Ford Exhaust System :: Position Of Muffler In The System Affect Performance?
Apr 22, 2008
Was just mulling over redoing part of the exhaust system on my truck. As it stands the original y-pipe is still intact but some bozo reduced the rest of the system down to 2.25 inch with an ancient glasspack for a muffler. Maybe he thought it would net some kind of benefit, maybe he was just throwing together parts from his backyard. Either way it's going, I'm planning to keep the Y-pipe but step it up to 3 inch with a Flowmaster chambered muffler and I just suddenly wondered if the position of the muffler in the system affects performance. If I put it directly after the Y-pipe the exhaust pulses would hit it sooner...
View 14 Replies
Advertisement
i have my 4 inch exhaust pipe cut just behind the rear of the cab right now with no muffler. If i cut it further up maybe jsut under the front seat or so what would this to the sound? would it make it deeper or louder?
View 7 Replies
I own a 2005 F350 Diesel and I want to remove my stock exhaust and run a side exhaust with no muffler. Has any Diesel owners out there run a side exhaust system?
View 14 Replies
i plan on getting rid of either the cat or the muffler probly in about a week...which one would be better to lose?
i dont care about the sound cause either way i go if i keep one it shouldnt get much louder right and either one will increase power/torque... im wondering which one bill better my mpgs the most im leaning towards muffler it will be easier and more legal...then again my truck already passed inspection
View 6 Replies
I just got a Walker SoundFX muffler and there is no drain hole for condensation. Should I make one?
View 3 Replies
I have an 2003 Explorer 4.0 and I am looking at replacing my muffler. Only problem is I don't know who to go with. I am looking for a mellow tone with minimal interior noise. I have been looking at Flowmaster, Magnaflow & Dynomax although I can't make a decision. I have heard how the 4.0 Ranger sound's on Magnaflows website(sound's OK) aside from all the horrible sound clips floating around that don't have good quality to listen too. I was looking at Flowmaster 50 series Delta Flow and there SUV muffler(a tad thicker than Delta series) but want some feedback on who/what to go with. Also, right before the tailpipe ends, next to the spare tire underneath, there looks to be what looks like a resonator if I am correct on the tailpipe. Can this be removed and replaced with new piping? Will it hurt performance or make the exhaust sound different?
View 14 Replies
Yesterday, I heard a loud "pop" while cruising at 60mph. Pull into a rest stop and and discovered a hole in the muffler. The engine now idled roughly, but seem to smooth out about 2000 rpm.
Question for the experts: can the loss of a muffler cause the engine to run rough? It's a 460cid in a '77 F350.
View 3 Replies
Sunday I received the dreaded DEF system fault message on my 2012 CC SRW SB FX4 with 7800 miles on it. Warned me that speed will be reduced to 50 MPH in 50 miles. I have a CTS Insight, so I checked for DTC's. First one was P2200 - NOx sensor circuit (Bank 1, Sensor 1), the second one was P204F - Reductant system performance (Bank 1).
After 50 miles it warned me that speed would be reduced to 50 MPH on next restart. Sure enough, Monday morning speed was limited to 50. I took it to the dealer, but I should have left it running. When the service guy started it, the fault had cleared and it no longer showed the P2200 NOx sensor code, although the P204f code was still there.
My question is, why in the world would Ford make it so that the code is cleared if the fault goes away, especially after putting you through the 50 MPH limit scenario?
Dealer did a reflash and said its OK now, but I'm not so sure. My trucks build date is 10/6/11. I read TSB 11-11-13 which states the NOx sensor module should be replaced for P2200 on trucks built before 10/11/11. Is that only for a persistent P2200?
View 5 Replies
Want to install exhaust system on my 06 F350.Tell me,what is the best brand for my truck,I know, very good intake system is from K&N,what about exhaust?
View 10 Replies
I have 2 70's trucks, one with a 360 and one with a 390. Which I don't think makes any difference. The problem is, I experienced poor operation in that after driving for a while engine showed symptoms of reduced performance and stalling and shortly stalling all together. It would not restart even after changing fuel filters and checking pressure. It has a two barrel holley. I took the top off the carb to check for debris in the jets. What I found was a clear jelly like substance. I pulled it out and set it in the open air. After a few minutes it evaporated. I concluded it was something like alcohol created by the vacuum in the carb. After that the truck ran fine until it happened again a few days later. Always after sitting it would restart. When it did not I found the substance in the carb. Now I have the same problem with the other truck. It sounds like a few of the cylinders are starving for fuel and the carb is all but new with twin fuel filters. Ignition is fine on both trucks after hooking up the scope. What is this crap and how to get rid of it?
View 4 Replies
So i got a cooling system performance light and haven't had time to change the sensor out along with the housing... But
Last night i was stopped to see if it was still there after a little driving and it was indeed. So i figured i would try and clear the code to see if that work and it did. I cleared the code and almost instantly with the car still idling, the ticking sound went away.
What could have cause the ticking sounds at all in relation to the cooling system?
View 1 Replies
Have an '07 2.0T w/92K on it. Check eng light came on over the weekend. Performance is fine etc. Went to AutoZone just to find the general area of the the trouble code since there's no one with a VAG Com nearby. The code is as the title indicates. For the last 5 months the temp gauge has been moving 1-2 ticks to the left (cooler) of the normal 200 degrees, then it will go back to 200 etc. It previously has always stayed on 200 once it warmed up. Does this sound like a thermostat?
If it is, I'm wondering if I could save some money while they were in there to go ahead and change the TB as well? From what I've researched the thermostat is in same area. I was planning on doing the TB at around 100-110k so while it would be earlier than planned I'd do it if it meant saving a bit from the combo work.
View 12 Replies
This code came up on my car, what it means or what part needs to be replaced.
008577 - Performance Malfunction in Cooling System
P2181 - 008 - Implausible Signal - MIL ON
Freeze Frame:
Fault Status: 11101000
Fault Priority: 0
Fault Frequency: 2
Mileage: 84971 km
[Code] .....
View 2 Replies
Like the title states, I've got P2181 (coolant system performance) CEL on again. I've had this code before and finally had everything serviced. It was off for 5k miles! I've spent a lot of time diagnosing this on the previous occurrences, and was 99% certain it was the thermostat due to the coolant temp dropping a notch or so when engine braking* on the interstate for more than a few seconds.
The current issue is mainly that the car will not heat up quite as fast, but it will not go lower from engine braking for a good chunk of time. I'm getting fairly poor MPG compared to what I was getting a month or two ago. The major changes are winter fuel blends and winter tires, which I'm sure affect the MPG a little, but I would hope not as much as I am seeing. Old average was around 27mpg combined and 30 or so for mostly highway, now I'm getting 24 tops. This is likely due to engine temps not being up to allow for most efficient fuel burning.
First plan is to change the CTS and see if that will fix it. If the code comes back after that, I'll have to check the thermostat and coolant mixture, but I wouldn't expect it to last only 5k miles.
Current: 105k
Thermostat and coolant changed at 100k
Water pump at 80k
CTS sometime around 70k
Engine braking lowering temp due to no fuel being ignited and coolant still circulating through the system if thermostat open.
View 9 Replies
Last night on my way to go get hammered the check engine light popped on...
"Cooling System Performance"
I have read a few different post, and the last one I read referred to his radiator fans. I know for a fact one of them isn't working and I haven't replaced it yet because it hasn't advisable effected my driving.
So my question is what could be causing this? Also I'm not sure if this matters but my a/c doesn't work either.
View 10 Replies
The code in question is:
18613 - Performance Malfunction in Cooling System
P2181 - 008 - Implausible Signal - MIL ON
Long story short, there are 5 main reasons this problem can pop up, listed in order of likelihood, least to greatest:
1) Coolant sensor
2) Thermostat
3) Bad fans
4) Coolant mixture
5) Water pump
It's a fun catch-all code that can be thrown from any of those. Given that our cars are approaching the 6 year mark, the coolant sensor & thermostat are the most likely culprits. Most of us up on maintenance have already done the green-top sensor, so it's probably the thermostat. In which case, here is the official changing the thermostat DIY: [URL] .....
If you get this code, first check your fans. They're running? Okay, change your sensor & clear it. If it comes back, change the thermostat. If it still comes back, which has been known to happen, investigate further. [IMG] [URL] .....
View 24 Replies
I tore it apart and there was no gasket or donut ring in the flange. Is there supposed to be a gasket or donut ring? I can feel the leak with my hand. I have retightened & it still "tick-ticks" real bad.
View 7 Replies
I have a 90 bronco with a efi 351w and im missing one nut for the manifold to exhaust pipe flange. I have looked all over the net and can't find the size I know its a 1/2in socket but I need the thread pitch and size, had the parts guy try to sell me the stud and nut kit seem really expensive for just a nut and to install the full kit I have to pull skid plates and the trany supports just to start to get room to do the job, seems like a lot of work to replace 1 nut...
View 1 Replies
I just purchased a 2003 V10 with 270 000kms. The truck had had regular maintenance. It has an exhaust leak and runs a little bit rough. Could the exhaust leak cause the truck to run a little rough or am I dealing with another issue?
View 2 Replies
My F150 exhaust seems rather quiet when I first start it up, but after it gets warmed up good, the exhaust is much louder (which I like). I started wondering if I had a crack up front that widened out when it got hot, so looked under it when I got home today with it hot and still idling, but didn't see any cracks. Also I did not hear any noise like a leak. All sound was coming from the side exit pipe. So... what is the phenomenon that would cause this?
View 5 Replies
Long story, I'll try to make this short, 2000 E250 5.4L What would or could happen if the catalytic converter was removed from the exhaust system?
View 5 Replies
