Ford Excursion :: Steering Wheel Clicking While Turning With Turn Signal On
Aug 11, 2017
My wife asked me yesterday what was that "clicking" sound when I turned. I never noticed it before, now I notice it constantly.
With the wheels straight - activate either side turn signal. Now turn the whee IN the direction your signal is activated, notice a clic-clic-clic??
Then when you turn back towards straight the signal will de-activate and the clicking is gone. This an indication the multi-function switch is going?
View 10 Replies
Advertisement
I installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
View 14 Replies
my turn signals only work with the steering wheel tilted all the way up. It works for me, but my wife drives the truck mostly because we live a mile from her work. The dealer said it was a "peanut connector." And can someone walk me through the steps to fixing it?
View 8 Replies
Getting a slight clicking sound/feel when turning the steering wheel when either stopped or moving very slowly. It's most noticeable when turning in and out of a parking space. Don't think it's subframe but may the strut bearing caps.
View 16 Replies
I am getting a click from the steering when rocking the wheel left or right. It is coming from the assembly the intermediate shaft is connected to. I see there is a large bearing on the end where the shaft comes out. I am not sure what this assembly is called. I have had it at the dealer and they said they re-torqued everything but they could not duplicate it.
I do not fall in the range for the recall and I have no problem with the car pulling left so I do not think it has anything to do with the intermediate shaft. It is clearly from the assembly the intermediate shaft is connected to on the steering wheel end of the intermediate shaft. 2011 limited
View 13 Replies
Front sway bar bushings causing "clicking" noise while turning the steering wheel? Usually happens when I'm moving into or out of a parking spot and while I'm turning my steering wheel. I got the driver side, I believe, lower control arm replaced and after that i started getting a faint clicking noise when I'm turning the steering wheel.
The dealer, after multiple visits, discovered it's the front sway bar bushing causing the noise. They said it's really not worth the cost, since it's isn't a safety issue and the whole sway bar needs to be replace since you can't buy bushings alone. I want to get rid of the noise regardless of safety or not.
View 5 Replies
Starting having a problem with the front suspension on my 01 excursion. When you go over a incline I am getting a big bang in the front suspension also when you turn the steering wheel to the middle it has a jerk right before its in the straight position.
I have new wheel bearings and new locking hubs coming, this problem still happens without the hubs in. Could it be a front axle or U joint but it happens with the 4x4 disengaged.
View 11 Replies
I've recently replaced the power steering pulleys and belts. Now when i turn car, it makes a clunking /clicking noise and sometimes the power steering tugs back a bit. 2010 camry.
View 3 Replies
I have 2016 camry 4 cyl have roughly 2300 miles and I'm noticing a click click while turning the steering wheel left or right while stationary and vehicle running sounds like it's coming from under the dash.
I've seen there is a tsb for other year camry intermediate shaft issue, my vehicle is lowered on eibach Springs and would hate to take back to dealer and have them blame it on the springs in a vehicle that has only 2,500 miles.
View 10 Replies
When I am sitting at a dead standstill and I turn the wheel lock to lock, left or right, I hear a clicking sound. The clicking is louder inside the car, but I can't tell if it's coming from the steering column or the various linkages in the suspension or drive systems.
If I drive in circles, with the wheel at a constant (or changing) angle, there are no clicks, so I don't think this is a CV joint issue.
What could be causing this noise? I really don't want to take off my lowering springs and restore this thing to the original configuration for a warranty repair visit to the dealership.
If I do, you may see a fire sale of H&R 20mm wheel adapters and B&G lowering springs in the near future.
View 3 Replies
I have a 2009 screw with ~60k miles. It is used for DD and tows our small camper or my flat deck w/jeep.
The other day I noticed an issue when turning right. The wheel gets hard to turn and does not want to return to center. There is also a low speed clunk you can feel in the steering wheel/column itself.
The truck is at the dealer now and they said the rack needs to be replaced and there is something in the column they need to replace too. I have the extended warranty, so this is all but covered 100%. I just have a deductible to pay.
I have not hit anything with the truck, so I am not sure what caused these issues.
View 3 Replies
This is my first VW and I have a strange clicking noise when I turn left or right and especially after a turn and the steering wheel turns back to center. Taken it in twice and no one can figure it out. I have never heard this before on any car. What this may be?
View 4 Replies
09 Camry steering wheel clicks when going over speed bumps or if turning the wheel left and right somewhat rapidly at a stop. Seems to not be as bad when the tilt is all the way down.
View 1 Replies
I had the neuspeed springs installed last weekend and now the Front right side make a loud clicking noise every one turn on the steering wheel. it sounds like the springs it self. What could it be?
View 9 Replies
For the last few months, I have been chasing down steering problems. Alignment, end links, ball joints... and now, humming. Every time I take a turn that requires more than 1/4 turn of the steering wheel, the car hums. It wasn't very noticeable at first, but over the last week it has gotten much louder.
I have topped off my PS fluid and replaced my belts, but this has not solved the issue. Before I start replacing a pump and/or a steering rack.
View 3 Replies
I have a 2004 Pruis. Lately I have been noticing a problem with the cruise control. Often when I press the button to turn on the CC it will not come on, but if I turn the steering wheel to the left a bit I am able to turn on the cruise, sometimes when I turn the wheel back it will continue to work and other times it will not. I tried to search and found others posts about prius CC but couldn't find anything that included all of my symptoms.
View 6 Replies
My neighbors 02 250 6.8l the turn signal/hazard relay is clicking with key off, sounds exactly like a turn signal when truck is off and switches are not engaged. Here's the weird thing, if you hit the brakes the relay stops clicking, if you engage the turn signal or the hazards the lights on the dash are in time with the relay as it should be, but when the turn signal switch or hazards are turned off the relay keeps clicking except when you hit the brakes. Also the turn signal will work with ignition off, if you pull the relay out the turn signals and hazards are inoperable but the brake lights still work. I swapped in a new relay and same thing...
View 8 Replies
All of a sudden, my turn signal won't stop automatically after making a turn. I read that the multi function lever needed to be replaced. I did, and nothing changed... what is wrong since its not the lever assembly itself?
View 6 Replies
I towed my friends car hauler yesterday for a short distance for him. I had no turn signals or 4 way flasher while towing. After dropping off the trailer still no signals or 4way flasher. I parked and checked fuses all were good and signals started to work. But still no 4ways. Any thoughts on what to look for. Never had this before. I have blown a fuse before and always been able to find and fix.
View 13 Replies
I'm having problems with my left turn signal not working. It sounds like it's blinking super fast from inside the vehicle, the left turn dash light does not illuminate, and the outside front bulb does not blink. When I turn my emergency flashers on, the left front still doesn't work, but all others do. All the other bulbs are in working order. I searched through some old threads on this and couldn't find much other than to replace the bulb and bulb housing, which I did with no luck.
View 14 Replies
My driver mirror has small clip failed, only way is a new mirror. I found a pair of mirrors with heat like mine BUT they have the turn signal.
View 9 Replies
