While I was at the shop getting the steering fixed I asked about the inop washer pump. They told me the pump failed.
Anyway 30 minutes later I have replaced it but still does not work.
So what next?
Which fuses do I check (I already checked them but give me specific numbers)
Where are the relay and how do I check them?
How do I test the pump?
2001 XLT V10 4x4 Excursion
If I push button for windshield washer the wipers come on but no fluid sprays on windshield. Same with rear....wiper comes on but no spray.
Jumped washer pump directly from battery and pump comes on and water squirted on windshield.
Had kids push washer button while I held volt meter on washer pump power and ground wires.....Nothing 0.0 volts at pump, but wipers came on.
All fuses are new, is there a relay? I did swap them around with no change.
I have a 2003 Explorer Sport and the windshield washer pump is not getting power. Owners manual does not show fuse or relay locations.
View 2 RepliesI just bought a 1998 ford f150. Wipers do not work, the wipers only work when i hit windshield washer, but no washer fluid comes out, what could it be?
View 2 RepliesI can't find the fuse from the manual. Is it under another name?
View 8 RepliesI have a windshield washer fluid leak. It's leaking onto the passenger side floor under the dash. Any have a good place to start looking or how to access the area it might be leaking at?
View 6 RepliesI have a 2005 F-250 6.0 Powerstroke.
My washer fluid pump is not working, it was a few weeks ago but now it is broken. The Owner's Manual only has the listing fuse 33 for "cluster, 4x4, wipers". It looks like some of the older models have an actual fuse for the "washer fluid pump". I checked fuse 33 under the dash and it is ok. What fuse controls the washer fluid pump?
The pump does not make noise when activated, so I'm starting at the fuse but I don't know what the hell is going on.
getting weak spray/dribble (yea, it could be a "personal problem " on the drivers side squirter. Left side great. I have replaced both squirters and blew out the line where it T's over to the drivers side.
Still weak.. I'm thinking its most likely low pressure coming off the pump and maybe it's time to replace I haven't crawled under there to inspect placement of pump. Thought while there I would also replace the reservoir.
The windshield washer does not work. What could the problem be? I thought I would check the fuse. What fuse is for the washer and were ls it loc? is it under the hood ? or could it be the pump and how would i check it ?
View 7 RepliesI just bought a 1995 S10 4x4 for my son and the windshield washer pump is not working. It doesn't make a sound and I have measured that no voltage is going to the hot side of the harness going to the pump. The ground tested fine. It was also having wipers issues where they stopped at random places when turned off and the timing was screwy. I removed and resoldered the wiper pulse board and cleaned up the contacts. Wipers are good, but still no squirter.
View 2 RepliesWindshield washer nozzle stop working? Is there an easy way to unclog it or does it need to be replaced?
View 3 Replies20+ year old Corolla. There's a leak that appears to be at the point where the windshield washer pump attaches to the plastic bottle. I've had a leak in that area before, where the hose attaches to the pump, but that was just a crack in the hose. This one appears to be where the pump attaches to the plastic bottle. The pump is on the outside of the bottle, not inside. Is the pump held there by friction, like with an o-ring?
View 18 Repliesi have a 2010 vw gti 4dr, reservoir is full, they worked yesterday but not this morning. they didnt work yesterday morning but when i checked in the afternoon i saw that the hood liner was blocking them and was saturated with washer fluid. i removed it, and they worked fine. now this morning no dice...
View 3 RepliesI have a 2010 Prius and now is cold here 20-30F. So, i filled up with tinter wash fluid the bottle and today when i entered my card was 25F and i can spray out washer fluid on back window but on front window it seems it is not working. It can't be frozen because under the hood i removed hose from one connection and it is not spraying also when it is removed as i thought that the problem can be nozzles, but no. Or maybe is a pump problem? So we have two pumps on 2010 Prius for washing windows(one pump for front windows and one pump for rear windows? or there is a common one? Because there may left some water after i filled up with wash fluid. Yesterday it was working even in front and even on back. Today after i left car for two hours in underground Mall Parking i thought it will work when i'll come, but surprise, it wasn't working and there was 42F in parking.
View 9 RepliesI have a 2010 Prius and now is cold here 20-30F. So, I filled up with tinter wash fluid the bottle and today when i entered my card was 25F and i can spry out washer fluid on back window but on the front window, it seems it is not working? It can be frozen because of low quality fluid? then why it sprays on back? Or maybe is a pump problem? So we have two pumps on 2010 Prius for washing windows (one pump for front windows and one pump for rear windows? or there is a common one? Because there may left some water after i filled up with wash fluid. Yesterday it was working even in front and even on back. Today after I left car for two hours in underground Mall Parking i thought it will work when i'll come, but surprize, it wasn't working and there was 42F in parking. But the back spray is still working? So, what do you think? Can I have a pump problem? Does Prius have two pumps for washing windows?
View 3 RepliesI recently purchased a 2003 Explorer. Two weeks after I bought it I found out the motor on the windshield washer water pump was shot. The dealership fixed it for free. About a week after I got it back when I was driving in the morning to work I noticed the check gauge light go on and saw that my temp gauge was pointed at HOT!! I pulled over and stopped immediately. As soon as I slowed down the temp gauge went back down to normal. It happened 2 or 3 more times and had it back at the dealership. They are stumped. They sent it to a Ford dealership and they couldn't find anything either.
They said they have checked everything and it is not overheating. They even put a thermometer on it while they drove it and it didn't get over 205* I am surprised it didn't do it to them because it happens almost every morning. I only work 4.3 miles from my house so its not like I am driving very far. It usually happens at about 3 miles. As soon as I see it going up (and I watch it a lot!!) I take my foot off the gas and start to slow down or barely press the brake it goes right back to normal. Then it stays at normal the rest of the day. Is it the sensor or the wiring or did the do something to it when the fixed the washer motor?
all in sudden I found that the windshield washer of my Hyundai Sonata 2006 GL doesn't work. When I pulled back the control bar, the wipers were swapping but no water came out. I was pretty sure that the water tank was full, and I didn't hear any motor working sound when I did that. Is there any way I can replace it by myself? Or how much does it cost if I go to a Hyundai dealer? This is the very first time that my car had an issue. In the past years, I never went to a repair shop except for oil change and other maintenance.
View 11 RepliesI own an Elantra GLS 2012, and starting a week ago, I noticed my windshield washer was coming out through the nozzles with low pressure (1/2 of the windshield). Yesterday one stopped working and the left nozzle is "spitting" (1/3 of the windshield).
I thought they are clogged and today I tried to unclog them using computer air cleaner, but air was coming out through the left nozzle with pressure and nothing through the right nozzle. When I tried to wash my windshield, no pressure on my right nozzle and low pressure on my left nozzle. Same as before.
I plugged off the tube from the hose connector under the hood, and if I pull back the control bar, I have a stream of washer liquid over 3m (10ft) long, but if I put my finger on the hose, I don't have pressure on the windshield washer.
My question is: the nozzles are clogged or the pump is dead?
I know the clogged nozzles are not under warranty, but what about the pump?
I have a 2006 Solara and overnight the windshield washer pump stopped working. I thought the problem was no washer fluid, filled it, and nothing. I checked the hose near the hood and nothing came out. The motor isn't humming like it is trying to pump, so I checked the fuse (I think I checked the right one, not sure, it was a 15a) and it appeared to be good. I checked the wires going to the pump with a multimeter and didn't get power, so is there any other "secret" fuse I am missing. I know on an older car I had, the fuses were sometimes mixed with other items and not labeled.
View 11 RepliesOkay, So my rear washer is not pushing out the nozzle. Pump works, line from res checks okay, nothing frozen at this point. What route the line goes through the body, or what the diag steps are or the process to service it?
View 10 Replies(04 FX4)... having issues with your windshield washer? The next to last time I used it, I got a dribble, so I figured that I needed fluid...added more fluid, but it was still half full, I pressed the button, I heard noise, probably the pump. but no fluid. Could it be something as simple as a clog? I could tear it apart.
View 12 Replies