Ford Excursion :: Start Then Die Immediately - Fuel Pump?
Sep 25, 2016
As in a previous post, i have been having issues with my truck starting then immediately dieing if i dont keep my foot on the gas.
Ive learned how to drive with 2 feet because of it, but I'm afraid i might be doing some type of damage since it keeps dieing and I have to keep starting it.
Once i get going for about 10-15 minutes its fine but its happening every time i start the truck.
Before it starts running correctly, it only idles around 400 rpm.
I think its the fuel pump, since my mechanic put a code scanner on there and it didn't throw any codes, he thinks it might be the fuel pump.
My question is, should i go with a ford pump from the dealer or are the ones sold from discount/o'reilly/napa just as good?
View 14 Replies
Advertisement
Before I left on Spring Break last week, truck wouldn't start. It was a Saturday morning, so I had it towed to the only open shop in town. He said the fuel pump was going out. He got it started maximizing the fuel pressure with his scan tool.
The unusual thing is I replaced the fuel pump (I have a V-10) earlier this year with a Motorcraft Pump from Amazon. I also replaced the fuel filter about 60,000 miles ago.
Does this sound right? I have never heard of turning up the pump with a scan tool.
It did fine over Spring Break, but is in my driveway right now refusing to start. I can't believe the fuel pump went out that quickly.
Does it sound like the fuel pump?
View 5 Replies
I own a 2003 Limited with the 6.8 V10. I drove the truck on Sunday and all appeared to be fine, gas gauge was setting just under a half tank. When I went to start it yesterday, it would not start. Strong crank, no start. I checked my fuse and it was fine. Fast forward to this morning, since I had kind of depleted the battery with attempting to start, I put my little jump start pack on it and gave it a whirl. Truck started fine but the gas gauge was sitting on empty. I had five gallons of gas in the garage so I added that to the tank then drove to the local gas station to add more fuel. I put another 10 gallons in the tank so it should have roughly 16 or 17 gallons in the tank. Gauge shows 3/4 tank but miles to empty is right around 175 miles which would seem right with 17 gallons in the tank. I suspect the fuel pump. I don't really want to spend $500 on the Motorcraft unit but was wondering if the group believes the Delphi or the Bosch units are quality replacement parts?
View 7 Replies
Black Beauty finally gave up. Replaced battery, replaced fuel pump relay. Would only run with starter fluid sprayed into the air intake. She'll crank but not start. Here she sits at the dealership.
View 14 Replies
I have an issue of fuel pressure I believe on my 2003 3.5 Santa fe...It would start then stall...I'm at my wits end with this thing...I checked the relay and its good...checked all fuses and they are good...I don't hear the 2-3 second whine of the pump when I turn the ignition to the on position, so I suspected a bad pump...but before I bought a new pump I took out the back seat, removed the access cover and checked the connector to see if the pump is getting power...its not...I'm at a loss as to where to look next...
View 35 Replies
So it has happened twice now that gas will NOT go into the tank on my 2001 Saturn L200. The pump immediately shuts off and gas spills out. From some research I believe there is a kinked hose but where and why did this happen 2 months ago and then now after several fill ups between. The first time it happened the problem fixed itself after sitting for a day, I guess I'll find out today if that is the case.
View 3 Replies
So for about two months now, every time I get gas, the pump cuts off almost immediately after i start pumping. After that, I am able to pump about a second or two before the pump shuts off. It recently has started spitting gas back out of the tank (I'm assuming it's the gas I just pumped into it being spit out). I'm not sure what is wrong. I have not gotten into an accident, there is no smell of gas in the car, the gauge still works fine, and no check engine light on.
View 3 Replies
I just got my Bosch fuel pump from Riff Faff and will be installing it this weekend.
I want to add a Pre and Post filters to the pump and had a couple of questions
1) the threaded end that's under pressure what is that connection.. I would like it hard connected to a filter and then the stock line connected to the out put of the filter.
2) for Pre Filter its a push Lock connection... Should I keep it or look for something that works better under Vacuum?
View 9 Replies
Have any of you tried to cut an access hatch in the rear of your truck to get to the fuel pump without dropping the tank? Am I way off? can it even be done? My fuel pump took a dump with about a quarter of a tank. I'm trying to find a work around.
View 14 Replies
It has been a while. My 2000 2wd 5.4 Ex has developed a issue and I'm going to say it is the fuel pump. It was right before Christmas and I went out and the truck would not start. I panicked and remembered the relay. It pressed it, it clicked and off I went. Last week I was leaving work and it did the same thing but the relay was not tripped.
I got under it and rapped the tank a couple times with a rubber mallet and it fired up just fine. Went out this morning, super cold out and nothing. Rapped on the tank, nothing. Took the other car to work and came home, rapped on it again and nothing. The fuses are good but I'm sure it is the pump because I was able to hit the tank and start it.
My question is, any write up on removing the tank or a video? I like to see what i'm up against before I start to pull it. The bad thing for me is I have a little over half a tank of gas in it and no place to put it. This is going to be fun.
View 8 Replies
01 7.3. Cranks, won't start. Tank was at 1/4 but is full now. The lift pump runs, I can feel and hear that the motor is spinning when I cycle the key. I removed the fuel filter and cycled the key and get no fuel into the bowl. It looks like the lines are stainless from the pump to the tank so I doubt it is sucking air. I pressurized the tank with a shop vac and I get fuel coming into the filter housing. Am I missing something obvious? I have never seen an electric pump that would run and not pump fuel. I removed the suction line at the pump and don't feel any suction there.
View 14 Replies
Looking for a link to the fuel pump wiring for a 2000 V10 Ex? I'm trying to pinpoint my no start issue and want to make sure I don't miss anything. I think it goes from 20 amp fuse under hood to inertia switch to relay under hood to pump? 20 amp fuse has power but at the inertia switch I have no voltage, just approx 35 ohms resistance to ground on both outside wires. Does the inertia switch close a ground or should it have voltage?
View 10 Replies
I have been chasing down what was a perceived vacuum leak...
My Ex (V10, 4x4, 217K miles) started to have an intermittent rough running/no power situation very randomly. No codes on the scanner, and no real apparent cause or condition to pin it down. I noticed what sounded like a like throttle ping...figured it was a vacuum leak someplace in the spaghetti under the hood.
I began to run down the possibilities. I have recently had the entire suspension replaced and upgraded all 4 corners to Power Stop brakes. Figured it might be something related like the classic lines to the hubs.
Replaced the vacuum lines to the hubs - ran OK for a bit, then rough start/idle/no power.
Replaced the vacuum switch for the hubs - ran OK for a bit, then rough start/idle/no power.
Replaced fuel filter - ran OK for a bit, then rough start/idle/no power.
Ordered a new vacuum reservoir...
While waiting on that, changed all 10 plugs and coils. Not. Cheap. Ran OK for a bit, then rough start/idle/no power.
Replaced IAC - ran OK for a bit, then rough start/idle/no power.
As I was getting ready to install the vacuum res, it just croaked. it would turned over like it wanted to start, but wouldn't catch.
Of course.... So, now it had to be towed and yes, the fuel pump puked and that was that. I've never had one do anything but just quit suddenly before, so lesson learned. Evidently these pump can act up for a bit before they die.
View 4 Replies
- Fuse Box - Part # 3C7T-14A067-DC Engineering Number on white label.
- Ford Dealer Part # 3C7Z-14A068-DB
I have a 2004 Ford Excursion 6.8L 4x4 that has a bad fuel pump relay. I am looking for a used replacement fuse panel.
Of all these number and letters which of them tells me the real part number? Does the last two letters mean anything "DC" or "DB"?
So I don't get one for a diesel, what is the prefix for the diesel? I am assuming the 3C7T is gas and the year model?
Also, will this fuse panel interchange with a F250/F350 6.8L or do I need to stick with a fuse panel from an Excursion?
View 1 Replies
The fuel gauge sender quit the other day so Im replacing the pump assembly. I believe in replacing fuel and ignition related parts with factory equipment. So I was going to get a Ford Motorcraft pump, but my wife checked for one through her work(local parts store). The counter guy found one that said original equipment, called them and was told "It is the same pump that gets installed on the assembly line". Well it came in today and its a Delphi. I was expecting a Ford pump. I associate Delphi with GM and I know GM pumps go out all the time. I know Ford pumps go out too, but I know several people with GMs that have replaced pumps multiple times within 100000 miles. Is Delphi worth taking a chance on?
View 6 Replies
My eXcursion is showing the typical signs of a failing fuel pump. It cranks and fires on a few cylinders, then quits. I released the schrader valve on the fuel rail but very little pressure is released. From these indications, and after checking for a blown fuse, it appears the fuel pump is going. I say going because it did start after this happened, but would you trust it?
I ordered a new fuel pump, it's due in tomorrow. I remember seeing instructions on how to drop the tank but can't locate them with the search function. I'm also concerned with how to remove the pump from inside the tank. I know you have to spin off the big plastic ring, how do you get the pump off the bottom of the tank?
View 14 Replies
I have a 2004 f150 fx4 no start.fuel pump doesn't run. I have power at pump connector but the ground has high resistance.did visual on harness and connectors nothing found.I don't have access to a diagram to chase it any further.?
View 1 Replies
I have a 2000 4.0 Explorer that sometimes will not start. It has happened on cool mornings as well as hot days after I shut it off, for example, shutting it off to fuel up. I always turn the key to the on position and wait a second or two before cranking, and when I do that, I can usually hear the fuel pump. It's when I don't hear the fuel pump that I know it won't start, and sure enough, crank and no start. My question is, is the fuel pump going out? Or another thought I had was maybe the inertia switch starting to fail? It runs great when it starts, just has a problem starting sometimes.
View 8 Replies
My car is almost turning on. It goes all the way but then just doesn't start. The fuel pump is working, can hear it. We checked for spark and there is. we sprayed that carburetor or whatever it is in the air intake thing too and it still didn't start. My buddy is saying that it has to be a sensor. Either O2 or crankshaft something sensor.
View 13 Replies
My parent's bought a 2002 Explorer 4.0 V6 very early, either late '01 or early '02 when it first came out. Besides the dash blackout (which I found a fix for, need to do) it's been plauged latley (since Nov/Dec 2010) with the intermittent issue of when... You turn the key on to start, you dont hear the fuel pump enguage, thus no start. Get towed, it works like a champ.
It's blown a fuse 1 or 2 times cause of this, had the fuel pump recently replaced (dec/jan this year) and just did it again. Our local Ford dealership figured the fuel pump went bad from sitting, the vehicle only has about 33k miles on it (dad dont drive much). What appears to be a bad fuel pump, only to have it get towed, or sit overnight and start like nothing ever happened?
Dad's ranting about not trusting the vehicle anymore, he's 80yrs old so I can't blame him for wanting to feel comfortable with knowing his vehicle should start, but it is a machine, they do break but we cant seem to get this fixed.
View 14 Replies
My 1995 ford ranger with a 3.0 will not start. It acted like the fuel pump was going out so I replaced it. I also replaced cmp sensor and the camshaft synchronizer due to old cmp sensor broke and messed up the synchronizer. My truck is getting fuel and spark but still will not start. Where do i go next?
View 4 Replies
