Ford Excursion :: Wiring Diagram For Trailer Wires From Fuse To Plug
Feb 10, 2013
My park lamp circuit is dead. I have tested with a multi-meter and there IS power at the fuse. However, no power at the plug. I have pulled the bumper and found the plug for both the rear taillights (the park lamp circuit WORKS in the taillights) and the trailer wires. Confirmed it is dead there as well.
Both bundles go into the frame rail at the fuel tank, but I not sure which is which where it comes out at the firewall. A web search did not reveal a diagram and the Ford repair CD I have does not list Excursion diagrams.
View 6 Replies
Advertisement
Need a wire diagram. I have a connector in the cab that has red,blue,lt green,white wires. It's causing my brake lights not to work. I need a wire diagram that shows were they go. I can't find these wires in my Haynes manual.
View 3 Replies
I posted earlier about the tranny in my 01 Ex v10 having a transmission problem. The show looked at it and found the O2 sensor had shorted out and in some way sending the truck in to limp home causing the tranny fuse to blow????
Any way they fixed it or so they said and I drove it for a few hours and it did fine. The next morning I drove it and it blew the fuse. (under hood box I belive #19) I took it back to the shop and they beat and banged on it....got it wet etc. and can not get it to do it again. I know whe have an electrical issue but what all runs off of the fuse that controlls the tranny?
Is there any online wiring diagrams of excursions or superduty drive trains? Where all to look for the problem?
View 4 Replies
I removed all the spark plug wires for testing/cleaning and install new spark plugs, but stupidly forgot to mark the wires where they came off at the Coil Pack. yes, Now I cannot find a diagram for the Driver's Side wire positions at the Coil Pack.
(The Passenger side wires are 1-2-3, starting from the front of the engine, simple enough); The Coil pack itself has numbers stamped on it, so I have the Passenger side done correctly.
But the Driver's Side wires are not in a Sequence of 4-5-6, instead they are 4-6-5 (or something like that), and I can't remember their positions at the Coil Pack. Looking for a drawing showing the Driver's side Wires as they connect to the Coil pack?
Example:
Front Driver's side plug wire connects to which coil pack position? (Front, Center, or Rear?)
Center Driver's side plug wire connects to which coil pack position? (F, C, or R?)
Rear Driver's side plug wire connects to which coil pack position? (F, C, or R?)
View 7 Replies
I have a '99 Rodeo 2.2L, 2wd with 60k. Time for new plugs and wires. Any engine diagram? I haven't found the Distributor Cap.. AND... my Haynes Repair Manual mentions coil packs... when I went to AutoZone for Spark Plug wires, they didn't say anything about coil packs.
View 2 Replies
Fuse #41 keeps blowing...scan tool says o2 sensor heater circuit malfunction. Problem is that when the o2 sensors are unplugged it keeps blowing fuse the second I hit the key. Where this short would be? I can't find a wiring diagram anywhere. ( I'm new to this forum and I'm sure there is a sticky somewhere..
DTC codes: P1451, P0743. P0750. P0760. P0765. P1747. P0135. P1409. P0755. P0155
View 6 Replies
Only numbers 1,2,5 match the diagram below. my 6,7,8 are BK/W, PK/B, BR/PK. My Sony CD player came with bare wires. So I could cut off the truck oem plug. How hard is it to find a plug that goes from my OEM plug to my Sony CD player?
View 10 Replies
Well, it's starting to look like I may have to build my underhood harness from bits of multiple harnesses. I found a 2000 Excursion harness, but the engine plugs and wires were hacked off during engine removal.
After in-depth study of wire diagrams, it looks like I can just get a pickup harness and combine it with the aforementioned damaged Excursion harness to get what I need- and do it for about 50 bucks.
I also notice that there are a few Ebay sellers who just sell the fuse/relay box with the wiring harness hacked off of it. So my question is- how do you remove the wires (including the terminal ends) from the fuse/relay box? I've fiddled around with my burned up parts and can't seem to figure it out.
View 2 Replies
Looking for a pic of the headlight plug wiring diagram?? I have the B5.5 lights, I don't know if that makes a difference. I need it for my latest retrofit.
View 1 Replies
My wife's 2013 Passat started blowing hot air. I checked the fuses and they are ok. I looked at the sensor switch for the AC on the passenger side of the engine compartment and it looks like the wire caught on something and frayed/cut through. I don't see where it went through to fix. Finding info on this car is a slight challenge. The owners manual doesn't even have a map of the fuse panels.
View 3 Replies
I have a 03 for excursion and I am pretty sure i blew the relay for the fog lights today but looked in the glove box and everywhere for the owners manual and cannot find it anywhere in site... Looking for a diagram or can take a picture of where the fog light relay is and post it on here and which fuse or relay it is ?
View 14 Replies
I removed the rear radio controller from the back of the console and installed a power inverter in its place. It fit great and everything went smoothly. I should have known it was too easy... I now have no sound coming out of the rear speakers. I assume there is a way to jump the wires to allow the speakers to work, but I'd need a wiring diagram. Right now I have the controller hooked up and buried in the console, which I guess is fine. It's just annoying.
View 10 Replies
Working on the dang ram 3500... I am needing to add a relay, however, i need to strap the coil of it with a diode to protect the frigging cluster (the new dodges aren't very mod friendly!). My question is, should I add a second diode before the relay to protect the cluster against back emf, or will the one strapped across the relay coil be enough?
Since I am sure you're curious now, the cargo light (light that lights up the bed) gets its power from the gauge cluster of all places. I need to add a relay to the cargo light circuit to drive some other lights, and I am worried the back emf from the relay coil will fry the cluster circuitry.
View 2 Replies
Looking for a wiring diagram for the interior lights? 2004 EB.
Gotta chase down the problem, no interior lights coming on, switch or gem...
View 4 Replies
Ive got a 2004 excursion Eddie bauer and I've got the non-towing paddle mirrors with power adjustment, heated, and turn signals. I want to put the 2008 style towing mirrors on that have power adjustment, heated, turn signals, and have the marker lights but not power fold or power telescope.
How I can wire these new mirrors to my factory wires? I understand that the marker light may have to be separately wired in, but all of the other functions I want to wire in to my existing wires.
View 7 Replies
Currently I have a license plate camera wired always on connected to a 7inch lilliput monitor infront of my center console on that hump in the floor. The monitor is connected to a 12v plug on the dash. In this configuration, I have to reach down and turn the monitor on whenever I want to reverse and im hoping I can make it turn on whenever I go into reverse. Right now, if I turn it on then turn the truck off, the monitor stays on with a bright blue no signal screen which forces me to turn the monitor on, then off, every time I reverse if I want to use it.
Any way to make the monitor turn on/off when I put my Ex in reverse?
View 14 Replies
Looking for the wiring diagram for the circuits on the steering wheel? For some reason, when I hit my cruise control on button, the horn honks...
View 6 Replies
Looking for a link to the fuel pump wiring for a 2000 V10 Ex? I'm trying to pinpoint my no start issue and want to make sure I don't miss anything. I think it goes from 20 amp fuse under hood to inertia switch to relay under hood to pump? 20 amp fuse has power but at the inertia switch I have no voltage, just approx 35 ohms resistance to ground on both outside wires. Does the inertia switch close a ground or should it have voltage?
View 10 Replies
Installion of hitch and trailer wiring on a 2015 PIP?
I found ZERO posts about installing a Curt 11276 hitch on a 2015 PIP. Or installing ANY OTHER hitch on a 2015 PIP.
Same applies to adding wiring for towing a trailer behind a 2015 PIP.
View 4 Replies
Need a wiring diagram that will show me how the rear window defroster circuit works in my Excursion. I have the EATC, which may or may not be related... not sure. So the diagram would probably need top be from 2002-2005. Obviously I ask because mine is not working (and neither are the mirror heaters since they are activated by the same switch - I think???). I've checked fuses to no avail...
Mine has never worked since I got this Excursion put together last year. I have read some previous threads that mention two different rear hatch glass defroster grids, one being a higher output grid (and different resistance?) than the other. Is there a chance my system is looking for the higher ohm grid, but my window grid is the lower ohm unit and therefore not activating the timer? I only ask this because my electrical system is M/Y 2002, but my back hatch is from a 2000 M/Y.
Also, I get no indicator light when the switch is depressed. I have tried 3 different switches just because I had extras... no luck.
View 5 Replies
I am in need of a wiring diagram for a 00 ex with factory auto dimming rear view mirror. It only has 3 wires and I think I have them figured out but would like to make sure before making a pigtail to install a mirror I have that has 6 wires.
View 7 Replies
