I've got a problem with the turn signal on my '01 V10 4x4. 3 out of 4 times I hit my turn signal, it immediately resets because my wheel may not be perfectly straight. If my wheel is not straight or turned significantly (>180 degrees) the turn signal will not reliably latch. Its a minor annoyance that could turn into a safety concern.
Is there anyway to adjust the latch mechanism?
I towed my friends car hauler yesterday for a short distance for him. I had no turn signals or 4 way flasher while towing. After dropping off the trailer still no signals or 4way flasher. I parked and checked fuses all were good and signals started to work. But still no 4ways. Any thoughts on what to look for. Never had this before. I have blown a fuse before and always been able to find and fix.
View 13 RepliesI'm having problems with my left turn signal not working. It sounds like it's blinking super fast from inside the vehicle, the left turn dash light does not illuminate, and the outside front bulb does not blink. When I turn my emergency flashers on, the left front still doesn't work, but all others do. All the other bulbs are in working order. I searched through some old threads on this and couldn't find much other than to replace the bulb and bulb housing, which I did with no luck.
View 14 RepliesMy driver mirror has small clip failed, only way is a new mirror. I found a pair of mirrors with heat like mine BUT they have the turn signal.
View 9 RepliesPut a new bulb in the right front turn signal, still doesn't work (parking light works though).
View 10 RepliesI installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
My wife asked me yesterday what was that "clicking" sound when I turned. I never noticed it before, now I notice it constantly.
With the wheels straight - activate either side turn signal. Now turn the whee IN the direction your signal is activated, notice a clic-clic-clic??
Then when you turn back towards straight the signal will de-activate and the clicking is gone. This an indication the multi-function switch is going?
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
I got my headlights swapped but the turn signal sockets can't go into the housings. The old bulb socket thing is a 90 degree twist in and it would twist in if there was room for the socket to twist. The back of the housing has a blocky lumpy thing in the way and I need a straight in socket I guess.
View 14 RepliesTurn signal flasher doesn't work in the heat. What gives?
All lights work. Turn signal stalk works fine. It just flashes a couple of times, then stays on. Everything works fine in cool weather, but it rarely works at all when the temperature outside is above 90 degrees. Very annoyed.
2003 X limited, 2wd 6.0L
Last week wife's right rear turn signal/brake light stopped working. The left one flashes normally. The right tail light works fine which is a different bulb. I tried changing bulbs (didn't work).....tried a new socket with new and old bulb (didn't work). Could it be a relay? Or not relay as they would be both out (left and right)?
I looked at my trailering wiring plug down by bumper and the white wire with green stripe looks split a little towards the end. Could it be a bad ground or short in that wire? Would the trailering wiring have anything to do with it? I was going to try to replace the relay if I could find it, what is the part number for it.
Door on the T-reg that is hard to get latched completely? I'm finding a need to reopen/slam the driver's door on a regular basis. Is this something the dealer can "adjust" for me? What would it involve? I don't think the other three doors need to be slammed anywhere near as hard.
View 1 RepliesI have a 72 F250. When I put the left turn signal on and apply the brakes, the signal stops blinking. I checked the bulb and it was fine. What is the likely cause?
View 2 RepliesHaving problem with the rear door latching?the glass hatch closes ok it is just the barn door that wont latch. Is there a fix or do I have to replace the lock mechanism...
View 10 RepliesWe have a 2015 Sonata 2.4 Sport that has developed an intermittent turn signal problem. When the left turn signal is turned on, the right signal will blink. When the right signal is turned on, nothing blinks. A new symptom that recently started is sometimes neither turn signal will turn on regardless of the position of the turn signal stalk. I managed to get the car to dealer #1 while the LEFT=RIGHT & RIGHT=NOTHING issue was happening but while troubleshooting it, they ran across an inactivated aftermarket alarm system that dealer #2 that sold me the car had installed. I guess the alarm they install is so cheap, it's not even worth removing if they are unsuccessful in upselling you at the time of purchase.
Since dealer #1 would not troubleshoot any further unless the alarm was removed, I retrieved the car and took it back to the original dealer #2 I bought it from. They removed the alarm and the turn signals started working again, however, this lasted about 2 weeks before the symptoms returned. I booked an appointment at the dealer #1 to bring the car in & half way during the drive there, the turn signals started working again. With nothing to show them, I didn't drop off the car. Now the problem is back. Since it tends to come and go, I have try and time when I can drop the car off so it's happening when they get it.
How many have had luck and results adjusting there steering box.I ajusted mine and it corrected the bad wandering proplem. I just hope this will last.
View 7 RepliesWhat model year(s) 2nd row bench seats that have a factory LATCH system will fit in a 2002 Ford Excursion to replace the seat that is missing the anchors that are between seat bottom and seat back?
View 14 Replies2003 Ex, EB, bench style middle row. I have owned less than a year.
Purchased with a broken latch assembly the drivers side middle row...promptly replaced for $70. Today, it is broke again, less than a year. I am going to do some more investigating as to HOW this happened TWICE.
Chipped, broken housing on their middle latch assembly? It breaks the black part first, which holds the guts in alignment....once the black part slips down or up to far...the guts do not function.
Jumped in the truck this evening to go to the store and when I stared it up the left turn signal was blinking. Lifted the arm as usual to cancel and it does not cancel. Cannot get the left signal off unless I hold the turn signal up for the right signal. The right signal does not activate, but the left does go out as long as I hold the arm up. Let go and the left starts blinking again. Tried driving around to see if it would cancel and no luck. The bulbs are all good. I checked the relays in the fuse panel and they are good. Dang thing just won't shut off. It is a 2011 F150 SCREW Platinum w/5.0.
View 4 RepliesI picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 RepliesMy reverse lights and back up alarm will not engage unless i hold up on the shifter while in reverse the only thing i found was a adjuster for the indicator....
View 14 Replies