I have a 2000 Excursion lifted 6 inches with 35" tires on 20" Fuel wheels and i notice when I make a left or right hand turn between 10-20 mph i get a single pop or clunk from the front end.
Also one more really annoying thing while i am turning there is creaking, sounds like body flex? maybe body mounts? Any issues with ball joints?
I have a 2005 Saturn Ion stalls when I make left hand turns! The engine light comes on and the car goes into limp mode! I stop the car and wait a minute or two and it starts right back up and after driving it for a while the engine light goes out! I took it to a shop and they replaced the throttle body and ignition coil on two different occasions and my car still does the same thing!
View 2 RepliesMy wife informed me about a noise coming from the chassis of her truck.
2007 Explorer XLT 4x4, 4.0 OHV, AT, 89,000 miles on the odometer.
We took the truck to dinner last night so I could investigate the problem. This occurs while only making left hand turns at slow speed.
There is a definite clunk sound AND feel. It actually sounds and feels like we are driving over a loose manhole cover, and IT DOES feel like metal to metal contact on the driverʻs sids of the truck.
For the past couple of days, I've been hearing the sound of pouring, sloshing liquid when I make a right hand turn. It comes from down below the dashboard, toward the middle. It seems to happen only when I've had the air conditioning on, and only when I make a right turn. Today, some liquid actually trickled out onto my foot. What might be going on and how I can get it taken care of inexpensively?
View 5 RepliesI got a heat shield that just will not stop causing me grief. When I installed the headers and pipes I had a heat shield that was too close to the passenger side pipes. I bent it down some to clear the pipe and got rid of a nasty metallic sound I had on the throttle and making left hand turns. Well that little sound returned last week and I crawled under and looked and sure enough the heat shield was touching again.
Who knows why maybe a bit a spring sag. So yesterday I bent it down a little more. Today I start getting a nasty clunk on dips and especially when on a bump why turning. I crawl under there too look and find the same heat shield now has a huge gouge on the under side of it where the leaf spring near the rear bushing is smacking it. I'm sure Ford put it there for a good reason so hate to remove it.
First pic of the hacked up bend job I put on it.
Second pic of the gouge in the bottom of it where it's hitting.
The other day I hit a good size bump at speed, slightly bent a wheel which I didn't even notice at first. The car drove straight and had no other symptoms, thought everything was okay. A couple days later I heard a weird grinding noise while making a left hand turn, it was so faint I honestly thought it was the fender liner. After the noises continued and further examination I noticed that the carrier is rubbing the rotor on the lower drivers side corner.
View 1 RepliesMy Neon has this strange problem and I can't figure it out neither can my mechanic. Mainly when I'm making a left hand turn there is a knock sound underneath the car, like I can almost feel something jerking up underneath my pedals. And then after making the left hand turn and then accelerating... my car would almost feel like it was stuck to the left and jerk itself straight again.
NOTE: I have replaced/checked the Lateral and Radius Bushings, Control Arm Bushings, Sway Bar and I also recently got new rims and tires which at that point I got an alignment. But nothing has worked so far and I'm at a loss.
I have a 96 Buick Century Special with the 3.1 six cylinder engine. Starting on March 18, 2015 my car has started blowing the Injector Coil fuse any time I take a fast left-hand turn. It never does it during a right-hand turn. I have now replaced the fuse a total of 5 times since March 18.
View 1 RepliesHave a problem When i make a slight turn to the left sounds like the tire is rubbing the inner fender. Don't do it all the time. The tire is not rubbing.
View 4 RepliesMy 2002 Honda Odyssey makes a squealing noise when I make a hard left turn. Could it be related to power steering? Is it an urgent problem? I will take a trip next week (~650 miles each way), and need to know if I should address this first.
View 3 RepliesI have a 2004 Accord. The radio died a slow death (going on and off at will.) It's finally dead, now. The other strange thing, is the the dome light comes on when I make a left turn. The mechanic I took it too couldn't figure it out, and told me to take it to the dealer.
View 3 RepliesSo I've been driving my 3GS 350 and every time i make a right turn the left wheel makes this metal shaking sound? or scraping sound? I've checked it out seems like nothings in the way but I don't know how to tell if i have a bad wheel bearing..
View 9 RepliesJust got a diagnostic from the nice people at Prius Battery Repair. Check engine light was on and intermittent red triangle when I make a left turn. Code PO505 came up- Idle control System. I have 162,000 miles and just put in a reconditioned battery that checks out fine.
View 5 RepliesBasically, when I make a hard left turn I hear a noise out of the front right wheel area. I do not hear anything in any other condition. It sounds like something rubbing up against something else. I know that my rims are in good shape - is this an outer or inner bearing issue? Or is this something completely different?
View 2 RepliesI am having a problem with my 2007 R32 manual,over the last few weeks its developed a whining noise in what seems to sound from the rear left side,more so when driving around a left hand corner (weight is off the noisy side),or when i let my foot off the gas and let the car run,ive jacked it up and when I grab the back left drive shaft and shake it, I found there's a bit of play on the side going into the diff, there's 70000 miles on it and no problems to date, looking for some info on what problem could be?
View 6 RepliesWhen making turns and occasionally during slowing and accelerating, a klunk or pop sound comes from the front of the vehicle. It is a F-150 STX 2011 2WD shortbed with 16,000 miles. Engine is 5.0 with 6 speed auto. Previos owner had (before returning to stock) put a lowering kit in, headers back exhaust, intake, tuner, etc. Truck is butchered a bit from pos previous owner. Front end components have all been checked, bolts torqued. Even the cab mounts have been checked. The only thing that can be seen that might contribute is the cat crossover supports have been hacked off.
View 1 RepliesA while back as I was driving, I heard some sort of clunk, and the steering wheel locked and would not turn left. It then unlocked after a few seconds. Ever since then, it has been very hard to turn to the left (and right, at slow speeds and on sharp turns, but much easier than turning left). This happened a few days after I replaced both front end struts and inner tie rod ends, and got an alignment - they were cheap quick struts (entire assembly), but seem to be of fairly good quality.
Initially after some consultation I thought it was the power steering pump, so I replaced that. It became easier to turn right, but still very hard to turn left. I took the front end off the ground and turned the wheel all the way left and right, no problem or resistance. I am nearly certain it is not the pump.
At this point, I am fairly certain it is either the steering gear or some part of the rack and pinion. I am planning on getting the assembly replaced. The fastest and cheapest way is apparently to just buy the entire steering gear/r&p assembly. Would bad strut mounts ever cause an issue like this? Any other possibilities besides the steering linkage?
If I am going under 15mph or so and turn the wheel left or right i hear a small "clunk" sound. It happens when i get the wheel to about 2 and 3 when i turn right and about 10 and 9 when i turn left... What could this be? Also i do not hear it when I am going over 20mph or so ...
View 24 Replies2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
I have 3 major problems which non of my mechanics can figure out.
One problem I have is, I hear a clunk when I change from D to R or R to D ( no pause for neutral ), If I do pause, there is no clunk. Could this be a u joint problem?
Second issue I have is when I turn left, the whole car shakes side to side, it feels like its the transmission that's shaking and seems like its going to fall off. CV Axle or drive shaft?
Third, when I accelerate from 0 - 20 mph, I have a quick shimmy from the transmission area but stops after I go to 25mph. U joint or center bearing?
I'm having problems with my left turn signal not working. It sounds like it's blinking super fast from inside the vehicle, the left turn dash light does not illuminate, and the outside front bulb does not blink. When I turn my emergency flashers on, the left front still doesn't work, but all others do. All the other bulbs are in working order. I searched through some old threads on this and couldn't find much other than to replace the bulb and bulb housing, which I did with no luck.
View 14 Replies