Ford Excursion :: Washer Nozzles On Rear Wiper Arm Froze Solid
Jan 19, 2010
I'm guessing that the washer nozzles on the rear wiper arm froze solid. When the washer was turned on the pressure build up made a hose fitting pop off. What I heard, then saw, was blue washer fluid pouring onto the cargo area rug.
I removed the ~3' plastic trim under the lift gate and the rearmost dome light. You can see the cutout over my pinky & ring fingers. I also removed the r/s trim panel, but think I could have left it in place.
Plugged it back together with some zip ties to strengthen all of the connections. So far, all good
View 14 Replies
Advertisement
Have a 2011 Golf TDI hatchback. Located in Toronto, Canada where it's about - 20 Celsius with windchill today. Currently have no washer fluid coming through the front or rear nozzles. Thought I was out of fluid but tank is full. Tried piercing the nozzles but nothing changed and they don't look blocked. Don't think it's the weather either as my car is parked in my garage overnight. When I try to spray I can hear the mechanism trying to spray but nothing comes out.
View 10 Replies
I am looking for info regarding motor swap. I blew the motor in my truck a couple weeks ago (5.4L Triton). She froze solid going down the HWY pulling my boat. I purchased a motor from a wrecking yard with~ 70k miles on it. I decided to do the swap myself and have run into a dilemma. In order to un-mate the trans from the motor the torque converter nuts need to be removed. There is an access port where you access the nuts one at a time. You must roll the engine over to bring each nut into view. This is where I am stuck. The motor is seized solid and will not turn over by hand even with a socket and a cheater bar on the main crank pulley. Do I need to remove the oil pan and/or the heads to figure out how it's stuck (pretty sure it ate a valve)?
View 1 Replies
My new to me, 2005 F-250 windshield washer nozzles don't work. I have replaced the windshield washer pump, cleaned out the washer fluid container and rubber filter screen, blew air through the lines and the passenger side nozzle barely sprays and the driver side nozzle does nothing at all. I guess I have clogged nozzles. What is the part number or place you bought them? Looked online and everything I can find is so generic.
View 14 Replies
I own an Elantra GLS 2012, and starting a week ago, I noticed my windshield washer was coming out through the nozzles with low pressure (1/2 of the windshield). Yesterday one stopped working and the left nozzle is "spitting" (1/3 of the windshield).
I thought they are clogged and today I tried to unclog them using computer air cleaner, but air was coming out through the left nozzle with pressure and nothing through the right nozzle. When I tried to wash my windshield, no pressure on my right nozzle and low pressure on my left nozzle. Same as before.
I plugged off the tube from the hose connector under the hood, and if I pull back the control bar, I have a stream of washer liquid over 3m (10ft) long, but if I put my finger on the hose, I don't have pressure on the windshield washer.
My question is: the nozzles are clogged or the pump is dead?
I know the clogged nozzles are not under warranty, but what about the pump?
View 15 Replies
So my rear wiper works, but I can get no washer fluid to come out. Yes, I filled it properly. Is there a separate pump for the rear? a separate fuse? is it clogged?
View 5 Replies
How do I turn on the rear wiper without it spraying the window with washer fluid? I've followed the instructions in the manual for using the rear wiper, but very time I turn the wiper on it sprays the window with washing fluid. I don't need washer fluid sprayed on the window if the window is already wet from rain.
View 11 Replies
I've got a MkV R32, and I had an '07 GTI before it. I never had this problem with my GTI, but with the R32, the rear wiper jet had become clogged, and then started moving from it's 12 o'clock position to 9 o'clock with the wiper arm when in use.
I replaced the jet last week, which seemed to solve part of the clog issue, but the jet/nozzle, still moves. I am going to try popping the rear hatch cover off today to try and see what if there's an issue there, (I suspect there is, as I have washer fluid leaking through the hatch latch still, MkV R32.
I suspect there is a buildup of residue on something that it dragging on the new nozzle. I don't want to mess something up....
View 12 Replies
I've been having trouble with my wiper fluid nozzles or something else in the fluid assembly freezing and becoming inoperable. It's pretty dangerous because I'm usually driving on the freeway with a lot of spray hitting the windshield and clouding the view.
Forgot to mention....this happens typically below 20 degrees and I'm using -20 fluid.
View 6 Replies
A weird problem occurred today on my 07 with 61000 miles, with no accidents or electrical problems before. When i pull the right stalk towards me to activate the front wiper washers, the rear washer turns on, and nothing at all comes out of the front washers, but the front wipers would still wipe several times as they normally would when front washers are activated.
View 6 Replies
When i try to use rear window washer the fluid comes out on the front window with front wipers not activating and rear one moving. The front washer works fine. The hose was disconnected above the headliner.
View 12 Replies
I tried starting up the Ex last night and it would not stay running unless I pressed on the gas and once I let go of the gas it would die. It had been pretty cold in Austin the last few days and I hadn't driven the Ex since Sunday.
So today I went to start it just now after it warmed up pretty good and the sun has been out. It would not start on key crank alone, I had to hit the gas but once I hit the gas it would stay running so I left it running for a few minutes then turned it off then waited a few minutes and turned it back on with the key alone and now it starts without needing to press the gas!
Is this just a product of the cold weather, was the IAC Valve froze stuck? Is that something I'd never have to worry about in the summer?
Should I clean the IAC? If so what cleaner recommended? Should I replace it? Will happen again after a cleaning?
I was super bummed when it would not start last night but I'm glad it's running again! I'm sure towing this beast would be expensive if I got stranded somewhere else but home.
In my searching for this problem I found a guy with a different car who said he had to keep both feet on the gas and brake (which was dangerous he said) but was the only way to get it home without paying for a tow truck.
View 6 Replies
Okay, So my rear washer is not pushing out the nozzle. Pump works, line from res checks okay, nothing frozen at this point. What route the line goes through the body, or what the diag steps are or the process to service it?
View 10 Replies
I tried oiling the hinge and installing a new wiper but it seems like the spring isn't strong enough.
View 14 Replies
My son just got a 2001 Explorer Sport. Among the minor issues that need taken care of is an interesting situation with the wipers. The wipers only function when you press the wash button. It operates fine with wash, it parks fine after wash cycle. However, I get no response from any settings in the normal wiper switch. Where to start looking? Bad connector? Switch? It does have a tilt wheel, wire pulled out of connector?
View 14 Replies
So my wife and I swap vehicles for one day and what happens? It snows like hell and she can't get any wiper fluid to come out!
I started some troubleshooting and missed some clear indicators of the problem.
->Rear fluid works
->No pump engagement when trying the front fluid
Wasn't sure if I had 1 or 2 pumps (separate front and back or just one) so I bought one, tore out the reservoir (that air intake was a tough one), swapped the pumps and PRESTO! Still didn't work.
This leads me to believe I should have realized it was switch/power related all along. I don't mind tearing things apart, but I'm not good with electrical. Should I just buy a new whole stock and see if that works? My fuse isn't blown and seems to also be for the power windows, which do work, so I think I should be fine from that point.
View 13 Replies
When I tried to spray fluid into front windshield fluid is coming out very very very little on left and right side wipers, do I need to add any liquid or any problem with that..?
View 9 Replies
I've got this 1998 Monte Carlo with 191K on the odometer. Last year, when it got cold out, the washer pump did not work. But when it warmed up, it worked. This last summer, I replaced it with a new one. I clean out the squirters and verified that it all worked beautifully and was ready for the cold again. Well, it worked a couple of weeks ago, but now that it has gotten cold, it does not work. And the real weird thing is that when you are trying to get the washer to work, the wipers are going, right? Well, when you engage the washer, the wipers slow down, like there is a tremendous load on the circuit, but there is no sound from the washer pump.
View 5 Replies
2002 7.3 ...On my way home tonight, my Service engine soon light came on. How can I pull the code to see whats going on?
View 14 Replies
I have a 2000 Ford Excursion XLT 2WD with just over 155,000 miles on it, for awhile now My battery light has been on and off or it'll flicker and some times it will even stay solid. I checked the batteries and the alternator a while ago and got good readings from them. I just thought it was a code that never got reset. Well this morning I was driving it and I noticed that when I brought the RPMs over 3,000 the battery gauge would go up to 18 volts and the battery stayed on until the RPMs went back down past 3,000. It did this all morning until I got home and just for kicks I put it in park and revved the engine up to 3,000 RPMs, when I did nothing happened. I tried looking online for an answer and I called a few mechanic shops who all said it was my alternator. I want to make sure that it is in fact the alternator....
View 13 Replies
When I fill up my washer fluid reservoir, about half of it leaks out somewhere near the front of the passenger door and falls to the ground. Where it could be coming from? Is the rear washer hose routed through this area?
View 14 Replies
