Ford - Explorer :: 1993 - Rear Axle Replacement
Jan 26, 2017
The axle seal is bad on my 93 Explorer, manual, 4x4 both sides. The shocks and leaf springs are also shot. Instead of replacing the seals, was advised to just replace the entire axle and pick one up at the boneyard with springs.
I am wondering what axles from other vehicles will work? I have been able to find this before through RockAuto's website but there is no information concerning rear axle. Is there a source showing interchangeable parts between vehicles? Aside from the body, Explorer is basically rebuilt now, just needs the gearbox replaced.
View 1 Replies
Advertisement
I replaced my right front axle a week ago because I was getting severe popping/clicking noises. The boot was torn on the axle and I had grease all over the inside of my rim etc...
The popping/clicking sound was gone immediately after replacing the axle. Now starting yesterday, exactly one week after I replaced it I noticed the popping/clicking sound coming back. It was faint at first but started getting louder. Now today it's almost as bad as it was before I replaced the axle. I still have to get underneath and see if I can hear where it's coming from? Think the axle is bad again? It is an after market Axle, ToughOne is the brand I believe.
Just for a quick history. All four wheel bearings were replaced about two years ago. All four ball joints about a year and a half ago. I replaced the outer tie rod ends about two weeks ago.
2004 Ford Explorer, 4X4, 4.0 Flex Fuel
View 4 Replies
How do you replace the rear axle seal in a 1995 F150?
View 14 Replies
2000 Explorer: on the drivers side is what looks like a vent hose coming off the axle housing. Is it a vent and why??
View 3 Replies
I am replacing the rear steel brake lines and I have a bit of a mystery...when the lines come off the wheels, I see them going over the pineapple and it LOOKS like it's just coming down the other side into the other wheel. That should be impossible, right? How would it go about getting brake fluid into the system?
I can't see on top of the pineapple, so I don't exactly know whats going on up there. I don't see any hydraulic hose coming from the top of the pineapple. I'm currently clueless as to how the rear brake lines fit together.
View 2 Replies
Looking for a video, pictures, or steps that are in depth on how to replace my rear seals and bearings? They are leaking very badly and would like to see some other ways to get it done.
View 3 Replies
I have a constant whine going down the road with foot on the gas. Back off and it quiets up. At 2-3 MPH i think i can here a " tick- tick". Took the drive shaft off, wheels off ground, cover off and oil out. Spin wheel and i can hear a tick - tick, I think around the pinion bearing. No play up and down or in and out, but it appears to have 2-3 times the backlash i would expect. I used the screw driver- stethoscope--- still think its the bearing. This is a 9.75 axle. What kind of luck would I have pulling the yoke off and going in from the front without removing axles halves and ring gear? I thought I had read that here before. Never done one that way .
View 2 Replies
I own a 2003 Explorer, 4.0 v6, w/93k. When turning either direction from a stop I get a shudder from the rear end. Ford has issue tsb # 17717 but I cannot fix the fix, only a description of the problem. Where can I find a fix I wondered?
View 2 Replies
I have finally gotten my 93 Explorer back on the road. Now I have a few things that I am trying to get fixed.
The first things that I need to get repaired is my Fuel Sending Unit replaced. How hard is this and what kind of pitfalls am I looking at.
The problem that I am having is that my fuel gauge is never right. The other day I ran out of gas, but the gauge said full. Go firgure.
Anyway I have been told that the problem is my sending unit in the fuel tank. So is there any advise on this repair.
View 2 Replies
I have a 2003 Explorer EB that on deceleration of all speeds, the drivers side rear axle is popping or clicking. Could this be a CV joint? It does not happen on acceleration.
View 3 Replies
I replaced the master cylinder 2 months ago and now every now and then the rear lock up for a second. its only happened a couple of times. Pulled the wheels and everything is in place with nominal wear with clean drums and rotors. Am at a loss as to why this is happening.
View 1 Replies
so while replacing the rear brake lines in my 2001 F-250. / 5.4, the flex line that drops from the frame bolts to the axle through the axle breather threaded vent line. The friggin thing crumbled on me and now I can't find a replacement for it. Where I can get it or what it's actual name / part number is so I can call the Ford dealer and hope it's not obsoleted?
View 3 Replies
I need to replace rear spring packs on our
97 Explorer sport 4.0 auto 4x4.
What years should I look for? Will 91-01 packs work?
I know of a 92 4x4 close by that is being parted out.
View 2 Replies
2001 Ford Explorer Sport (not sport trac) 4.0l 5r55e 2wd.. Ok so I picked up a sweet deal of an explorer yesterday.
Sure enough I get her home and find out she needs both the rear body mount bushings replaced. Ok no sweat so I go to autozone...they cant find them... Ok I look in the book for replacement procedure... Nothing, To YouTube! ...nope nothing there either.
View 1 Replies
I just got my left front axle replaced on my Toyota (1993) and my engine mounts as well. The car is in great shape and has been driving well.Drove it away, and it was running great. It is still running great (after driving all the way home) but, I noticed it is making a loud clunking, metal on metal kind of noise on the front left axle when in first gear, happens more when turning (I think right, but maybe both right and left). I just paid a lot of money and trust the mechanic, but this does not sound right at all.
View 7 Replies
I recently had my rear axle seals replaced due to leaking. Does the rear diff fluid get replaced on that repair since the rear diff cover comes off? Trying to figure out when my next interval for changing rear diff fluid should be.
View 1 Replies
I have an 04 Limited, 6.0 PSD, 4x4 which I need to replace the front inner axle seals, the right side is leaking out the shaft. I have watched a couple of YouTube videos on how it is done but would like to get some first hand knowledge and recommendations.
First, how important is it to check the backlash before beginning the removal of the gear assembly? Do I need to remove the pinion gear as well or just the gear assembly?
How difficult is it to get everything back on place once the seals are replaced? I have not done this type of repair before and am concerned I might miss something.
I am planning to replace all the ball joints at this time also, this was the primary reason for this maintenance in the first place.
View 8 Replies
I currently have the rear axle shafts off the truck. I took off, cleaned then put on the rear diff cover.
I live in an area that does nothing but form rust anywhere and everywhere in very little time.
I don't want rust forming in the rear diff gears - can I fill the rear diff up ? Or will it leak out of the rear shaft holes ? Can I fill it up halfway then ?
View 2 Replies
My 93 ford explorer has a factory alarm. It went off this morning, 2am! in the rain. I tried the remote, nothing, tried the second remote, nothing. Honking and lights flashing, I disconnected the battery to calm the neighbors and hopefully reset everything. I also disconnected the horn. After reconnecting the battery, and waiting a few minutes, the alarm again triggered.
View 6 Replies
Did ball joints this weekend and now have little axle fluid leaking out passenger side. was going to change axle fluid when i saw this so continued and when pulled the fill plug i would say 8oz or more came draining out. Did I mess up the seal inside the tube?
View 5 Replies
1998 F-250LD 4X4 ... The outer boot is cracked, so I got a new one. Took the axle off, but cannot understand how to remove the boot. Where do I take the joint apart?
View 2 Replies
