Ford Exhaust :: Stock Exhaust Into Dual Exhaust?


Mar 16, 2011

.What would happen if I had a muffler shop turn my stock exhaust into a true dual exhaust system with 2 magnaflow mufflers on my 6.9L N/A diesel?

View 5 Replies

Advertisement

Ford Exhaust System :: Dual Exhaust Without Engine Possible?

Is it possible to do so with out engine problems later? I would love to go with duals front to rear 3in pipe and tips. Any do's or dont's?

View 11 Replies

Passat (B7) :: Dual Exhaust On A 2.5L SE

Contemplating getting exhaust on my 2.5L SE. Haven't decided on what type of muffler, but I would only get one (1 in with 2 out). Two questions:

First, I'd like to get the bottom black piece from the V6 Passat with two cutouts for the exhaust tips. This way I wouldn't have to cut or modify mine -- just swap them out. Can you just swap out the black plastic or is the bumper just all one piece?

Second, on the right side bumper -- under the frame -- there is large cover. On the opposite side it's where the tailpipe is and what looks like another muffler? What's under this cover?

My bad for not knowing the technical terms for these parts.

View 5 Replies

Ford F-150 (2009-2014) :: 2010 - Adding Dual Exhaust?

Looking to put dual exhaust on my 2010 F150. Which muffler. Flowmax or Magnaflow. Do not want it very load. Looking a little smooth churn like the Mustang. As you know ford is very distinctive and I want it to be heard to some degree.

View 14 Replies

Ford Exhaust System :: Exhaust Leak - No Gasket Or Donut Ring In The Flange?

I tore it apart and there was no gasket or donut ring in the flange. Is there supposed to be a gasket or donut ring? I can feel the leak with my hand. I have retightened & it still "tick-ticks" real bad.

View 7 Replies

Ford - Taurus :: 1993 - Exhaust Clamp Between Resonator And Exhaust Pipe Came Off

I have a 93 ford taurus 3.8L V6 automatic GL. The exhaust clamp between the resonator and exhaust pipe came off and I need to know what size clamp I will need to replace it. I think it is a 2 inch but I am not sure.

View 1 Replies

Ford Exhaust System :: 351w Exhaust Collector Stud Nut Size

I have a 90 bronco with a efi 351w and im missing one nut for the manifold to exhaust pipe flange. I have looked all over the net and can't find the size I know its a 1/2in socket but I need the thread pitch and size, had the parts guy try to sell me the stud and nut kit seem really expensive for just a nut and to install the full kit I have to pull skid plates and the trany supports just to start to get room to do the job, seems like a lot of work to replace 1 nut...

View 1 Replies

Ford Exhaust System :: 2003 V10 - Running Little Bit Rough / Exhaust Leak?

I just purchased a 2003 V10 with 270 000kms. The truck had had regular maintenance. It has an exhaust leak and runs a little bit rough. Could the exhaust leak cause the truck to run a little rough or am I dealing with another issue?

View 2 Replies

Ford Exhaust System :: Exhaust Quieter When Cold / Much Louder When Warmed Up

My F150 exhaust seems rather quiet when I first start it up, but after it gets warmed up good, the exhaust is much louder (which I like). I started wondering if I had a crack up front that widened out when it got hot, so looked under it when I got home today with it hot and still idling, but didn't see any cracks. Also I did not hear any noise like a leak. All sound was coming from the side exit pipe. So... what is the phenomenon that would cause this?

View 5 Replies

Ford Exhaust :: Exhaust Manifold Leak Due To Broken Rusted Bolts

I have a 97 Expedition with the 5.4 engine and 160k miles. Recently while having other work done I was told that I had an exhaust manifold leak due to broken rusted bolts.

View 3 Replies

Ford Exhaust :: 2000 - Can Remove Catalytic Converter From The Exhaust System?

Long story, I'll try to make this short, 2000 E250 5.4L What would or could happen if the catalytic converter was removed from the exhaust system?

View 5 Replies

Ford Exhaust System :: 1996 F150 - Exhaust Making Strange Howling Noise

Ok, probably about 1/3 times i start my 96 f150 4.9 with true duals, the left pipe has a higher pitched howling noise, its a steady tone whether I rev the truck up or not it just gets louder. It will do it for about 6 seconds and then stop. The truck doesn't run badly because of it, but i took her to autozone to get her scanned and they said that the oxygen sensor on the first manifold bank has a slow response on startup. Is that what causes this strange noise, I don't even know how it would make it, it sounds much different from the engine. The right pipe doesn't do anything.

View 9 Replies

Ford Exhaust System :: Exhaust Manifold Leaking / Louder Than Normal Knock When Accelerating

Leaking exhaust manifold? The truck has a much louder than normal "knock" when accelerating. At first I thought and had some bad fuel in the tank. I eliminated that with a full take of good fuel and some STP but the "knocking" continued. Then I thought that perhaps it wasn't firing on all cylinders but it felt like it had full power. I took it to my mechanic and he said it as a exhaust manifold leak. He said that he has never replaced the exhaust manifold but that it was a "nightmare" and expensive. He also said that it's not a safety issue but on the long run the leak would cause the truck not to pass its emission test. He said the problem was with rusted bolts that would be difficult to remove.

View 12 Replies

Ford Exhaust System :: 1994 Ranger - Loud Exhaust Sound In / Outside The Truck And At Idle

I have a 94 ranger 4L. I am looking for a more loud exhaust sound in/outside the truck and at idle. I have had a cherry bomb turbo on it and it was ok but not loud enough for my liking. I just picked up a flowmaster 40 2 days ago and it sounds good but again just not loud enough for my taste and kinda a lot more. I was looking for a louder muffler that is not a glasspack and would like to stay under like 80 or so.

I also thought about getting a high flow cat which i think might make some more sound but was not sure. Im running the stock pipe which is 2" and end in back of the wheel on the right. I look at the Hooker Headers Maximum Flow Muffler which i thought would be louder b/c it's more straight through the muffler so it would put off more sound better. What would u recommend for something more loud ?

View 14 Replies

Ford Exhaust :: 2008 F150 - Changing Exhaust To Something Having Lower Rumble And Deep Sound?

I just got a brand new 2008 F150 supercrew FX2 last wed. I love it, it's my first truck ever and I'm excited to drive it. I wanted to change the exhaust to something that has a low rumble and is deep, not too loud or anything.

View 1 Replies

Ford F-150 (2004-2008) :: 2005 - After Dual Exhaust CEL Came On - Sulfur Smell?

Just put a dual flowmaster exhaust on my truck, a week later my engine light came on. I also smell a sulfer smell and the truck seems to sutter when in gear at a stop, and also hard to start at times. What this could be!

View 9 Replies

Ford Exhaust System :: Exhaust Leak At Manifold Where Donut Gasket Meets The Catalytic Converters

My truck just started running really loud when it's cold and the leak goes away when it warms up to operating temperature.I did a little bit of investigating and I have found where the leak is coming from at the end of the exhaust manifold where the donut gasket meets the catalytic converters. It appears that the bolts rotted that hold the system together at the gasket. What should I do to repair this? I don't really want to replace the whole manifold because I know I'll break a stud off in the engine because everything is pretty rusty down there. I even took some pictures of the problem....

View 3 Replies

Ford F-150 - 1997-2003 :: Exhaust Leak On Passenger Side / Broken Exhaust Manifold Bolts

My wife's 97 f150 4x4 had an exhaust leak on the passenger side. 7 out of the 8 bolts holding the manifold on are snapped off. 4 of them are snapped off 1/8" below the top of the hole on the cylinder head . I am I unable to get a drill in to drill these out. The other 3 I've tried welding a nut on these but they won't budge and I wring the nuts off. If I have to pull the head(something I don't want to do)can I just pull that 1 head or do I have to tear the intake and everything off?

View 1 Replies

Ford Exhaust System :: 1994 F250 - Replacing Exhaust?

I have been thinking about toying with my exhaust. I don't have a crazy amount of money. I got a 94 F250 with the 5.8 liter 351. Heres what I was thinking. Get rid of everything after the cat, and then run a single 3 inch pipe from the cat to a flowmaster 40 series, and then exit either right before the back tire or right after it.

View 7 Replies

Ford Exhaust System :: Exhaust Pipe Cut Just Behind The Rear Of Cab - No Muffler

i have my 4 inch exhaust pipe cut just behind the rear of the cab right now with no muffler. If i cut it further up maybe jsut under the front seat or so what would this to the sound? would it make it deeper or louder?

View 7 Replies

Ford Exhaust System :: Copper Exhaust Coming Off The Headers

Why it won't work. copper exhaust coming off the headers. I have the ability to get it and bend it and how cool would that be copper duals. Why won't it work. If I bolt it right to the headers.

View 7 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved