Ford Excursion :: Squeaking / Odd Grinding Coming From Front Brakes
Aug 23, 2012
Replaced both rear calipers about 4 months ago, both were frozen. A few weeks ago I started getting some bad squeaking from the front brakes. The front calipers seemed fine when I did the rears.
Tonight I had even more fun with the beast. Drove to my sons baseball game and felt an odd "grinding" when braking. *Seems* to be coming from the front. On the way home, the grinding was worse and then the fun really started. Hit the brakes and the wheels started hopping enough to shake the whole friggin' truck. Leaving from a light, you could feel the brakes stick and then release, next stop was more shake n bake.
Not sure where to start on this one.
View 10 Replies
Advertisement
Just got a 2013 IS-F. Loving this car, but discovered an annoying issue. Grinding noise coming from front brakes when slowly coming to a stop below 5 mph. Is this normal?
View 9 Replies
My 2003 windstar SEL needed new brakes and to have the rotors turned... instead I opted to buy new discs and pads online ... To my surprise the new discs were about a 16th of an inch thinner than the old.... I changed discs and pads and was happy for a few days, but now on occasion when coming to a stop the front brakes grind terribly....the next time i stop everything is fine...visa versa...dscs feel true (no pulsing) I DID APPLY BRAKE QUIET TO THE BACKS OF PADS....
View 2 Replies
My wife told me she was hearing a squeaking sound coming from the front end of our 2006 Prius (90,000 miles) along with a noise when she applied the brakes.
View 1 Replies
After putting my Ford Ranger in park and pressing down on the E-break to get the news-paper or mail. I've noticed that there is a consistent squeaking coming from the back drum brakes when the brake pedal is applied. But only for a certain period of time; then the squeaking stops.
View 8 Replies
So, last week I got my transmission replaced and they also had to replace the CV axle because it was damaged beyond repair when the Transmission self-distructed. They drove it after all the repairs and said it was driving fine, just that it had a belt squeak.
On my way home (30 min drive) about 10 minutes in, still in the city, my brakes start making a grinding noise and sort of a thump thump thump when I brake which sounds like its coming from the passenger side front, it makes me really nervous. It doesn't sound like any brake grindy noise Ive ever heard before and it wasn't making any brake noises before it broke down. (On a side note: it also made a weird noise maybe the first 3 times I drove it after getting it back and I turned the wheel hard to back out of a parking space, that used to be when I heard the belt squeak but I haven't made it squeak since I got the car back.)
Everyone I talked to said it sounded like it needed new pads so tonight I bought new brake pads and rotors for the front and got everything taken apart. The rotors didn't look bad at all, just some light surface scratches, nothing deep, no warping I could see, and the brake pads look almost brand new. I did notice that the inside brake pad on the passenger side was missing its little metal plate that is usually between the caliper and the pad, so I went ahead and replaced all of the brake pads hoping this lost metal plate was the issue.
I also turned the rotor by hand on each side while the brake pads were off and the only difference I could notice was when turning the passenger side one it made a little more noise almost like it was loose.
I got everything put back together and drove around the neighborhood with my boyfriend in the car to listen, the grinding noise was gone and it seemed to brake really well (never got above 30 mph.) However, on my way to return the rotors to advanced auto (45-50 mph) it started making the thump thump thump noise but without the grinding, still on the passenger side. I can feel it in the gas pedal and now it not only happens when I'm braking, but also any time I let my foot off the gas pedal. The only time I dont feel/hear it is when I'm accelerating.
View 3 Replies
We have a 1998 Toyota Corolla with 170k miles. The brakes are squeaking and grinding often. In Feb. the front brake pads were replaced, but the noises continued. In May, they replaced the front pads again, within a week the grinding and squeaking continued. Finally, I took the car in late July and had the mechanic drive the car around. He said the back brakes were making the "grinding" noise and the front was squeaking. He said it was "cheap brake parts". When he looked at the brakes he said the back brakes needed adjusting and may not be working as well, therefore making the front brakes work hard. This caused the front brakes to get hot and develop a glaze. He adjusted the back brakes and scratched up the front brakes. The car was fine for about 2 weeks or so. The sounds have gotten progressively worse and I refuse to drive the car. The brakes seem to work, but the sound is so terrible like something is loose, or off and scraping metal. We have used this mechanic for years with a recommendation from our neighbors.
View 4 Replies
Driving at hwy speeds and head a pop noise in front end. Stopped and couldn't find anything, heard it a couple of more times, still nothing found, now I have a grinding noise left front wheel. What the issue may be. 2001 Ford EX 4X4.
View 6 Replies
So to start at the beginning.... Traveled across Canada East to West towing 11000lb travel trailer, no problem. Have used 4x4 in a few campsites to pull out of a pitch without spinning the wheels and causing damage to the site when it has been really wet. All good.
Got to Banff in December and the town was an Ice rink, engaged 4x4 and all good. Crossed the Rockies and the 4x4 starts making grinding noises. Up and down some mountains and squeaking, grinding noise then clunking.
I have manual hubs, disengage and the noise all goes away. Engage 1 hub and no noise. Engage both hubs, noise back.
I bought some needle bearings and went to swap them. Got hubs apart and they look good. No scoring on the drive shafts. They are not dry, but as I have them open, repack them with grease anyway.
Do more research... Remove ABS sensor and repack main bearings with grease. (broke one sensor pulling it out, too cold plastic brittle oops). Still clunking noises.
The universal joints look good, doesn't appear to be any play in them. However, the axle seal (knuckle seal) (F81Z-3254-CB) does move around a lot in it's metal casing. It is tight on the shaft, but with the hub off, I can move it in and out, and move it side to side. If I had ESOF hubs I guess they would not be locking as I'm sure there would be no vacuum in there!
Question is then, would this seal be allowing the universal joint to wobble under load in 4x4 mode? Would this wobble be the cause of the rumble? As it is labelled as a seal and not a bearing, I wouldn't of thought this would have been a loaded point, and the weight would have been taken by the associated bearings and it could be run without this seal? But if it is not this, then I'm still looking for a clue as to what is making the rumble....
View 3 Replies
So my front brakes are squeaking pretty damn bad, and I'm pretty sure that I need to replace them. However, with the history that we have with the rears wearing faster than the fronts, and since neither have been replaced in 30K miles.
I don't want to have to come back and go at it again, and would rather spend one day then two getting the job done. .
View 14 Replies
My 2013 gs 350 f sport sounds like a school bus. I already replace the front pads with a new set of oem pads and had them resurface the disk too. after a couple of hours the noise came back! seems like my lexus dealer can't solve my issue.
View 14 Replies
Have 2005 excursion. Just did ball joints , wheel bearings all of them, axle joints and seals.Also warn manual hubs. Have a intermittent scraping grinding noise sounds like driver but could be both front.4wd works fine in high or low, no vibration just this annoying noise. took brakes apart and no funny wear or foreign object in dust shield.
View 3 Replies
my 99 s/w 2 started making a squeaking sound coming from the front right wheel area it goes away when I apply the brakes? is that one of those built in warning features to let you know the brake pads are getting low? the brakes have 86,000 miles on them.
View 2 Replies
Had a grinding noise in my front end, left side. Found the hub was bad so got it replaced. Now I still have a grinding noise that comes and goes. If I hit a bump, it starts the grinding noise but nothing constant. Had the front end checked and nothing was obvious. Was trying different things and when I put it in 4WD, with the switch on the dash, the noise goes away. What to try next?
View 2 Replies
I'm hearing a sort of faint rotating squeaking noise coming from the front of the engine; I can only assume that it's something with the belts. Nothing too pronounce cause I just notice it yesterday, anyway I was hoping I get another take on what this might be before I take it to the mechanic tomorrow.
View 12 Replies
But I'm still getting a grinding/clunk noise and general loose feeling from the front end. The only play I can feel is when I grab the u-joint/knuckle and pull up and down on it. I also noticed the seal at the end of the axle shaft tube is not there on 1 side... would this lack of seal cause the looseness?
View 9 Replies
Started about a month ago with a very infrequent squeaking coming from area of front left wheel. Has started getting more and more frequent to the point of being constant for about 10 minutes today, then just went away for the remaining 15 miles home. Front left hub was definitely warmer than the other one but not too hot to touch or anything. Start of a bearing issue or something to do with the auto locking hubs for the 4wd???
View 14 Replies
we've had a bunch of snow this week and I've been driving around with my hubs locked in. today I noticed when I was slowing down to pull into my driveway I could hear a slight squeaking sound(sounded like a squeaky belt) coming from the front.
I verified it was coming from underneath the truck behind the engine compartment so I unlocked the hubs and went for a drive, the sound was gone. I crawled underneath and turned the front driveshaft by hand and I could hear a slight rubbing sound at the back of the pinion. The bearing doesn't have any play in and there are no leaks. What is going on? Could the bearing be starting to fail or could the rubber seal around the pinion have some grit in it causing the noise?
View 10 Replies
So I have every so often been hearing a grinding noise coming from what I believe is my back brakes (only does it when I brake). It isn't every time I brake but it does seem to happen almost every time I back up out of my spot initially and touch the brakes. It happens almost everytime I brake when driving at a reasonable speed. Tiggy has like 53,000 on it.
I have looked online and I just don't have the tools or access to a garage to do them myself so I think I am going to have to bring it in. Any rough estimate of what it is going to cost me? Also, I just bought this used on 7/5/14, I was under the impression in California that they can't sell a car with having brakes that are this worn.
View 3 Replies
I replaced the pads and rotors on my 1989 toyota camry yesterday. Took it out for a test drive and all appeared to be OK. I did not bleed the brakes, but did have to remove a small amount of brake fluid after installing everything.
On my way into work this morning there was quite a bit of grinding noise coming from the brakes. The noise was not consistent, happening both while brakes were depressed and also when not in use. It also would go away after a few minutes and didn't always happen while braking.
I'm thinking the piston may be locking up at times, but don't know. I'll also throw out there that this is my first brake job. I did follow my Haynes manual and don't think I did anything wrong.
View 8 Replies
The front brakes are pulsing (slightly, enough to spill my coffee when they line up together) with each rotation. I can't tell if they're warped, or if they have a rough patch on each disc.
View 9 Replies
