Ok, I know I have a vaccum leak. I have manual hubs now and those lines are capped. The AC is blowing through the deforst and the pump is running non stop. I have replaced the vac pump a couple of years ago and it worked fine then. any other places to look?
View 1 RepliesHaven't been on here for a while. My f250 AC vacuum pump is out. This means the AC being reverted to blowing out the defrost. I have found the defrost/vent vacuum solenoid and zip-tied it open for a vents-only experience. I just realized, without the vacuum pump, there is really no way of determining if it is on recirculate or fresh air. I wish for the recirculate so I don't get someone else's or my own exhaust in the cab. Does the system stay on recirculate without vacuum power? if not what actuator must I zip-tie next?
View 1 RepliesOk, I have capped off the vacuum lines to the front hubs and replaced the vacuum solenoid on the passenger inner fender. Still stuck on defrost. I know there are several options from this point what would be the next step after what I have just recently done. Going away on a ski trip and would like to have it working properly before I go.
View 14 RepliesSo, my original pump finally died and I replaced it....however upon doing so I realize there is a leak/crack in the lines as it never shuts off (explains why the factory one died).
After a bit of troubleshooting, I've discovered the leak HAS to be down in the passenger fender where the black and grey lines travel over the blower housing and go straight down up against the inner fender wall.
Where doe these come out or connect? I clearly cant get a hand down in there...does the inner fender well have to come out to access this? or is there a junction box/splitter somewhere accessible?
My 2005 Freestar (not the Freestyle) a/c is working properly except that it is only blowing through the defrost. I've read other posts about it being a leaking vacuum system on other ford vehicles that cause this problem.
1) I'd like to confirm that this Freestar a/c works on a vacuum system to open the a/c duct doors.
2) If it is, where are the vacuum hoses located? I'd like to check them to see if they are connected or if they have a hole.
I know all about vacuum leaks and such causing this problem, and I tend to think that is my problem. But isn't the temp change dial also vacuum controlled (in my case of an 06 f250 6.0) by that valve near the oil fill tube on the passenger side? I ask because, while I am stuck on defrost i can change the temp of the air that comes out still, telling me there is enough vacuum in the system to at least control that.
I also know everyone talks about checking the ESOF system for cracked lines/leaks, but this shouldn't come in to play unless I have 4WD selected or if the EFOF solenoid is bad, right? I just got done tearing the top end of this engine apart, twice, for oil temp problems and am about done working on this POS!!!
This has been on going for the past year. The blend works fine. Fan speed works correctly. The selection for ac, max ac, etc., will only allow air through defrost vents. Vacuum leak?
1998 4.6 auto super cab
I have a 2004 Ford Escape 3.0 V6 FWD, and the air conditioning has been blowing only to defrost for a few weeks now. After many searches online, most sources seem to agree it is a vacuum leak, as the selector switch is vacuum driven if you want anything except defrost. I popped the hood and within one minute I found one open vacuum line that looks like it has been worn in two.
The line in question goes from the vacuum canister towards the passenger side of the firewall, then goes to a T connector, then a line (the one that is broken) continues towards the heater core lines to where the break in the line is. I found a picture online of what it should look like, but I am having trouble accessing the line that goes through the firewall and behind the glove compartment. I am pretty sure this vacuum line continues through the firewall between the two heater lines, but after that I am stumped.
I popped the glove box down out of the way and I see two thin vacuum lines and a small metal "can" nearby. The black line goes from a fitting and into the A/C bundle, and the white line goes from the top of the metal canister and down into the same bundle. My main question is which line controls the AC selector, and how do I pass a replacement line through that part of the firewall to make a good connection, as it seems the break is at the firewall itself with no extra sticking out for me to connect to.
Its hot in St. Louis and my windshield sure is staying cold (ac blows from defrost vents only).
1999 Ford F350 7.3 diesel 4x4 (4x4 lever on the floor). About a month ago, the ac starts blowing out of the defrost vents only. I assumed it was a vacuum issue.
Lines looked good; very plyable still. Canister looked fine. The vacuum pump on the pass fender well smelled burnt, so I replaced it. Got the new pump in and it didn't work. Checked the fuse panel and found two blown fuses, replaced them and the pump worked.
Here's my issues: if AC max is used, the vacuum pump stops working and air blows through defrost only . If the dash switch is in the off position and then turned back on, air blows through defrost vents again and vacuum pump will not work.
Is there a solenoid or switch to this vacuum pump that I'm not seeing?
The front a/c on my ex on the highest blower motor speed blows out the vents like its on low, but I can hear the motor blowing at full speed. It's not blowing out of defrost or floor unless I switch it. On lower settings I can barely feel any air at all. Only does this rarely. Could it be my vacuum pump?
View 4 RepliesI'm not sure if on my 2002 Excursion limited the air vents are controlled thru vacuum or electronically. Where to start. Where to even begin looking to correct this problem. I'd rather not have to pay the dealer prices unless it is something out of my league of fixing.
View 4 RepliesMy 02 V-10 Ex seems to be blowing Air from the front vents up to the Defrost unless it go through a series of events-- Hit Auto then forward Air then the fan has to be a 4 only. It will blow forward vents then go back and forth from theirr to the defrost. Also the Temp seems to be much hotter then it should.
Took a interstate trip this weekend though and it seems to blow much colder and do a little bit better staying in the front vents however still goes back and forth. Im in FL and its HOT!!!! The only thing I know is that its a vacuum system.. and that again its HOT in the truck as a daily driver.
Haven't found any other useful info on this, but local dealer says that's where my truck is leaking oil from, and since it's considered brakes not powertrain the repair won't be covered under warranty ...
Backstory goes : dropped my truck off at local dealer Thursday to repair an oil leak from near front main seal area of the engine discovered while inspecting to initiate a bumper-to-bumper warranty through Ford ESP- their platinum warranty. I figured with all the electronic widgets and non-powertrain stuffs on this beast I wouldn't mind paying for 3yrs/36k miles of trouble-free motoring, y'know?
Apparently it's the O-ring on the brake vacuum pump that's allowing engine oil to leak. I can't even find this thing, just looking for some further explanation. I'm keeping an open mind so far, I don't suspect the dealer's just trying to get one over on me, just trying to be good and educated before I go plunk down for the repair.
My vacuum pump I noticed is running constantly and also my vents are stuck on defrost.
I narrowed it down by taking off the lines going from the tank to the 4x4 solenoid and the tank to the HVAC line. If I plug both lines I get pressure to both but it still won't shut the pump off. Why won't the pump shut off? Leaky tank?
If I plug the red line back into the solenoid I cannot get pressure to come out of the HVAC line. (Switch in cab set in 2wd)
I can make the pump shut off by plugging the main inlet to the pump.
I took the tank out and can't find any cracks or leaks. Could something inside the tank be broke?
Also why can't I get pressure when the red line is plugged into the selinoid?
I can't figure it out. Almost seems like the 4x4 solenoid and the tank are both the problem.
I have a 2004 F-350 diesel. My vent selector is always on defrost so I suspected a broken hose but traced all out and all seem to be fine. I disconnected the line coming from the pump to the tank and no vacuum. The pump doesn't seem to be running but it's hard to tell with the engine noise and vibration. What tells the pump to run and how can I bench check it?
View 8 RepliesI recently had a Jasper rebuilt engine installed in my Ford E150. Since than my check engine light keeps coming on and the computer is saying my cas air mix is "lean". The instaler says i need a new fuel pump.Another mechanic says it is more likely a vacuum problem.I know it's possible that the fuel pump is bad bur since this has just started since the install, I don't believe it can be the fuel pump unless it's just one hell of a coincidence.
View 6 RepliesI have a 2008 F350 FX4 with the 6.4l diesel, a couple weeks ago I was reprogramming the ecm and noticed the vacuum pump was running and wouldn't stop, so after a bunch of reading and testing i changed the solenoid vacuum valve. I tested all the vacuum lines and found no leaks.
View 3 RepliesI've had this problem for a little while now, my 97' F150 V8 4.6L, has been running real loud and heavy. When it starts up it sounds like a race car. It finally shot me a code for P0171 - Bank 1 (passenger side) running too lean. From what I've read, this is most likely a vacuum leak but I don't know too much about it.
A couple of things I've noticed while driving it around:
1. If you are in the engine compartment while its running, you smell the excess gas on the passenger side of the truck.
2. The exhaust also smells really heavy
3. The loud and heavy running is mainly when accelerating, if I maintain a constant speed at for a little while it almost starts to run normal. Cruising down the highway its almost just as quiet as before the issue
4. Engine coolant heats up much more quickly, but doesn't get above operating temperature (read from tuner, never above 200 degrees)
In response to the problem I replaced both the O2 sensors closest to the engine and the PCV and elbow. No change. Have a fuel filter ready to install, but for some reason I don't think that is it either, as it would probably effect both bank 1 and 2.
Like I said I'm not too well versed in the vacuum system but if any of these symptoms stand out I'd love to hear your thoughts.
I have a 2005 F250 , 4.2 tdi diesel. I just bought the truck recently and still getting to know it.
I noticed recently that when I turn on the key, the vacuum pump starts running and does not go off. It seems to run continuously and will only shut off if I block the white outlet pipe with my finger. Is this normal or is the pump stuffed.
I have been having some issues I think are vacuum related but I'm not sure how to correctly diagnose or pinpoint exactly where the problem is. 2 issues that seem vacuum related:
The first is a sound and vibration I get while driving forward. While the wheels are moving, it sounds just like a baseball card in bike spokes, it usually happens after I backed out of a parking spot and put it back into drive. I will get that sound and vibration until I slow down, and just as I begin to stop, I feel and hear a big bump and the sound goes away.
The second is the old climate control settings. The settings switch without moving. Sometimes while I have the AC running through the dash vents it will switch to the defrost setting and then back to AC after a couple minutes. Sometimes it won't stay in the defrost setting and switches to the vents. How to diagnose?
I had the doors open while unloading the car this morning and noticed that the brake booster pump just kept running and running and running, plus I can hear a strange, hollow rattling sound somewhere under the car that coincides with the pump. When I say it runs "constantly," I really mean that it runs for 10 seconds (with the rattle), stops for about 5 seconds (silence), runs and rattles for ten seconds again, stops for another five, and just keeps on going for as long as I care to sit there with the door open.
View 15 Replies