priming. The engine was running 100% before this 2 techs saw it and the vw dealer i workrd at looked it over.
View 7 Replies
It was acting rough and was a little loud. Like a low deep loud, the engine light came on. I tried to start it, it would crank but no start.
Code came up P0340 (Cam sensor) So i replaced it, reseted and scanned again, now it says P0343 To much input sensor 1 bank 1. When i turn the key over to "ON" I don't hear the fuel pump, is this normal?
I don't understand what to do I am so lost, I am ready to do the timing. Is there something cutting my fuel pump out or is it done? Do i do the timing, or replace the pump ...
View 7 Replies
Sometimes my Bravada won't start. It cranks good (new battery) and I can hear the fuel pump , but it doesn't fire up. I just got it back from the repair shop.?
View 4 Replies
My issue. 95 short Aerostar, Vulcan engine, A4LD trans. Just got it last week. Bought a new trans and when I went to pull the van into the shop, it wouldn't start. Cranks but won't run. First thing I checked is fuel pressure, got zero. Pulled the kick panel and found the inertia switch, but the harness for the switch is getting 1.8 volts with the key in "ON" and the same with it in "START". IIRC it should be zero in RUN after a second or two (if the engine isn't actually running, that is), and 14 in START.
Checked all fuses in the panel by the steering column, they're good, and switched around the 3 relays by the battery. No good and I don't hear the FP relay when I turn the key. For now I'll run wires directly from the battery to the pump, just til I get the trans done, but it needs to be fixed anyway because I plan to make this van a DD. Here are my questions:
-Is there a second fuse panel I didn't find?
-Could this be a computer issue? If it is, would the computer fuse be blown?
View 2 Replies
My 1995 ford ranger with a 3.0 will not start. It acted like the fuel pump was going out so I replaced it. I also replaced cmp sensor and the camshaft synchronizer due to old cmp sensor broke and messed up the synchronizer. My truck is getting fuel and spark but still will not start. Where do i go next?
View 4 Replies
I have a 03 explorer sport trac that has no fuel pressure the pump will not run. It is a bew pump just replaced it amd drove 4 miles cut it off filled up with gas now it wont run I replaced the pump again thinking I might have got a bad pump but it still wont run. I've checked the relay and inertia switch I have the 5 pin connector on the fuel pump module. 1 wire has good power to it but the pump won't run...
View 6 Replies
My friends 2000(I think) explorer With the 4.0 86k has burnt up two pumps in two weeks. This last one only lasted a day. There was over half a tank of fuel in it when installed and only drove it to work and back, about 50 miles. Next morning he went to leave, nothing. Pump won't run. Checked fuses and relays they were okay. Why would this be happening?
View 2 Replies
I have a 2002 ford explore 4.0 sport 4wd. I have a problem with my car, one day I tried starting the car and it didn't want to start. So i replaced the fuel filter and the car started. then after starting it a few times it didn't want to start anymore, so i took of the fuel tank (thinking bad gas, and there was stuff in the gas) so i take out the old gas out and put new gas, and bought a new fuel pump and filter, and when i put the gas tank back on the car, it still didnt want to start, so i take the fuel pump and find a random battery and connected it to the fuel pump and the pump spins so it works. I connected the pump to the car by itself not it the fuel tank (from underneath the car) and i was under the car to see if the pump turns on and someone tuned the car on, and the pump doesn't turn on (doesn't spin or anything). Long Story short, what i should do? Also I was looking for the fuel pump fuse and couldn't find it (thinking it might be the fuse) what is the fuse number or where its located.. i know where the fuel pump relay is, but just not the fuse. Why the pump wouldn't turned on??? The pic is how my fuse box looks like(there are many different version of the fuse box just wanted to show you how mine looks)...
View 11 Replies
Just did a complete engine rebuild on 2003 Explorer. All back together....have new battery, starter working, spark at plugs lol crank but no start. Next check is fuel. Fuel pump WAS working fine when timing chain guides went about a year ago...(had to rehab 2 parents and finish bath remodel before pulling engine) So... 1 year later I can't seem to get the fuel pump to work. I checked all fuses and relay. The fuel gauge is working - full tank.
View 14 Replies
I have a 2000 4.0 Explorer that sometimes will not start. It has happened on cool mornings as well as hot days after I shut it off, for example, shutting it off to fuel up. I always turn the key to the on position and wait a second or two before cranking, and when I do that, I can usually hear the fuel pump. It's when I don't hear the fuel pump that I know it won't start, and sure enough, crank and no start. My question is, is the fuel pump going out? Or another thought I had was maybe the inertia switch starting to fail? It runs great when it starts, just has a problem starting sometimes.
View 8 Replies
I have an 03 Explorer that had a starting issue. Long story short, it had no fuel pressure. So after testing the relay, I switched out the pump with an Airtex unit . All seemed fine...for a while.
Became hard to start again, checked Schrader valve with the key on, and not running, no pressure. Strange though, it would run.
So got the fuel pressure gauge on it. Turn the key and pressure will go to about 5-10psi and then drop to zero. Turn key off and on again, up to 5-10psi, then drop to zero. Turn the key to start and pressure goes up to 10psi, then starts, then goes to 30 while running and you can drive it around. Shut off motor and pressure goes down to zero.how the sending unit is supposed to hold fuel pressure and not release it? Is there some kind of check valve in the sending unit assembly that can be cleaned or does it need a whole sending unit with another pump? I already spent the $100 for the pump, and it is working if you can drive it!
View 13 Replies
My parent's bought a 2002 Explorer 4.0 V6 very early, either late '01 or early '02 when it first came out. Besides the dash blackout (which I found a fix for, need to do) it's been plauged latley (since Nov/Dec 2010) with the intermittent issue of when... You turn the key on to start, you dont hear the fuel pump enguage, thus no start. Get towed, it works like a champ.
It's blown a fuse 1 or 2 times cause of this, had the fuel pump recently replaced (dec/jan this year) and just did it again. Our local Ford dealership figured the fuel pump went bad from sitting, the vehicle only has about 33k miles on it (dad dont drive much). What appears to be a bad fuel pump, only to have it get towed, or sit overnight and start like nothing ever happened?
Dad's ranting about not trusting the vehicle anymore, he's 80yrs old so I can't blame him for wanting to feel comfortable with knowing his vehicle should start, but it is a machine, they do break but we cant seem to get this fixed.
View 14 Replies
After my 95 GCL wouldn't start and was towed to Jeep dealership, the problem was diagnosed has the fuel pump. I went to pick up my Jeep. Started and ran beautifully..but I noticed the air bag light was on, and wasn't that way before it wouldn't start. Went back into dealership and told'em..they told me nothing they did would have any bearing on the air bag or the dash warning light. What could have happened to cause this problem? I have re-booted the electrical system (more than once) by disconnecting the battery.
View 1 Replies
I have an 04 Ford Explorer XLT 4.0 Flex Fuel. There has been loss of power to fuel pump. Relay and fuse both good, replaced the inertia switch...still nothing. Could a FPDM (fuel pump driver module) have anything to do with this issue? Or what should I check next? I am definitely at a loss as to what the issue could be! I know it is fuel related because I used starting fluid and it started right up and run for just a few seconds, so that should rule out ignition I think.
View 3 Replies
Sometimes after running my 94 Limited, it doesn't want to start - it does crank - like it's not getting fuel. I have found the work around and want to know if it would be fixed by replacing the fuel pump relay.
The symptom is just after starting, it starts to run poorly, and then dies out, then will not start at all. I use to keep trying to start it for 20-40 minutes and suddenly it seemed to work.
It seems the work around is to turn the key to on for about 5 seconds and then turn it off - then it starts and runs as good as ever.
So, is this a symptom of a bad relay? I thought I'd start there because of the cost of the relay is fairly cheap. 1994 Explorer Limited 4x4?
View 14 Replies
