Ford Excursion :: Transmission Leak / Hard Time When Try To Reverse
Mar 25, 2015
I've seen this talked about before and it's happened to me before as well but now the tranny is leaking onto my Ypipe a couple times per week and it's giving me a hard time when I try to reverse. revs drop and it stalls if I don't give it enough gas.
So I know I have to change the seal but Ford is telling me the torque converter will need to be replaced but another transmission shop told me once the seal is changed and fluid level set appropriately I shouldn't have the reversing problem anymore?
Is this something I could attempt myself... looks almost like I'd have to move the exhaust to drop the tranny...
View 12 Replies
Advertisement
2001 VW Jetta 1.8t automatic.
Transmission has a hard time going into 1st and reverse. Also some times hits hard going into third. I have a CEL for a vehicle speed sensor? Was wondering if it's not the VSS but maybe one of the other tranny sensors?
Separate question. Same car has a rough idle issue. Occasionally stalls but intermittently runs normal always has a low idle around 600 rpm. I have a code for an injector on cylinder three.
VSS code : P0725 - engine speed sensor circuit malfunction
Injector code : P0203 - injector circuit open cyl 3
View 4 Replies
The backup alarm sounds when I put the truck in reverse when there is nothing behind me. I found posts about people not getting any sound at all but none like mine. I'm guessing I have at least bad sensor that 'thinks' there's something in the way when there isn't.
View 5 Replies
2003 Excursion 4wd. Noticed a few days ago that when selecting reverse, it seemed to take longer to actually go into gear. Didn't think much of it and it has been fine since. Pulled the camper a few hours away for the weekend..
Now the truck is slow to engage reverse. Even when warm, when I put it in Reverse, it takes up to 30 seconds or so for it to 'catch'. I checked fluid and it's ok. Shifter feels ok. Fwd gears are fine?
View 14 Replies
We are planning on taking our 07 Explorer in to the dealer to have them check on a couple of issues. 4.0 with auto and about 45,000 miles on the ody.
1. While taking off after waiting at a stop light or slow speed traffic crawling there is a high revving sound coming from the engine compartment. Sounds like the fan is over revving compared to the engine speed.
2. Recently the truck has a hard time going into reverse. Physically hard to move the gear select lever and there is a hard "thunk" when it does actually shift into reverse.
I just want to be armed with information before heading to the dealer. The truck is still under a warranty plan, I just need to be prepared. Could it have to do with the Transmission Range/Position Sensor?
View 2 Replies
Lately (within the last couple of days) when we park the Excursion we have a difficult time getting it out of park and into gear whether it is going in to Reverse or Drive the gear shift does not want to move.
I have not forced anything at any time but eventually with some pumping of the brake pedal and some putting into park and out of park we can free it up. This is something that happened virtually overnight and once we are in gear everything is normal.
What is causing it? I am making an assumption that it has to be some switch in the steering column but I am no mechanic and only guessing.
View 4 Replies
I have a 2005 Ford F-150 with a 4.6L and auto tranny non 4 wheel drive. I have a hard time moving from park to drive and reverse. Is there a switch that lets you put it in gear once the brake pedal is depressed? Could that have gone bad?
View 5 Replies
Every time it rains I get a wet spot in the far left corner by the spare tire. Am I looking at a new seal or is this a trait with a different fix.
View 14 Replies
He has a 2002 Explorer 4.6. The truck is having a hard time going into reverse intermittently, hard shift in normal driving and thinks it has slipped in first gear going up his driveway that is steep. He is worried that he put slightly over sized tires and this may hurt his tranny. The overdrive has blinked twice with in the year. Possible problems that could create this he is thinking solenoid pack, servos, torque converter. The truck has 110k and never done fluids, Would lucas slip fix or hurt we have heard that these tranny's are finicy.
View 1 Replies
My V10 Excursion is giving me a little bit of a hard time. Once warm, it shuts off when I go from drive to reverse and when I have to brake hard. I cleaned the mass air flow sensor and replaced the idle air valve behind the throttle body. Not sure what else I can do.
View 14 Replies
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 Replies
I have a 2003 Accent and it has been over heating constantly for about 5 months. After it started, we replaced the main radiator hose, thermostat, radiator cap AND a head and head gasket. It worked for about 2 weeks and then over heated again. It seems like there is too much pressure somewhere because the lid for my reservoir shoots off and all the coolant comes out. I'm just not sure where to look for a clog since it is coming out of the reservoir. It also recently started having transmission problems(?) or that is what I think it is... It won't go in reverse and has a hard time shifting sometimes. I'm not sure if it could be related or if it is the tranny also.
View 4 Replies
[URL] .... My engine has been making this sound for a while now I am at 125000 miles, what it could be and if i need to be worried about it? also, possibly unrelated, it has a SUPER hard time shifting into reverse, it gets stuck and it feels just super sticky shifting in and out of reverse. Sometimes I can't even get it to go into reverse without letting the car roll a bit. Also, at around 3k rpm the engine sounds a little grinder in any gear. 2008 Honda Fit Sport ...
View 19 Replies
3 for 3 this year. When I'm towing, arrive at our campsite and back our trailer into the spot. I get white smoke pretty quickly and there is transmission fluid all over the ground.
4R100 transmission with 71k miles on it. I had the fluid changed this year HOWEVER it did do the same thing last year on a camping trip when I was towing.
I don't have any other issues other than this. I assume the fluid is getting ridiculously hot and then boiling over? The gauge doesn't change at all in the cab (but I assume it is either a GOOD/BAD sensor vs. an actual temp sensor).
I've tried using 2WD, 4HI and 4LO all with the same results. What needs to be done to prevent this? Larger transmission cooler? Is there anything that is 'plug and play'?
View 14 Replies
For the past two years I've noticed a decrease in fuel economy and recently noticed that the truck did not "feel" as if it had the same power especially when towing. Checking all the usual suspects with the engine turned up nothing and the transmission wasn't showing any signs of problems other than an occasional delay going into reverse. But it had been doing that for years and so I just ignored it.
Recently the torque converter started acting up and had some other occasional shifting delays and so decided to put the vehicle in the shop. The electronics all checked out and so a HD rebuild kit was ordered. The truck was finished this morning. Just barely pressing the accelerator makes the vehicle instantly start forward with noticeable zip. Plenty of power at all speeds, the engine now feels like new.
I suspect the main culprit was the torque converter. It wasn't enough to notice in excessive rpms nor heat (at least according to the instrument gauge) but the loss is noticeable in hindsight when compared to the repaired system. Over the next few weeks I'll get some mileage numbers and will know for sure whether I've found the sole cause of my power problems but I am sure that I've made a fairly large step in solving them.
View 14 Replies
My new/used 2000 4x4 excursion with 214000 miles on it has a transmission fluid leak.
It could be a rear portion of pan gasket but it seems to be coming out of the area where the transmission bolts to the extension housing.
I just put a transfer case in it. Thought all the fluid all over was due to exploded T case.
It seems the output shaft seal may be bad. I cannot seem to find an OEM part number for this seal.
What is part number for this seal, if one exists? Maybe the seal is in the extension housing and it's just the gasket between Trans and housing.
View 8 Replies
I'm having problems with my 6r140 in my 2011, the truck is an early build around 8/2010 I believe.
After cold soak when shifting into reverse after allowing engine to warm a bit the transmission almost always slams hard into reverse.
After that shifting from 1-3 is awful, the transmission will try to go into 3rd but downshift to 1st then fail to go back into 3rd multiple times. This situation is extremely dangerous when trying to pull into traffic.
Oh and once the transmission gets into 3rd it will skip 4th and go right into 5th. There is only 94k miles on this transmission/truck.
I just bought this truck about a month ago, does this sound like an issue with the solenoids in the valve body?
I'm very mechanically inclined and can swap them if need be but now we're talking few hundred in solenoids and then getting the trucks pcm flashed right?
Also fluid has been changed and I used mercon lv.
View 14 Replies
I have a 2000 V10 2WD Excursion with 104,000 miles. Last week it started shifting hard between first and second, but only when I am between 1500-2k RPMs. If I rev the engine higher, it shifts smooth. I checked the fluid and it is fine. I rarely tow anything except my little trailer to the dump every few months. I have a few questions:
1. Should I drop the pan and change the tranny filter?
2. Should/Can I check the rear diff fluid? (haven't noticed any leaks)
3. Could an inline flush and fill work?
4. I saw a post about a speed sensor in the rear diff. Could this be the issue?
View 4 Replies
As it turns out, my shift cable wasn't bad. The transmission lever coming out of the transmission doesn't want to move very easily. When in gear, it shifts fine as it should, so I'm thinking something is bad with the lever. Problem is, I don't know what could possibly be causing it.
View 8 Replies
I drive a 1998 honda civic 5 speed manual transmission. The transmission is loud in all gears(including reverse) nearly all the time. It is not exactly a grinding sound, but that is as close as I can describe it. When taking off from a stop, sometimes it won't initially make the sound, but around 15-20 mph it will start to make the sound in 1st or 2nd gear. Once the sound starts, it won't go away. I can't link the time when it starts making the noise to any particular RPM.
I've hard the car for 5 years and 50,000 miles and it's made this noise the whole time I've had it. It is annoying more than anything (shifts smoothly, clutch not slipping). Someone who looked at my car shrugged his shoulders and said "when the clutch goes, put in a whole new transmission, that will probably fix it".
View 8 Replies
05 F-350 6L .. Automatic Transmission
When I got the truck I noticed it would slam hard into reverse. Ever since it is taking longer to engage reverse gear and now I have to rev it to 1000 rpms for it to engage with a hard SLAM.
I also noticed that if I do a fast take off, there is a knocking sound coming from drive shaft/differential area (like knock knock knock knock knock then goes away). Then a slight vibration ending at around 30 kph (~20 MPH). There is also some oil leaking from the transmission. I added some mercon sp yesterday - it was a bit low.
My guess for the knocking and vibration is the center support bearings and U-joints. Transmission??? One thing I know I am going to be banging away at that shaft but the transmission problem really scares me.
View 5 Replies
