Ford Excursion :: White Smoke For A While After Startup
Jan 18, 2016
I've been googling for about 3 hours now, and no answers for the gassers, just diesels. When I start my excursion (v10) it pours white smoke for a while, then stops. It does this every time I start it no matter how far I go or how long it sits.
There is plenty of coolant in it and I've never had to top it off, so I don't think it is getting coolant in the cylinder. With that much smoke it wood definitely need coolant if that's what it was. Oil consumption is kind of high in my opinion, but the smoke smells rich.
View 10 Replies
Advertisement
I've been chasing a problem all summer. Began with crappy batteries dying intermittently. I replaced the batteries, FICM, finally cleaned EGR valve and replaced ICP with pigtail. The problem is still persistent. Basically a rough idle, puff of whit smoke on cold startup, rough running at around 1500 rpms( driving at 50 mph). The ICP was soaked in oil so i was confident replacing it would finally cure my issues. It actually got worse with the rough idle turning to a surging idle and quite rumbly at 50 mph speed. I guess its time to look to injector issues but i thought id check if after replacing icp/ cleaning egr. I also have a slight exhaust leak at turbo out that i can see. The clamp is not seated properly. This after turbo connection to exhaust.
View 1 Replies
2006 blowing white smoke and sluggish until its driven for a few miles ..smells like fuel .. New head gaskets and the works started after 20 days over below freezing temps nights at 5 to -5 ....
View 14 Replies
I have long been having troubles with white smoke at startup, even when its 90 degrees out. Long story short I've got new glowplugs, GPR, UVCHs, valve cover gaskets, injectors, turbo, valve seals, valve springs, and HPOP all within the last year. Most of those parts were needed, some maybe not so much. After installing injectors things started getting worse, whether they're related or not I'm not sure yet. I pulled passenger side valve cover off again in an attempt to figure something out and heard this coming out of the intake spider.
[URL].....
The strange thing is it goes away when it warms up. I should also note the reason I started with the passenger side is because I did a compression test and this side had the lowest readings, with #5 being 270 psi. I disconnected each injector one at a time on the passenger side to see if it made a difference while running but didn't really notice a difference. Am I looking at a motor rebuild, or at the very least a head removal?
View 14 Replies
Coolant spilled on my upper intake manifold. I washed it off to the best of my ability but when i started the car white smoke came from tge exhaust. What my next move should be?
View 3 Replies
So my truck a stock 2000 7.3 started smoking when I would start it up in the morning... figured it was a glow plug issue. Checked the relay it was good, checked the glow plugs found 2 were bad replaced them.
Thought I was done, well I started it up and took it for a drive. still smoked... thought no big deal I know some oil leaked into the cylinders doing the glow plugs.
Then it started rattling like a lift went out, no more smoke though because the truck was warm... shut it off at my buddies. Limped it "it actually still drives ok" 5 miles home.
From my research it sounds like an injector. I have tried a buzz test and they all sound the same.
View 2 Replies
I'm in the middle of an extended coolant flush and switch over to ELC. As of recently, I have noticed white smoke at startup and driving while cold and warming up. (Even at times accelerating when half warmed up ~170*). At first I attributed it to suction, so last night I changed the oil with T6 along with a new OEM filter.
After I got done with the oil, I pulled my EGR valve when the engine was hot. Is this simply goey due to warmth, or do you suspect EGR cooler leaking? I didn't take pictures of the manifold, but the lower chamber was hard and dry, while the middle section seemed to be "goey". EGR Cooler or something else???
View 6 Replies
My 06 6.0 is blowing a fair amount of blueish, whitish smoke only on initial startup, then continues to blow smoke slightly for around 10 min until it's warmed up. It seems to be getting a little worse as time goes on, only on startup though. truck has no other issues otherwise, has an egr delete, and some old edge tuner. I don't think it's head gaskets, no other symptoms.
View 6 Replies
I have a 03 Camry, that has started to release white Smoke from the exhaust only on start-up for about a week now. After that I don't see anything not even if i rev up the car.. Only on start up.. WHY??
View 13 Replies
V6 diesel engine producing white smoke shortly after startup. I noticed it this evening when leaving to come back to London and shortly after starting the journey the exhaust was laying down a rather nice smoke screen that stopped very quickly after about 750 metres.
I only noticed a small amount of smoke later in journey when pulling away from some lights and it was illuminated by the car behind. The smoke definitely wasn't black and the only thing I can think of that's been out of order recently was the oil being overfilled by the dealer. I did an oil change this weekend and removed about 8 litres (the engine accepted about 6.75).
View 20 Replies
2009 Camry 4cyl
I changed my PCV valve over a month ago and still have white smoke coming form exhaust on startup. The smoke goes aways as always, after that the smell is gone and the car runs like normal. The smell of the smoke is not really sweet as if it was coolant leaking, but its not exactly smelling like burnt oil either (I've had cars that burnt oil real bad and it smelled different than this camry).
I've been keeping an eye out on my oil and coolant levels, both seem to be ok. I refilled my coolant tank to full about 2.5 months ago as it was very low and its still almost at full right now. My oil after about 4k miles on the dipstick measures right in the middle of the min and max dots, which it has been for as long as I've owned the car. So these levels are ok I think.
Now, I've read somewhere a while back that after changing the PCV valve or rather after taking the old one off that there still will be some residue to be burnt off. A way to get rid of that is to create a makeshift vacuum by plugging one end of the hose (the one that attaches to PCV valve) and leaving the PCV valve off while running the engine, putting some kind of cloth or similar over where the PCV valve should go to collect all the burnt stuff, thus cleaning the remainder out. Is it possible that this might be the a solution?
View 14 Replies
I have a 2002 Toyota Highlander 6 cyl, 148,000 miles. I get a cloud of white smoke from the tailpipe upon starting a cold engine. Smokes for about 1-2 minutes, then smoke stops.
View 4 Replies
I have an issue with a slightly rough sounding engine and some white smoke on start up. It disappears very quickly. I have been told it may be glow plugs or an idle actuator thingy, how do i check which one it is. How can you tell if a glow plug is working or not. I have a 2006 Santa Fe 2.0 with 58000 on the clock.
View 2 Replies
Tonight we left baseball field and my 2005 excursion was white smoking all the way home. I Stopped Several Times And Checked Coolant Level And It Never dropped. I let it sit for a hour and coolant level is still at my black mark. So does this mean it's a injector? It poured down raining so I'll have to wait till morning. Will scanguage show any codes for injectors. If so I can program in the morning.
View 5 Replies
2004 6.0 Excursion.. I had an issue with lots of white smoke. A p0401 code, then the smoke stopped. I removed the egr and cleaned it. All seamed good until two weeks later. Now I have smoke again. Its seems to be only after it is warm. Do I need a NEW egr valve?
View 2 Replies
I was having an issue with coolant loss and white smoke from tailpipe. Was told it was likely intake leak vs headgaskets. Changed intake gaskets, fixed the issue for a day then it started just dumping coolant from every available place in the exhaust system. Was draining a full collant bottle in about 2 minutes. Was also checking for exhaust in the coolant with the tube and blue liquid which it stayed blue. Had previously done a degas pressure test and it passed. The only test I hadn't performed was compression test which all the cylinders output was lowest 160 to the highest about 185. Did not perform a wet compression test as I was mainly looking for base compression and consistency.
Not sure what healthy is on these vehicles but considering they were all running pretty close I call it good. Also it idles just as smooth. Pulled intake a 2nd time and rechecked my previous work. Everything looked fine so I put it back together. Ran smoke free for about 50 miles now I'm back to smoke after it sits a bit but it clears up after a short drive. What am I missing? I will note that I had a small coolant leak from drivers side rear of engine that I noticed while it was parked in the shop. I'm assuming that would be the oil cooler? But oil is clean so it's not mixing. What other avenues on these engines can coolant make it into the exhaust? Drives perfect with no power loss.
View 5 Replies
My 7.3 won't start after sitting for almost 2 months, the wiring for the injectors was bad, and the first package was damaged, so I had to order a new one, and wait trough Christmas before I get the new parts. The valve cover seals have now been installed, and all parts fitted. Thieves stole my batteries so I had to buy new ones there as well.
When I tried to start it, it will crank, but not start, white smoke comes out of the exhaust, and glow plugs seem to be fine. One thing I did notice is that the fuel pump under the driver side of car was making a wired noise when turning on the ignition, it was not a constant hissing sound that I used to on my other cars. I poured a small amount of condensation remover in the tank, the tank is half full, but still no start.
After trying a few times, it did sound like it would get better, but that only lasted for a second. Strange problem, I think my fuel pump is acting up, but I don't know for sure yet. The fuel pump did work when I parked it. Could it be a fuse that does it? I checked the hpop to see if there was any oil there, and it was.
View 2 Replies
After a hard rain overnight, my truck would not stay on. I had to give it gas while still in park or it would cut off. Also I noticed white smoke from the exhaust while doing that. Eventually car stayed on. But now at when I come to a stop, the car will cut off when I put my foot on the gas to take off. I also.noticed the overdrive button will start to blink. Once the car gets going a few miles, then it's fine. Then this process starts all over again once the car is parked. Also the service engine soon light came on.
View 1 Replies
So I bought an 04 3 months ago everything seemed good all deltas were good had a small leak nothing serious. I had the egr deleted then i did the mistake of flooring it 1 morning at top end and the mech is telling me threw a valve. The truck was stumbling and running ruff with white smoke. looks like cycl. 7 took a hit and shows 10 psi of compression. The injector are in working order and so are the rockers. the bill is 3500 all in for new gaskets and oil cooler head work, arp studs and labor.
View 8 Replies
Got a 2 wheel drive 2000 Excursion with approx. 215K miles with the 7.3L.
Slight shake in motor + you can literally floor the pedal and you'll move a little faster than a snail.
Does this sound like bad injectors? Also - tried to start it today and it was just cranking forever...Couldn't get it to start..I did notice while I was in drivers seat looking out the window...some white smoke coming from tail pipe while it was cranking...
View 13 Replies
My beloved excursion is 300 miles away from me in a no start condition. Vehicle has 270K miles. Very well cared for. No issues to date since purchase 5 years ago. Went to back up and the vehicle starting Caming like it had a big cam in it. went from reverse to drive and problem went away. Drove vehicle for 2 more weeks without issue. Then all of a sudden it dies. Restart driver on down the road 1/4 mile, dies again. Restart, make 45 mile drive home vehicle is low on power will hardly pull a grade but I got to my friends house. Went to start vehicle next day and no start. Puff white smoke while trying to start. It hits every once in awhile but wont run.
The vehicle is throwing NO CODES other than an open glow plug on 1&8 which it has for sometime now. I have changed, fuel filter, fuel pump, CPS(genuine ford), IPR and IPS. No real changes still wont start. I disconnected the IPS and it started but it sounded like it was only running on a couple of cylinders. It would not accept throttle. The local Forddealer does not have a Ford diesel tech. Ive called a couple of diesel shops and I hear could be a bad HPOP, or bad ECM or a bad IDM but without seeing it. I am at my wits end with this thing. I am an electronic engineer by background. So I have a good sense of the process. I have checked all fuses, relays, etc. I will say I did have one issue with it a year ago where the UVC problem popped up but the dealer fixed it and it has been fine ever since.
View 14 Replies
